• 대한기계학회논문집B
• /
• 제32권2호
• /
• pp.100-106
• /
• 2008

An experimental study was carried out in a small-scale test furnace to investigate the performance, such as $NO_X$ emission, enhancement of heat transfer, uniformity of temperature, and etc, of oscillating combustion applied in radiant tube burner system. A premixed type burner and a cyclic oscillating control valve were designed and used. The fuel, used commercial LPG in this study, was only oscillated using the cyclic oscillating control valve. As oscillating combustion was applied in radiant tube burner system, it is found that $NO_X$ emission, compared to no oscillation, could be reduced by 38% at $90{\sim}120rpm\;(1.5{\sim}2.0Hz)$. However, as oscillating frequency was increased, effect of abatement of $NO_X$ emission is gradually reduced. From the measurement of furnace heating time from $100^{\circ}C$ to $720^{\circ}C$, heat transfer is increased by 11.5% at the oscillation of 120rpm. Temperature distribution of radiant tube surface is more uniform at oscillation of 120rpm with decrease of the peak temperature and increase of low temperature. From these results, it is confirmed that oscillating combustion is useful in radiant tube burner system.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2008년도 추계학술대회A
• /
• pp.1692-1696
• /
• 2008

In this paper, we characterize the mechanical properties of PCL strand which is made by oscillating nozzle for tissue engineering scaffold. In order to increase the mechanical properties of the PCL strand, we designed an oscillating nozzle system for the 3D plotting system. First, we check the effect of the nozzle speed (3 to 8 mm/sec), frequency (0 or 300 Hz) and the oscillating amplitude (0 or 100 V) on the diameter of the PCL strand. Second, we observe the effect of the frequency (0, 100, 200 and 300 Hz) and the oscillating amplitude (0, 50 and 100 V) on the mechanical property of PCL strand. The mechanical properties and surface morphology of PCL strand made by oscillating nozzle are compared with the PCL strand made by normal nozzle using Nano-UTM and SEM.

• 설비공학논문집
• /
• 제19권3호
• /
• pp.220-227
• /
• 2007

Heat transfer and momentum transfer under conditions of both oscillating flow and oscillating pressure within pulse tubes show very different behavior from those for steady state conditions. The analytic solutions of axial velocity and temperature of the gas within pulse tubes were obtained by assuming that the variations in pressure and temperature were purely sinusoidal and small. The shear stress and the heat flux at the tube wall obtained from the solutions are expressed in terms of the cross-sectional averaged velocity, the difference between mean temperature and instantaneous cross-sectional averaged temperature and the difference between mean pressure and instantaneous pressure. It is shown that the complex shear factor, which has been applied to momentum transfer of incompressible oscillating flow, and the complex Nusselt number, which has been applied to either heat transfer with oscillating pressure only or heat transfer of incompressible oscillating flow, could also be used for momentum transfer and heat transfer subjected to both oscillating flow and oscillating pressure, respectively.

• Bulletin of the Korean Chemical Society
• /
• 제19권7호
• /
• pp.743-746
• /
• 1998

The Belousov-Zhabotinskii (BZ) reaction, which is composed of a bromate-organic acid-metal catalyst and an acidic solution is a commonly employed chemical oscillating reaction system. Cyclohexanedione (CHD) has been used as an initial organic substrate in oscillation systems. We studied each system of 1,4-CHD/BrO3-/Ce4/H+ and 1,3-CHD/BrO3-/Ce4+/H+ oscillating reactions, and studied the control of oscillating characters in a CHD/BrO3-/Ce4+/H+ batch system using a mixed substrate of 1,4-CHD and 1,3-CHD under a fixed total CHD concentration. In the mixed reactions, 1,4-CHD was used as a main substrate and small amounts of 1,3-CHD were used in order to vary the oscillatory behaviours by changing the mixing amount ratio of two substrates.

