• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.12
• /
• pp.1776-1783
• /
• 2002

A population segregating for the naked neck (Na) gene was used to evaluate its effect on fast growing broilers at heat stress. An experimental stock comparable to those of modern broilers was established by backcrossing to colour synthetic male and female lines. Matings between heterozygous (Na/na) males and females produced normally feathered (na/na), heterozygous (Na/na) and homozygous (Na/Na) chicks for the present study. Day old to seven week old coloured broilers of three genotypes viz. normally feathered (na/na), heterozygous naked neck (Na/na) and homozygous naked neck (Na/Na) were compared for heat dissipation, growth performance, body conformation traits, blood biochemical parameters and carcass traits in tropical climate. In hot climate, naked neck broilers had significantly less body temperature and better heat dissipation capabilities as compared to normal broilers. The naked neck broilers had significantly higher body weight and better feed conversion ratio than na/na broilers. The Na/Na or Na/na broilers exhibited higher giblet yield, blood loss and lower feather mass compared to na/na broilers. The results indicated that the reduction in feather coverage in Na/Na and Na/na broilers facilitates better heat dissipation with lower body temperature, more body weight gain, better FCR and carcass traits compared to normal broilers.

• The Korean Journal of Physiology
• /
• v.9 no.2
• /
• pp.33-39
• /
• 1975

Changes of urinary aldosterone excretion, concurrent sodium and potassium excretion following furosemide administration were studied in normotensive young Korean with high sodium intake, moderate sodium restriction and marked sodium depletion. After intravenous injection of furosemd 40mg, plasma and urine samples were collected at every thirty minutes for two hours. Plasma-and urinary aldosterone, electrolyte concentration and urine flow rate were measured by means of radioimmunoassay or flamephotometry. Relations of urinary aldosterone to concurrent sodium or potassium/sodium ratio, and of urinary aldosterone to concurrent plasma aldosterone activity were studied. Following were the results: 1. Furosemide administration resulted in a increased urinary aldosterone concentration and unchanged or somewhat decreased sodium concentration in course of time after the injection. 2. Urinary potassium concentration showed initial decrease and subsequent increase in course of time after furosemide administration and it resulted in a gradual increase in urinary potassium/sodium ratio. 3. Studying the relations between urinary aldosterone excretion and potassium/sodium excretion ratio, or sodium excretion were meaningless because of the urinary flow rate after the injection was decreased with time course. 4. Furosemide administration showed a good relationship of urinary aldosterone concentration to concurrent potassium/sodium ratio rather than concurrent sodium concentration in subjects with sodium restriction, but no meaningful relationship was detected in subjects with high sodium intake because increasing rate of the ratio was not so wide. 5. Furosemide also resulted a reasonable relation of plasma aldosterone concentration to concurrent urinary aldosterone concentration especially during low sodium intake. 6. Above results suggested that relation of urinary aldosterone concentration to K/Na ratio following furosemide administration during sodium restriction is significant and has a benefit to reduce the variation induced by kalemic change showing in the diragram for daily aldosterone to sodium excretion.

• Journal of Korea Foundry Society
• /
• v.2 no.3
• /
• pp.16-24
• /
• 1982

For the purpose of development of domestic carburizer, when the basicity of ash in carburizer was changed from $Na_2O/Al_2O_3+SiO_2$ ; 0.06 to $Na_2O/Al_2O_3+SiO_2$ ; 0,196wt%, using $Na_2O$ as flux for domestic graphite resource (Bong Myung armorphous graphite), carburizing efficiency was improved as basicity increased, optimum basicity value was $Na_2O/Al_2O_3+SiO_2$ ; 0.151. This means that $Na_2O$ contributed to lower viscosity of slag and raise occurence probability of specific reaction surface between molten iron and carburizer. The experiment of effect of general characteristics offecting carburizing ability of this carburizer was performed, the result is that 10/30 mesh was optimum size of the carburizer and as carbon equivalent of molten iron was higher, carburizing ratio was lowered, but when si concentration was below 1.8% in general cast iron melting region, recovery showed 75-85%. As agitation rate of molten iron and temperature interval were higher, Carburizing ratio was increased and showed max, 94%. Desulfurizing phenomena of molten iron by $Na_2O$ in carburizer didn't appear.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.2
• /
• pp.74-79
• /
• 2015

