• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.2
• /
• pp.225-233
• /
• 2007

Road runoff water is one of the non-point sources (NPSs) of pollution negatively influencing drinking water source. Numerous road runoff NPS waters have been studied for over the last decade. However, the sources of pollution can be conditional, seasonal, or accidental. Therefore, measurement of pollutant loadings in different site is necessary to estimate the effect of road runoff water. The objective of this study was to examine the quality of road runoff water from a city bridge in Seoul, Korea. This study was conducted for two years to assess annual discharge pollution loads. In this study, key water quality parameters including chemical oxygen demand ($COD_{Cr}$), biochemcial oxygen demand ($BOD_5$), total nitrogen (T-N), total phosphorus (T-P), and suspended solid (SS) were measured at 18 different events. The results showed that typically the pollutant concentrations are higher at the beginning of each event and decrease afterwards. The first 20% of the volume of the runoff from each event is transporting 46% ($COD_{Cr}$), 48% ($BOD_5$), 50% (T-N), 34% (T-P), 30% (SS), respectively. The event mean concentrations (EMCs) were $COD_{Cr}$ (199 mg/L), $BOD_5$ (41.2 mg/L), T-N (7.97 mg/L), T-P (0.42 mg/L) and SS (113 mg/L). Although the results were consistent with the previous study (Barbosa and Hvitved-Jacobsen, 1999), $COD_{Cr}$, $BOD_5$, T-N exhibit a stronger first flush effect compared to the other contaminants.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.57 no.5
• /
• pp.129-137
• /
• 2015

The objective of this study was to test the non-point source pollution (NPS) control by the vegetated ridge and silt fence through field monitoring. The experiment plots were established with three sizes which are 5 m width by 22 m length with 8 %, 3 % slope and 15m width by 15 m length with 6 % slope. Flumes with the floating type stage gages were installed at the outlet of each plot to monitor the runoff. For a rainfall monitoring, tipping bucket rain gage was installed within the experiment site. Water quality samples were monitored during the heavy rainfall occurred. The amount of rainfall from 4 monitored events ranged from 27.6 mm to 130 mm. The runoff reduction rate could vary depending on slope, soil, crop growth condition, rainfall amount, rainfall intensity, antecedent moisture condition, and many other factors. The runoff from vegetated ridge and silt fence treatment plots was 24.05 % and -8.28 % lower than that from control plot, respectively. The monitoring results showed that the average pollution loads reduced by vegetated ridge compared to control were BOD 36.62~53.60 %, SS 40.41~73.71 %, COD 39.34~56.41 %, DOC 49.08~53.67 %, TN 26.74~67.23 %, and TP 52.72~91.80 %; by silt fence compared to control were SS 41.73 %, COD 1.93 %, and TN 2.38 %. The paired t-test result indicated that the vegetated ridge and silt fence were statistically significant effect in SS load reduction, with a 5 % significant level. Monitored results indicated that vegetated ridge and silt fence were both effective to reduce the pollutant from the field surface runoff.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2002.10a
• /
• pp.417-420
• /
• 2002

Non-point source pollution of sediment, plant nutrients and pesticides from cropland has been identified as a significant environmental problem. Vegetative Filter Strips have been identified as one of BMPs to control nonpoint source pollution. This paper reviews the concept, functions, design criteria and management of VFS to control nonpoint source pollution.

• Journal of Wetlands Research
• /
• v.15 no.3
• /
• pp.387-396
• /
• 2013

Non-point pollution source is difficult to control due to uncertain outflow path and emission. So, There are many development and research to Best Management Practices(BMP) established to manage the Non-point pollution source. Besides, various methods of estimated efficiency to exact assessment of BMP is presented. In this study, the impact about length of Grassed Swale on reduction efficiency based on monitoring results of Grassed Swale by length is studied. By estimating Grassed Swale reduction efficiency in a variety of methods, the difference between the methods of estimated efficiency was compared with those that. Estimated efficiency method using ER, SOL, ROL, ROF, SOLF, and ROLF methods is analyzed. EMC analysis result is high inflow and outflow concentration distinction organic compound for nutritive salts The result of efficiency analysis along Grassed Swale length sharply increases in a Grassed Swale inlet. After this increase, the efficiency gradually decreases. This is expected that cistern installed in the end of the front. To obtain a stable reduction efficiency of Grassed Swale, minimum length 30m of Grassed Swale should be enough. Also, in order to efficiently and economically design Grassed Swale, the researches on length of Grassed Swale are needed rather than simple analysis of efficiency.

