• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.552-558
• /
• 2014

In this paper, we propose a side-peak cancellation technique of composite binary offset carrier (CBOC) signals for e-navigation. First, we divide a CBOC sub-carrier into several sub-carrier pulses, and then, observe that CBOC autocorrelation is the sum of multiple sub-correlation functions. Finally, we propose a novel correlation function with no side-peak and a sharp main-peak by combining the sub-correlation functions to improve the positioning accuracy. From numerical results, we confirm that the proposed correlation function with a sharp main-peak provides a better positioning performance than the conventional correlation functions in terms of the tracking error standard deviation.

• Environmental Engineering Research
• /
• v.13 no.1
• /
• pp.19-27
• /
• 2008

Simultaneous removal of ternary gases of $NH_3$, $H_2S$ and toluene in a contaminated air stream was investigated over 180 days in a biofilter. A commercially available inorganic/polymeric composite chip with a large void volume (bed porosity > 0.80) was used as a microbial support. Multiple microorganisms including Nitrosomonas and Nitrobactor for nitrogen removal, Thiobacillus thioparus (ATCC 23645) for $H_2S$ removal and Pseudomonas aeruginosa (ATCC 15692), Pseudomonas putida (ATCC 17484) and Pseudomonas putida (ATCC 23973) for toluene removal were used simultaneously. The empty bed residence time (EBRT) ranged from 60 - 120 seconds and the inlet feed concentration was $0.0325\;g/m^3-0.0651\;g/m^3$ for $NH_3$, $0.0636\;g/m^3-0.141\;g/m^3$ for $H_2S$, and $0.0918\;g/m^3-0.383\;g/m^3$ for toluene, respectively. The observed removal efficiency was 2% - 98% for $NH_3$, 2% - 100% for $H^2S$, and 2% - 80% for toluene, respectively. Maximum elimination capacity was about $2.7\;g/m^3$/hr for $NH_3$, > $6.4\;g/m^3$/hr for $H_2S$ and $4.0\;g/m^3$/hr for toluene, respectively. The inorganic/polymeric composite carrier required 40 - 80 days of wetting time for biofilm formation due to the hydrophobic nature of the carrier. Once the surface of the carrier was completely wetted, the microbial activity became stable. During the long-term operation, pressure drop was negligible because the void volume of the carrier was two times higher than the conventional packing materials.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.1
• /
• pp.99-108
• /
• 1999

In this paper, we propose $\pi$/4 QPSK scheme with block modulation algorithm, which can reduce preamble in order to transmit ATM cell efficiently in the uplink channel of LMDS, and also designed a new carrier recovery circuit which can improve carrier synchronization performance of block demodulation algorithm. The $\pi$/4 QPSK scheme employing the proposed block modulation algorithm achieved efficient frame transmission by making use of a few preamble when carrier synchronization, symbol timing synchronization and slot timing synchronization were performed by burst data of ATM cell in LMDS environment. For performance evaluation of the proposed method, a simulation analyzing the variation of carrier synchronization, symbol timing synchronization and slot timing synchronization using LMDS environment and burst mode condition was executed. In the simulation, the proposed method showed a good performance even though the reduced preamble as a few aspossible when carrier synchronization, symbol timing synchronization and slot timing synchronization is performed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.8 no.2
• /
• pp.63-75
• /
• 1983

This paper has investigated and discussed the effects of multiple PSK signals upon an wideband FM signal in an intersystem interference environment between analog and digital radios. Using the derived approximate equation for the output haseband interference noise, the signal-to-interference noise power ratio(SNR) in the top channel baseband signal has been numerically calculated. The results are plotted in graphs as the functions of carrier-to-noise ratio(CNR), carrier-to interfer power ratio(CIR), and normalized carrier separation. From the results in this paper, one can know some optimu, or suitable, operating conditions(frequency allocation, bandwidth, and power, etc.) for an FM channel in the intersystemn interferences from digital PSK channels.

