• Journal of Wetlands Research
• /
• v.17 no.4
• /
• pp.428-435
• /
• 2015

Constructed wetlands (CWs) have been accepted as an attractive and economic alternative to a variety of pollution control and provided potentially valuable wildlife habitat in urban and suburban areas, as well as esthetic value within the local natural environment. CWs are known eco-friendly technology to solve the problem of the climate change and urbanization issues. Numerous studies have been published on the various aspects of a CW. However, there are current limitations about the CW operations such as few design guidelines, poor performance results regarding the simple construction. Therefore, the objective of this research was to suggest an appropriate design and maintenance guidelines for a CW by thorough investigation of site monitoring results. The research also concentrated in redefining and reclassifying CWs, based on literatures made by the Ministry of Environment (MOE) and other organizations. Investigation at 43 CWs in Korea was performed by using collected data and by performing site survey from 2013 to 2014. Based on the results, the best practices among the investigated CWs provided water treatment, wildlife habitat, environmental education, and leisure. Also these CWs conducted a regular maintenance such as vegetation, sediment dredging and cleaning of facilities. Results obtained are intended for use by academics and any organizations involved in CW management.

• Journal of Korea Water Resources Association
• /
• v.41 no.3
• /
• pp.293-303
• /
• 2008

Reservoir turbidity flows degrade the efficiency and sustainability of water supply system in many countries located in monsoon climate region. A decision support system called RTMMS aimed to assist reservoir operations was developed for the real time monitoring, modeling, and management of turbidity flows induced by flood runoffs in Daecheong reservoir. RTMMS consists of a real time data acquisition module that collects and stores field monitoring data, a data assimilation module that assists pre-processing of model input data, a two dimensional numerical model for the simulation of reservoir hydrodynamics and turbidity, and a post-processor that aids the analysis of simulation results and alternative management scenarios. RTMMS was calibrated using field data obtained during the flood season of 2004, and applied to real-time simulations of flood events occurred on July of 2006 for assessing its predictive capability. The system showed fairly satisfactory performance in reproducing the density flow regimes and fate of turbidity plumes in the reservoir with efficient computation time that is a vital requirement for a real time application. The configurations of RTMMS suggested in this study can be adopted in many reservoirs that have similar turbidity issues for better management of water supply utilities and downstream aquatic ecosystem.

• Journal of the Korean Society for Railway
• /
• v.11 no.4
• /
• pp.349-356
• /
• 2008

Put Safety-critical systems related to the railway communications are currently undergoing changes. Mechanical and electro-mechanical devices are being replaced by programmable electronics that are often controlled remotely via communication networks. Therefore designers and operators now not only have to contend with component failures and user errors, but also with the possibility that malicious entities are seeking to disrupt the services provided by theirs systems. Recognizing the safety-critical nature of the types of communications required in rail control operations, the communications infrastructure will be required to meet a number of safety requirements such as system faults, user errors and the robustness in the presence of malicious attackers who are willing to take determined action to interfere in the correct operation of a system. This paper discusses the safety strategies employed in the railway communications and proposes a security mechanism for Korean railway communication system. We present the developed communication safety evaluation tool based on the proposed security mechanism and also evaluate its protecting capability against the threats of masquerading, eavesdropping, and unauthorized message manipulation.

• Journal of the Korean Society for Library and Information Science
• /
• v.13
• /
• pp.39-71
• /
• 1986

