• Annals of Clinical Neurophysiology
• /
• v.4 no.2
• /
• pp.119-124
• /
• 2002

Background : Guillain-$Barr{\acute{e}}$ syndrome(GBS) is a neurologically emergent condition, leading to respiratory insufficiency without an early and appropriate treatment. Thus, the treatment of GBS requires early diagnosis but it is difficult due to the low sensitivity of laboratory tools in the initial stage. Hoffman reflex (H-reflex) and its facilitation by Jendrassik maneuver (JM) are sensitive tools evaluating the central circuit of motor system on the spinal cord level. The aim of this study is to test whether the change of H-reflex and F-wave under the JM is able to detect the early stage of GBS and whether GBS involves the central nervous system (CNS). Material and Methods : All 7 GBS patients who showed normal or nearly normal nerve conduction study were included. The facilitation of H-reflex and changes of F-wave were calculated by measuring the percent difference of H-reflex or F-wave amplitude under JM compared to basal H-reflex of F-wave amplitude. The changes of F-wave and H-reflex in the GBS patients were compared with them of 8 healthy controls. Results : The F-wave amplitudes of both healthy controls and GBS patients did not changed under the influence of JM ($102.4{\pm}24.9%$, $108.7{\pm}29.0%$ respectively). However, the facilitation of H-wave by JM in the GBS patients was absent ($98.8{\pm}5.8%$), even though the H-reflex amplitude I the healthy controls increased under the influence of JM ($124.8{\pm}12.1%$). Conclusions : The loss of H-reflex facilitation in GBS implies that this phenomenon might be the most early change detected in the electrophysiological study and support the early diagnosis, and that GBS might include lesion in the spinal motor CNS.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.7
• /
• pp.56-63
• /
• 2016

This paper presents a novel method for detecting a ghost key at the membrane type keyboard, which has additional resistive coating to the membrane film. Also, the optimal ratio of resistances for detecting a ghost key was designed based on the characteristics of the membrane film. The optimal ratio of resistances was considered to be able to detect the worst case (i.e., difference voltage between normal key and ghost key is minimum). The ability of the proposed methods are evaluated by simulation studies in this paper. In order to verify the proposed method, the experiment was carried out with a designed circuit and A/D (analog to digital) in MCU (micro controller unit). The proposed method is implemented into the membrane type keyboard and is verified by experimental results.

• Journal of the Korean Academy of Child and Adolescent Psychiatry
• /
• v.16 no.2
• /
• pp.183-191
• /
• 2005

Tic disorder including Tourette's disorder is a neurodevelopmental disorder that appears in childhood and characterized by the presence of motor and vocal tics. Childhood-onset obsessive-compulsive disorder (OCD) is suggested to be a phenomenologically and etiologically distinct subtype of OCD, bearing a close genetic relationship to tic-disorders. Tourette's disorder and OCD are comorbid in $40-75\%$ of patients initially diagnosed with either disorder. Basal ganglia and cortico-striato-thalamic circuits are implicated in the pathophysiology of both disorders and these disorders have similar clinical features. Over the past decades, the progress in research on Tourette's disorder and OCD has been extraordinary. This review describes some of important insights from these work, involving these areas : 1) clinical implication 2) genetics and epidemiology 3) brain imaging study 4) neuroche-mistry 5) pediatric autoimmune neuropsychiatric disorders associated with streptococcal infection (PANDAS).

• Fire Science and Engineering
• /
• v.27 no.6
• /
• pp.89-96
• /
• 2013

The purpose of this study is to check the fire origin and cause of the fire by observing the shape of the flame propagation in air-conditioner indoor unit through the fire tests. We supposed that the flame is spread from the surroundings to the top of the air-conditioner and ignited on top of the air-conditioner with n-heptane. And then repeated this experiment twice under the same conditions. After the ignition, refrigerant filled in air-conditioner and lubricating oil exploded with large explosion and flame having high temperature and pressure belched out rapidly due to bursting refrigerant pipe linked air-conditioner between 734 seconds and 559 seconds. After result of checking the combustion residue we found that almost all of that was lost except a part of the evaporator, motor and metal. The position of short-circuit traces of wiring for the air-conditioner ignited itself is similar to that of fire damage by external flame. Therefore, we verified that it is not certain to determine the ignition cause and point by only the shape of the combustion residues.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.6
• /
• pp.1493-1498
• /
• 2015

The autofocus system is automatically to drive the focus. It is very important to computer vision system. In the case of a compact camera, the actuator technology is used for auto-focus in mass production. the position sensor is required, the circuit configuration and easy method is widely used in VCM, compared to the stability of the drive size and the noise is a big stepping motor type, size has a piezo system having a humidity problem and the small leaded vulnerability. In addition, there is a liquid lens system, the advantages of low power in a compact structure but also a structure with proven quality and reliability and features required pressure. In this paper, we implement two control systems that can control the actuator as a liquid range of VCM using a sharpness of the image acquired by the image sensor automatically initiates 5Mpixel class was the implementation verification of focusing.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.6
• /
• pp.130-137
• /
• 2003