• Journal of Korean Society on Water Environment
• /
• v.25 no.6
• /
• pp.972-978
• /
• 2009

This study modifies the present total maximum daily load (TMDL) system of Ministry of Environment and applies to the Anyangcheon watershed. Hydrologic Simulation Program-FORTRAN (HSPF) model is used to simulate both runoff and non-point source pollution, simultaneously, instead of QUAL2E. The drought flow (355th daily flow) is proposed for the target water quantity since it is easier to satisfy low flow (275th daily flow) for the target water quality than drought flow. The increase of discharge is more than the increase of pollutant load except for the period under low flow. The measured unit loads for non-point source are used to consider the regional runoff characteristics. The measured water quantity and quality data are used since the ministry of environment supports only water quality. This analysis results show some reasons for the improvement of the present TMDL system of Korea.

• Journal of Korean Society on Water Environment
• /
• v.27 no.4
• /
• pp.499-508
• /
• 2011

We analyzed the variations of water quality with flow regime alterations to determine the characteristics of the stream where the stream management is considerably difficult due to the high variability of the flow rates. In this study, both flow rates and water qualities were monitored at the tributaries, 34 in count, of both Geum River and Sabgyo Lake Basins. The variation of water qualities were divided into 2 types, based on their stream flow rates, known as Type I and Type II. If the water quality of a stream increases during low flow rate periods compared with high flow rate periods, it is classified as Type I; if the water quality of the stream increases during high flow rate periods compared with low flow rate periods, it falls under Type II. The analysis for the variations of water qualities, of all 43 basins, resulted to 24 basins under Type I and Nineteen 19 basins under Type II. The variations of water qualities were analyzed first by using Regression Analysis followed by Statistical Analysis. The average slope of the variations of water qualities and the slope of the standard deviations were 0.00135 and 0.00477, respectively. The Probability Distributions of both Type I and Type II basins were 61.1% and 38.9%, respectively. The basin having a probability distribution of 61.1% and is also known as Type I, increases during periods of low flow rates, due to the presence of point sources. Therefore, the basin should be enforced with stream management. Before the stream management can be implemented in all streams falling under Type II, the sources of contaminants should first be estimated. These contaminants can be classified into two parts, the first is Point source pollution and the second is Non-point source pollution, where the Non-Point source pollution can be sub-divided into two types, with storm runoff and without storm runoff.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.6
• /
• pp.597-606
• /
• 2019

Due to climate change, coastal areas are being flooded with torrential rain, typhoons, and tsunamis. In addition, non-point source pollutants (NPSs) that accumulated on the ground, streets, and buildings during the dry season are washed off by rain and stormwater runoff, which adds to the damage associated with environmental pollution, e.g., pollution that makes its way into the ocean. Recently, low impact development (LID) has been considered as a means of controlling water circulation and NPSs. In the coastal area, permeable blocks have been constructed mainly to reduce the flood damage caused by waves. Some important design factors that must be considered to ensure long-term performance are the permeability coefficient, clogging, and the efficiency of the removal of total suspended solids (TSS), but currently there are no standardized design criteria or testing techniques that are used worldwide. Herein, we analyzed the permeability coefficient and the TSS removal efficiency tendency according to the permeability area ratio with an easily-detachable, permeable block filled with calcinated yellow soils as the filter media. Our lab-scale tests indicated that, when the permeability area ratio was 25%, the reduction of the permeability coefficient after clogged was 11%, which was a significant decrease compared to other cases. Permeability persistence increased when the permeability area ratio increased from 50% to 75%. The TSS removal efficiency decreased as the permeability area ratio increased. Our pilot-scale test indicated that the TSS removal efficiency was more than 80% higher in all cases. We also found that the permeability persistence was excellent as the permeability area ratio increased, and, in actual construction, it is effective to set 5.3% of the total area as permeable area in terms of permeability and economic feasibility.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 1999.06a
• /
• pp.137-159
• /
• 1999

