• Journal of Korean Society on Water Environment
• /
• v.22 no.1
• /
• pp.23-29
• /
• 2006

Biosorption technology was used to remove hazardous materials from wastewater, herbicide, heavy metals, and radioactive compounds, based on binding capacities of various biological materials. Biosorption process can be explained by two steps; the first step is that target contaminants is in contact with microorganisms and the second is that the adsorbed target contaminants is infiltrated with inner cell through metabolically mediated or physico-chemical pathways of uptake. Until recently, no information is available to explain the definitive mechanism of biosorption. The purpose of this study is to evaluate biosorption capabilities of organic matters using activated sludge and to investigate affecting factors upon biosorption. Over 49% of organic matter could be removed by positive biosorption reaction under anoxic condition within 10 minutes. The biosorption capacities were constant at around 50 mg-COD/mg-MLSS for all batch experiments. As starvation time increased under aerobic or anaerobic conditions, biosorption capacity increased since higher stressed microorganisms by starvation was more brisk. Starvation stress of microorganisms was higher at aerobic condition than anaerobic one. As temperature increased or easily biodegradable carbon sources were used, biosorption capacities increased. Consequently, biosorption can be estimated by biological -adsorbed capability of the bacterial cell-wall and we can achieve the cost-effective and non -residual denitrification with applying biosorption to the bio-reduction of nitrate.

• Journal of Korean Society of Water and Wastewater
• /
• v.29 no.3
• /
• pp.337-345
• /
• 2015

Two step rapid filter system as a pre-treatment for the injected water into aquifer storage and recovery (ASR) in Korea was developed to reduce physical blockage and secure the volume of the injected water. First, single rapid sand filters with three different media sizes (0.4~0.7, 0.7~1.0 and 1.0~1.4 mm) were tested. Only two sizes (0.4~0.7 and 0.7~1.0 mm) satisfied target turbidity, below 1.0 NTU. However, they showed the fast head loss. To prevent the fast head loss and secure the volume of the injected water, a rapid anthracite filter with roughing media size (2.0~3.4 mm) were installed before a single rapid sand filter. As results, both the target turbidity and reduction of head loss were achieved. It was determined that the media size for a rapid sand filter in two step rapid filter system (i.e. a rapid anthracite filter before a rapid sand filter) was 0.7~1.0 mm. In addition, the effects of coagulant doses on the removal of natural organic matter (NOM), which might cause a biological clogging, were preliminarily evaluated, and the values of $UV_{254}$, dissolved organic carbon (DOC) and SUVA were interpreted.

• Journal of Climate Change Research
• /
• v.6 no.3
• /
• pp.233-241
• /
• 2015

In 2014, the United Nations Framework Convention on Climate Change (UNFCCC) agreed to submit the Intended Nationality Determined Contributions (INDCs) at the conference of parties held in Lima, Peru. Then, the South Korean government submitted the INDCs including GHGs reduction target and reduction potential on July, 2015. The goal of this study is to predict GHGs emission and to analyze reduction potential in agricultural sector of Korea. Activity data to estimate GHGs emission was forecast by Korea Agricultural Simulation Model (KASMO) of Korea Rural Economic Institute and estimate methodology was taken by the IPCC and guideline for MRV (Measurement, Reporting and Verification) of national greenhouse gases statistics of Korea. The predicted GHGs emission of agricultural sectors from 2021 to 2030 tended to decrease due to decline in crop production and its gap was less after 2025. Increasing livestock numbers such as sheep, horses, swine, and ducks did not show signigicant impact the total GHGs emission. On a analysis of the reduction potential, GHGs emission was expected to reduce $253Gg\;CO_{2-eq}$. by 2030 with increase of mid-season water drainage area up to 95% of total rice cultivation area. The GHGs reduction potential with intermittent drainage technology applied to 10% of the tatal paddy field area, mid-drainage and no organic matter would be $92Gg\;CO_{2-eq}$. by 2030.

