• 한국해안해양공학회지
• /
• 제10권2호
• /
• pp.100-108
• /
• 1998

해양구조물의 연직 원형파일에 작용하는 파력은 파일 직경이 입사파장에 비해 매우 작은 경우에는 주로 항력과 관성력의 합으로 표시되는 Morison 식을 이용하여 결정하여 왔다. 그러나 Morison 식은 대칭형장을 유지하며 비교적 완만히 변화하는 파에 대해서 적용이 가능하다. 구조물 부재에 쇄파가 작용할 경우, 쇄파파력은 항력과 관성력에 추가하여 강한 충격쇄파력을 고려해야 한다. 본 연구는 임의 이차원 경사해빈에서 경계요소법을 적용하여 쇄파 내부점들의 수립자 속도 및 가속도를 계산하고, 이들을 이용하여 쇄파에 의한 쇄파파력을 계산하기 위한 모델기법을 수립하였다. 모델결과는 기존의 쇄파파력 측정 실험결과와 매우 잘 일치하였으며, Morison 식의 적용결과와 비교할 때 쇄파파력은 최고 약 3배, 모멘트는 최고 약 5배 정도 크게 나타났다

• 한국해양공학회지
• /
• 제25권2호
• /
• pp.7-14
• /
• 2011

Numerical simulations were performed for the evaluation of wave and current loads on a fixed cylindrical substructure model for an ocean wind turbine using the ANSYS-CFX package. The numerical wave tank was actualized by specifying the velocity at the inlet and applying momentum loss as a wave damper at the end of the wave tank. The Volume-Of-Fluid (VOF) scheme was adopted to capture the air-water interface. An accuracy validation of the numerical wave tank with a truncated vertical circular cylinder was accomplished by comparing the CFD results with Morison's formula, experimental results, and potential flow solutions using the higher-order boundary element method (HOBEM). A parametric study was carried out by alternately varying the length and amplitude of the wave. As a meaningful engineering application, in the present study, three kinds of conditions were considered, i.e., cases with current, waves, and a combination of current and progressive waves, passing through a cylindrical substructure model. It was found that the CFD results showed reasonable agreement with the results of the HOBEM and Morison's formula when only progressive waves were considered. However, when a current was included, CFD gave a smaller load than Morison's formula.

• 한국해안해양공학회지
• /
• 제12권4호
• /
• pp.157-167
• /
• 2000

한국해양연구소는 1998년에 이어도 종합해양과학기지의 기본설계를 수행한 바 있으며 심해 설계파에 Morison 식과 Stream function 이론을 적용하여 설계파력을 결정한 바 있다. 본 연구에서는 삼차원 수리모형실험 통하여 이어도 해역에서의 파랑전파를 모의하였으며, 구조물의 파력 및 Air gap를 계측하고 이들을 SACS 프로그램의 계산치와 비교함으로써 기본설계 값들의 타당성을 검토하였다. 그 결과, 시도된 4개의 심해파향 중에서 SSW, S, SE계열의 파향에 대해서는 계측치가 SACS 계산치 보다 작게 나타났다. 그러나, 유일하게 구조물에 미치기 전에 쇄파되는 NNW계열의 파향에서는 전반적으로 SACS 계산치를 상회하였으며, 그방향성 흐름과 파가 복합되어 있는 경우와 매우 유사한 파력변화를 보여주었다. 구조물의 Air gap은 모든 심해파향에 대하여 계측치가 기본설계치보다 작은 것으로 나타났다.

• 한국해양공학회지
• /
• 제28권6호
• /
• pp.508-516
• /
• 2014

A numerical method to investigate the non-linear motion characteristics of a TLP is established. A time domain simulation that includes the memory effect using the convolution integral is used to consider the transient effect of TLP motion. The hydrodynamic coefficients and wave force are calculated using a potential flow model based on the HOBEM(higher order boundary element method). The viscous drag force acting on the platform and tendons is also considered by using Morison’s drag. The results of the present numerical method are compared with experimental data. The focus is the nonlinear effect due to the viscous drag force on the TLP motion. The ringing, springing, and drift motion are due to the drag force based on Morison's formula.

• 해양환경안전학회지
• /
• 제24권5호
• /
• pp.537-544
• /
• 2018

본 연구에서는 해수 중 유체력에 의한 인공어초의 활동 및 전도를 평가하기 위한 간편하고 효율적인 사용자 중심의 전산 프로그램(SCAR program)을 개발하였다. 개발된 전산 프로그램은 인공어초의 안정성 평가 공식인 모리슨(Morison) 식을 기반으로 델파이(Delphi) 코드 및 그래픽 사용자 인터페이스(GUI, Graphic User Interface) 방식을 적용하였다. 개발된 SCAR 프로그램은 학부 및 대학원 과정, 실제 현장 전문가들의 수산구조물(인공어초 또는 수중구조물 등) 설계 및 안정성 평가에 널리 적용 가능할 것으로 판단된다.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제13권1호
• /
• pp.718-733
• /
• 2021

A prediction method, based on the Morison equation as well as Froude-Krylov formula, is presented to simulate the loads acting on the columns and caissons of the semi-submersible platform induced by Internal Solitary Wave (ISW) respectively. Combined with the experimental results, empirical formulas of the drag and inertia coefficients in Morison equation can be determined as a function of the Keulegan-Carpenter (KC) number, Reynolds number (Re) and upper layer depth h₁/h respectively. The experimental and calculated results are compared. And a good agreement is observed, which proves that the present prediction method can be used for analyzing the ISW-forces on the semi-submersible platform. Moreover, the results also demonstrate the layer thickness ratio has a significant effect upon the maximum horizontal forces on the columns and caissons, but both minimum horizontal and vertical forces are scarcely affected. In addition, the incoming wave directions may also contribute greatly to the values of horizontal forces exerted on the caissons, which can be ignored in the vertical force analysis.

