• Nuclear Engineering and Technology
• /
• 제47권5호
• /
• pp.559-566
• /
• 2015

The thermalehydraulic characteristics for the CANadian Deuterium Uranium Flexible (CANFLEX)-burnable poison (BP) fuel channel, which is loaded with a BP at the center ring based on the CANFLEX-RU (recycled uranium) fuel channel, are evaluated and compared with that of standard 37-element and CANFLEX-NU (natural uranium) fuel channels. The distributions of fuel temperature and critical channel power for the CANFLEX-BP fuel channel are calculated using the NUclear Heat Transport CIRcuit Thermohydraulics Analysis Code (NUCIRC) code for various creep rate and burnup. CANFLEX-BP fuel channel has been revealed to have a lower fuel temperature compared with that of a standard 37-element fuel channel, especially for high power channels. The critical channel power of CANFLEX-BP fuel channel has increased by about 10%, relative to that of a standard 37-element fuel channel for 380 channels in a core, and has higher value relative to that of the CANFLEX-NU fuel channel except the channels in the outer core. This study has shown that the use of a BP is feasible to enhance the thermal performance by the axial heat flux distribution, as well as the improvement of the reactor physical safety characteristics, and thus the reactor safety can be improved by the use of BP in a CANDU reactor.

• Nuclear Engineering and Technology
• /
• 제49권4호
• /
• pp.838-849
• /
• 2017

This paper proposes penalty factor equations that take into consideration the weld strength over-match given in the classified form similar to the revised equations presented in the Code Case N-779 via cyclic elastic-plastic finite element analysis. It was found that the $K_e$ analysis data reflecting elastic follow-up can be consolidated by normalizing the primary-plus-secondary stress intensity ranges excluding the nonlinear thermal stress intensity component, $S_n$ to over-match degree of yield strength, $M_F$. For the effect of over-match on $K_n{\times}K_{\nu}$, dispersion of the $K_n{\times}K_{\nu}$ analysis data can be sharply reduced by dividing total stress intensity range, excluding local thermal stresses, $S_{p-lt}$ by $M_F$. Finally, the proposed equations were applied to the weld between the safe end and the piping of a pressurizer surge nozzle in pressurized water reactors in order to calculate a cumulative usage factor. The cumulative usage factor was then compared with those derived by the previous $K_e$ factor equations. The result shows that application of the proposed equations can significantly reduce conservatism of fatigue assessment using the previous $K_e$ factor equations.

• Journal of Pharmaceutical Investigation
• /
• 제20권2호
• /
• pp.79-88
• /
• 1990

A numerical model for diffusion and dissolution controlled transport from dispersed matrix is presented. The rate controlling process for transport is considered to be diffusion of drug through a concentration gradient coupled with time-dependent surface change and/or disappearance of the dispersed drug in response to the dissolution. The transport behavior of drug was explained in terms of ${\nu}$ parameter: ${\nu}$ value means a ratio of diffusion time constant and dissolution time constant. This general model has wide range of application from where release is controlled by the diffusion rate to where release is governed by the dissolution rate. Based on this model, theoretical drug concentration, particle size distributions in the polymer matrix system and the resulting release rate were also investigated.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 추계학술대회 논문집 전력기술부문
• /
• pp.176-179
• /
• 2007

This paper proposes a fuzzy linear programming based solution approach fur the long-term generation mix with multi-stages (years) considering air pollution constraints on $CO_2$ emissions, under uncertain circumstances as like as ambiguities of budget and reliability criterion level. This paper approaches to generation mix problem for 2030 year in Korea eventually. The proposed approach may give more flexible solution rather than too robust plan. The effectiveness of the proposed approach is demonstrated by applying it to solve the multi-years best generation mix problem on the Korea power system which contains nuclear, coal, LNG, oil and pumped-storage hydro plants.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2006년도 Proceedings of ISRS 2006 PORSEC Volume I
• /
• pp.75-78
• /
• 2006

The Korea Ocean Satellite Center (KOSC) is under development to establish in line with the launch of the first Korean multi-function geostationary satellite COMS (Communication, Ocean and Meteorological Satellite) scheduled in 2008. KOSC aims to receive, process and distribute Geostationary Ocean Color Sensor (GOCI) data on board COMS in near-real time. In this report, current status of KOSC development is presented in the following categories; site selection for KOSC, antenna design, GOCI data receiving and processing system, data distribution, future works.