• 대한전자공학회논문지
• /
• 제24권3호
• /
• pp.413-419
• /
• 1987

In this paper, self-oscillating mixer is designed by small signal S-parameter and series feedback circuit. The input-output matching circuit is accomplished from double stub and additional matching stub. The self-oscillating mixer is oscillating itself and amplifies without any external local oscillator and an intermediate frequency amplifier, so it has advantages in its economical and system simplification. The experimental results show the maximum conversion gain 1.5d B and the noise figure 6.5d B at RF center frequency 4GHz and IF 1.1GHz` output oscillating power 4d Bm, efficiency 13.4%, stability -10MHz/V and -0.5MHz/\ulcornerC at oscillating frequency 5.1GHz.The rejection band loss characteristics in band pass filter and low pass filter are -40d B and -30d B, respectively.

• 전력전자학회논문지
• /
• 제15권1호
• /
• pp.1-8
• /
• 2010

본 논문은 별도의 PWM-IC없이 저가 구현이 가능한 자려 발진 플라이백 컨버터의 대기전력 저감을 위한 회로를 제안한다. 제안된 자려발진 플라이백 컨버터는 기존 자려발진 플라이백 컨버터의 스위치 초기 동작을 위한 경로에서 발생하는 지속적인 전력손실 문제를 개선하기 위해 DC-Blocking 캐패시터를 삽입한 형태로써 약 1W의 대기전력 저감효과 및 시스템의 전력 변환 효율 향상이 가능하다. 본 논문에서는 제안된 회로의 동작원리를 설명하고, 실제 35W급 전원시스템을 구현하여 기존 회로와의 비교를 통해 제안된 회로의 타당성을 검증한다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.153-156
• /
• 2000

To reduce the maintenance expense, and the possibility of electric outage and accident, we should optimize the outdoor insulation system. And for the optimization, accurate measurement for the degree of contamination with climatic conditions, such as wind, rain, and drought, should be carried. However the classical measuring method, brush wiping, has some problems in the aspect of man power, reliability, and expense. In this paper, we propose two type apparatus, which could detect the degree of contamination on insulators in outdoor insulation system, such as transmission and distribution line insulator and bushing. One use the leakage current, and the other use the oscillating frequency to check the degree of contamination. To avoid the oxidation of electrode AC source, and the low degree of contamination was applied. From the result of this investigation we could get the good relationship between the degree of contamination and the leakage current and oscillating frequency

• 대한기계학회논문집B
• /
• 제25권9호
• /
• pp.1272-1280
• /
• 2001

An experimental study has been conducted to elucidate the resonance of natural convection in a side-heated square enclosure having a mechanically oscillating bottom wall. Under consideration is the impact of the imposed oscillating frequency, amplitude and the system Rayleigh number on the fluctuation of air temperatures. The experimental results show that the magnitude of the fluctuation of air temperature is substantially augmented at a specific forcing frequency of the oscillating bottom wall. The resonant frequency is increased with the increase of the Rayleigh number and it is little affected by the amplitude of the oscillating wall. It is also found that the resonant frequency is relevant to the Brunt- V$\"{a}$iS$\"{a}$l$\"{a}$ frequency which represents the stratification degree of the system.

• 전자공학회논문지B
• /
• 제33B권3호
• /
• pp.56-61
• /
• 1996

In this paper, new buck converter of a TV power system is presented. First, we devised a revised driving circuit for an emitter-coupled type buck converter, by which it is possible to reduce the material cost of transformers and voltage stress of power device. Secondly, we adopted a hybrid oscillation technique. When TV system is in off-stage, initial standby power which is necessary for remote controllable TV system is supplied by self-oscillating mode. Main power which is necessry in TV system bing on state is provided by an externally triggered oscillating mode. The switching frequency is synchronized to the oscillating frequency of horizontal deflection in TV, by which we can reduce picture noises and the size of power transformer. Thirdly, a simple error amplifier is inserted to the feed-back loop to keep the output voltage constant which means pulse width modulatio mode is added in driving part of power device. Finally, we showed by experiments that our proposed converter performs well enough to be close to the theoretically predicted values.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 춘계학술대회
• /
• pp.1499-1505
• /
• 2003

Rapid development of electronic technology requires small size, high density packaging and high power of electronic devices. So, in this paper, characteristics on oscillating heat pipe according to operating conditions(environment temperature, charging ratio of working fluid, inclination) based on experimental study was investigated. From the experimental results, $25^{\circ}C$environment temperature), R-141b(working fluid)40%(charging ratio) was best performace at others of inclination angle and The top heating mode of OCHP performed 80% efficiency of the bottom heating mode.