Because of falling-off in power quality by harmonics, obstacles like lowering of capability, noise, vibration of power facilities and so on are occurred. Also generation of harmonics is inevitable and the point at harmonics is seriously gathering strength because energy saving installation using semiconductor circuit as countermeasures to enhance energy efficiency will be broadly spread and the use of energy conversion equipment like motor speed control contrivance, energy keeping installation and so on will increase, in the future. In order to eliminate harmonics obstacle, precision measurement and analysis on voltage, current, power factor, the each ingredient of harmonic order, the percentage of total harmonic distortion, and so forth are needed. In this paper, we developed low-cost measurement system to measure and analyze power quality connected with harmonics and verified it's performance by measuring and analyzing power quality in the three-phase and four-wire system.

• The Journal of Korean Physical Therapy
• /
• v.9 no.1
• /
• pp.59-70
• /
• 1997

The ability of neurotropic alpha herpesviruses to replicate within synaptically linked neurons has made these pathogens valuable tools for transneuronal analysis. Recent studies suggest that unique gene products expressed by genetically engineered strains of virus may permit the use of multiple strains in complex tracing paradigms. In the present study we have examined the invasiveness of two genetically engineered strains of the swine pathogen known as pseudorabies virus(PRV). The two strains were isogenic with the attenuated Bartha strain of PRV; in one strain a lacZ reporter gene was inserted into the gC locus (PRV-BaBlu; $4.75\times10^8pfu/ml$) contrained a PRV envelope glycoprotein gene that was absent in PRV-BaBlu. Simultaneous or temporally separated sequential injection of $4\mu\ell$ of each strain into the ventral wall of the stomach produced a predictale course of retrograde synaptic infection. The results were as follows: 1. PRV-BaBlu and PRV-D infected the dorsal motor nucleus of vagus nerve(DMV) and paraventricular nucleus(PVN). 2. Invasion and replication of PRV-D occured at a faster rate than the parental strain or PRV-BaBlu. 3. PRV-D was much more virulent than PRV-BaBlu or the parental strain. 4. Co-injection of PRV-D and PRV-BaBlu produced an infection that was more virulent than that produced by the parental strain (PRV-Bartha), 5. Neurons in DMV were permissive to co-infection with PRV-D and PRV-BaBlu when they were injected simultaneously into the same site. 6. Replication of PRV-BaBlu was compromised by prior infection of the same circuit with PRV-D. 7. Prior infection of neurons with PRV-D maked them resistant to infection with PRV-BaBlu.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.6
• /
• pp.49-57
• /
• 2013

In this study, we fabricated a parallelly connected Li-ion battery/supercapacitor hybrid cell to combine the advantageous characteristics of Li-ion battery and supercapacitor, high energy density and high power density, respectively, and investigated its discharging characteristics over a wide temperature range from -40 to $25^{\circ}C$. At the initial state of discharging of the hybrid cell, the power was mostly provided by the supercapacitor and then the portion of the Li-ion battery was gradually increased. By installing a switching system into the hybrid cell, which controls the discharging sequence of Li-ion battery and supercapacitor, the maximum power was improved by 40% compared with non switching system. In addition at low temperatures, the power and discharging time of the hybrid cell were significantly enhanced compared to a battery-alone system. The hybrid cell is expected to be applied in electric vehicles and small domestic appliances that require high power at initial discharging state.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.14 no.3
• /
• pp.29-37
• /
• 2000

In this paper, the thrust control of PWM Inverter-fed SLIM(Single-sided Linear Induction Motor) is achieved by vector control and PID control with DSP(TMS320C32). SLIM which used as a conveyor has required the quick response and the constant operating without air gap trembling while it conveys load.Thus, SLIM should have the smallest trembling of air gap length. First, voltage equations for SLIM are calculated from the proposed equivalent circuit in this peper, and not only the exciting current but also the thrust component are obtained from them. The thrust current ripple can be reduced by the vector controller using a slip angle frequency, and the PID controller is also use for the position control.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.6
• /
• pp.2497-2503
• /
• 2012

In this study an educational robot for programming education was designed and implemented. The robot in this study is composed of hardware containing a sensor, a processor, and a motor driver circuit, software to control the educational robot, machine parts to manufacture the robot structure, and a teaching material containing educational contents and the manufacturing manual. This robot is characterized by direct programming without a computer, which gives no spatial restrictions on robot education and enables dynamic program education beyond limitations of the existing static computer program education since students' programming results are found in the robot's movements. User-centered functional commands, which make it possible to control the robot with simple knowledge concerning hardware and basic commands, were used to enable even students who first accessed a robot or computer program to make access with ease.