• 한국전자통신학회논문지
• /
• 제12권5호
• /
• pp.731-736
• /
• 2017

본 논문에서는 광통신용 공진기에 필요한 광섬유의 오목한 면 제작에 관한 연구를 진행하였다. 불산(Hydrofluoric acid) 용액과 이 용액에 잘 흡수될 수 있는 파장인 $1.55{\mu}m$의 레이저를 인가하여 광열효과를 유도하였고, 식각 용액에서의 광열효과를 통해 광섬유 끝단의 곡률 반경을 자유롭게 변경할 수 있는 점을 현미경 사진 촬영으로 확인하였다. 빔 프로파일러를 이용하여 제작한 결과물의 끝단에서 방사되는 빔의 크기 변화를 관측하여 유효성을 검증하였고 본 논문의 저자들은 제시한 방식이 광통신용 공진기에 적용 가능성이 있을 것으로 보고 있다.

• ETRI Journal
• /
• 제30권2호
• /
• pp.275-281
• /
• 2008

A 40 Gb/s clock and data recovery (CDR) module for a fiber-optic receiver with improved phase-locked loop (PLL) circuits has been successfully implemented. The PLL of the CDR module employs an improved D-type flip-flop frequency acquisition circuit, which helps to stabilize the CDR performance, to obtain faster frequency acquisition, and to reduce the time of recovering the lock state in the event of losing the lock state. The measured RMS jitter of the clock signal recovered from 40 Gb/s pseudo-random binary sequence ($2^{31}-1$) data by the improved PLL clock recovery module is 210 fs. The CDR module also integrates a 40 Gb/s D-FF decision circuit, demonstrating that it can produce clean retimed data using the recovered clock.

• 한국통신학회논문지
• /
• 제21권6호
• /
• pp.1596-1603
• /
• 1996

A single body type of fiber-optic current and voltae sensor using a rare earth doped YIG and a bismuth silicon oxide single crystsl is proposed, which is used for simultaneous measurement of the AC electric current and AC electric voltage over the trasmission lines. Experimental results showed that the fiber-optic current sensor has the maximum 7.5% error within the current range of 0A to 400A, and the fiber-optic voltage sensor has the maximum 0.87% error within the current range of 0V to 400V. The output waveforms of proposed fiber-optic sensor system has a good agreement with output waveforms of conductor current and voltage. Experimental results proved that the output of fiber-optic current sensor is not affected by the electric voltage applied to the fiber-optic voltage sensor, and also, that the output of fiber-optic voltage sensor is not affected by the electric current applied to the fiber-optic current sensor.

• Journal of the Optical Society of Korea
• /
• 제12권4호
• /
• pp.351-354
• /
• 2008

We demonstrate an ultra-dense wavelength-division- multiplexed (UD-WDM) passive optical network (PON) where 12.5-GHz spaced 1 GbE ${\times}$ 256 optical channels are distributed using 12.5- and 200-GHz arrayed waveguide gratings in series. For the generation of upstream signals, we use reflective semiconductor optical amplifiers. We use two optical fiber amplifiers at the optical line terminal to amplify downstream and upstream channels.

• ETRI Journal
• /
• 제30권2호
• /
• pp.249-254
• /
• 2008

In this paper, we demonstrate an electrically band-limited carrier-suppressed return-to-zero (EB-CSRZ) signal generator operating up to a 10 Gbps data rate comprising a single-stage Mach-Zehnder modulator and a wideband signal mixer. The wideband signal mixer comprises inverter stages, a mixing stage, and a gain amplifier. It is implemented by using a 0.13 ${\mu}m$ CMOS technology. Its transmission response shows a frequency range from DC to 6.4 GHz, and the isolation response between data and clock signals is about 21 dB at 6.4 GHz. Experimental results show optical spectral narrowing due to incorporating an electrical band-limiting filter and some waveform distortion due to bandwidth limitation by the filter. At 10 Gbps transmission, the chromatic dispersion tolerance of the EB-CSRZ signal is better than that of NRZ-modulated signal in single-mode fiber.

• Journal of the Optical Society of Korea
• /
• 제20권4호
• /
• pp.470-475
• /
• 2016

In this paper, the effects of filter parameters on a supercontinuum-based all-optical thresholder are experimentally investigated. By tuning the filter parameters, the power transfer function and power transmission function are tailored. The experimental results show that a thresholder with short center wavelength has a better power function, and the slope in the middle level of the thresholder increases with increasing bandwidth. Through tuning the filter parameters, the thresholder can achieve a steplike power transfer function for optical thresholding, and a steplike power transmission function for optical self-switching. This makes the supercontinuum-based thresholder more flexible, and allows customization of performance to meet different demands in various applications.

• Current Optics and Photonics
• /
• 제5권2호
• /
• pp.121-128
• /
• 2021

We propose a novel, tiny optical receiver engine utilizing an all-in-one package based on embedded optics technology. The package's best transmission S21 and reflection S22 opto-electric (OE) bandwidths are 49.8 GHz and 34.9 GHz, respectively, and the reflectance of the optical engine is below -31.7 dB for all channels. The engine satisfies the MIL-STD-883G standard for reliability tests, such as mechanical and thermal shock, and vibration resistance. The sensitivity after 10 km single-mode fiber (SMF) transmission is below -8 dBm. The optical receiver engine is cost-competitive and applicable for 400G coarse wavelength division multiplexing 4 (CWDM4) 10 km optical transceivers.

• 한국통신학회논문지
• /
• 제25권10B호
• /
• pp.1707-1713
• /
• 2000

We have proposed a tunable optical ADM using a fiber-optic transversal filter which is composed of fiber couplers and metal-film coated fiber-optic tapped delay-lines with a flat spectral response in abroad range of wavelength. Simulation results show that the optical loss at the DROP and PASS wavelengths of the OADM is negligible and the wavelength tunability is 0.78${\mu}{\textrm}{m}$/ps for the unit time delay of 2 ps. In order to investigate the effects of wavelength drift of the imput optical signal on the OADM the loss at the DROP port and the crosstalks to the other ports have been calculated. The maximum bit rates have been calculated at 46.26 Gb/s for the input Gaussian pulse width of 10 ps.

• 한국광학회지
• /
• 제29권5호
• /
• pp.187-203
• /
• 2018

본 논문에서는 지난 40여 년간 이룩된 광통신 기술의 눈부신 발전 과정을 되돌아보고 예상되는 향후 발전 방향에 대하여 기술하였다. 특히, 초고속 대용량 광전송 시스템의 발전 과정에서 핵심적인 역할을 수행한 기술들을 역사적 관점에서 정리하였다. 본 논문은 광통신 분야에 새로이 입문하는 젊은 공학도들을 위하여 작성된 것이다.

• 한국통신학회논문지
• /
• 제28권8A호
• /
• pp.657-662
• /
• 2003

광성능을 모니터하기 위해 필요한 것이 OPM(optical performance monitoring module)이다. OPM에서 가장 중요한 것은 광 신호의 파장을 측정하는 것이다. 기존에는 pilot tone을 사용하였으므로 파장값을 얻기가 어려웠지만, 그후 AWG(arrayed waveguide grating), AOTF (acousto optic tuneable filter) 등을 사용하여 다채널 신호에 대한 파장과 전송 품질을 모니터하게 되었다. 본 논문에서는 일반적으로 광 분해능이 우수하다고 평가되는 FFP-TF(fiber fabry perot tuneable filter)를 채택하였으며, FFP-TF를 사용하기 때문에 필요한 기준파장의 설정을 위하여 광섬유격자(FBG : fiber bragg grating)를 사용하였다.