• Journal of the Korean Vacuum Society
• /
• v.12 no.2
• /
• pp.79-85
• /
• 2003

Experimental investigations are performed for the rarefied gas flows in a multi-stage disk-type drag pump. The pump considered in the present study consists of grooved rotors and stators. The flow-meter method is adopted to calculate the pumping speed. Compression ratios and pumping speeds for the nitrogen gas are measured under the outlet pressure range of 0.13∼533 Pa. The present experimental data show the leak-limited value of the compression ratio in the molecular transition region. The rotational speed of the pump is 24,000rpm, and nitrogen is used as a test gas. The pumping characteristics of various drag pumps are performed. The inlet pressures are measured for various outlet pressures of the test pump. The ultimate pressures for zero throughput are measured for three-stage, two-stage and single-stage disk-type, respectively.

• Journal of the Korean Wood Science and Technology
• /
• v.26 no.1
• /
• pp.29-37
• /
• 1998

Alkali-soluble extracts were prepared from medium-sized barks of Radiata pine(Pinus radiata). There are difficulties in the production of extracts with uniform quality and in the preparation of adhesives with suitable viscosity. Ultrafiltration using an Amicon cell was subjected to fractionate extracts according to molecular sizes in order to overcome the above problem. The filtration efficiency was studied by using thin channel filtration systems. Adhesive manufacturing was also examined. Removal of particles greater than 0.45m from the extracts increased both filtration speed (flux) and yields of solids in the filtrates. Ultrafiltration with PM 10 membrane was very effective to fractionate and concentrate the extracts. Stiasny precipitates from the filtrates obtained by PM 10 membrane were very lower than that(83%) of the retentates. This ultrafiltration method was efficient for obtaining high yield purified phenolic compounds(mainly polyflavanoids) and thus important for preparing wood adhesives from barks. The extracts were shown excessive high viscosities at the concentrations required for adhesive formulation, but this high viscosity and short gelation time was reduced by lowering pH of the extracts and addition of urea. The highest bonding strength of plywoods(340g/$m^2$ of adhesive spreads) was achieved with adhesive formulated by 100parts of mixed alkali extracts and urea(70/30,w/w), 10parts of p-formaldehyde and 3.5parts of wheat flour at pH 6, and by hot pressing at the conditions of 12kg/$cm^2$ at $120^{\circ}C$ for 10 minutes.

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.1
• /
• pp.37-41
• /
• 1997

Hot-water soluble extracts were prepared from medium-sized barks of Siberian larch (Larix gmelineii). The extracts were fractionated by ultrafiltration method for producing uniform quality of adhesives. Molecular weight distribution of the extracts was ranged of 100 to 300.000. pH of the extracts affected amounts of flux, and the range of pH 6~pH 8 was proper for wood adhesives, because of easy concentration and fast gelation time. Removal of particles greater than $0.45{\mu}m$ from the extracts increased both filtration speed (flux) and yields of solids in the filtrates. In ultrafiltration process. operating pressure, filtrate temperature, and flow rate significantly increased with the increase of individual condition. Ultrafiltration using PM10 membrane was very effective to fractionate and concentrate the extracts. Removal of large particles greater than 0.45 m from the extracts increased filtration speed(flux) and yields of solids in the filtrates. A gelation time was accelerated with the increasing pH of the extracts and its concentration. The Stiasny precipitate(26%) from the filtrate obtained by PM 10 membrane was very lower than that(78%) of the retentates. This ultrafiltration method was efficient for obtaining high yield purified phenolic compounds.

• Applied Chemistry for Engineering
• /
• v.1 no.2
• /
• pp.116-123
• /
• 1990

Synthesis and characterization of photosensitive orthonaphthoquinonediazide-sulfonyl derivatives were studied. These photoactive compounds underwent a UV induced transformation to the base-soluble photoproduct. The photoresists were prepared using these photoactive compounds with low molecular weight m-cresol novolacs as matrix resin. And photosensitive characteristics of the photoresists were studied. 3, 4, 5-Trihydroxy-benzophenone with bulky resonance structure increased the sensitivity and the solubility rate of the exposed region. The mixture of PAC and matrix resin having 3:8 weight ratio had the moderate rate of dissolution in the developer. The photoresist using these conditions showed the best snsitivity and contrast under the fixed conditions.

• Molecules and Cells
• /
• v.39 no.2
• /
• pp.77-86
• /
• 2016

Cancer is a heterogeneous disease caused by diverse genomic alterations in oncogenes and tumor suppressor genes. Despite recent advances in high-throughput sequencing technologies and development of targeted therapies, novel cancer drug development is limited due to the high attrition rate from clinical studies. Patient-derived xenografts (PDX), which are established by the transfer of patient tumors into immunodeficient mice, serve as a platform for co-clinical trials by enabling the integration of clinical data, genomic profiles, and drug responsiveness data to determine precisely targeted therapies. PDX models retain many of the key characteristics of patients' tumors including histology, genomic signature, cellular heterogeneity, and drug responsiveness. These models can also be applied to the development of biomarkers for drug responsiveness and personalized drug selection. This review summarizes our current knowledge of this field, including methodologic aspects, applications in drug development, challenges and limitations, and utilization for precision cancer medicine.

