• Journal of Korea Water Resources Association
• /
• v.39 no.10 s.171
• /
• pp.833-844
• /
• 2006

The objective of this study is to evaluate the snowmelt effects on the hydrological components, especially on the runoff, by using the soil water assessment tool(SWAT) which is a continuous semi-distributed long term rainfall-runoff model. The model was applied to the basin located in the upstream of the Chungju Dam. Some parameters in the snowmelt algorithm were estimated for the Chungju basin in order to reflect the snowmelt effects. The snowmelt effects were assessed by comparing the simulated runoff with the observed runoff data at the outlet of the basin. It was found out that the simulated runoff with considering the snowmelt component matches more satisfactorily to the observed one than without considering snowmelt effect. The simulation results revealed that the snowmelt effects were noticeable on March and April. Similar results were obtained at other two upstream gauging points. The effect of the elevation bands which distribute temperature and precipitation with elevation was analyzed. This study also showed that the snowmelt effect significantly affects the temporal distribution as well as quantity of the hydrological components. The simulated runoff was very sensitive to the change of temperature near the threshold temperature which the snowmelt can occur. However, the reason was not accounted for this paper, Therefore, further analyses related to this feature are needed.

• Journal of the Korean Society for Heat Treatment
• /
• v.21 no.1
• /
• pp.10-19
• /
• 2008

To investigate the effect of ultrasonic nano-crystalline surface modification (UNSM) treatment on rolling contact fatigue and residual stress properties of bearing steels, this paper carried out a rolling contact fatigue test, measured residual stress and retained austenite, performed a wear test, observed microstructure, measured micro hardness, and analyzed surface topology. After the UNSM treatment, it was found that the surface became minute by over $100{\mu}m$. The micro surface hardness was changed from Hv730~740 of base material to Hv850~880 with about 20% improvement, and hardening depth was about 1.3 mm. The compressive residual stress was measured as high as -700~-900 MPa, and the quantity of retained austenite was reduced to 27% from 34%. The polymet RCF-6 ball type rolling contact fatigue test showed over 4 times longer fatigue lifetime after the UNSM treatment under 551 kgf load and 8,000 rpm. In addition, this paper observed the samples, which went through the rolling contact fatigue test, with OM and SEM, and it was found that the samples had a spalling phenomenon (the race way is decentralized) after the UNSM treatment. However, before the treatment, the samples had excessive spalling and complete exploration. Comparison of the test samples before and after the UNSM treatment showed a big difference in the fatigue lifetime, which seems to result from the complicated effects of micro particles, compressive residual stress, retained austenite, and surface topology.

• Economic and Environmental Geology
• /
• v.20 no.2
• /
• pp.97-106
• /
• 1987

The geology of the Bupyeong mine area is consisted of Precambrian Gyeonggi gneiss complex and Mesozoic igneous rocks; i.e., pyroclastic rocks, intrusive breccia, granite and felsic porphyries which were formed during a Jurassic to early Cretaceous resurgent caldera evolution. Granites are not observed on the surface and in the underground of the mine. Bupyeong silver deposits occur as stockworks of base metal sulfides- minor silver minerals-quartz - carbonate veinlets, hosted by pyroclastic rocks and intrusive breccia at the southwestern margin of the caldera. Silver occurs mainly as native silver, and other silver minerals, minor in quantity, are argentite, tetrahedrite-freibergite, pyrargyrite, polybasite, canfieldite and dyscrasite. The average grade of silver ore is about 180g/t Ag. Discrimination of silver ore from the country rocks depends largely on the chemical analyses of rock samples taken every two meters from tunnels, diamond-drilling cores and mining stopes, because silver minerals are hardly observed in the ore by crude eye, and silver orebodies do not properly coincide with the concentrated zone of base metal sulfides which were precipitated at the earlier stage than the stage of precipitation of native silver. General characteristics of the loci of the silver orebodies are as follows; (1) The host rocks of orebodies are pyroclastic rocks and intrusive breccia. (2) Many of the orebodies are distributed around Gyeonggi gneiss complex. Especially where the paleotopography of gneiss complex shows a gradual slope, the basal stratigraphic horizon of the pyroclastic rocks unconformably overlying the gneiss complex offered a favorable loci of high grade ore. (3) $N5^{\circ}W$ to $N15^{\circ}$ E-striking faults played an important role in the localization of the orebodies. (4) Conduits of intrusive breccia within the gneiss complex, through which the intrusive breccia intruded into the upper pyroclastic rocks, exist beneath most of the main orebodies. This suggests that the conduits of intrusive breccia served as channelways for the migration of ore fluids.

