• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.2
• /
• pp.103-111
• /
• 2011

Recently, wireless mesh networks are used in various application areas. However, wireless mesh networks have limited bandwidth by the wireless transmission property, and have severe throughput degradation in multi-hop transmission in single channel wireless mesh networks. To solve this problem and support QoS, a lot of routing protocols have been proposed in mesh networks. In this paper, we propose a wireless mesh networks architecture with MPLS for QoS service. The path and traffic management from the application could be independent from QoS routing protocols by using the MPLS in wirelss mesh networks. In this paper, we design a MPLS-based mesh router with IEEE 802.11e for traffic differentiation and investigate the operation by implementation and test.

• Journal of Power Electronics
• /
• v.10 no.1
• /
• pp.85-90
• /
• 2010

In this paper the effects of a Static Synchronous Series Compensator, which is constructed with a 48-pulse inverter, on the power demand from the grid are studied. Extensive simulation studies were carried out in the MATLAB simulation environment to observe the compensation achieved by the SSSC and its effects on the line voltage, line current, phase angle and real/reactive power. The designed device is simulated in a power system which is comprised of a three phase power source, a transmission line, line inductance and load. The system parameters such as line voltage, line current, reactive power Q and real power P transmissions are observed both when the SSSC is connected to and disconnected from the power system. The motivation for modeling a SSSC from a multi-pulse inverter is to enhance the voltage waveform of the device and this is observed in the total harmonic distortion (THD) analysis performed at the end of the paper. According to the results, the power flow and phase angle can be controlled successfully by the new device through voltage injection. Finally a THD analysis is performed to see the harmonics content. The effect on the quality of the line voltage and current is acceptable according to international standards.

• Publications of The Korean Astronomical Society
• /
• v.25 no.1
• /
• pp.23-28
• /
• 2010

We present results of a test-study of the large-scale survey using the multi-beam receiver system recently installed on the 14 m telescope at Taeduk Radio Astronomy Observatory (TRAO). We have tested several modes of mapping, and found suitable (time-saving) mapping parameters of 'ON-SOURCE' = 8, 'OFF-SOURCE' = 1 when using 'RPT' = 3 as a position-switching mode. We observed 504 spectra towards the NGC 7538, a star forming molecular cloud in the transition of J = 1 - 0 of $^{12}CO$. From the Outer Galaxy Survey database (Heyer et al., 1998) we obtained 504 spectra for the same region. We compared integrated intensities, line profiles of two databases, and found that they are consistent to each other. From the intensity ratio of these two databases we also found that the value of forward spillover scattering of the TRAO telescope system is 0.58.

• Journal of Advanced Marine Engineering and Technology
• /
• v.22 no.6
• /
• pp.901-907
• /
• 1998

This paper presents a real-time control technique for the development of a ship main engine remote control system, In general several tasks are executed by the event-driven method in real-time system. However when some tasks have time delay components it is difficult to achieve good real-time performance. To cope with this problem a number of timers in most conventional system have been used. In this paper we introduce a real-time control methodology of dealing effectively with tasks including time delay components using one hardware timer. And also a speed control method of main engine which includes critical revolution range a crash astern and a emergency ahead function a switching method of remote control position and a flickering method for the indication of multi-stage alarm are discussed. As long as functions and method are imple-mented as forms of tasks the development of main engine remote control systems can be easy for different types of engines.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.6
• /
• pp.906-913
• /
• 2010

Recently, lots of researches are carried out to develop hybrid power generation system for ocean facility. Normally, the stand-alone type power system is used in the ocean facility, which is influenced by weather condition. To improve the efficiency, a various charging strategy with switching algorithm has been studied. In this paper, the power system using multi-level type is proposed. The simulation results based on actual data of photovoltaic and wave hybrid power system are presented. The results show that the rate of charging time is increased 5~11% and 7~47% respectively to compare the conventional technique.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.71-74
• /
• 2006

