• Journal of the Society of Disaster Information
• /
• v.19 no.4
• /
• pp.984-992
• /
• 2023

Purpose: The core problem of this study is that there are no specific noise regulation standards for domestic blasting work. Currently, the domestic blasting work noise regulation standard has not been established separately, and the noise regulation standard of 80 decibels is corrected by 10 decibels to 70 decibels, which is the daily living noise standard. In contrast, many foreign countries have separate noise regulation standards specifically tailored to blasting work. Accordingly, it is intended to present international reasonable blasting noise standards by comparing domestic and foreign blasting work noise regulation standards. Mmethod: This study can be inferred as a comparative analysis of domestic and foreign noise regulation standards. Data on the current noise regulation standards during domestic blasting and noise regulation standards during blasting operations in the United States, the United Kingdom, Australia, Japan, and China are collected and analyzed. Results: According to the study, the noise regulation value during blasting work at domestic construction sites was not separately established, so it was not properly tailored to the specific and characteristics of blasting noise. In the case of overseas, a realistic noise regulation value was established so that a safer, more efficient and eco-friendly blasting method could be applied to the noise regulation value uniformly during blasting work. Conclusion: In this study, it is hoped that noise regulations will be established during reasonable blasting work, as shown in domestic and international comparative studies, and will be widely adopted without interfering with the introduction of efficient, economical, and eco-friendly blasting methods by complying well with blasting safety standards.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.19 no.8
• /
• pp.809-815
• /
• 2009

The previous work(Cheong et al., 2006) where the characteristics of acoustic emissions of wind turbines has been investigated according to the methods of power regulation, has showed that the acoustic power of wind turbine using the stall control for power regulation is more correlated with the wind speed than that using the pitch control. In this paper, basically extending this work, the noise generation characteristics of large modern upwind wind turbines are experimentally indentified according to the power regulation methods. To investigate the noise generation mechanisms, the distribution of noise sources in the rotor plane is measured by using the beam-forming measurement system(B&K 7768, 7752, WA0890) consisting of 48 microphones. The array results for the 660 kW wind turbine show that all noise is produced during the downward movement of the blades. This result show good agreement with the theoretical result using the empirical formula with the parameters: the convective amplification; trailing edge noise directivity; flow-speed dependence. This agreement implies that the trailing edge noise is dominant over the whole frequency range of the noise from the 660 kW wind turbine using the pitch control for power regulation.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2009.04a
• /
• pp.63-67
• /
• 2009

The previous work (Cheong et al., 2006) where the characteristics of acoustic emissions of wind turbines has been investigated according to the methods of power regulation, has showed that the acoustic power of wind turbine using the stall control for power regulation is more correlated with the wind speed than that using the pitch control. In this paper, basically extending this work, the noise generation characteristics of large modern upwind wind turbines are experimentally indentified according to the power regulation methods. To investigate the noise generation mechanisms, the distribution of noise sources in the rotor plane is measured by using the Beam-forming measurement system (B&K 7768, 7752, WA0890) consisting of 48 microphones. The array results for the 660 kW wind turbine show that all noise is produced during the downward movement of the blades. This result show good agreement with the theoretical result using the empirical formula with the parameters: the convective amplification; trailing edge noise directivity; flow-speed dependence. This agreement implies that the trailing edge noise is dominant over the whole frequency range of the noise from the 660 kW wind turbine using the pitch control for power regulation.

• Journal of Environmental Impact Assessment
• /
• v.10 no.4
• /
• pp.305-317
• /
• 2001

Effects on increased noise influenced residents on the urban areas as well as the rural areas because of rapidly increasing traffic volume and newly-constructed road. The object of this study is to better establish environmental policy for the year 2000s through analyzing current environment administration system in the field of noise and vibration. Noise and vibration administration system in Korea is composed of various standards in areas of noise environment, traffic noise regulation, living noise regulation, factory noise and vibration regulation, and aircraft noise regulation. Furthermore, there exists environment noise and vibration monitoring networking system. This study is to improve noise and vibration administration system through analyzing present condition and problems. This study suggests improved noise and vibration administration system by achieving four steps ; 1) goal establishment in noise and vibration administration system; 2) development of reduction mitigation method; 3) estimation of reduction mitigation method; 4) establishment of enforcement method. Proposed "Noise and Vibration Policy Committee" should be established to harmonize noise and vibration policy on scientific basis for the $21^{st}$ century.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.05a
• /
• pp.941-945
• /
• 2006