$Na-ZnCl_2$ battery, which operates as the same mechanism of $Na-NiCl_2$ battery using solid-electrolyte, is able to reduce its material cost by 40 % comparing to the $Na-NiCl_2$ battery. It has been known that the $Na-ZnCl_2$ battery produces $Na_2ZnCl_4$ as an intermediate phase during charge/discharge process. Therefore, the redox process is divided into four steps having the voltage range of 1.92~2.13 V. However, effects of the critical factors such as the composition of cathode materials, depth of charge and discharge, and additives have not been reported yet. We examined the effect of the Zn/NaCl ratios and revealed that its optimum ratio was in the range of 1.3~1.7.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.2 no.4
• /
• pp.360-366
• /
• 2014

In this study, effect of types and replacement ratio of alkali activator on compressive strength of ground granulated blast furnace slag mortar has been reviewed. Types of alkali activator are NaOH, $Ca(OH)_2$, $Na_2SO_4$, and KOH. Replacement ratio of alkali activator is 7.5, 10, 12.5, and 15%, respectively. As results, under high temperature curing condition, 1 day compressive strength development with NaOH and KOH was higher than that of $Ca(OH)_2$ and $Na_2SO_4$. Regardless of types of alkali activator, compressive strength increased with increasing pH. This can be explained by the fact that impermeable film on the surface of slag which is generated when slag contacts water has been destroyed by alkali activator, and this promotes hydration reaction. Also, 1 day age compressive strength of specimen with high temperature curing was higher than that of specimen with standard curing. 28 days age compressive strength of specimen with high temperature curing was less than or equal to that of specimen with standard curing.

• Analytical Science and Technology
• /
• v.12 no.1
• /
• pp.13-21
• /
• 1999

Silicate used as laundry detergent builder was good for pH buffering capacity and solubility but calcium-ion binding capacity and surfactant adsorption ability were lower. As $SiO_2/Na_2O$ molar ratio became higher, pH buffering capacity and ion exchange ability were lower and surfactant adsorption ability was little higher. Anionic surfactant LAS (linear alkylbenzene sulphonate), nonionic surfactant LA-9 (lauryl alcohol EO-9) were used to investigate the detergency performance. Zeolite was better than sodium silicate in detergency performance. In case of LAS, detergency performance was good when $SiO_2/Na_2O$ molar ratio was lower. In case of LA-9, detergency performance was similar without discrimination of molar ratio of $SiO_2/Na_2O$.

• Resources Recycling
• /
• v.26 no.6
• /
• pp.91-96
• /
• 2017

Tungsten (W) recovery from tungsten carbide (WC) was researched by alkali melt followed by water leaching. The experiments of alkali melt were carried out with the change of the sort of alkali material, heating temperature, and the heating duration. Water leaching of W was performed in the fixed conditions ($25^{\circ}C$, 2 hr., slurry density: 10 g/L). From the mixture of WC and sodium nitrate ($NaNO_3$) in the molar ratio of 1:2, treated at $400^{\circ}C$ for 6 hours, only 63.3% of W might be leached by water leaching. With the increase of sodium hydroxide (NaOH) as a melting additive, the leachability increased. Finally it reached to 97.8 % with the melted mixture of ($WC:NaNO_3:NaOH$) in the ratio of (1:2:2). This imply that NaOH may play a role as a reaction catalyst by lowering Gibb's free energy for alkali melt reaction for WC.

