• Korean Journal of Agricultural Science
• /
• v.12 no.1
• /
• pp.108-117
• /
• 1985

The process of conveying of soil with the open auger to cover the seed completly with less power was reviewed by theoretical analysis. The power efficiency, the reasonable range of RPM of the open auger and the velocity of soil conveying to the direction of the shaft are examined to establish the extent of characteristics of the open auger performance. The results of theoretical analysis and application of similitude are as follows: 1. It is possible to predict the power efficiency by the following equation; ${\eta}_p={\frac{P_n}{P_g}}=({\frac{{\omega}_s}{{\omega}_a}}){\cdot}tan{\gamma}{\frac{mg}{(F_mcos{\alpha}+F_scos{\gamma})}}$ 2. The reasonable range of the revolutions per minute of the open auger was presented as follow to cover completely with less power ; $$\frac{4d(L_a-L_i){\cdot}V_w}{{\pi}(D_o^2-D_s^2){\cdot}r{\cdot}{\frac{{\omega}_s}{{\omega}_a}}{\cdot}tan{\gamma}}{{\leq_-}}{\omega}_a{{\leq_-}}({\frac{{\omega}_a}{{\omega}_s}}){\sqrt{\frac{g}{r}}}$$ 3. The velocity of soil conveying to the direction of the auger shaft may be calculated by the equation; $V_h=({\frac{{\omega}_s}{{\omega}_s}})V_a{\cdot}tan{\gamma}$ 4. The factor of RPM was more important than other factors on the power efficiency.

• 유체기계공업학회:학술대회논문집
• /
• 2003.12a
• /
• pp.63-72
• /
• 2003

In order to reduce NOx emissions in the 20kW class microturbine under development, the low NOx characteristics, as being an application to the lean premixed combustion technology, have been investigated. The study has been conducted at the conditions of high temperature and high pressure. Theair from a compressor with the pressure of 2.5bar, 3.0bar, 3.5bar was supplied to the combustor with the temperature 560K through the air preheat-treatment. The sampling exhaust gas was measured at the immediate exit of the combustor. For the effect of temperature on NO and CO emissions, though NOx were increased, CO was decreased with increasing inlet air temperature. With increasing inlet air pressure, NOx were increased and CO was decreased also. NOx were decreased, but CO was increased with increasing inlet air mass flow rate. The test has been performed on the equivalent ratio of 0.10 to 0.16 in the lean region. NOx were increased with increasing equivalent ratio, but CO was decreased as an influence of flame temperature. CFD work with an appropriate combustion model predicated a complicated swirling flow pattern in the combustor, and also produced a numerical value of NOx and CO emissions which was to be compared with the experimental one. As the results of this study, NOx are expected to be reduced to less than 42ppm at 15% O2 when operated at the design condition of the 20kW class microturbine.

• Korean Journal of Environmental Agriculture
• /
• v.31 no.1
• /
• pp.1-8
• /
• 2012

BACKGROUND: Organic fertilizers in watermelon cultivation are widely used to supply nutrient and organic matter. This study was conducted to investigate the effects of application rate of organic fertilizer on the watermelon growth and soil chemical properties in greenhouse METHODS AND RESULTS: The organic fertilizers used in this experiment were mixed expeller cake (MEC) and mixed organic fertilizer (MOF). The treatments were conducted with 4 levels (1.0 N, 0.7 N, 0.5 N and 0.3 N) on the basis of soil testing nitrogen fertilization (STNF) using MEC or MOF as the basal dressing, and using chemical fertilizers (CF) as the additional dressing on the rest of STNF. These fertilizations were compared to CF 1.0 N (0.3 N as the basal and 0.7 N as the additional dressing) and non fertilization (NF). The leaf area of watermelon in treatment 0.5 N and 0.3 N using MEC or MOF was similar to CF treatment. The absorbed nutrient amounts by leaf, weight and sugar contents of fruit in the 0.5 N and 0.3 N treatments were higher than other treatments. In 0.5 N and 0.3 N treatments using MEC or MOF on the basis of STNF, soil chemical properties such as electrical conductivity (EC), available $P_2O_5$ and exchangeable K concentrations after experiment showed tendency to decreasing or similar level before experiment. CONCLUSION(s): These results suggest that the MEC or MOF application as the basal dressing at the 30~50% level of STNF and CF application as the additional dressing on the rest of STNF be best to maintain adequate nutrient of soil and to increase marketable yield for watermelon.