A new multi-output LLC resonant converter is proposed for high efficiency and low cost plasma display panel (PDP) power module. In the proposed converter, zero-voltage (ZV) turn-on of the primary MOSFETs and zero-voltage (ZC) turn-on and turn-off of the secondary diodes are guaranteed in the overall input voltage and output load ranges. In addition, the primary MOSFETs and the secondary diodes have the low voltage stresses clamped to input and the output voltages, respectively. Therefore, the proposed converter shows the high efficiency due to the minimized switching and conduction losses. Moreover, by employing the transformer with multiple secondary windings, the proposed converter can have multiple outputs, which show the great crossregulation characteristics. Therefore, the proposed converter is suitable for high efficiency and low cost PDP power module.

• Proceedings of the KIPE Conference
• /
• 2003.07b
• /
• pp.606-610
• /
• 2003

This paper presents a simple carrier symmetric method for the voltage balance of flying capacitors in FCMLI(flying capacitor multi-level inverter). To achieve the voltage balance of flying capacitors, the utilization of each carrier must be balanced during a half-cycle of the switching period such as PSPWM(Phase-Shifted PWM). However, the CRPWM(Carrier Redistribution PWM) method causes the fluctuation of flying capacitor voltages because the balanced utilization of carriers is not achieved. Moreover, it does not consider that the load current change has an influence on flying capacitor voltages by assuming that the current flows Into the load. To overcome the drawbacks of CRPWM, it is modified by the technique that carriers of each band are disposed symmetrically at every fundamental period. Firstly, the CRPWN method is reviewed and the theory on voltage balance of flying capacitors is analyzed. The proposed method Is introduced and is verified through the experiment result.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.5
• /
• pp.606-612
• /
• 2012

A highly efficient multi-mode balanced power amplifier(PA) structure is proposed for W-CDMA handset applications. The proposed PA has 2-stage amplifier configuration and the stage-bypass and load impedance switching techniques were applied to enhance power efficiency at medium power level as well as low output power level. Using the two techniques, four highly efficient power modes were realized. To demonstrate the usefulness of the proposed structure, a GaAs HBT balanced PA module was designed, fabricated, and measured.

• Journal of the Korean Society of Safety
• /
• v.18 no.4
• /
• pp.98-104
• /
• 2003

Various nondestructive evaluation (NDE) techniques have been studied to locate steel rebars of dowel, and to detect invisible damage such as voids and cracks inside concrete and debonding between rebars and concrete caused by corrosions and earthquakes. In this study, the aurhors developed 3-dimensional (3D) electromagnetic (EM) imaging technology to detect such damage and to identify exact location of steel rebars of dowel. The authors have developed sub-surface two-dimensional (2D) imaging technique using tomographic antenna array in previous works. In this study, extending the earlier analytical and experimental works on 2D image reconstruction, a 3D microwave imaging system using tomographic antenna array was developed, and multi-frequency technique was applied to improve quality of the reconstructed image and to reduce background noises. This paper presents the analytical expressions of numerical focusing procedures for 3D image reconstruction and numerical simulation to study the resolution of the system and the effectiveness of multi-frequency technique. Also, the design of 4?4 antenna array with switching devices is introduced as a preliminary study for the final design of whole array.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.12
• /
• pp.64-70
• /
• 2008

In case that conventional PRC(Pseudo-Randomized Frequency Carrier) modulation scheme is applied to a three-phase HBML(H-Bridge Multi-Level Inverter), the dominant harmonics spectra appear at twice switching frequency. In this paper, the dominant harmonics spectra spreading effect of the conventional PRC scheme was improved by using three stage MUXs(Multiplexers) and two triangular carriers with fixed frequency which has mutual relation of the twice frequency. To confirm the validity of the improved PRC scheme, the experiment were performed on a 1.5[kw] three-phase HBML based induction motor drives. And, the harmonics spectra of the conventional and improved PRC schemes are compared and discussed.