• Journal of Advanced Navigation Technology
• /
• v.13 no.2
• /
• pp.224-230
• /
• 2009

In the latest date, medical body area networks (MBANs) are emerging as a new technology for diagnosis the human body. MBANs in the health care fields are based on short-range and low-power (e.g. ubiquitous computing) among small-sized devices, and have been used by means of medical services. In this paper, we proposed an emergency message transmission protocol using carrier sense multiple access/time division multiple access in MBANs. This scheme focuses on dependability and power-efficiency. In order to increase the reliability of the transmission, this scheme modified a MCTA slot of IEEE 802.15.3 standard to a SR-MCTA slot. SR-MCTA slot is assigned by MBAN coordinator according to requesting terminal nodes. The method, having the priority of transmission, occurs a collision packet randomly. Results from this proposed solution revel that reservation-based TDMA medical body area network(MBAN) protocol for transmitting emergency message was improved in terms of transmission delay.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.4
• /
• pp.25-33
• /
• 2018

In this paper, we propose an iterative self-interference (SI) channel estimation method for in-band full-duplex cellular systems that employ orthogonal frequency division multiple access (OFDMA) on downlink (DL) and single-carrier frequency division multiple access (SC-FDMA) on uplink (UL), as in Long Term Evolution (LTE) systems. The proposed method first acquires coarse estimates of SI channels using DL signals and UL pilots, which are known to the base stations, and then refines the estimates by consecutively exploiting averaging in the frequency domain and channel truncation in the time domain. In addition, the method enhances the estimates further by iteratively executing this estimation procedure, and does not require any radio resources dedicated to SI channel estimation. Simulation results demonstrate that by significantly improving the SI channel estimation performance without requiring exact knowledge of the SI channel length, the proposed method achieves UL channel estimation performance and signal-to-interference-plus-noise ratio (SINR) performance very close to those in perfect SI cancellation.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.9
• /
• pp.67-74
• /
• 2016

This paper presents a novel multiple orthogonal subcarrier modulation based UHF band RFID communication system. In tag-to-reader communication, the demonstration system can deliver 1.6 Mbps through four subcarriers. To improve data rate while suppressing increase in circuit complexity, tag employs square-waves as the subcarriers and uses individual load modulators for each subcarrier. By using multiple orthogonal subcarrier based modulation, proposed communication system can be operated under existing UHF band RFID regulation. In reader, an OFDM demodulator is used. Since the tag backscatters the reader's CW carrier, carrier frequency offset compensation is not necessary in reader demodulator. Experimental results show that the demonstration system achieves a bit error rate of 10-5 at an Eb/N0 of 10.8 dB.

• Journal of Information Processing Systems
• /
• v.9 no.3
• /
• pp.499-510
• /
• 2013

Hardware-Software co-simulation of a multiple image encryption technique shall be described in this paper. Our proposed multiple image encryption technique is based on the Latin Square Image Cipher (LSIC). First, a carrier image that is based on the Latin Square is generated by using 256-bits of length key. The XOR operation is applied between an input image and the Latin Square Image to generate an encrypted image. Then, the XOR operation is applied between the encrypted image and the second input image to encrypt the second image. This process is continues until the nth input image is encrypted. We achieved hardware co-simulation of the proposed multiple image encryption technique by using the Xilinx System Generator (XSG). This encryption technique is modeled using Simulink and XSG Block set and synthesized onto Virtex 2 pro FPGA device. We validated our proposed technique by using the hardware software co-simulation method.

• ETRI Journal
• /
• v.33 no.6
• /
• pp.841-848
• /
• 2011

A signal-to-noise ratio (SNR) enhancement algorithm using multiple chirp symbols with clock drift is proposed for accurate ranging. Improvement of the ranging performance can be achieved by using the multiple chirp symbols according to Cramer-Rao lower bound; however, distortion caused by clock drift is inevitable practically. The distortion induced by the clock drift is approximated as a linear phase term, caused by carrier frequency offset, sampling time offset, and symbol time offset. SNR of the averaged chirp symbol obtained from the proposed algorithm based on the phase derotation and the symbol averaging is enhanced. Hence, the ranging performance is improved. The mathematical analysis of the SNR enhancement agrees with the simulations.

• Proceedings of the Korea Institute of Convergence Signal Processing
• /
• 2003.06a
• /
• pp.217-221
• /
• 2003

In this paper, the Viterbi decoder containing new branch metrics of the squared Euclidean distance with multiple order phase differences is introduced in order to improve the bit error rate (BER) in the differential detection of the trellis-coded MDPSK-OFDM. The proposed Viterbi decoder is conceptually same as the multiple Phase differential detection method that uses the branch metric with multiple phase differences. Also, we describe the Viterbi algorithm in order to use this branch metrics. Our study shows that such a Viterbi decoder improves BER performance without sacrificing bandwidth and power efficiency. Also, the proposed algorithm can be used in the single carrier modulation.