• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.5
• /
• pp.443-450
• /
• 2013

We consider user pairing and resource allocation for the uplink of cellular systems employing virtual multiple input multiple output (MIMO). As a multiple access scheme, discrete Fourier transform spread orthogonal frequency division multiple access (DFTS-OFDMA) is adopted for more flexible resource allocation than single carrier (SC)-OFDMA adopted in the Long Term Evolution (LTE) system. We formulate the optimization problems of user pairing and resource allocation to maximize the throughput of the DFTS-OFDMA system under different constraints. The DFTS-OFDMA allowing non-contiguous subcarrier allocation and redundant user assignment provides a better throughput than the SC-FDMA at lower complexity in finding the optimal solution but at the cost of the increased control information indicating the allocated resources.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.12
• /
• pp.1061-1068
• /
• 2013

In this paper, we propose a $M{\times}M$ beam-space multiple input multiple output (BS-MIMO) system using electronically steerable parasitic array radiator (ESPAR) antenna. Conventional MIMO method required multiple RF chains because it map the transmission signals onto multiple antennas. So, conventional MIMO system has high cost for design and high energy consumption at RF circuit. Also, It is difficult to use MIMO system in battery based mobile terminals with limited physical area. In order to solve these problems, BS-MIMO technique which map the data signal onto bases in beam space domain was proposed using ESPAR antenna with single RF chain. This paper, we design and analyze the performance of extended $M{\times}M$ BS-MIMO technique. Simulation results show that the proposed BS-MIMO system has similar BER performance compare to conventional MIMO scheme. Therefore, BS-MIMO system with single RF chain will has a low RF power consumption and low cost for RF hardware design as compared with conventional MIMO technique with multiple RF chains.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.1022-1030
• /
• 2004

The next generation cellular radio systems require high data rate transmission and large system capacity In order to meet these requirements, multiple antennas can be used at the base and mobile stations, forming MIMO(multiple-input, multiple-output) channels This paper considers a downlink MIMO system assuming a large number of base station antennas, a small number of mobile station antennas, and rich-scattering, quasi-stationary, and flat-fading channel environments When the channel state information is given at the base station in a single user system, a MIMO technique with SVD(singular value decomposition) and water-filling can achieve the maximal downlink channel capacity. In multi-user environments, however, SDMA(space division multiple acces) technique can be used to further increase the total channel capacity supported by the base station This paper proposes a MIMO SDMA technique which can transmit parallel data streams to each of multiple users. The proposed method. can achieve higher total channel capacity than SVD-based MIMO techniques or conventional SDMA using smart antennas.

• Journal of Multimedia Information System
• /
• v.3 no.4
• /
• pp.141-148
• /
• 2016

This paper proposes a medium access control (MAC) protocol for multiple-input multiple-output (MIMO) ad-hoc networks. Multiple-packet receptions in MIMO systems have attracted as a key technique to achieve a high transmission rate. In the conventional protocols for multiple-packet receptions, timing offsets among multiple-frame transmissions cause frame collisions induced by hidden nodes, which degrades network performance. In the proposed protocol, transmission synchronization among hidden nodes can be achieved by applying pulse/tone exchanges. By applying the pulse/tone exchanges, multiple-packet receptions among hidden nodes can be achieved, which enhances network throughputs compared with the conventional protocol. Simulation results show effectiveness of the proposed protocol.

• Structural Engineering and Mechanics
• /
• v.27 no.5
• /
• pp.527-540
• /
• 2007

The modal controller of single-input system cannot stabilize the defective system with positive real part of repeated eigenvalues, because some of the generalized modes are uncontrollable. In order to stabilize the uncontrollable modes with positive real part of eigenvalues, the multi-input system should be introduced. This paper presents a recursive procedure for designing the feedback controller of the multi-input system with defective repeated eigenvalues. For a nearly defective system, we first transform it into a defective one, and apply the same method to manage. The proposed methods are based on the modal coordinate equations, to avoid the tedious mathematic manipulation. As an application of the presented procedure, two numerical examples are given at end of the paper.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.12C
• /
• pp.1044-1051
• /
• 2010

