• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.31 no.3
• /
• pp.359-371
• /
• 1998

The cold water event near Gampo-Ulgi coast in summers between 1987 and 1994 are studied using sea surface temperature records at the coastal stations, ocean winds measured by SSM/I and AVHRR SST images. The response time of the cold water events by upwelling is less than two days and surface cold water expands up to the Ulleung Island. An analysis of 61 upwelling favorable winds indicates that the surface water temperature drops more than $1^{\circ}C\;in\;80\%$ of the south-westerly wind events. The linear correlation coefficient between wind impulses and the maximum temperature drops is good (0.6). It is found that the major cause of the cold water events is the along-shore wind in summer. The bottom topography and off-shore direction of the East Korean Warm Current by the potential vorticity conservation near Gampo coast also contribute the formation of the cold water along the southeast coast of Korea.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.06a
• /
• pp.423-426
• /
• 2007

Pohang Wind Energy Research Center (PoWER-C) is developing a 3 MW Radial Flux Permanent Magnet (RFPM) Synchronous Generator for offshore Wind Energy Converter (WEC). The rotor rpm is 15.7 and the gear ratio is set to be 92.93. The nominal generator rpm at the rated load is about 1459. To reduce the switching loss in the power electronics, the maximum frequency is limited to 100 Hz. This requirement limits the number of pole to six or eight. Permanent magnet excitation is assumed for higher energy yield and higher efficiency. In this report, the requirements and the first efforts for the physics design are described.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.3
• /
• pp.65-70
• /
• 2010

As for the present wind power industry, most of the computerization for monitoring and control is based on the traditional development methodology, but it is necessary to improve SCADA system since it has a phenomenon of backlog accumulation in the applicable aspect of back-data as well as in the operational aspect in the future. Especially for a system like offshore wind power where a superintendent cannot reside, it is desirable to operate a remote control system. Therefore, it is essential to establish a monitoring system with appropriate control and monitoring inevitably premised on the integrity and independence of data. As a result, a study was carried out on the modeling of offshore wind power data-centered database. In this paper, a logical data modeling method was proposed and designed to establish the database of offshore wind power. In order for designing the logical data modeling of an offshore wind power system, this study carried out an analysis of design elements for the database of offshore wind power and described considerations and problems as well. Through a comparative analysis of the final database of the newly-designed off-shore wind power system against the existing SCADA System, this study proposed a new direction to bring about progress toward a smart wind power system, showing a possibility of a service-oriented smart wind power system, such as future prediction, hindrance-cause examination and fault analyses, through the database integrating various control signals, geographical information and data about surrounding environments.

• Journal of Navigation and Port Research
• /
• v.36 no.5
• /
• pp.357-361
• /
• 2012

Anemometer is a meteorological instrument that measures wind direction and wind speed in real time, and is mounted to the cranes that are used at ports, shipbuilding yards, off-shore structure, or construction sites that are influenced by wind, and it is used in conjunction with the safety system. Load cell-type anemometer measures the wind direction through the ratio of load between 4 positions by mounting the thin plate to 4 load cells, and measures wind velocity through the summation of loads. In this study, we compared and analyzed the results in the theoretic approach, analytic approach and experimental approach to derive the correlation between load ratio and wind direction. Wind direction was selected as the design variable, and selected 9 wind direction conditions from $0^{\circ}{\sim}90^{\circ}$ with $11.25^{\circ}$ space for analysis, and 10 wind direction conditions with $10^{\circ}$ space for experiment.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.9
• /
• pp.4186-4192
• /
• 2012

Because wind turbines are larger and more off-shore construction due to economic and environmental factors, it is more difficult to access the wind turbine as well as the necessary parts and the maintenance costs are increasing. So, we need to minimize fault elements and to prevent a secondary accident at failure through monitoring to reduce maintenance costs and to increase reliability of operation. In this paper we have implemented ZigBee based wireless sensor nodes and network for wind turbine condition monitoring using temperature, humidity, voltage, current, wind direction, and wind speed sensors. ZigBee wireless sensor nodes signals are transmitted to a central monitoring system via routers. Also, the sensor signals are collected and processed using LabVIEW program to monitor the wind turbine conveniently. The administrators and users can monitor the condition of wind turbine at remote site in real time over TCP/IP.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.7
• /
• pp.1299-1304
• /
• 2011

A wind turbine (WT) should be shut down as fast as possible to minimize its own damage in a storm-driven situation. Shutdown of a large wind farm requires a power grid to have a ramp-up capability large enough to balance between generation and consumption of electrical energy. This paper proposes a supervised shutdown algorithm of a wind farm to meet a required ramp-down rate in a grid code in the case of a storm-driven situation. The information on the speed and the direction of wind is measured at a wind mast (WM) installed around a wind farm. If the wind speed exceeds a cut-out speed, the number of WTs to be shut down simultaneously is decided to meet a required ramp-down rate of a grid-code. Arrival times to each WT from the WM are calculated and sorted in the order of time. Then a sequence of groups is generated. The shutdown start/end times of each group are decided to avoid superposition between adjacent two groups. The performance of the proposed shutdown algorithm is verified under various storm scenarios. Results indicate that the proposed algorithm can not only protect the wind farm in the case of a storm-driven situation but also meet the required ramp-down rate. In addition, the algorithm can produce more energy than that of a conventional shutdown algorithm.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.23 no.5
• /
• pp.497-512
• /
• 2017