• Korean journal of food and cookery science
• /
• v.24 no.3
• /
• pp.349-357
• /
• 2008

In an effort to augment extractability of carnosine and anserine at the levels of pro-oxidants such as iron and protein in Tuna boiled extracts(Skipjack, Yellowfin and Bigeye), we assessed the effects of heated and ion exchange chromatography(IEC) and ultrafiltration(UF) using a MW 500 cut-off(500 MWCO). We also evaluated the antioxidant activity of these extracts processed as free radical scavengers and reducing agents. Tuna boiled extracts of dark and ordinary muscle protein and total iron were reduced, whereas carnosine and anserine concentrations and antioxidant activity were increased. The carnosine and anserine concentrations of the ion exchange and permeate UF(IEC-UF) extracts were higher than those observed in the heated and permeate UF(heat-UF), whereas the protein and total iron contents were lower than that observed in the heat-UF. The quantity of carnosine and anserine in ordinary muscle was higher than that detected in dark muscle. HPLC analysis and SDS-PAGE were shown to removes the effect of UF on high molecular weight impurities in the tuna boiled extracts. The major free amino acids(FFAs) from Skipjack, Yellowfin and Bigeye tuna IEC-UF extracts were anserine, histidine and carnosine. These three peptides constituted more than 80～85%. of the detected amino acid. The IEC-UF treated ordinary muscle extracts evidenced the highest levels of DPPH radical scavenging activity and the highest levels of reducing power among the various extracts. The IEC-UF extracts evidenced a DPPH radical scavenging effect equal to that of 1mM ascorbic acid.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.729-736
• /
• 2009

Several well resistance effects induced by bending, confining stress, temperature, bubbles, and apparent opening size have been considered and researched for the reasonable PBD design. The effect of apparent opening size(AOS), however, was not extensively studied and the clogging effect by AOS was not clearly researched. In this paper, the slurry consolidation test which 4 types of PBD are installed in large slurry consolidometer($H{\times}D$, $2.0m{\times}1.2m$) is performed to investigate the clogging effect by filter's AOS. The results show that the internal clogging is observed all types of PBD, and a quantity of inflowed soil particles are increased at the lower part of PBD and the kink zone. In addition, the internal clogging phenomenon does not relate with the shape and size of PBD. In filter's AOS test, it was easily observed that soil particles bigger than AOS of tested filter passed PBD filter by SEM. This paper demonstrates that the reduction of discharge capability may be accelerated by internal clogging at the kink zone.

• Korean Journal of Materials Research
• /
• v.28 no.7
• /
• pp.417-422
• /
• 2018

The stereotype of flexible MOFs(Amino-MIL-53) and carbonized porous carbon prepared from renewable resources is successfully synthesized for $CO_2$ reduction application. The textural properties of these microporous materials are investigated, and their $CO_2$ storage capacity and separation performance are evaluated. Owing to the combined effects of $CO_2-Amino$ interaction and its flexibility, a $CO_2$ uptake of $2.5mmol\;g^{-1}$ is observed in Amino-MIL-53 at 20 bar 298 K. In contrast, $CH_4$ uptake in Amino-MIL-53 is very low up to 20 bar, implying potential sorbent for $CO_2/CH_4$ separation. Carbonized samples contain a small quantity of metal residues(K, Ca, Mg, S), resulting in naturally doped porous carbon. Due to the trace metal, even higher $CO_2$ uptake of $4.7mmol\;g^{-1}$ is also observed at 20 bar 298 K. Furthermore, the $CH_4$ storage capacity is $2.9mmol\;g^{-1}$ at 298 K and 20 bar. To evaluate the $CO_2$ separation performance, the selectivity based on ideal adsorption solution theory for $CO_2/CH_4$ binary mixtures on the presented porous materials is investigated.