In this paper, we propose an efficient soft-output signal detection method for spatially multiplexed multiple input multiple output (MIMO) systems. The proposed method is based on the ordered successive interference cancellation (OSIC) algorithm, but it significantly improves the performance of the original OSIC algorithm by solving the error propagation problem. The proposed method combines this enhanced OSIC (ESIC) algorithm with a multiple ordering technique in a very efficient way. As a result, the log likelihood ratio (LLR) values can be computed by using a very small set of candidate symbol vectors. The proposed method has been implemented with a $0.13{\mu}m$ CMOS technology for a $4{\times}4$ 16-QAM MIMO system. The simulation and implementation results show that the proposed detector provides a very good solution in terms of performance and hardware complexity.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.5
• /
• pp.10-22
• /
• 2015

Recently, 3rd Generation Partnership Project (3GPP) has developed sidehaul system to cope with the explosively increasing mobile data traffic. The sidehaul system is based on single carrier-frequency division multiple access (SC-FMDA) due to its low peak to average power ratio (PAPR). Also, antenna array is designed to support multiple input multiple output (MIMO) in a restricted space. In this paper, we design the antenna array about uniform linear array (ULA), uniform circular array (UCA) and uniform planar array (UPA), and analysis the performance in sidehaul system. In addition, we propose the novel hybrid receiver full suppression cancellation (FSC) to reduce the interference from neighbor cell in sidehaul system. The proposed receiver can suppress and cancel the interference by combining interference rejection combining (IRC) with successive interference cancellation (SIC).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.6
• /
• pp.464-472
• /
• 2018

Future spaceborne satellite synthetic aperture radar(SAR) system is expected to acquire high-resolution images over wide swath areas. Conventional SAR systems suffer from ambiguity problems in both azimuth and range directions that lead to image quality degradation. Recently, multiple input multiple output(MIMO) SAR techniques having multiple orthogonal waveforms are proposed to overcome the conventional ambiguity problems in wide-swath imaging modes. In this paper, noisy orthogonal frequency division multiplex(OFDM) waveforms are developed to reduce the ambiguity problems and suppress the image quality degradation. SAR simulations are performed to evaluate the performance of the proposed technique for wide-swath SAR imaging.

• Journal of Communications and Networks
• /
• v.16 no.4
• /
• pp.447-457
• /
• 2014

In this paper, we investigate the frequency domain channel estimation for multiple-input multiple-output (MIMO) single-carrier frequency-division multiple-access (SC-FDMA) systems. In MIMO SC-FDMA, code-division multiplexed (CDM) pilots such as cyclic-shifted Zadoff-Chu sequences have been adopted for channel estimation. However, most frequency domain channel estimation schemes were developed based on frequency-division multiplexing of pilots. We first develop a channel estimation error model by using CDM pilots, and then analyze the mean-square error (MSE) of various minimum MSE (MMSE) frequency domain channel estimation techniques. We show that the cascaded one-dimensional robust MMSE (C1D-RMMSE) technique is complexity-efficient, but it suffers from performance degradation due to the channel correlation mismatch when compared to the two-dimensional MMSE (2D-MMSE) technique. To improve the performance of C1D-RMMSE, we design a robust iterative channel estimation (RITCE) with a frequency replacement (FR) algorithm. After deriving the MSE of iterative channel estimation, we optimize the FR algorithm in terms of the MSE. Then, a low-complexity adaptation method is proposed for practical MIMO SC-FDMA systems, wherein FR is performed according to the reliability of the data estimates. Simulation results show that the proposed RITCE technique effectively improves the performance of C1D-RMMSE, thus providing a better performance-complexity tradeoff than 2D-MMSE.

• The KIPS Transactions:PartB
• /
• v.17B no.3
• /
• pp.233-238
• /
• 2010

In this paper, we propose a multiple classifier combination method based on image degradation modeling to improve recognition performance on low-quality images. Using an image degradation model, it generates a set of classifiers each of which is specialized for a specific image quality. In recognition, it combines the results of the recognizers by weighted averaging to decide the final result. At this time, the weight of each recognizer is dynamically decided from the estimated quality of the input image. It assigns large weight to the recognizer specialized to the estimated quality of the input image, but small weight to other recognizers. As the result, it can effectively adapt to image quality variation. Moreover, being a multiple-classifier system, it shows more reliable performance then the single-classifier system on low-quality images. In the experiment, the proposed multiple-classifier combination method achieved higher recognition rate than multiple-classifier combination systems not considering the image quality or single classifier systems considering the image quality.