• Bulletin of the Korean Chemical Society
• /
• v.24 no.3
• /
• pp.279-284
• /
• 2003

The One Pass Method (OPM) previously presented for the identification of single input single output systems is used to estimate the parameters of a Decentralized Control System (DCS). The OPM is a linear and therefore a simple estimation method. All of the calculations are performed in one pass, and no initial parameter guess, iteration, or powerful search methods are required. These features are of interest especially when the parameters of multi input-output model are estimated. The benefits of the OPM are revealed by comparing its results against those of two recently published methods based on pulse testing. The comparison is performed using two databases from the literature. These databases include single and multi input-output process transfer functions and relevant disturbances. The closed loop responses of these processes are roughly captured by the previous methods, whereas the OPM gives much more accurate results. If the parameters of a DCS are estimated, the OPM yields the same results in multi or single structure implementation. This is a novel feature, which indicates that the OPM is a convenient and practice method for the parameter estimation of multivariable DCSs.

• Proceedings of the KIEE Conference
• /
• 2005.11b
• /
• pp.125-128
• /
• 2005

This paper illustrates potential applications of POM/OPM/BOR, which are used for deterministic reliability evaluation in the operation mode (operational planning and operating) in Korea Power System. Deterministic reliability evaluation in this paper bases the philosophy of the marginality and the limitation of physical quantity (voltage and thermal in main) under contingency analysis. The POM/OPM/BOR tools have been developed by V&R (Vaimann and Research) in USA. Before case studies, main frame and feature of the tools are introduced in brief. Case studies of the actual power system of Korea are demonstrated for checking the application possibility of POM/OPM/BOR.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.8A
• /
• pp.657-662
• /
• 2003

The OPM(optical performance monitoring module) is needed in order to monitor optical performance. the most importance of OPM is to measure the wavelength of optical signal. In the past time, it was very difficult to get the wavelength value because they used pilot tone. Since then, using AWG(arrayed waveguide grating) and AOTF(acousto optic tuneable filter), the wavelength and the transmission qualify for multi channel signal have been monitored. In this paper, we chose the fiber fabry-perot wavelength variable filter which be evaluated for optical resolution ability to excellent, so that FBG(fiber bragg grating) was used for setting reference wavelength because chose a wavelength variable filter.

• The Korean Journal of Financial Management
• /
• v.1 no.1
• /
• pp.133-149
• /
• 1985

The theory of option pricing has undergone rapid advances in recent years. Simultaneously, organized option markets have developed in the United States and Europe. The closed form solution for pricing options has only recently been developed, but its potential for application to problems in finance is tremendous. Almost all financial assets are really contingent claims. Especially, Black and Scholes(1973) suggest that the equity in a levered firm can be thought of as a call option. When shareholders issue bonds, it is equivalent to selling the assets of the firm to the bond holders in return for cash (the proceeds of the bond issues) and a call option. This paper takes the insight provided by Black and Scholes and shows how it may be applied to many of the traditional issues in corporate finance such as dividend policy, acquisitions and divestitures and capital structure. In this paper a combined capital asset pricing model (CAPM) and option pricing model (OPM) is considered and then applied to the derivation of equity value and its systematic risk. Essentially, this paper is an attempt to gain a clearer focus theoretically on the question of corporate stock risk and how the OPM adds to its understanding.

• Food Science and Biotechnology
• /
• v.15 no.1
• /
• pp.86-90
• /
• 2006

Two lactic acid bacteria (LAB) with high ${\gamma}$-aminobutyric acid (GABA)-producing capacity were isolated from naturally aged cheese. Examination of the biochemical features using an API kit indicated that the two strains belonged to Lactobacillus. They were gram positive, rod-type bacteria, and fermented arabinose, melezitose, melibiose and xylose, but did not utilize cellobiose or trehalose. 16S rDNA sequencing analysis confirmed that they were Lactobacillus buchneri and Lactobacillus sp. They were accordingly named as Lactobacillus buchneri OPM-1 and Lactobacillus sp. OPM-2, and could produce GABA from MRS broth supplemented with 10 g/L of monosodium glutamate (MSG) at a productivity of 91.7 and 116.7 mg/L/hr, respectively. Cell extracts of L. buchneri OPM-1 and Lactobacillus sp. OPM-2 showed glutamate decarboxylase (GAD) activity, for which the optimum pH and temperature were 5.5 and $30^{\circ}C$, respectively.

