• Nuclear Engineering and Technology
• /
• v.54 no.2
• /
• pp.501-506
• /
• 2022

Long turn-off time limits high frequency operation of Bipolar Junction Transistors (BJTs). Turn-off time decreases with increases in the recombination rate of minority carriers at switching transients. Fast neutron irradiation on a Si BJT incurs lattice damages owing to the displacement of silicon atoms. The lattice damages increase the recombination rate of injected holes with electrons, and decrease the hole lifetime in the base region of pnp Si BJT. Fast neutrons generated from a beryllium target with 30 MeV protons by an MC-50 cyclotron were irradiated onto pnp Si BJTs in experiment. The experimental results show that the turn-off time, including the storage time and fall time, decreases with increases in fast neutron fluence. Additionally, it is confirmed that the base current increases, and the collector current and base-to-collector current amplification ratio decrease due to fast neutron irradiation.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.8 no.2
• /
• pp.170-177
• /
• 2008

In the present work a methodology to minimize short channel effects (SCEs) by modulating the effective channel length is proposed to design 25 nm single and double gate-source/drain underlap MOSFETs. The analysis is based on the evaluation of the ratio of effective channel length to natural/ characteristic length. Our results show that for this ratio to be greater than 2, steeper source/drain doping gradients along with wider source/drain roll-off widths will be required for both devices. In order to enhance short channel immunity, the ratio of source/drain roll-off width to lateral straggle should be greater than 2 for a wide range of source/drain doping gradients.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.2
• /
• pp.163-168
• /
• 2014

Bottom gate thin-film transistors were fabricated using solution processed IGZO channel layers with various gallium composition ratios that were annealed on a hot plate. Increasing the gallium ratio from 0.1 to 0.6 induced a threshold voltage shift in the electrical characteristics, whereas the molar ratio of In:Zn was fixed to 1:1. Among the devices, the IGZO-TFTs with gallium ratios of 0.4 and 0.5 exhibited suitable switching characteristics with low off-current and low SS values. The IGZO-TFTs prepared from IGZO films with a gallium ratio of 0.4 showed a mobility, on/off current ratio, threshold voltage, and subthreshold swing value of $0.1135cm^2/V{\cdot}s$, ${\sim}10^6$, 0.8 V, and 0.69 V/dec, respectively. IGZO-TFTs annealed at $300^{\circ}C$, $350^{\circ}C$, and $400^{\circ}C$ were also fabricated. Annealing at lower temperatures induced a positive shift in the threshold voltage and produced inferior electrical properties.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.694-697
• /
• 2003

In applying LCD to TV application, one of the most significant factors to be improved is image sticking on the moving picture. LCD is different from CRT in the sense that it's continuous passive device, which holds images in entire frame period, while impulse type device generate image in very short time. To reduce image sticking problem related to hold type display mode, we made an experiment to drive LCD like CRT. We made articulate images by turn on-off backlight, and we realized the ratio of Back Light on-off time by adjusting between on time and off time for video signal input during 1 frame (16.7ms). Conventional CCFL (cold cathode fluorescent lamp) cannot follow fast on-off speed, so we evaluated new fluorescent substances of light source to improve residual light characteristic of CCFL. We realized articulate image generation similar to CRT by blinking drive. As a result, reduced image sticking phenomenon was validated by naked eye and response time measurement.

• Journal of Korean Neurosurgical Society
• /
• v.64 no.1
• /
• pp.51-59
• /
• 2021