• Journal of Microbiology and Biotechnology
• /
• v.20 no.5
• /
• pp.925-934
• /
• 2010

Three typical biological solid wastes, namely, animal manure, garbage, and sewage sludge, were compared with regard to the composting process and the changes in microbial community structure. The effects of different bulking agents such as rice straw, vermiculite, sawdust, and waste paper were compared in manure compost. The differences in the microbial community were characterized by the quinone profile method. The highest mass reduction was found in garbage composting (56.8%), compared with manure and sludge (25% and 20.2%, respectively). A quinone content of $305.2\;{\mu}mol/kg$ was observed in the late stage of garbage composting, although the diversity index of the quinone profile was 9.7, lower than that in manure composting. The predominant quinone species was found to be MK-7, which corresponds to Gram-positive bacteria with a low G+C content, such as Bacillus. The predominance of MK-7 was especially found in the garbage and sludge composting process, and the increase in quinones with partially saturated long side-chains was shown in the late composting process of manure, which corresponded to the proliferation of Actinobacteria. The effects of different bulking agents on the composting process was much smaller than the effects of different raw materials. High organic matter content in the raw materials resulted in a higher microbial biomass and activity, which was connected to the high mass reduction rate.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.407-409
• /
• 2006

Geochemical analyses carried out on samples collected from cores on and near the southern smit of Hydrate Ridge have advanced understanding by providing a clear contrast of the two major modes of marine gas hydrate occurrence. High concentrations (15%-40% of pore space) of gas hydrate occurring at shallow depths (0-40 mbsf) on and near the southern summit are fed by gas migrating from depths of as much as 2km within the accretionary prism. This gas carries a characteristic minor component of C2-C5 thermogenic hydrocarbons that enable tracing of migration pathways and may stabilize the occurrence of some structure II gas hydrate. A structure II wet gas hydrate that is stable to greater depths and temperatures than structure I methane hydrate may account for the deeper, faint second bottom simulating reflection (BSR2) that occurs on the seaward side of the ridge. The wet gas is migrating In an ash/turbidite layer that intersects the base of gas hydrate stability on the seaward side of and directly beneath the southern summit of Hydrate Ridge. The high gas saturation (>65%) of the pore space within this layer could create a two-phase (gas + solid) system that would enable free gas to move vertically upward through the gas hydrate stability zone. Away from the summit of the ridge there is no apparent influx of the gas seeping from depth and sediments are characterized by the normal sequence of early diagenetic processes involving anaerobic oxidation of sedimentary organic matter, initially linked to the reduction of sulfate and later continued by means of carbonate reduction leading to the formation of microbial methane.

• Coupled systems mechanics
• /
• v.12 no.6
• /
• pp.531-537
• /
• 2023

Municipal solid waste landfills are unpredictable bioreactors which in cases of mishandling and bad supervision presents numerous risks. The key to municipal waste landfills is to approach them from the point of prevention of the possible consequences, which means using methods of organized waste disposal, and also utilizing landfill gas, as an unavoidable consequence with disposal of municipal solid waste with a high share of biodegradable organic matter. This paper presents an overview about problems of solid municipal waste management, type and composition of waste, and an overview of waste management condition. Further, the problem of landfill and landfill gasses is described with the calculation models of landfill production, as well as the use of the SWM GHG Calculator and LandGEM software on a specific example of gas production for the central zone at Sarajevo landfill "Smiljevici". Main focus of this thesis is the analysis of potentials of greenhouse gas emission reduction measures from the waste management. Overview of the best available techniques in waste management is presented as well as the methodology used for calculations. Scenarios of greenhouse gas emission reduction in waste management were defined so that emissions were calculated using the appropriate model. In the final section of the paper, its description of the problem of collection and utilization the landfill gas at the sanitary landfill "Smiljevici", and implementation of the system for landfill gas collection and solution suggestion for the gasification and exploitation of gas. Energy, environmental and economic benefits can be accomplished by utilizing municipal solid waste as fuel in industry and energy and moreover by utilizing energy generation from landfill gas, which this thesis emphasizes.