• Korean Journal of Medicinal Crop Science
• /
• v.11 no.2
• /
• pp.102-108
• /
• 2003

This experiment was conducted to evaluate the diversity and purity of the Korean ginseng (Panax gjnseng) lines developed by the pure line selection using RAPD markers. Four primer (OPA 19, OPM 11, URP 3 and UBC 98) out of the 48 primer tested produced band which showed within-line polymorphisms at least in one line. Within-line polymorphisms were detected in six lines by OPA 19, in four lines by URP 03, in five lines by OPM 11, and in one line by UBC 98 respectively. Five plants obtained from the commercial cultivar 'Cheonpung' were differentiated using the primers OPA 19 and OPM 11. Five plants obtained from the 'Yeonpung were differentiated using the primer OPM 11. Detection of within-line RAPD polymorphisms might be attributed to the fact that cross pollination appear in P. gjnseng and a long period of three to four years required to reach the reproductive stage thereby delay the process to homozygosity.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.2
• /
• pp.313-319
• /
• 2010

GNSS receiver which uses the weak satellite signal is very vulnerable to the intentional jamming or non-intentional electromagnetic interference. One of the best method to overcome this disadvantage is to use an adaptive array antenna which has the capability of beamforming or nulling to the certain direction. In this paper, the performance of spatial adaptive null pattern control algorithm of 5 element array antenna is analyzed. A control algorithm which is designed in the 5 element array antenna is OPM(Output Power Minimization) which is eliminating the correlation characteristics between a reference antenna and the others. This algorithm can be applied effectively to the satellite navigation's CRPA because the satellite direction is not considered and GNSS signal power is below the thermal noise. The feature of the OPM algorithm is analyzed and the performance is compared with other null pattern control algorithm.

• Journal of Korea Multimedia Society
• /
• v.18 no.12
• /
• pp.1528-1537
• /
• 2015

In this research, we show that constructing a specific job-processing-sequences like a OPL paragraph in OPM (we call it int a new terminology 'program', which just means plan) is essential step in programming, just like a blueprint for a wood furniture or a house. As a result of our research on how to produce a specific job-processing-sequences without OPM, we found that outlining tool is the most easy-to-use tool for the required job. We show that the MS-word outlining function can be used easily as a good programming supporting tool with Visual Studio C/C++.

• Journal of the Korean Ceramic Society
• /
• v.56 no.2
• /
• pp.197-204
• /
• 2019

An electrochemical oxygen permeating membrane (OPM) is fabricated using Zr_0.895Sc_0.095Ce_0.005Gd_0.005O_2-δ (ScCeGdZ) as the solid electrolyte and aLa_0.7Sr_0.3MnO₃-bScCeGdZ composite (LZab, electrode) as the electrode. The crystal phase of the electrode and the microstructure of the membrane is investigated with X-ray diffraction and scanning electron microscopy. The electrochemical resistance of the membrane is examined using 2-p ac impedance spectroscopy, and LZ55 shows the lowest electrode resistance among LZ82, LZ55 and LZ37. The oxygen permeation is studied with an oxygen permeation cell with a zirconia oxygen sensor. The oxygen flux of the OPM with LZ55 is nearly consistent with the theoretical value calculated from Faraday's Law below a critical current. However, it becomes saturated above the critical current due to the limit of the oxygen ionic conduction of the OPM. The OPM with LZ55 has a very high oxygen permeation flux of ~ 3.5 × 10^-6 mol/㎠s in I = 1.4 A/㎠.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.5
• /
• pp.1606-1623
• /
• 2015

Optical switching will be applied in datacenter networks because electronic switching is costly and power-consuming. In this paper, considering the ring-based interconnection using optical switching in the core of a datacenter, we study the home circuit (HC) construction for the labeled optical burst switching with home circuit (LOBS-HC), a new paradigm trying to share wavelengths among the HCs from the same source. In particular, aiming to construct HCs dynamically and properly, a scheme named optimal path matching and symmetric HC matching (OPM-SHM) is proposed. The main idea of OPM-SHM is to dynamically construct HCs by sharing wavelength(s) not only among the same-source HCs but also with symmetric HCs which have different sources other than the original LOBS-HC features. The simulation results demonstrate that OPM-SHM achieves better performance than some other methods in terms of burst loss rate and wavelength utilization of physical links. More specially, it maintains good load balancing for the datacenter network using an LOBS-HC ring. In addition, due to the symmetric feature of SHM, the proposed scheme can decrease the upper bound of the average hop count of the routing paths to half of the ring size.