• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2003.05a
• /
• pp.283-287
• /
• 2003

In recent years, design of an optimal blank shape is very important for sheet metal forming process in the automobile industry because the raw material cost rate is significant part in the automobile industry. With the design of an optimal blank shape, the engineer can protect a blank from an excessive holding force to improve the quality and reduce the ratio of material scrap. Therefore design of an optimal blank shape is inevitable in sheet metal forming process. However, if it causes a complicated shape of blank, it may be difficult to do the blank layout optimally. In this study, we developed software of optimal blank layout connected with the software of optimal blank shape design which was created in the past by the present authors. And by using these softwares, we would like to present the method in order to get optimal utilization ratio easily and precisely within short time for the sequence of works from design to blank layout.

• Transactions of Materials Processing
• /
• v.23 no.8
• /
• pp.501-506
• /
• 2014

Progressive shearing with blanking dies is commonly employed to produce large quantities of tiny sheet metal electronic parts. Sheet metal pins, which are narrow and long, that are sheared with a progressive die set are often twisted. The twist in the sheet metal pins, which usually occurs in the final shearing operation, generally decreases with increasing blank holding force. The blank holding forces in all shearing operations are not the same because of different shearing positions and areas. In the current study, the optimal layout of the springs in a progressive die set to minimize the twist of the sheet metal pin is proposed. In order to find the holding force acting on the tiny narrow blanks produced with the proposed springs during the shearing process, the equivalent area method is used in the structural analysis. The shearing of the sheet-metal pin was simulated to compute the twist angle associated with the blank holding force. The constraint condition satisfying the pre-set blank holding force from the previous shearing operations was imposed. A design of experiments (DOE) was numerically implemented by analyzing the progressive die structure and by simulating the shearing process. From the meta-model created from the experimental results and by using a quadratic response surface method (PQRSM), the optimal layout of the springs was determined. The twist of sheet metal pin associated with the optimal layout of the springs found in the current study was compared with that of an existing progressive die to obtain a minimal amount of twist.