• 수산해양교육연구
• /
• 제28권3호
• /
• pp.630-644
• /
• 2016

We conducted a comprehensive review on artificial reefs (ARs) including seaweed reefs for marine afforestation in relation to their development and research from 1972 to 2016, and then systematically analyzed their current a state-of-the-art and practice. From the review, the followings conclusions are made. First, the objectives of AR projects in the Southeast Asia can be classified into three, i.e. protection and increase of fishery resources, local community's profits, and ecological tourism. Second, fish gathering effects by ARs can be determined in terms of wake region or wake length that tends to increase with the K-C (Keulegan-Carpenter) number. Third, ARs are desirable to deploy across a direction of the main flow but it is essential to keep the deployment interval two to four times the length of a single reef. Fourth, stability of ARs depends on how to evaluate drag coefficient, and Morison formula turns out to be practical. Fifth, local scours of ARs are likely to occur due to a downward flow around the center of the front surface. Finally, it is natural for ARs to positively contribute to the marine ecosystem but it is imperative to develop an evaluation method for the effects of ARs on the marine ecosystem.

• Ocean Systems Engineering
• /
• 제7권2호
• /
• pp.143-155
• /
• 2017

For complex flexible structures such as nets, the determination of drag forces and its deformation is a challenging task. The accurate prediction of loads on cages is one of the key steps in designing fish farm facilities. The basic physics with a simple cage, can be addressed by the use of experimental studies. However, to design more complex cage system for various environmental conditions, a reliable numerical simulation tool is essential. In this work, the current load on a cage is calculated using a Morison-force model applied at instantaneous positions of equivalent-net modeling. Variations of solidity ratio ($S_n$) of the net and current speed are considered. An equivalent array of cylinders is built to represent the physical netting. Based on the systematic comparisons between the published experimental data for Raschel nets and the current numerical simulations, carried out using the commercial software OrcaFlex, a new formulation for $C_d$ values, used in the equivalent-net model, is presented. The similar approach can also be applied to other netting materials following the same procedure. In case of high solidity ratio and current speed, the hybrid model defines $C_d$ as a function of Re (Reynolds number) and $S_n$ to better represent the corresponding weak diffraction effects. Otherwise, the conventional $C_d$ values depending only on Re can be used with including shielding effects for downstream elements. This new methodology significantly improves the agreement between numerical and experimental data.

• 한국해안해양공학회지
• /
• 제11권2호
• /
• pp.87-94
• /
• 1999

圓形斷面 部材를 갖는 해안 및 해양구조물의 설계에서 波力은 주로 正弦波의 입사를 가정한 모리슨식을 적용하여 산출하는 것이 상례이나. 구조물에 대하여 강한 卷波性 碎波가 작용할 경우에는 모리슨식에 의한 계산치보다 훨씬 큰 衝擊碎波力이 발생한다. 그러나, 충격쇄파력은 그 작용시간이 매우 짧기 때문에 구조물 설계로의 반영 여부 및 규모를 결정하기 위해서는 충격쇄파력 작용에 대한 구조물 전체의 動的擧動을 검토하여야 한다. 본 연구는 충격쇄파력의 작용에 의한 단일 연직파일의 동적변위를 해석하기 위한 수치해석기법을 수리하였으며, 파일의 제원을 달리하는 여러 예제해석을 통하여 파일의 정적변위와 동적 변위를 비교하였다.

• 대한조선학회논문집
• /
• 제51권4호
• /
• pp.274-282
• /
• 2014

Time series of the dynamic response of a slender marine structure was predicted using quadratic Volterra series. The wave-structure interaction system was identified using the NARX(Nonlinear Autoregressive with Exogenous Input) technique, and the network parameters were determined through the supervised training with the prepared datasets. The dataset used for the network training was obtained by carrying out the nonlinear finite element analysis on the freely standing riser under random ocean waves of white noise. The nonlinearities involved in the analysis were both large deformation of the structure under consideration and the quadratic term of relative velocity between the water particle and structure in Morison formula. The linear and quadratic frequency response functions of the given system were extracted using the multi-tone harmonic probing method and the time series of response of the structure was predicted using the quadratic Volterra series. In order to check the applicability of the method, the response of structure under the realistic ocean wave environment with given significant wave height and modal period was predicted and compared with the nonlinear time domain simulation results. It turned out that the predicted time series of the response of structure with quadratic Volterra series successfully captures the slowly varying response with reasonably good accuracy. It is expected that the method can be used in predicting the response of the slender offshore structure exposed to the Morison type load without relying on the computationally expensive time domain analysis, especially for the screening purpose.