• Journal of the Korean Magnetics Society
• /
• v.4 no.2
• /
• pp.135-141
• /
• 1994

With the variation of Cr content and $N_2$ flow ratio, the soft magnetic properties, corrosion resistance and reactivity of the sputtered nanocrystalline FeZrCrN thin flims were investigated. In case of FeZrCrN thin films, a saturation magnetization was decreased with increasing $N_2$ flow ratio. In addition, good soft magnetic properties were obtained at the flow ratio of 3% $N_2$. The $Fe_{64.9}Zr_{8.8}Cr_{5.8}N_{20.5}$ nanocrystalline thin film after annealing at $550^{\circ}C$ exhibited the saturation magnetization of 12.5kG, low coercivity of 0.4 Oe and high permeability of 2600 at 5 MHz. Films containing up to 7.5% Cr showed an enhanced corrosion resistance and reduced reactivity with the bonding glass without degradation of soft magnetic properties, although the saturation magnetization was decreased slightly with the Cr addtion.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.1
• /
• pp.77-82
• /
• 2013

The growth and removal capacity of nitrogen and phosphorus of Chlorella vulgaris were evaluated in artificial wastewater with different nitrogen and phosphorus concentrations as element growing components for microalgae growth. The nitrogen concentration was varied in 9, 15, 30 and 60 mg-N/L with fixed phosphorus concentration of 3 mg-P/L. The growth and phosphorus removal capacity of C. vulgaris were high at initial nitrogen concentration of 15 and 30 mg-N/L, and the corresponding N/P ratios calculated were 5 and 10. In the case of varying in 1.5, 3, 6 and 10 mg-P/L of phosphorus concentration with fixed nitrogen concentration of 30 mg-N/L, the growth and removal capacity of nitrogen and phosphorus were excellent with phosphorus concentration of 3 and 6 mg-P/L. The corresponding N/P ratios were shown as 10 and 5. Therefore, the appropriate N/P ratio was concluded between 5 and 10 for wastewater treatment using C. vulgaris.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.31 no.5
• /
• pp.1-10
• /
• 2003

The purpose of this study was to verify the shore margin protection effect of a root system developed from direct sticking of Salix gracilistyla Miq., focusing on the reinforcement of soil shear strength. The materials were 20cm long sticks whose average diameter and weight were 7.52mm and 14.58g respectively, and sandy loam(Sand 60.36%, Silt 28%, Clay 11.64%), whose maximum dry weight(${\gamma}$$_{dmax}$) was 1.59gf/㎤ at the water ratio( $W_{opt}$) 13.8%. The direct shearing test(KS F 2343) was applied to cylindric columms(diameter 132mm) of pure soil and two years old root reinforced soil. At each condition of vertical stress, 10N/$ extrm{cm}^2$, 14.41N/$\textrm{cm}^2$ and 18.82 N/$\textrm{cm}^2$, five soil+root columns were sheared. After shear tests, the root area ratio and soil moisture on the shear plane were measured. The results of this research were as follows: 1. The average of root area ratio was 1.86% and the soil moisture 14.67%. 2. Two years old root system was found to increase the soil shear strength of pure soil in terms of Cohesion(C) and Inner friction Angle($\phi$) as follows. 3. The relationship between root area ratio and the increased shear strength can be presented with the following equation, $\Delta$S ≒ 0.33ㆍ TrㆍAs/A $\Delta$S : Increased Shear Strength Tr : Average Tension Strength of Root, Ar/A : Root Area Ratioioage Tension Strength of Root, Ar/A : Root Area Ratio

• Journal of Environmental Science International
• /
• v.16 no.11
• /
• pp.1271-1277
• /
• 2007