• Ocean and Polar Research
• /
• v.25 no.3
• /
• pp.277-286
• /
• 2003

Nitrification performance of fixed film biofilters using coarse sand, loess bead, or styrofoam beads in biofilter columns 1 meter high and 30cm in diameter were studied at different hydraulic and organic matter loading rates. Synthetic wastewater was supplied to the culture tank in order to maintain desired TAN concentrations in inlet water to biofilters. All the biofilters were conditioned 5 months before start of sampling. TAN and $NO_2-N$ conversion rates increased with an increase in the hydraulic loading rate (HLR). However, the improvement in biofilter performance was not linearly correlated to HLR in styrofoam bead filters. This is mainly due to the characteristics of the styrofoam beads used. TAN conversion rates of sand filters increased with the increase of HLR up to $200m^3/m^2$. per day. No increase in the TAN conversion rate was observed at the highest HLR since flooding on the media surface took place. HLR had a significant impact on the TAN conversion rates in loess bead filter up to the highest HLR tested (P<0.05). TAN conversion rates were much less at organic matter loading rates of 9 and 18kg $O_2/m^3$ per day than those without the addition of organic matter in styrofoam bead filters. The addition of glucose resulted in a reduction of the TAN conversion rate from 540 to 284g $TAN/m^3$ per day. No significant difference of TAN conversion rates between the two organic matter loading rates was found (p<0.05). This indicates that the impact of organic matter on nitrification becomes less and less sensitive with an increase in the COD/TAN ratio. At an organic matter loading rate of 9kg $O_2/m^3$. per day, a great reduction of TAN conversion rates was observed in sand filters and loess bead filters. Clearly, organic matter can be one of the most Important Impacting factors on nitrification. $NO_2-N$ conversion rates showed a similar trend for TAN. Based on the TAN and nitrite conversion rates, styrofoam beads showed the best performance among the three filter media tested. Also, the low gravity and price of styrofoam beads make the handling easier and more cost-effective for commercial application. The results obtained at the highest organic matter loading rates can be used in the biofilter design in recirculating aquaculture system.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.1
• /
• pp.15-18
• /
• 2003

High purity single crystalline calcium fluoride ($CaF_2$) has excellent optical transmission characteristics down to deep UV and is therefore selected as the main optical material for the next generation of lithography apparatus operating at wavelength of 157 nm. The growth of large sized $CaF_2$ single crystals with the required properties for this optical application can be achieved only by optimizing the crystal growth process by the aid of numerical simulation. This needs especially a precise calculation of the heat transport and temperature distribution in the solid and liquid $CaF_2$ under crystal growth conditions. As $CaF_2$ is considered to be semitransparent, the internal radiative heat transfer in $CaF_2$ plays an decisive role in the simulation of the heat transport. On the other hand it is very difficult to obtain quantitative experimental data for evaluating numerical models as $CaF_2$ is extremely corrosive at high temperatures. In this work we present a newly developed experimental technique to perform temperature measurements in $CaF_2$-crystal as well as in the melt under conditions of crystal growth process. These experimental results are compared to calculated temperature data, which were obtained by using different numerical models concerning the internal heat transfer in semitransparent $CaF_2$. It will be shown, that an advanced model, which was developed by the authors, gives a much better agreement with experimental data as a standard model, which was taken from the literature.

• Applied Chemistry for Engineering
• /
• v.22 no.5
• /
• pp.453-460
• /
• 2011

Recently, there is growing interests in the application of supercritical fluids for food and medical fields since supercritical fluids ($CO_2$ and $N_2O$) have known to be safe and effective as a non-thermal sterilization technique. Although supercritical fluids have been investigated for various kinds of products, they have not yet been used in common currency due to their lack of knowledge related to the antimicrobial activity or detailed mechanisms. In this review paper, we summarized the characteristics, antimicrobial activity and mechanisms, important factors, and applicability of supercritical fluids to help the investigation and commercialization of supercritical fluids sterilization technique.

• Journal of the Korean GEO-environmental Society
• /
• v.24 no.9
• /
• pp.5-13
• /
• 2023

Cement-based reinforcement materials, which are representative slope reinforcement materials, can cause contamination of ground and groundwater when ground injection or surface application is applied. Accordingly, slope reinforcement materials using eco-friendly biopolymers are attracting attention as a means of replacing existing materials, but the biopolymers currently used are easily dissolved when exposed to groundwater or rainfall environments, reducing strength. In order to solve this problem, the cross-linking of protein between sodium casein and Transglutaminase (TGase, C₂₀H₁₆N₄O₂S₂) was used to increase the water resistance of biopolymers, and a rainfall slope test was conducted to evaluate their usability and applicability as a slope reinforcing material. In the case of reinforcement with only sodium casein, the precipitation dissolved sodium casein, and the slope was completely destroyed in 1 hour. On the other hand, it was observed that the slope reinforced by adding a small amount of TGase (0.5%) do not collapse even after 80 hours of rainfall duration due to increased water resistance. Strength and water resistance increases due to the addition of a small amount of TGase, and its applicability as an eco-friendly reinforcement is confirmed.