• Journal of Korean Society on Water Environment
• /
• v.24 no.1
• /
• pp.7-18
• /
• 2008

The objective of this study was to develop and apply a water quality simulation model for the evaluation of ungaged watershed. The Modified WASP5 consisted of three sub-models, LOAD-M, DYN-M, and EUT-M. LOAD-M, an empirical model, estimates runoff loadings using point and non-point source data of villages. Daecheong Dam watershed was selected for the research to calibrate, verify and application of Modified-WASP5. LOAD-M model was established using field data collected from all items of water quality and water quantity gaging stations of the watersheds, and was applied to the ungauged watersheds, taking the watershed properties under consideration. The result of water quality simulation using ModifiedWASP5 shows that the observed BOD data of Yongpo and Daechong Dam in 1999 were 0.8 mg/L and 1.0 mg/L, and simulated data were 0.9 mg/L and 0.9 mg/L, respectively. In case of 1999, average BOD concentrations were 0.8 mg/L and 1.0 mg/L. Simulated concentration showed 1.1 mg/L and 1.5 mg/L, respectively. Generally, the simulation results were in good agreement with the observed data. This study was focused on formulating an integrated model for evaluating ungauged watersheds. Even though simulation results varied slightly due to limited availability of data, the model developed in this study would be a useful tool for the assessment and management of ungauged watersheds.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.6
• /
• pp.1139-1148
• /
• 2000

To treat and recycle a large quantity of converter slag. the milling properties of -14/ +24 mesh-sized slag has been considered. The optimal conditions in milling process were investigated for producing powder-type slag and the required consumption was derived for the economical grinding. The characteristics of milling processes were studied in the variation of the rotational speed, milling time, filling ratio of ball, and size and amount of feed. The grinding efficiency was also examined. The optimal rotational speed in this experimental condition was observed to be the value of 79% of critical speed. The extent of grinding was increased with increasing the grinding time. but the efficiency of milling was decreased with the time. 50% ball filling was shown to have the optimal grinding effect, and less amount and small-sized feed made the milling efficiency high. As the result, using Bond's equation, power required for efficient milling was considered and the highest value was observed in the condition of high grinding time and optimal rotational speed.

• Journal of Nutrition and Health
• /
• v.55 no.6
• /
• pp.699-708
• /
• 2022

Purpose: Adequate nutrition is to be provided for normal growth and development during early childhood. Currently, childcare teachers provide lunch to most children in Korea. The purpose of this study was to investigate the portion size provided by teachers and examine the effect of education on food serving size. Methods: The subjects were childcare teachers (n = 120) in charge of children aged 3-5 years at a daycare center in Hanam-si. The survey was conducted through questionnaires which included questions on the general characteristics of the teachers, their nutritional education status, and the source of nutrition information. In addition, the portion sizes of items on the menu currently provided to children were measured and the data were analyzed. To assess the effectiveness of education in determining serving size, the subjects were randomly equally divided into two groups. In the first group (n = 60) theoretical education on nutrition and serving sizes was given, whereas in the second (n = 60), practical education on these topics was provided. Results: The difference between the actual portion size of rice and the serving size announced on the menu was observed to decrease along with the increase in the experience of the teacher, although the differences in the main dish and kimchi were higher. The gap between the serving size mentioned in the menu and the portion size distributed widened as the age of the teachers increased. Notably, the difference between the portion size and the serving size of food decreased after both practical and theoretical education. Furthermore, the effect of education on the serving size of the main dishes (p < 0.001), side dishes (p < 0.01), and kimchi (p < 0.01) was observed to be greater in the practical education group than in the theoretical education group. Conclusion: Regular education should be provided to teachers on the serving sizes mentioned in the menu, as the quantity of food served depends on the experience and age of teachers. In the case of rice, theoretical education alone sufficed to ensure a proper serving size. However, hands-on training on the main and side dishes, and kimchi would be much more helpful.

• Water Engineering Research
• /
• v.3 no.2
• /
• pp.143-153
• /
• 2002

As the natural flows in rivers dramatically decrease during drought season in Korea, a deterioration of river water quality is accelerated. Thus, consideration of downstream water quality responding to changes in reservoir release is essential for an integrated watershed management with regards to water quantity and quality. In this study, water quality models based on artificial neural networks (ANNs) method were developed using historical downstream water quality (rm $\NH_3$-N) data obtained from a water treatment plant in Geum river and reservoir release data from Daechung dam. A nonlinear multiple regression model was developed and compared with the ANN models. In the models, the rm NH$_3$-N concentration for next time step is dependent on dam outflow, river water quality data such as pH, alkalinity, temperature, and rm $\NH_3$-N of previous time step. The model parameters were estimated using monthly data from Jan. 1993 to Dec. 1998, then another set of monthly data between Jan. 1999 and Dec. 2000 were used for verification. The predictive performance of the models was evaluated by comparing the statistical characteristics of predicted data with those of observed data. According to the results, the ANN models showed a better performance than the regression model in the applied cases.