• Journal of Korean Society of Forest Science
• /
• v.84 no.2
• /
• pp.178-185
• /
• 1995

Air pollution effects on soil chemical properties, denitrifying and sulfur-reducing bacteria and lichens were examined around the Yeochun industrial estate. Soil samples were collected from mountain and/or mountain edges around the Namhae Chemical Corp., which is located at the southern edge of the estate, and sampled plots which were selected at 2km, 4km, 6km, 8km, and 10km apart from the industrial estate. The forest soils around the industrial estate could be classified into the Reddish yellow forest soil group, but soil pH was quite lower than the soils of the group. Because of the extremely low soil pH, microbial activity related to mineralization of organic matter was expected to be very low even though C/N ratio ranged from 15 to 20. As a result, soil organic matter and total nitrogen in soil were relatively high compared to the soils of the group. In general, soil chemical properties around the industrial estate up to 4km apart from the estate were significantly different from the rest(more than 6km apart from the estate) possibly due to air pollution. However, denitrifying bacteria and sulfur-reducing bacteria did not show significant differences in colony forming units by the distances from the industrial estate. By the way, lichens showed distinct differences in frequencies and coverages by the distances from the industrial estate possibly due to air pollution. The corticolous lichens showed more sensitive response to the air pollution compared to the saxicolous lichens.

• Journal of Marine Life Science
• /
• v.4 no.2
• /
• pp.86-90
• /
• 2019

This study aimed to compare the disinfection efficiencies of the ultraviolet and plasma systems, the two systems designed and commercialized to disinfect water in aquaculture, by putting each in a 100 ℓ water tank and concentrating 1.0 ℓ of treated water to check the changes in the number of bacteria in the samples. Each system was operated for 6 hours to culture the typical seawater bacteria in the Marine agar, Thiosulfate citrate bile salts sucrose agar and Salmonella Shigella agar media, respectively, to check the number of bacteria in the media, and the changes in the number of Edwardsiella piscicida in the treated water were checked after the artificial inoculation of E. piscicida in the disinfected seawater. As a result, the two disinfection systems showed the almost similar levels of bacterial reduction efficiency between 99.5% and 99.9%. However, the result of this study showed that, with 100 ℓ of water treated for the same length of time using the two systems, the plasma system turned out to disinfect bacteria in a shorter period of time than the UV system. However, as the changes in the number of bacteria were checked for a short length of time (6 hours) in this study, it was judged that, considering the actual aquaculture environment in which the quality of water significantly changes with feed residues, excretions and coastal contamination, etc., and a lot of biofilms and organic matter exist, the plasma system would be more efficient than the UV system as the former is capable of continuously maintaining a certain level of efficiency than the latter that is limited in terms of efficiency depending on the level of turbidity and the existence of organic matter.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.12
• /
• pp.682-688
• /
• 2015

Effect of electrode spacing on the performance of microbial electrolysis cells(MECs) for treating sewage sludge was investigated through lab scale experiment. The reactors were equipped with two pairs of electrodes that have a different electrode spacing (16, 32 mm). Shorter electrode distance improved the overall performance of MEC system. With the 16 mm of electrode distance, the current density was $3.04{\sim}3.74A/m^3$ and methane production was $0.616{\sim}0.804Nm^3/m^3$, which were higher than those obtained with 32 mm of electrode spacing ($1.50{\sim}1.82A/m^3$, $0.529{\sim}0.664Nm^3/m^3$). The COD removal was in the range of 34~40%, and the VSS reduction ranged 32~38%. As the current production increased, VSS reduction and methane production were increased possibly due to the improved bioelectrochemical performance of the system. Methane production was more affected by current density than VSS reduction. These results imply that the reducing the electrode spacing can enhance the methane production and recovery from sewage sludge with the decreased internal resistance, however, it was not able to improve VSS reduction of sewage sludge.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.1
• /
• pp.23-33
• /
• 2017

In this study, water and organic treatment efficiency and operating characteristics (temperature, salinity effect) were evaluated when food waste with high water content was treated by Bio-dying method. In addition, the optimum conditions for producing pellets for evaluating the decomposition products as SRF(Solid Refuse Fuel) after Bio-drying and evaluating the use value of SRF as a solid fuel were analyzed. As a result, the temperature, $CO_2$ concentration, organic matter removal rate and weight reduction rate according to the daily dose were about 86% and 68% at the input of 2.4 kg/day. The optimal food waste input was estimated to be 2.4 kg/day. As a result of the pellet molding and produce, Pellets can be produced within 10~25% of raw material water content. It was judged that the water content of 25%, which showed the best quality results in terms of external shape maintenance and strength. The high calorific value of SRF of decomposition products after Bio-drying was more than 3,500 kcal/kg.