• Journal of the Korean Ceramic Society
• /
• v.53 no.2
• /
• pp.206-214
• /
• 2016

This study aims to produce dolomitic hydraulic lime (D-NHL) using domestic low grade dolomitic limestone and to determine the effect of adding blast furnace slag (BFS) and gypsum as part of an investigation of the hydration properties of D-NHL to increase the mechanical properties. The main mineral phases of D-NHL as a hydraulic lime binder were $Ca(OH)_2$, $Mg(OH)_2$, $C_2S$, $C_3S$, and MgO residues. $Ca(OH)_2$ transformed into $CaCO_3$ in D-NHL paste over the period of 28 days, but the carbonation of $Mg(OH)_2$ and the hydration of $C_2S$ did not occur until hydration, after 28 days. Through an investigation of the hydration properties of D-NHL pastes mixed with BFS and gypsum, Al-based compounds such as calcium aluminate hydrates ($C_4AH_{13}$) and ettringite were observed at early hydration time. The compressive strength was improved due to the increased quantities of these hydration products. These results show that good performance results from the application of dolomitic hydraulic lime and that a high value product can be made from domestic waste materials.

• Korean Journal of Soil Science and Fertilizer
• /
• v.32 no.1
• /
• pp.76-83
• /
• 1999

Studies were conducted during 2 months from May of 1997 to evaluate the effects of pig manure compost(PMC) on soil microbial flora. To do so, a field experiment of Chinese cabbage(Brassica campestris L.) was conducted in a randomized block design on a sandy loam soil and microbial floral characteristics in soils were analyzed. Treatments to control included the application of PMC at (A) $8Mg\;ha^{-1}$CM-8), (B) $29Mg\;ha^{-1}$(CM-2,9), and (C) $57Mg\;ha^{-1}$(CM-57), and of chemical fertilizer(D) at $320N-80P_2O_5-200K_2O\;kg\;ha^{-1}$(NPK). In each treatment, the rhizosphere and non-rhizosphere soils were tested for the analysis of microbial populations. The populations of bacteria, actinomycetes, and fungi increased in soils with the applications of PMC and chemical fertilizer, but that of Bacillus sp. decreased. However, the population of fluorescent Pseudomonas sp. was reduced in NPK plots only. With increasing application rates of PMC, the number of colony forming units(cfu) of bacteria (Pseudomonas sp. and actinomycetes) and fungi increased. in all PMC-treated plots, the population density peaked at early growth stage for bacteria(including Bacillus sp.), at late growth for fluorscent Pseudomonas sp., and at harvest for fungi and actinomycetes. The rhizosphere effect was greatest for fluorscent Pseudomonas sp. As the application rates of PMC increased, Total N, organic matter, available phosphate, and exchangeable -K, -Ca, and -Mg increased compared to control, but soil pH was lowered. In NPK plots, EC was 3.4-fold and exchangeable K was 5-fold higher than control.

• Korean Journal of Organic Agriculture
• /
• v.22 no.2
• /
• pp.293-302
• /
• 2014

As part of the agricultural natural circulation, the present study was performed. Recently, there has been the movement toward reusing the Liquid Pig Manure as an alternative fertilizer sources for agricultural lands. For instance, LPM (Liquid Pig Manure) liquid fertilizer has been developed and widely used in Korea. However, the impacts of LPM on both agricultural environment and crop triticale yield have not been investigated yet. The experiments were studied on paddy field after treatment of LPM on plant height, root length, plant length, dry matter yield and soil chemical properties. The effect of LPM by application on triticale was more increased plant height, root length and plant length than the Control. Chemical soil characteristics were not significantly different between on Control and LPM. Soil pH, OM, TN, $P_2O_5$ and exchangeable cation of triticale (X Triticosecale wittmack) appeared to be lower than before the treatment. Dry matter yield were produced 834.3kg $10a^{-1}$ of in LPM plot and 684.4kg $10a^{-1}$ in Control plot. In these results show abbreviated as the application of LPM increases the yield index of triticale. However, the properties of paddy soil were not affected by the LPM application.