Interlibrary loan has been a very common library service in the developed countries but it is yet to be actualized formerly in Korea. As Korea is moving toward an information society where all the individual user's request in the library should be met, we need to understand, in detail, the theory and practice of interlibrary loan service. As various information technology has been applied to the libraries, the libraries became the open system. Thus, the libraries become more cooperative, form networks, and make interlibrary loan service available. This study is based on the following three hypothesis formulated from the systems theory. 1. If libraries cooperate each other and form some kind of networks by mail, computers or telecommunications, they become the open system. 2. If a library develops as the open system, interlibrary loan becomes available in the library. 3. If the interlibrary loan system works, the role of the librarians will be changed. The research was carried out by analyzing the various studies about interlibrary loan service and by examining the interlibrary loan systerns presently working in the U.S.. The conclusions are reached deductively from the data. Some of the terminology used are defined as follows: System: a network of interrelated procedures that are joined together to perform an activity or to accomplish a specific objective. It is, in effect, all the ingredient which make up the whole. Cooperation: Working together to benefit participant libraries. Network: a much more structured type of cooperation in which definite regions or areas are connected by electronic or other means to promote interlibrary loaning of materials, in-service traing & other sharing of resources. Interlibrary loan: the lending of books between libraries. The model of cooperation or networks was used to be (1) a star type, (2) a hieranchical type, (3) a distributed type or (4) the combination of aforementioned three. However, the development of the telecommunications and computers enables all kinds of libraires cooperate together. Interlibrary loan service starts with the needs of user's information. The information have to be logically accessed through bibliographies, computers, electronic mails and satellite communications. And the logical access requires the information technology and the libraries become cooperative. The physical access to the information follows next but only traditional method of mail and some commercial service are currently available for this purpose. Therefore, researches are needed to develop this physical access. If the libraries form networks, the microaspect of library changes accordingly as the macroaspect changes. If the libraries . cooperate to become one large world library, the librarians plan, organize, control library operations and report the results. And the librarians work inside and outside of the library to cooperate with other libraries. Only the cooperation of the libraries will enhance interlibrary loan and the Korean librarians have to be prepared to accept the new role of librarianship for the interlibrary loan service.

• Journal of the Korean Institute of Gas
• /
• v.20 no.6
• /
• pp.80-88
• /
• 2016

A fire station and scuba have operated filling facilities for respiratory high-pressure cylinder without getting authority or reporting according to High-Pressure Gas Safety Control Act. They need facility improvement and special management to make provision for the time of accident during filling process. The Government have strived to correct illegal operations and suggested an alternative, establishing and operating the safety cabinet. It insures a safety being distance from danger caused by overpressure and a safety provoked by the protective wall equals or superiors. The safety cabinet is required to have an internal structure that smoothly distribute overpressure at the time of rupture. Plus, it needs to minimize fragments. It is also equipped with the performance of protective wall that makes overpressure to outside vent on the place where there is no person (top or bottom). This study calculated the consequence of physical explosion damage and built a prototype of safety cabinet. In addition, through the gas burst test, it derives for the ways to mitigate the physical explosion damage.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.6
• /
• pp.323-328
• /
• 2016

Pressurized membrane used for side-stream MBR process requires fouling control strategy both for normal and abnormal operation conditions for stable operation of the facilities. In this study, $85m^3/day$ of pilot-scale side-stream MBR process was constructed for the evaluation of fouling mitigation by air bubble injection into the membrane module. In addition, fouling phenomena at abnormal operation conditions of low influent and/or loading rate were also investigated. Injection of air bubble was found to be effective in delaying transmembrane pressure (TMP) increase mainly due to scouring effect on the membrane surface, resulting in expanded filtration cycle at a high flux of $40L/m^2{\cdot}h$ (LMH). At abnormal operation condition, injection of PACl (53 mg/L as Al) into the bioreactor showed 19% reduction of TMP increase. However, inhibition of nitrifying bacteria by continuous PACl injection was observed from batch experiments. In contrast, injection of powdered activated carbon (PAC, 0.6 g/L) was able to maintain the initial TMP of $0.2kg/cm^2$ for 5 days at the abnormal conditions. It may have been caused from the adsorption of extracellular polymeric substances (EPS), which was known to be excessively released during growth inhibition condition and act as the major foulants in MBR operations.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.70-80
• /
• 2020

This study examined the effects of the R&D project managers' leadership on the product development performance. A survey was carried out empirically on a group of 175 experts associated with project management R&D operations in the field of manufacturing, construction engineering, shipbuilding, plant, and IT. The survey results showed that the effects of the R&D project managers' leadership on the product development performance were not significant, and the mediating effects of the project sponsor roles were significant. This means that the leadership of leaders, which requires efficient control and management based on complicated intergroup relationships and roles, is important in a project involving experts from the professional field. This suggests that the efficient leadership of leaders can improve the performance through the cooperation of members in the organization and aggregation of their core competencies in a limited time. Overall, the key results of this study mean that project leaders should play an active mediating role to maximize their leadership and enhance the role of project sponsors. In addition, the mediating role of project sponsors has an effect on the leadership of project managers, affecting the project performance quality.

