• 대한기계학회논문집
• /
• 제19권2호
• /
• pp.559-567
• /
• 1995

The combustion process within a porous inert medium (PIM) burner is numerical studied. A detailed chemical reaction scheme including thermal and prompt NO$_{x}$ reactions is used to predict the formation and destruction of pollutants such as NO$_{x}$ and CO. The reaction paths for NO$_{x}$ formation are divided to quantify the amount of NO$_{x}$ formed through thermal NO$_{x}$ reaction or through prompt NO$_{x}$ reaction. Emission index is calculated to compare the actual mass of NO$_{x}$ or CO produced through the combustion of unit mass of fuel. It is found NO formation in PIM burner is confined in flame zone and formation is suppressed due to heat loss at down-stream of the flame. Higher production of NO through prompt NO reaction path is observed due to the higher concentration of fuel derivative species and its higher diffusion at flame front. For all equivalence ratios, CO emission within PIM burner is lower than that from the one-dimensional freely-propagating flame. PIM burner flame has better NO$_{x}$ emission index from .psi. = 0.75 to .psi. = 1.1. to .psi. = 1.1.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2001년도 제23회 KOSCO SYMPOSIUM 논문집
• /
• pp.73-82
• /
• 2001

The characteristics of the catalytically supported thermal combustion with Pd-based catalyst using the bench scale high pressure combustor has been investigated up to 7 atm. The emission of $NO_{\chi}$ depends on the preheating temperature and the excess air ratio. Most $NO_{\chi}$ emission seems to come from the pre-burner for the preheating of the inlet gas. Decreasing excess air ratio in the inlet gas below 1.5 results in the stable catalytically supported thermal combustion in the post combustion region while the $NO_{\chi}$ emission increased up to 15 ppm. Further, the increase of the pressure shows the dramatic increase of the emission CO and THC. However, the $NO_{\chi}$ emission decreased slightly due to the lower combustion temperature at the high pressure.

• 한국연소학회지
• /
• 제9권4호
• /
• pp.22-27
• /
• 2004

Lean premix combustion is a best method in low $NO_x$ gas turbine combustor and we must know the characteristics of NO emission in high temperature and pressure condition in premix flame. Numerical analysis was performed to investigate the NO emission characteristics by adopting a counterflow as a model problem using detailed chemical kinetics. Methane $(CH_4)$ was used as a test fuel which is the main fuel of natural gas. The tested parameters were stretch rate, equivalence ratio, initial temperature, and pressure in premix flame. Results showed that NO emission was high in low stretch rate, near stoichiometric equivalence ratio, high initial temperature, and high pressure. Also, the pressure effect was sensitive in high temperature condition.

• 한국자동차공학회논문집
• /
• 제10권3호
• /
• pp.77-84
• /
• 2002

Measurements of NO and NOx emission of laminar partially premixed LPG/air flames with and without acoustic excitation are reported. The NOx emission at the tailpipe of a combustion chamber is determined by chemiluminescent analyser. The NOx measurements are taken in flames with several different center tube equivalance ratio( ø$\sub$o/), and overall equivalace ratio(ø$\sub$o/) for a fixed fuel flowrate. The NOx emission decrease to reach a minimum value at an optimum ø$\sub$c/ 2. Theø$\sub$c/ 2 flame gives a compromise of thermal NO and prompt NO mechanism. In the case of excitation. the visual shape of the flame is changed from laminar flame to turbulent-like flame. With increasing levels of excitation amplitude, an optimum value of the NO and NOx emission exists. A shorter flame caused by the enhanced upstream mixing due to acoustic excitation results in the reduction of NO and NOx emission in the present flames. The reduction of flame length affects the shorter residence time of center tube mixture, and significantly influences the NOx reduction.

• 한국화재소방학회논문지
• /
• 제18권2호
• /
• pp.34-40
• /
• 2004

층류 비예혼합 분류 화염에서 다양한 주파수와 강도로 외부에서 유동장에 자극을 주었을 때 화염의 배출특성과 거동에 대해서 실험적으로 조사하였다. 먼저 일정한 관 공명 주파수에서 가진 강도를 가변시켜 난류화염 된 부상화염에서 질소산화물 배출 지수($EINO_x$)를 측정하였다. 또한, 가진 강도가 일정한 상태에서 주파수를 0 Hz에서 높은 주파수인 2 KHz까지 다양한 주파수 조건으로 가진된 한 경우에도 질소산화물의 배출지수를 측정하였다. 큰 가진 강도의 관공명 주파수로 가진된 경우 부상된 난류화염에서 $NO_x$ 배출 특성은 다음과 같이 크게 세 가지 형태의 특성을 보였다. Group I의 화염에서는 공간적인 섭동이 크며 비교적 화염길이가 길고 높은 $NO_x$ 배출 특성을 보였으며 Group II에서는 상대적으로 짧은 길이와 좁은 폭의 화염거동에 낮은 $NO_x$배출 특성을 보였다. Group III에서는 약간 긴 화염길이에 매우 큰 화염체적으로 상당한 높이까지 시ㆍ공간적으로 섭동이 큰 운동양태로 부상되는 거동과 가장 높은 $NO_x$ 배출 특성을 보였다.