• 대한기계학회논문집B
• /
• 제37권12호
• /
• pp.1113-1120
• /
• 2013

본 연구에서는 $45^{\circ}$기울어진 저온의 사각형 밀폐계 내부에 존재하는 고온의 원형 실린더의 위치 변화에 따른 밀폐계 내부 자연대류 현상에 대한 수치해석을 수행하였다. Rayleigh 수는 $10^3$부터 $10^5$까지 변화하였으며 내부 실린더의 위치는 $-0.4{\leq}{\delta}{\leq}0.4$ 범위에서 0.1 간격으로 변화시켰다. 원형 실린더의 위치 변화에 따른 밀폐계 내부의 자연대류 현상은 실린더 표면과 밀폐계 표면의 Nu 수, 밀폐계 내부의 등온선 및 유선을 바탕으로 분석하였다. 본 연구에서 고려한 Rayleigh 수의 범위와 원형 실린더의 위치 범위에서는 밀폐계 내부의 열유동은 정상상태의 특성을 보였다. 그리고 내부 원형 실린더가 벽면에 가까워 질수록 실린더벽면과 밀폐계 벽면의 평균 Nu 수가 증가하였다.

• ALGAE
• /
• 제30권2호
• /
• pp.139-146
• /
• 2015

Urchin barrens have been a major issue of rocky coastal ecosystems in temperate regions. In South Korea, the east coast and Jeju Island have especially been a focus because the area of barren ground increases in spite of continual efforts to install artificial reefs. This study approached the urchin barrens issue in South Korea, by focusing on a correlational analysis of urchin and macroalgal abundance. Urchin density and algal species coverage were obtained using a quadrat image analysis. Subtidal sites were then classified into three groups according to the average densities of urchins to evaluate the characterization of the macroalgal community: no urchin (NU) zone; transition (TR) zone, $4inds.\;m^{-2};$ and urchin (UR) zone, ${\geq}8inds.\;m^{-2}$. The average urchin density in the study site was $4.7inds.\;m^{-2}$ and 57 macroalgal species were found in the study site. From the NU zone to UR zone, total species number, species diversity index and evenness gradually decreased, whereas the dominance index increased. The algae species with negative correlations were Grateloupia divaricata, Polysiphonia morrowii, Chondracanthus intermedius, Delesseria violacea, Desmarestia viridis; and those with positive correlations were the crustose corallines, Sargassum horneri. Other species were not significantly correlated with urchin density. The significant correlations indicate that the abundance of some macroalgal species is proportionally regulated by sea urchin density. This study also shows how macroalgal vegetation changes in response to an urchin's density gradient in a natural condition; and there is a TR zone that existed with respect to an intermediate level of algal abundance.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.46-49
• /
• 2003

Chemical mechanical polishing (CMP) is an essential dielectric planarization in multilayer microelectronic device fabrication. In the CMP process it is necessary to minimize the extent of surface defect formation while maintaining good planarity and optimal material removal rates. The polishing mechanism of W-CMP process has been reported as the repeated process of passive layer formation by oxidizer and abrasion action by slurry abrasives. Thus, it is important to understand the effect of oxidizer on W passivation layer, in order to obtain higher removal rate (RR) and very low non-uniformity (NU%) during W-CMP process. In this paper, we compared the effects of oxidizer or W-CMP process with three different kind of oxidizers with 5% hydrogen peroxide such as $Fe(NO_3)_3$, $H_2O_2$, and $KIO_3$. The difference in removal rate and roughness of W in stable and unstable slurries are believed to caused by modification in the mechanical behavior of $Al_3O_3$ particles in presence of surfactant stabilizing the slurry.

• Toxicological Research
• /
• 제23권3호
• /
• pp.271-278
• /
• 2007

Several recent studies demonstrated the potential of bioengineering using stem cells in regenerative medicine. Adult mesenchymal stem cells (MSCs) have the pluripotency to differentiate into cells of mesodermal origin, i.e., bone, cartilage, adipose, and muscle cells; they, therefore, have many potential clinical applications. On the other hand, stem cells possess a self-renewal capability similar to cancer cells. For safety evaluation of MSCs, in this study, we tested tumorigenecity of canine adipose derived mesenchymal stem cells (cAD-MSCs) using Balb/c-nu mice. In this study, there were no changes in mortality, clinical signs, body weights and biochemical parameters of all animals treated. In addition, there were no significant changes between control and treated groups in autopsy findings. These results indicate that cAD-MSC has no tumorigenic potential under the condition in this study.

• Bulletin of the Korean Chemical Society
• /
• 제34권2호
• /
• pp.482-488
• /
• 2013

Two piperazine-containing 3,4-dihyroquinazolines (BK10007S/8S) have been synthesized, based on our previous work on the synthesis and antitumoral activity of 3,4-dihyroquinazolines. After evaluating them for T-type calcium channel blocking effect and in vitro anti-cancer effect, they were profiled for acute and repeat dose toxicity (40 mg/kg, 2 weeks) to BALB/c mice. BK10007S/8S were further in vivo evaluated against human pancreatic MIA PaCa-2 carcinoma in $BALB/c^{nu/nu}$ nude mice, which exhibited 54 and 61% tumor growth inhibition through 57-day oral administration of 2 mg/kg of body weight, respectively.