Temporal and spatial variations in surface water temperature were studied using data from temperature monitoring buoys deployed at 47 stations around Boryeong from 2011-2012 off the west coast of Korea. Temperature fluctuations are predominant at diurnal and semidiurnal periods for all seasons, and their amplitudes are large in spring and summer but small in autumn. The maximum annual change in air temperature takes place on August 2nd and August 22th for water temperature, which means the phase for air temperature precedes water temperature by 20 days. The diurnal period of water temperature fluctuation is predominant around Daecheon and Muchangpo Harbors, with the semidiurnal period around Wonsan Island, and the shallow water constituent period on the estuary around Daecheon River. On the whole, air and water temperatures fluctuate with wind. Spectral analyses of temperature records show significant peaks at the 0.5, 1 and 15 day marks with 7-10 day periods of predominant fluctuations. Cross-correlation analyses for the temperature fluctuation show that the waters around Boryeong can be classified into four areas: a mixed water zone around the southeast side of Wonsan Island, an off-shore area to the west, an off-shore area to the south and a coastal area along the shore from Song Island to Muchangpo Harbor.

• Structural Monitoring and Maintenance
• /
• v.2 no.1
• /
• pp.35-48
• /
• 2015

The main objective of this study is to evaluate the long-term performance of various concrete composites in natural marine environment prevailing in the Gulf region. Durability assessment studies of such nature are usually carried out under aggressive environments that constitute seawater, chloride and sulfate laden soils and wind, and groundwater conditions. These studies are very vital for sustainable development of marine and off shore reinforced concrete structures of industrial design such as petroleum installations. First round of testing and evaluation, which is presented in this paper, were performed by standard tests under laboratory conditions. Laboratory results presented in this paper will be corroborated with test outcome of ongoing three years field exposure conditions. The field study will include different parameters of investigation for high performance concrete including corrosion inhibitors, type of reinforcement, natural and industrial pozzolanic additives, water to cement ratio, water type, cover thickness, curing conditions, and concrete coatings. Like the laboratory specimens, samples in the field will be monitored for corrosion induced deterioration signs and for any signs of failureover initial period ofthree years. In this paper, laboratory results pertaining to microsilica (SF), ground granulated blast furnace slag (GGBS), epoxy coated rebars and calcium nitrite corrosion inhibitor are very conclusive. Results affirmed that the supplementary cementing materials such as GGBS and SF significantly impacted and enhanced concrete resistivity to chloride ions penetration and hence decrease the corrosion activities on steel bars protected by such concretes. As for epoxy coated rebars applications under high chloride laden conditions, results showed great concern to integrity of the epoxy coating layer on the bar and its stability. On the other hand corrosion inhibiting admixtures such as calcium nitrite proved to be more effective when used in combination with the pozzolanic additives such as GGBS and microsilica.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.8
• /
• pp.1773-1779
• /
• 2015

Shore-to-sea visible light communication using color clustered multiple-input and multiple-output (MIMO) is presented. The proposed maritime visible light communication (MVLC) offers a low-cost, high-speed wireless link for shore-to-sea maritime communications. Each color cluster is comprised of 50 red, green and blue (RGB) light emitting diodes (LEDs) and is modulated using on-off-keying (OOK). Selection combining is performed at the receiver, producing diversity effect within that color cluster. In this paper, we employ sea states (wave height, wind speed, etc.) data from both Pierson-Moskowitz and JONSWAP spectrum models under atmospheric turbulence conditions. Based on the simulation model, the maritime link quality is analysed in terms of coverage distance and bit error rate performance. The results show that the proposed system provides an efficient MVLC, while satisfying International Association of Lighthouse Authorities (IALA) requirements for maritime buoyage system and also offering sufficient illumination from high power LEDs.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.28 no.2
• /
• pp.117-131
• /
• 1992

A studies on the pattern of sea water circulation was carried out by using drogue experiments, tidal current measurement and hydrographic data in Kamak Bay which has two channels. At the flood, the water inflowed from the northern narrow channel flows mostly to the southward then the westward because Daekyung-island located at the flow path, at the same time the water from the southern channel of bay directed strongly to the north with a spine centered at around Gunnaeri. And these waters converged at the area between eng-Island and Deakyung-Island in the bigining of the flow, and placed at less southern part than the area at the late. The water of the north west inner bay having concave bottom topography inflows to Najin inlet with a spin of anti-clockwise. At the ebb, those waters in the bay turn back to two channels respectively, but most of waters directed to the southern channel of the bay. The directions of residual current of two channels are the southward mainly, and the current of inner area are influenced by the prevailing wind. The north-west inner bay which has the weak tidal current less than 10 cm/sec shows a similar upwelling by off-shore wind in winter, and the stratification in summer, respectively.