• 한국대기환경학회지
• /
• 제7권1호
• /
• pp.31-40
• /
• 1991

This study shows the correlation between $NO_x$ emission in the exhaust gas and various operation factors of dual fuel engine for Co-generation system. General tendency was shown that the thermal efficiency was lowered by the change of operation factors. However these were not confirmed on this experiment. Increasing T4 temperature (exhaust gas temperature at turbo-charger inlet) reduces $NO_x$ emission rate. The higher T4 temperature requires lower excess air as the excess air ratio is controlled by T4 temperature on gas mode operation. Another tendency was that $NO_x$ emission rate is reduced in case of increasing boost air temperature, quantity of pilot oil or bypassing flue gas through the exhaust gas boiler. The diameter of the fuel injection nozzle was changed smaller than design value and the injection timing was readjusted. Thus $NO_x$ emission rate could be reduced as retarding injection timing and changing hole diameter of fuel injection nozzle, however maxium engine out-put was decreased by changing fuel nozzle on the diesel mode operation.

• 한국환경과학회지
• /
• 제20권5호
• /
• pp.599-610
• /
• 2011

Emission of air pollutants such as nitrogen oxides ($NO_x$), hydrocarbons (HC), $SO_2$, and particulate matter (PM) and $CO_2$ from ship during 2009 in Busan port was estimated based on activity-based method. The significant fraction (> 50%) of ship emission resulted from container and general cargo ships. Emission at port operation mode was the most dominant compared to at sea and maneuvering modes. Emission at North port was the largest source of air pollutants among ports. The magnitudes of air pollutants $NO_x$, $SO_2$, HC, $CO_2$, and PM in Busan port were $8.7{\times}10^3$, $8.23{\times}10^3$, $0.35{\times}10^3$, $4.86{\times}10^6$, and $0.67{\times}10^3$ ton/yr, respectively. The ratio of $NO_x$ to VOC is about 25. Our ship emission estimate is 2 times higher than that in CAPSS emission inventory.

• 한국대기환경학회지
• /
• 제28권1호
• /
• pp.94-104
• /
• 2012

The purpose of this research is to quantify the compliance of on-road emission from a light duty diesel vehicle, based on a comparison to emission regulation standard. $NO_x$, CO and THC emissions were measured using a portable device on a selected real-world driving route with a length of approximately 22 km. On-road measurements were repeated by 10 times on a same route to reflect variability in traffic conditions. A test route was divided into 22 road links with length of 1 km to analyze emission results with higher spatial resolution. The average emissions of $NO_x$, CO and THC over total travel distance, which is approximately 220 km, were quantified to be in compliance with emission regulation standards. Under higher spatial resolution, $NO_x$ concentration exceeded a standard in 92 links out of 220 links. The extended time in stop period and the stop-and-go driving cycle were identified as two important reasons for increased $NO_x$ emissions in observed cases. Heavy traffics showed higher $NO_x$ emissions than free flow. These results indicate that the real-world vehicle emissions might exceed the compliance level associate with traffic conditions. Another interesting observation of this research is that the on-road emission characteristics can be independent to the average speed of road links with higher spatial resolution. Variability in on-road emission might not be fully described by solely relying on an average speed, because variability in traffic conditions and road conditions can influence on real-world vehicle emissions.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2006년도 제32회 KOSCO SYMPOSIUM 논문집
• /
• pp.63-68
• /
• 2006

Effects of oxidizer inlet velocity on NO emission characteristics of 0.2MW oxy-fuel combustor have been experimentally investigated. The NO formation process in the oxy-fuel combustion is extremely sensitive even for the small fraction of nitrogen in oxidizer. By increasing the oxidizer velocity, flame length is reduced due to the enhanced turbulent mixing. The increased oxidizer velocity also results in the decreased flame temperature through the elevated entrainment rate of the recirculated product and the corresponding NO emission is drastically decreased. Experimental results clearly indicate that the entrained product gases play a crucial role to decrease the temperature at the flame zone and the post flame zone where the thermal NO is mainly formed.

• 한국초지조사료학회지
• /
• 제44권2호
• /
• pp.133-139
• /
• 2024

This study aimed to evaluate the efficiency of combining acidification with adsorbents (zeolite and biochar) to mitigate the environmental impacts of pig slurry, focusing on ammonia (NH₃) emission and nitrate (NO₃^-) leaching. The four treatments were applied: 1) pig slurry (PS) alone as a control, 2) acidified PS (AP), 3) acidified pig slurry with zeolite (APZ), and 4) acidified pig slurry with biochar (APB). The AP mitigates NH₃ emission and NO₃^- leaching compared to PS alone. Acidification reduced the cumulative NH₃ emission and its emission factor by 35.9% and 12.5%, respectively. The APZ and APB increased NH₄⁺-N concentration, with the highest level in APB, compared to AP. The NH₄⁺ adsorption capacity of APB (0.90 mg g^-1) was higher than that of APZ (0.63 mg g^-1). The APB and APZ treatments induced less NH₃ emission compared to AP. The cumulative NH₃ emission was reduced by 12.2% and 27.6% in APZ and APB, respectively, compared to AP treatment. NO₃^- leaching began to appear on days 12 and 13, and its peak reached on days 16 and 17, which were later than AP. The cumulative NO₃^- leaching decreased by 17.7% and 25.0% in APZ and APB, respectively, compared to AP treatment. These results suggest that combining biochar or zeolite with acidified pig slurry is an effective method to mitigate NH₃ emission and NO₃^- leaching, with biochar being particularly effective.