Objective : Several studies have reported inconsistent findings among countries on whether off-hour hospital presentation is associated with worse outcome in patients with acute stroke. However, its association is yet not clear and has not been thoroughly studied in Korea. We assessed nationwide administrative data to verify off-hour effect in different subtypes of acute stroke in Korea. Methods : We respectively analyzed the nationwide administrative data of National Emergency Department Information System in Korea; 7144 of ischemic stroke (IS), 2424 of intracerebral hemorrhage (ICH), and 1482 of subarachnoid hemorrhage (SAH), respectively. "Off-hour hospital presentation" was defined as weekends, holidays, and any times except 8:00 AM to 6:00 PM on weekdays. The primary outcome measure was in-hospital mortality in different subtypes of acute stroke. We adjusted for covariates to influence the primary outcome using binary logistic regression model and Cox's proportional hazard model. Results : In subjects with IS, off-hour hospital presentation was associated with unfavorable outcome (24.6% off hours vs. 20.9% working hours, p<0.001) and in-hospital mortality (5.3% off hours vs. 3.9% working hours, p=0.004), even after adjustment for compounding variables (hazard ratio [HR], 1.244; 95% confidence interval [CI], 1.106-1.400; HR, 1.402; 95% CI, 1.124-1.747, respectively). Off-hours had significantly more elderly ≥65 years (35.4% off hours vs. 32.1% working hours, p=0.029) and significantly more frequent intensive care unit admission (32.5% off hours vs. 29.9% working hours, p=0.017) than working hours. However, off-hour hospital presentation was not related to poor short-term outcome in subjects with ICH and SAH. Conclusion : This study indicates that off-hour hospital presentation may lead to poor short-term morbidity and mortality in patients with IS, but not in patients with ICH and SAH in Korea. Excessive death seems to be ascribed to old age or the higher severity of medical conditions apart from that of stroke during off hours.

• Korean Journal of Agricultural Science
• /
• v.39 no.4
• /
• pp.459-466
• /
• 2012

The objective of this study is to observe growth pattern of grand rapids(lettuce) according to different dexperimental conditions for minimizing its growth period such as composition of nutrient, irradiation time of light source and cultivation mode. The culture of water spray type using seeds of grand rapids was performed during growth period of total 50 days. Experimental conditions consist of five compositions of nutrient (PW 0.5 mS/cm, PW 1.0 mS/cm, PY 0.5 mS/cm, PY 1.0 mS/cm, PW 2.0 mS/cm) and three irradiation times of light source (12h(on) / 12h(off), 18h(on) / 06h(off), 24h(on) / 00h(off)). Illumination was adjusted to ratio of 7:1:1 of red, blue and white color, respectively. Indoor environmental condition for cultivating grand rapids is as follows: temperature (19-$22^{\circ}C$), relative humidity (60-70%) and carbon dioxide (1,000-1,200 ppm). The data were obtained from five iteration tests. The maximum growth level was observed in the experimental condition of 18 hr(on) / 06 hr(off) and PY 1 mS/cm for 1st week of cultivation period, 24 hr(on) / 00 hr(off) and PY 1mS/cm for 2nd week of cultivation period, and 24 hr(on) / 00hr(off) and PW 1 mS/cm for 3rd week of cultivation period, respectively. On the contrary, the minimum growth level was observed in the experimental condition of 18 hr(on) / 06 hr(off) and PW 0.5 mS/cm for 1st week of cultivation period, 12 hr(on) / 12 hr(off) and PW 0.5 mS/cm for 2nd week of cultivation period, and 12 hr(on) / 12 hr(off) and PY 0.5 mS/cm for 3rd week of cultivation period, respectively. Based on the results obtained from this study, it is concluded that the growth level of grand rapids varied with different irradiation time of light source and composition ratio of nutrient according to cultivation period.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.21 no.3
• /
• pp.485-501
• /
• 1997

Pressure control is possible driving a simple ON/OFF 3-way valve of hydraulic servo system by pulse width modulation signal. But the pressure varies according to the duty ratio and carrier frequency and repeated on-off action induces pressure fluctuation. So equations for mean pressure and ripple amplitude are theoretically derived as a function of on/off time, the system parameters which decide the pressure characteristics are arranged and they are verified by experimental study. As the result selection criteria for the major design parameters are established and the basic strategy to suppress the unnecessary fluctuation can be provided for a hydraulic pressure control system using these type of valves.