This study was conducted to investigate the ratios of phosphorus release to COD uptake, phosphorus release to nitrate removal, and phosphorus uptake to phosphorus release by DNPAOs(denitrifying phosphate accumulating organisms). In case $I{\sim}IV$, influent 1 were fed with synthetic wastewater with influent 2 $NO_3^--N$ injection to anoxic zone and the case V were fed with municipal wastewater with side stream oxic zone instead of influent 2 $NO_3^--N$ injection. As a result, the ratio of phosphorus release to carbon uptake was increased in accordance with nitrate supply. The DNPAOs simultaneously took up phosphate and removed nitrate from the anoxic reactor. In case $I{\sim}IV$, with above 20 mg/L of sufficient $NO_3^--N$ supply, phosphate was taken up excessively by the DNPAOs in anoxic condition. The large amount of both uptake and release of phosphorus occurred above 20 mg/L of nitrate supply, achieving the ratio of phosphorus uptake to phosphorus release to be 1.05. In case V, phosphate luxury uptake was not occurred in system due to 6.98 mg/L of insufficient $NO_3^--N$ supply and the ratio of phosphorus uptake to phosphorus release was 0.98. Consequently, if nitrate as the electron acceptor was sufficient in anoxic zone, the ratio was found to be high.

• Korean Journal of Community Nutrition
• /
• v.1 no.3
• /
• pp.335-345
• /
• 1996

The solids(supplementary food) consumption of 200 healthy infants aged from 4 to 6 months have been measured. Five groups were assigned to different feeding patterns. Breastfed group(BF, n=38), formula-fed group(FF, n=102) and mixed-fed group(MF, n=14) were fed breast milk, formula and mixed(breast mile+formula) from birth until 6 months of age respectively. Convert 1 group(C1F, n=14) and convert 2 group(C2F, n=32) were fed breast milk and mixed milk at 2 months of age respectively and were switched to formula thereafter. All infants received solids form 4 months of age. The energy intake from solids at 4 and 6 months averaged 59.1 and 110.3㎉/d among BF groups vs 151.9 and 239.3㎉/d among FF groups respectively. Intakes of protein, calcium and iron were 38-46$\%$, 34-44% and 25-37$\%$ higher in the FF than in the Bf group during the first 6 months. However, no significant differences were found in the intakes of energy and nutrient intakes from solids in all 4 groups excluding BF group(39$\%$). Although BF infant's nutrient intakes from solids were lower than other group's intakes, they intaked evenly solids from various food groups. As the age of infant had increased, the energy intake ratio from solids was cereals and dairy products was increased whereas energy intake ratio from meats, eggs, fruits and vegetables was decreased. TSC4, TSC6(the frequency score for the kinds of weaning food taken) showed no significant difference among 5 feeding groups but CIF-and C2F group's scores tended to be high. Consequently, these results suggest that BF group's solid intake pattern is more desirable and that Korean lactating Mother's dependence on commercial weaning food is too high.

• Magazine of the Korea Concrete Institute
• /
• v.4 no.1
• /
• pp.81-87
• /
• 1992

In this thesis, the fatigue tests were performed on a series of SFRC(steel fiber reinforced concrete) to investigate the fatigue behavior of SFRC varying with the steel fiber contents and the steel fiber aspect ratios. The three point loading system is used in the fatigue tests. In tl1ese tests, relations between the repeated loading cycles and the mid-span deflections, number of repeated loadmg cycles when specimen was fractured were observed. On this basis, the mid-span deflections, the elastic strain energy and inelastic strain energy of SFRC were studied. A S - N curve \vas drawn to present the fatigue strength of SFRC beam. From che test results, by increasing the steel fiber content the energy lost on the permanent deformation decreases and the energy spent on crack growth increases. But in case of SFRC with the same steel fiber content the higher the steel fiber aspect ratio is, the less the elastic strain energy is. According to S - N curve drawn by the regression analysis on the fatugue test results, the fatigue strength with 2,000,000 repeated loading cycles in SFRC with the steel fiber content is 1.0% shows about 70% on the first crack static flexural strength.