• Proceedings of the Korean Society of Rheology Conference
• /
• 2006.06a
• /
• pp.81-84
• /
• 2006

Slot coating process, in continuous and patch modes, has been applied for the many precise coating products, e.g., flat panel displays and second batteries. However, manufacturing uniform coating products is not a trivial task at high-speed operations because various flow instabilities or defects such as leaking, bubbles, ribbing, and rivulets are frequently observed in this process. It is no wonder, therefore, that many efforts to understand the various aspects of dynamics and coating windows of this process have been made both in academia and industry. In this study, as the first topic, flow dynamics within the coating bead in slot coating process has been investigated using the one-dimensional viscocapillary model by lubrication approximation and two-dimensional model by Flow-3D software. Especially, operability windows in both 1D and 2D cases with various slot die lip designs have been successfully portrayed. Also, effects of process conditions like viscosity and coating gap size on slot coating window have been analyzed. Also, some experiments to find minimum coating thickness and coating windows have been conducted using slot die coater implemented with flow visualization device, corroborating the numerical results. As the second topic, flow dynamics of both Newtonian and Non-Newtonian fluids in patch or pattern slot coating process, which is employed in manufacturing IT products such as secondary batteries, has been investigated for the purpose of optimal process designs. As a matter of fact, the flow control in this system is more difficult than in continuous case because od its transient or time-dependent nature. The internal die and die lip designs for patterned uniform coating products have been obtained by controlling flow behaviors of coating liquids issuing from slot. Numerical simulations have been performed using Fluent and Flow-3D packages. Flow behavior and pressure distribution inside the slot die has been compared with various die internal shapes and geometries. In the coating bead region, efforts to reduce irregular coating defects in head and tail parts of one patterned coating unit have been tried by changing die lip shapes. It has been concluded that optimal die internal design gas been developed, guaranteeing uniform velocity distribution of both Newtonian and shear thinning fluids at the die exit. And also optimal die lip design has been established, providing the longer uniform coating layer thickness within one coating unit.

• Korean Journal of Microbiology
• /
• v.34 no.4
• /
• pp.200-206
• /
• 1998

The distributions and characteristics of bacteria on the deodorizing biofilters were studied as a part of biofiltration research for odor gas removal. The odor gas originated from a currently operating nightsoil treatment plant were mainly nitrogenous compounds of ammonia and amines. The filter media were consisted various ratio of pine bark, nightsoil cast and compost, and were sampled before and after operation of 153 days. Before operation, the level of bacteria on nitrification agar medium, nutrient agar medium and thiosulfate agar medium were around $10^7{\sim}10^8cfu/g$ media. After operation, the level decreased but still high as $10^5{\sim}10^7cfu/g$ media. The bacteria from reactors before and after operations were either rod or coccus after growth on nitrification agar media. The 45 isolated heterotrophic bacteria were further characterized and Pseudomonas, Bacillus, Flavobacterium, Alcaligenes were dominant genera. Genus Alcaligenes was particularly dominant when the isolates were incubated on nitrification agar media first and then transfered to nutrient media. The portion of Alcaligenes in the biofilter increased after operation, and was higher in the media contained nightsoil cast, which showed better treatment than the media with pine bark only.

• Journal of KIISE
• /
• v.42 no.8
• /
• pp.1057-1064
• /
• 2015

The tactical network is system based on wireless networking technologies that ties together surveillance reconnaissance systems, precision strike systems and command and control systems. Several alternative paths exist in the network because it is connected as a grid to improve its survivability. In addition, the network topology changes frequently as forces and combatants change their network access points while conducting operations. However, most Internet routing standards have been designed for use in stable backbone networks. Therefore, tactical networks may exhibit a deterioration in performance when these standards are implemented. In this paper, we propose Priority based Multi-Path routing with Local Optimization(PMPLO) for a tactical backbone network. The PMPLO separately manages the global and local metrics. The global metric propagates to other routers through the use of a routing protocol, and it is used for a multi-path configuration that is guaranteed to be loop free. The local metric reflects the link utilization that is used to find an alternate path when congestion occurs, and it is managed internally only within each router. It also produces traffic that has a high priority privilege when choosing the optimal path. Finally, we conducted a simulation to verify that the PMPLO can effectively distribute the user traffic among available routers.