• Journal of Bio-Environment Control
• /
• v.18 no.2
• /
• pp.112-118
• /
• 2009

To determine the effects of circulation frequency of nutrient solution, three frequencies of 10min. on/10min. off; 10min. on/110min. off; and 10min. on/1,430min. off. treatments were applied to leafy vegetable production using deep flow technique (DFT) systems and their growth and phytonutrient content were investigated. In the 10min. on/I,430min. off treatment, dissolved oxygen concentration (DOC) 17 days after treatment decreased to 2.8mg. $L^{-1}$, known to be a low DOC that causes hypoxia, and thereafter decreased to 1.5mg. $L^{-1}$ 20 days after treatment. Fresh weight of 7 leafy vegetables in the 10min. on/1,430min. off treatment was lower by 0${\sim}$24% than those in the 10min. on/110min. off treatment, and those in the 10min. on/10min. off was higher by -2${\sim}$34% than those in the 10min. on/110min. off treatment as control. As the more frequent circulation was applied, the higher phosphorous content and the lower carbon to nitrogen ratio (C/N ratio) and total ascorbic acid contents were resulted. Results indicate that the circulation frequency of 110min, on/110min. off could be recommended for the production of the tested leafy vegetables in DFT systems.

• Journal of the Korean Society of Combustion
• /
• v.17 no.1
• /
• pp.58-65
• /
• 2012

The influence of magnetic field on propane and acetylene diffusion flames have been experimentally investigated using an electromagnetic system. Periodically induced magnetic field having various frequencies and duty ratios was established in square wave form. The maximum intensity and gradient of magnetic field were 1.3 T and 0.27 T/mm, respectively. The width of a propane flame was reduced up to 4.5% and the brightness was enhanced up to 25% when the magnetic field was induced. The soot emission from an acetylene flame was ceased when magnetic field was induced. The alteration of flow field, which is due to the paramagnetic characteristics of oxygen molecule, is most likely to be responsible for the change in flame size and brightness. The effect of magnetic field on diffusion flames, which competes with the gravitational effect, was more apparent from a smaller size flame. The magnetic field effect, therefore, could be important under microgravity conditions. Since the time required to alter the flow field must be finite, the magnetic field effect is likely to be less significant for a periodically oscillating magnetic field at a high frequency or having a small duty ratio.

• 연구논문집
• /
• s.27
• /
• pp.87-99
• /
• 1997

Present paper describes on/off design performance of a 50KW turbogenerator gas turbine engine for hybrid vehicle application. For optimum design point selection, relevant parameter study is carried out. The turbogenerator gas turbine engine for a hybrid vehicle is expected to be designed for maximum fuel economy, ultra low emissions, and very low cost. Compressor, combustor, turbine, and permanent-magnet generator will be mounted on a single high speed (82,000 rpm) shaft that will be supported on air bearings. As the generator is built into the shaft, gearbox and other moving parts become unnecessary and thus will increase the system's reliability and reduce the manufacturing cost. The engine has a radial compressor and turbine with design point pressure ratio of 4.0. This pressure ratio was set based on calculation of specific fuel consumption and specific power variation with pressure ratio. For the given turbine inlet temperature, a rather conservative value of $1100^\circK$ was selected. Designed mass flow rate was 0.5 kg/sec. Parametric study of the cycle indicates that specific work and efficiency increase at a given pressure ratio and turbine inlet temperature. Off design analysis shows that the gas turbine system reaches self operating condition at N/$N_{DP}$ = 0.53. Bleeding air for turbine stator cooling is omitted considering low TIT and for a simple geometric structure. Various engine performance simulations including, ambient temperature influence, surging at part load condition. Transient analysis were performed to secure the optimum engine operating characteristics. Surge margin throughout the performance analysis were maintained to be over 80% approximately. Validation of present results are yet to be seen as the performance tests are scheduled by the end of 1998 for comparison.