• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1997년도 추계학술대회 논문집
• /
• pp.98-101
• /
• 1997

The nonuniformity of electrical characteristics of grain boundaries in ZnO varistors wei\ulcorner systematically analyzed. The high nonuniformity exist in barrier voltages and nonlinearity coefficients among different grain boundaries. The barrier voltages have normal distributions, only a few grain boundaries were electrically active, and the grain boundaries can be simply classified into good, bad, and ohmic ones according to the electrical characteristics of grain boundaries. The average barrier voltage is equal to 3.3 V by direct method, but it is only 2.3 V by indirect method. There is a high difference between the barrier voltages by direct and indirect measurement methods. The A1$_2$O$_3$ dopants affect the electrical characteristics of grain boundaries by changing the electron status In grain boundary and intragrain.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.92-94
• /
• 2004

In this investigation, 3C-SiC film deposited $1000{\AA}$ on the p-type silicon wafer which is resistance $0{\sim}30[{\Omega}{\cdot}cm]$ by PECVD (Plasma-enhanced Chemical Vapor Deposition). We deposited Cr, Ta, Pt in front of wafer to utilize DC-sputter for $500{\AA}$, the SiC Schottky diode made from Al ohmic contact about $4000{\AA}$, and to each different temperature which annealing in Ar atmosphere, we had forward characteristic analysis along to annealing temperature.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1997년도 추계학술대회 논문집
• /
• pp.5-8
• /
• 1997

A study on the electrical conduction characteristics of the ultrathin organic films is one of the important factors for the development of molecular electronic devices. The Langmuir- Blodgett(LB) technique has recently been attracted interest as a method of the deposition ultrathin films. We hate fabricated N-docosyl N\`-methyl viologen-diTCNQ(DMVT) anion radical LB film and investigated the molecular orientation and electrical conduction characteristics. We have measured infrared transmission-reflection spectra. The alkyl chain is found to he well-ordered with the tilt angle of 13$^{\circ}$ with respect to the substrate surface normal and the TCNQ plane is tilted at 76$^{\circ}$ the surface normal. In ESR spectrum, we confirmed that a half-amplitude linewidth is clearly dependent on the incident angle, which indicates conducting species change. The in-plane conductivity of 31 lagers is approximately 1.33$\times$10$^{-6}$ S/cm. The ohmic behaviour was observed below 0.6 V, when current-voltage(I-V) characteristics was measured verically.

• 한국안전학회지
• /
• 제18권3호
• /
• pp.54-59
• /
• 2003

The discharge energy by electrostatic discharge of the charged human body is calculated under the assumption that the stored charge is dissipated completely. However, it is well-known that the charge is slightly remained after electrostatic discharge. Therefore, The Rompe-Weisel model of the discharge analysis, which has somewhat more of a physical justification than the conventional energy equation, is proposed. It is proposed that the electrical conductivity of the arc should be proportional to the energy density transferred to it by Ohmic dissipation. For the electrostatic discharge energy analysis, the Rompe-Weisel model was compared by quasi static analysis. As a consequence, a study on a reliable energy evaluation based on simulation models during electrostatic discharge is carried out in this paper and is adopted to estimate the explosion hazards of flammable gases.

• 한국표면공학회지
• /
• 제27권4호
• /
• pp.223-233
• /
• 1994

It is well known that compositionally modulated Cu-Ni alloy can be produced by an electrochemical method in Ni sulfate solution containing trace amount of Cu. a mathematical model is presented to describe the current distribution and weight percent of Cu in Ni layer on the rotating disk electrode. The model includes convective-diffusion equation, the Laplace's equation and various overpotentials, and is solved numerically. The thickness of Cu layer is almost uniform whereas the thickness of Ni layer as well as the Ni/Cu weight ratio are increased approaching to the edge of the disk. These results agree well with the experimental values. The ohmic potential drop is suggested as a major cause of a nonuniformity in Ni layer. The optimum plating condition for the fabrication of susperlattice is proposed based on the results of this study.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 추계학술대회 논문집
• /
• pp.193-195
• /
• 2008

As arising the cost and decreasing of gasoline and fossil fuel, renewable energy sources such as photovoltaics, wind and fuel cell have been interested. Among of them, PEM fuel cells are good energy sources to provide reliable power at steady state regardless of weather, time of day and location as long as the fuel and air are supplied, but they cannot respond to electrical load transients as fast as desired. This is mainly due to their slow internal electrochemical and thermodynamic responses. Therefore, to use the fuel cells with high efficiency, this paper finds characteristic curve and understand operation of PEMFC based on three theoretical approaches such as activation, ohmic and concentration and make the model using MATLAB. That result was compared with real system to certify.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.146-147
• /
• 2007

A universal four-point contact measurement method, has an advantage of non-existence of contact resistance, is demonstrated by the experiments with carbon nanotubes and ZnO nanowire. Ti/Au and Pt are tried to compare the influence of contact resistance between two different metals. These metals are selected to make Ohmic contact and Schottky contact originated from their different work functions. For precise experiments, Ti/Au and Pt are separately evaporated to form double 'four-point contact electrodes' on CNTs or ZnO, and the voltage-current characteristics are measured. This method can be applied to universal resistivity measurement for nanotubes and nanowires.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.508-509
• /
• 2005

In case of ITO/MEH-PPV/Al structure, the quantity of charge carriers flowing through the organic material was few and the density of them is fixed. The electric field inside of the device almost didn't change with the position. On the other hands, in case of Au/MEH-PPV/Au structure, the hole density increased rapidly nearby the anode but decreased nearby the cathode. The space charge phenomenon followed sufficient hole injection resulted in the change of the electric field with the position inside of the device. We verified that the result of the current-voltage simulation corresponded with experimental result.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.481-482
• /
• 2005

유기발광소자의 발광층의 전압에 따른 임피던스의 변화를 살펴보았다. 임피던스는 전압의 변화에 따른 의존성을 보이며, 그에 따른 임피던스와 Cole-Cole 반원의 변화를 전기전도기구와 비교하여 살펴보았다. 소자의 구조는 ITO/$Alq_3$/Al의 구조로 발광층의 두께는 60 nm로 열증착하여 실험하였다. 실험에서 전기전도기구의 Ohmic 영역, SCLC 영역, 부성저항영역, TCLC 영역에서 각각 임피던스를 측정하였고, 전압의 증가에 따라 임피던스의 크기가 감소하고, 위상각은 0V에서 용량성을 보이다가 발광영역에서 저항성을 나타내는 것을 알 수 있었다. 또한 전압에 따른 Cole-Cole 반원을 살며보면 전압이 증가할수록 반원의 크기가 감소하는 것을 알 수 있으며, 이를 통해 간단한 등가회로를 예측할 수 있었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.633-634
• /
• 2005

Transparent conducting glasses exhibit high ohmic losses that are apparent in the case of large size Dye Sensitized Solar Cells (DSSCs). In this study, we investigated the impact of current collectors over the efficiency of DSSCs. The Silver current collectors were prepared on both counter electrode and working electrode surface by screen printing method. For long term stability in electrolyte environment and also to avoid the charge recombination, current collectors are protected by sodium silicate overcoat layer. These current collectors were characterized for their microstructure parameters. Also current collector's stability in electrolyte environment has been investigated.