• Journal of Crop Science and Biotechnology
• /
• v.10 no.3
• /
• pp.193-200
• /
• 2007

Mungbean plants generally have a relatively close canopy, thus a large amount of self-shading can reduce yield due to poor light penetration. Modification of leaflet type can affect leaf canopy and could alter seed yield. Two multiple leaflet mutants were obtained from gamma-ray irradiation and used to study the mode of inheritance related to leaflet types and to evaluate their agronomic features. The cross between large-heptafoliate leaflet with small-pentafoliate leaflet mutants produce all $F_1$ plants with normal trifoliate leaflets. The $F_2$ plants segregated in leaflet size and leaflet number into a 9:3:3:1 ratio of large-trifoliate: large-heptafoliate: small-pentafoliate: small-heptafoliate plants, suggesting that independent loci control leaflet size and leaflet number. Regarding leaflet number, the $F_2$ population can be classified into normal-trifoliate, small-pentafoliate, large-heptafoliate, and small-heptafoliate at the dihybrid ratio of 9:3:3:1. The gene symbols $N_1,n_1$ and $N_2,n_2$ are proposed to represent leaflet number. Since no plant was found with large-pentafoliate leaflets, we hypothesize that the $N_2$ allele expresses pleiotropic effect on both leaflet number and leaflet size. Another possibility is that an additional locus with S and s alleles controls leaflet size and S is tightly linked with $N_2$. The effect of multifoliate leaflet on yield and yield components was evaluated in four mungbean families each with four leaflet isolines under three environments. Averaging across the families and environments, the normal-trifoliate and large-heptafoliate lines gave higher yield than small pentafoliate and heptafoliate ones. These two large leaflet lines also had higher leaf area per plant than the other multifoliate lines. Therefore, the mungbean lines with a greater leaf area, which were likely to intercept more sunlight, gave greater yield. Three AFLP markers that were found to be linked to number of leaflets per leaf, corresponded to the N1 allele of the smallpentafoliate parent.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.4
• /
• pp.295-306
• /
• 2013

The purpose of this study was to provide high school male shot putters training methods of gliding and delivery motion through comparative analysis of kinematic characteristics. To accomplish this purpose, three dimensional motion analysis was performed for the subjects(PKC, KKH, YDL) who participated in high school male shot putter competition on 92nd (2011), 93rd (2013) National Sports Festival. The subjects were filmed by four Sony HXR-MC2000 video cameras with 60 fields/s. The three-dimensional kinematic data of the glide, conversion and delivery phase were obtained by Kwon3d 3.1 version. The data of the shoulder rotational angles and projection angles were calculated with Matlab R2009a. The following conclusions had been made. With the analysis of the gliding and stance length ratio, the gliding length was shorter at the TG than the SG with short-long technique but the gliding and stance length ratio was 46.8:53.2% respectively. The deviation of the shots trajectory from APSS(Athlete-plus-shot-system) revealed that the PKC showed similar to "n-a-b-c-I" of skilled S-shape type, KKH and YDL showed "n-a-d-f-I'" of unskilled type. Furthermore, they showed smaller radial distance from the central axis of the APSS and the shots were away from the linear trajectory. From this characteristics, The PKC who performed more TG than SG had shorter glide with S-shape of APSS(skilled type) showed the better record than others with technical skill. But KKH and YDL had bigger glide ratio with "n-a-d-f-I'" of unskilled type and improved their records with technical factor. The projection factor had an effect on the record directly. Because PKC maintained more lower glide and transition posture with momentum transfer through COG's rapid horizontal velocity respectively the subject possessed the characteristics of high horizontal and vertical velocity with large turning radius from shot putter to APSS.

• The Journal of the Acoustical Society of Korea
• /
• v.12 no.2
• /
• pp.5-13
• /
• 1993

The purpose of this paper is to suggest and analyze the parallel algorithm for merging two heaps, on SIMD-SM-R parallel computer. In order to create the parallel algorithm for merging two heaps, we have classified two subproblems. For the first method, to select node p as a LEVEL-FIND function, Wyllie(19) suggests the method with time complexity O(log n) while this thesis has O(log(n/k)). For the second method, to merge two subheap, our algorithm has O(log(n/k)*log(n)) using max(2**(i-1), 「(m+1)/4」)'s processors while Dekel and Sahni(4)'s method and Hong's method(18) have O(log m). Also our parallel algorithm's EPU is close to 1 and so has an optimal speed-up ratio.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2010.05a
• /
• pp.855-856
• /
• 2010