Over the last three decades, Korean farming system has been directed to maximum agricultural production and to increase farmer's income through adoption of high-yielding crop varieties and high input of agrochemicals . These farming practices have resulted in problems of water-quality deterioration, soil degradation , and food safety. At present, over 40 million tones of animal waste are bing produced annually, which amounts to disposing the waste at the annual rate of 20 tones per ha in the total area of farming land in Korea. Nearly a half of total available water resources is used as irrigation water predominantly for rice paddy field. Thus, non-point source contamination of the water resources has been linked to agriculture across the nation. However, the extent to which agriculture contributes to the water quality is not fully known. Recently, Korean government provided various institutional measures to reduce the negative impacts of agricultural practices on the environ ental quality, and the Agricultural Environment Act was also passed by the legislature in 1998 and became effective January 1999. This Act does not cover the broad spectrum of the sustainable agriculture ; thus, the limited incentives within this Act are arguably ineffective to control the non-point source pollution. Recently new bulk blending of fertilizers(BB fertilizer) are bing produced (100, 000 tones in 1998) with Government subsidies. The BB fertilizers are to balance N-P-K ratio in the soils . Although the use of the BB fertilizers are encouraged with Government subsidies, non-point source pollution is still serious and will become worse. Precision farming is regarded as a new means for sustainable agriculture. It is a new technology that modifies the existing techniques and incorporates new one such as GIS, GPS , differential applicator to produce a new set of tools for the farmer to use. Precision farming, however, has constraints for individual farming practices. For exam le , farm size or parcel unit of each farmer is too small to adopt the precision agriculture on farmhouse-hold bases and farmer's ability to adopt the new technology is limited. However, it would be appropriate to establish local or regional cooperatives to operate such a precision farming system. It is recommended that Government provide sufficient incentives to help establish local and/or regional cooperatives.

• Journal of Korean Society on Water Environment
• /
• v.37 no.2
• /
• pp.103-113
• /
• 2021

In this study, an Excel-based model (ROADMOD) was developed to estimate pollutant loading from the road and evaluate BMPs. ROADMOD employs the Chezy-Manning equation and empirical expression for estimating surface runoff, and power function for pollutant buildup, and exponential function for pollutant washoff in SWMM. The results of model calibration for buildup and washoff using observed data revealed a good match between the simulation results and the observed data. The long-term surface runoff and sediment simulated by ROADMOD demonstrated a good match with those by SWMM with 2 ~ 14% of relative error. The shorter sweeping interval (within 8 days) remarkably decreased sediment loads from the road. It was found that the effect of reducing sediment loads from the road was greatly affected not only by the sweeping interval but also by sweeping on the day before a rainfall event. The 48% of removal efficiency of sediment loads from the road was achieved with 26 times of road sweeping per year when sweeping was performed on the day before the rainfall event. A 4-day sweeping interval showed similar removal efficiency (48%) with 96 times of sweeping per year. It is considered that the road sweeping on the day before a rainfall event could maximize the effect of reducing the non-point source pollution from the road with minimization of the number of road sweeping. So, the road sweeping on the day before a rainfall event can be considered as one of the useful and best management practices (BMPs) on road.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.1
• /
• pp.79-86
• /
• 2019

In order to measure the filtration characteristics of a cotton ball shape filter, the experiments of suspended solids(SS) surrogate material selection and filtration performance have been carried out in this study. Between the two materials of powdered activated carbon(PAC) and powdered red-clay, PAC is more suitable surrogate material in terms of experimental criteria and particle size distribution in the non-point source pollutants removal system. As a result of the filtration experiments with the cotton ball shape filter, the initial headloss was about 8 cm, and the headloss slightly increased over filtration time. The Kozeny-Carman equation was used to analyze the changes of pressure and porosity during the filtration. The initial porosity was calculated as 0.945 and it decreased to 0.936 at the end of design filtration time. As the filtration continued, the SS concentration of the filtered water gradually increased and the SS removal rate gradually decreased. When the SS target removal efficiency is assumed to be 80%, the cumulative SS removal capacity is expected as $28.8kg/m^2$. This means the volume loading rate of the cotton ball shape filter can be $115m^3/m^2$ when the typical SS concentration of non-point source water pollution is assumed as 250 mg/L.