In the development of electricity generating wind turbines for wind farm application, only two types have survived as the methods of power regulation; stall regulation and fun span pitch control. The sound measurement procedures of IEC 61400-11 are applied to field test and evaluation of noise emission from each of 1.5 MW and 660 kW wind turbine generators (WTG) utilizing the stall regulation and the pitch control for the power regulation, respectively. Apparent sound power level, wind speed dependence and third-octave band levels are evaluated for both of WTGs. It is found that while 1.5 MW WTG using the stall control is found to emit lower sound power than 660 kW one using the pitch control at low wind speed (below 8 m/s), sound power from the former becomes greater than that of the latter in the higher wind speed. Equivalent continuous sound pressure levels (ECSPL) of the stall control type of WTG vary more widely with wind speed than those of the pitch control type of WTG These characteristics are believed to be strongly dependent on the basic difference of the airflow around the blade between the stall regulation and the pitch control types of WTG. These characteristics according to the methods of power regulation lead to the very different noise emission characteristics of WTG depending on the seasons because the average wind speed in summer is lower than the critical velocity over which the airflow on the suction side of blade in the stall types of WT are separated. These results propose that, in view of environmental noise regulation, the developer of wind farm should give enough considerations to the choice of power regulation of their WTG based on the weather conditions of potential wind farm locations.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.109-112
• /
• 2005

Since 1989, when the first European noise regulation against construction equipments came into force, much investigation had been devoted to reduce the noise and had produced the remarkable improvement in noise reduction technology. EU Directive 2000/14/EC Stage 2, more stringent noise regulation, is going to be implemented from Jan. 2006. The technology trends and examples for noise reduction in typical construction equipment R&D is described briefly.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2007.11a
• /
• pp.1482-1489
• /
• 2007

In this paper, characteristics of infrasound and low-frequency noise emission from large modern wind turbines are experimentally investigated. The sound measurement procedures of IEC 61400-11 and ISO 7196 are utilized to field test and evaluation of noise emission from each of 1.5 MW and 660 kW wind turbines using the stall regulation and the pitch control for the power regulation, respectively. It was found that the G-weighted SPLs of low-frequency noise including infrasound shows positive correlation with the wind speeds, irrespective of methods of power regulation. This highlights the potential complaint of local community against the infrasound and low-frequency noise of wind turbines. The comparison of measured data with the existing hearing thresholds and criteria curves shows that it is highly probable that the low-frequency noise from the 1.5 MW and 660 kW wind turbines in the frequency range over 30 Hz leads to the psychological complaint of ordinary adults, and that the infrasound in the frequency range from 5 Hz to 8 Hz causes the complaint by rattling the house fitting such as doors and windows.

• Journal of the Ergonomics Society of Korea
• /
• v.34 no.3
• /
• pp.265-278
• /
• 2015

Objective:To study the sources of indoor noise, its effects on human health, noise assessment and regulation through the use of standards, and techniques used to reduce noise. Background: Noise significantly affects the living environment, and there are an increasing number of reports of its impacts on human health. Method: We reviewed domestic and foreign data regarding environmental noise, and examined its effects and the standards used to regulate noise levels. Results: We describe the major sources of indoor noise and suggest possible legal standards, as well as recommended criteria for the control of noise. Conclusion: South Korea has higher legal standards of environmental noise than international standards in terms of threshold values. People in Korea are exposed to various sources of noise, and therefore the reduction of noise is urgently required. Application: Depending on the features of indoor spaces, an appropriate degree of indoor noise can be determined and techniques to reduce excess noise are required.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.16 no.8 s.113
• /
• pp.864-871
• /
• 2006

In the development of electricity generating wind turbines for wind farm application, only two types have survived as the methods of power regulation; stall regulation and full span pitch control. The main purpose of this paper is to experimentally identify the characteristics of noise emission of wind turbines according to the power regulation types. The sound measurement procedures of IEC 61400-11 are applied to field test and evaluation of noise emission from each of 1.5 MW and 660 kW wind turbines (WT) utilizing the stall regulation and the pitch control for the power regulation, respectively. Apparent sound power level, wind speed dependence, third-octave band levels and tonality are evaluated for both of WTs. It is observed that equivalent continuous sound pressure levels (ECSPL) of the stall control type of WT continue to increase with increasing wind speed whereas those of the pitch control type of WT show less correlation with wind speed. These observed characteristics are believed to be due to the different airflow patterns around the blade between the stall regulation and the pitch control types of WT; the airflow on the suction side of blade in the stall types of WT are separated at the high wind speed. It is also found that the 1.5 MW WT using the stall control emits lower sound power than 660 kW one using the pitch control at wind speeds below 8m/s, whereas sound power of the former becomes higher than that of the latter in the wind speed over 8m/s. This wind-speed dependence of sound power leads to the very different noise omission characteristics of WTs depending on the seasons because the average wind speed in summer is lower than 8m/s whereas that in summer is higher. Based on these experimental observations, it is proposed that, in view of environmental noise regulation, the developer of wind farm should give enough considerations to the choice of power regulation of their WTG based on the weather conditions of potential wind farm locations.

• KIEAE Journal
• /
• v.4 no.3
• /
• pp.37-44
• /
• 2004

In this study, foreign and domestic noise criteria on walls, floors, and water supply facilities were reviewed and the results are as follows : regulation can be divided two things, one is on thickness the other is sound insulation performance. Green Building regulation based on the law and this have sound classification systems. Since these regulations are not established in Korea. The noise regulation on water supply-drain facilities and domestic guideline on interior noise level is needed. Foreign regulations are stricter than those of ours. And those has sound classification system for the better acoustic condition of inhabitants'.