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.1
• /
• pp.23-27
• /
• 1997

Alkali-soluble extracts were prepared from barks of Japanese larch(Larix leptolepis). Siberian larch(Larix gmelineii) and Radiata pine(Pinus radiata) The effect of various factors, such as particle size, liquor ratio, extraction temperature, and reaction time, on the extracts yield was investigated. Particle sizes affected the alkali-soluble extracts; the finer the particle size, the higher extracts and extract efficiency. High temperature and high liquor ratio were more effective. In the range of 0.25% to 1% NaOH concentration, alkali extracts were increased with the increasing alkali concentration. However, extract yields were leveled off above 0.5% alkali concentration. Extractions with NaHCO3 were almost equivalent to those of NaOH extraction. 1% NaOH and 1% NaHCO3 resulted in the highest yields of alkaline extracts. Extracts from Japanese larch were lower than those from Siberian larch and Radiata pine barks. Siberian larch bark was the best raw material for tannin adhesives, because its extractive yield was higher than those of the other barks. Concerning pH of alkaline media during extraction, small increases of the extract yields were resulted at range of pH 7 to pH 9, while a large increases from pH 9.0 to pH 12. This phenomenon is attributed to higher alkalinity.

• Journal of Nutrition and Health
• /
• v.32 no.6
• /
• pp.661-670
• /
• 1999

Effects of Ca supplementation on blood pressure(BP) response to dietary Na level were studied in 15 normotensive healthy college women with family history of hypertension. All subjects, randomly divided into 3 groups, ate low Na diet(1816mg/day) prepared in the laboratory during the first 2 weeks and normal Na diet(4064mg/day) of their own home for the next 8 weeks. The one group received daily 1g Ca supplement at both low and normal Na diet periods, the second group took daily 1g Ca supplement only at normal a diet period, and the last group took placebo during both periods. Average Ca and energy intakes at the basal of and during the trial ranged 450-600mg and 1735-1878kcal, respectively. Systolic/diastolic BP was decreased by 9.2-9.8/4.4-4.5 mmHg during low Na diet period and was increased again during next normal Na diet period. However simultaneous Ca supplementation during both low and normal Na diet period suppressed the elevation of systolic/diastolic BP occurred at normal Na diet period. Ca supplementation only at normal Na diet peroid did not affect the BP elevation. The increase of serum Ca and Ca/Mg ratio and the decrease of serum Na and Na/K ratio might be related to the BP lowering effects of Ca supplementation. In conclusion, Ca supplement could attenuate BP elevation induced by increasing Na intake. The BP lowering effect of Ca supplementation was not appeared at low Na intake. Further studies were needed to make it certain. Low Na intake was also confirmed as an effective diet control for lowering blood pressure.

• Applied Chemistry for Engineering
• /
• v.30 no.6
• /
• pp.749-756
• /
• 2019

Na-X and Na-A zeolites that give high adsorption capacity for heavy metals in an aqueous system were synthesized from the coal fly ash obtained from a thermoelectric power plant using a fusion method. The characteristics and Cu(II) adsorption capacity of the synthetic zeolites were also compared to those of using a commercial zeolite. For the selection of optimum conditions of zeolite synthesis, the effects of major parameters in the fusion method such as a dosage ratio of NaOH, aging time, hydrothermal reaction time, and also the dosage ratio of NaAlO₂ (Na-A) on the characteristics and Cu(II) adsorption capacity of the synthetic zeolites were studied. For the analysis of characteristics of the synthetic zeolites, X-ray diffraction (XRD), cation exchange capacity (CEC), Brunaue-Emmett-Teller (BET) and scanning electron microscopy (SEM) were used. The optimum conditions for the synthesis of zeolites with a high adsorption capacity for cationic heavy metals including Cu(II) were the aging time of 6 h, hydrothermal reaction time of 6 h and NaOH and NaAlO₂ dosage ratio of 1.5 and 0.5 (Na-A), respectively. According to the Langmuir isotherm test, maximum Cu(II) adsorption capacities of the synthetic and commercial Na-X and Na-A zeolites were found to be 90.1, 105.26, 102.05, and 109.89 mg/g, respectively. This indicates that the adsorption capacity of synthetic zeolites was comparable to commercial ones. The results of this study also suggest that the coal fly ash can be potentially used as a raw material for the zeolite synthesis.