• Journal of The Korean Society of Inherited Metabolic disease
• /
• v.14 no.1
• /
• pp.48-53
• /
• 2014

Smith-Lemli-Opitz syndrome (SLO) is a rare, autosomal recessive disease caused by an inborn error in cholesterol synthesis. Patients with this disease suffer from multiple malformations due to reduced activity of 7-dehydrocholesterol reductase (DHCR7), which increases 7-dehydrocholesterol (7DHC) and 8-dehydrocholesterol (8DHC) concentrations and decreases cholesterol concentration in body fluids and tissue. Here, we describe Korean siblings with SLO who were diagnosed recently, and performed a review of literature about Korean cases with SLO to date. Microcephaly and syndactyly of the second and third toes are the most common physical finding in SLOS patients. Other malformations including growth failure, cleft palate or bifid uvula, various heart malformation, genital ambiguity in males are also accompanied. Not all patients showed low levels of serum cholesterol, so DHCR7 mutation analysis can be helpful to confirmative diagnosis. Two mutations on p.R352 locus (p.R352W and p.R352Q) are commonly identified in Korean SLO patients. Although rare in Korea, SLO should be considered in the differential diagnosis of growth failure with intellectual disability, especially in patients with multiple congenital anomalies.

• The Plant Pathology Journal
• /
• v.31 no.1
• /
• pp.78-82
• /
• 2015

In 2011, a leaf blight disease was observed on cosmos (Cosmos bipinnatus) leaves in Nonsan, Korea. The causal pathogen was isolated and identified based on morphological and molecular approaches. Morphological characteristics of the pathogen matched well with the Alternaria cosmosa and also easily distinguishable from Alternaria zinniae reported from cosmos seeds by producing branched beak. Phylogenetically, the pathogen could not be distinguished from A. passiflorae based on the sequence analysis of a combined data set of Alt a1 and gpd genes. However, A. passiflorae was distinguished from the present species by having conidiophores with 4 to 5 conidiogenous loci. The results indicate that the present Alternaria species is A. cosmosa. Pathogenicity tests revealed that the isolate was pathogenic to the leaves of Cosmos bipinnatus. This is the first report of Alternaria blight disease caused by A. cosmosa on cosmos in Korea.

• The Plant Pathology Journal
• /
• v.30 no.3
• /
• pp.269-278
• /
• 2014

Remorins, a family of plant-specific proteins containing a variable N-terminal region and conserved C-terminal domain, play a role in various biotic and abiotic stresses, including host-microbe interactions. However, their functions remain to be completely elucidated, especially for the Arabidopsis thaliana remorin group 4 (AtREM4). To elucidate the role of remorins in Arabidopsis, we first showed that AtREM4s have typical molecular characteristics of the remorins, such as induction by various types of biotic and abiotic stresses, localization in plasma membrane and homo- and hetero-oligomeric interaction. Next, we showed that their loss-of-function mutants displayed reduced susceptibility to geminiviruses, Beet Curly Top Virus and Beet Severe Curly Top Virus, while overexpressors enhanced susceptibility. Moreover, we found that they interacted with SnRK1, which phosphorylated AtREM4.1, and were degraded by the 26S proteasome pathway. These results suggest that AtREM4s may be involved in the SnRK1-mediated signaling pathway and play a role as positive regulators of the cell cycle during geminivirus infection.

• The Plant Pathology Journal
• /
• v.29 no.1
• /
• pp.10-16
• /
• 2013

Hevea brasiliensis is a natural source of rubber and an important plantation tree species in Malaysia. Leaf blight disease caused by Fusicoccum substantially reduces the growth and performance of H. brasiliensis. The aim of this study was to use a combination of both morphological characteristics and molecular data to clarify the taxonomic position of the fungus associated with leaf blight disease. Fusicoccum species were isolated from infected leaves collected from plantations at 3 widely separated locations - Selangor, Perak, and Johor states - in Peninsular Malaysia in 2010. All the isolates were identified according to their conidial patterns and DNA sequences generated from internal transcribed spacers (ITS1 and ITS2), the 5.8S rRNA, and an unknown locus (BotF15) containing microsatellite repeats. Based on taxonomic and sequence data, Neofusicoccum ribis was identified as the main cause of leaf blight disease in H. brasiliensis in commercial plantations in Malaysia. A pathogenicity trial on detached leaves further confirmed that N. ribis causes leaf blight disease. N. ribis is an important leaf pathogen, and its detection in Malaysia has important implications for future planting of H. brasiliensis.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.04a
• /
• pp.128-131
• /
• 2003

It is well known that the membrane separation process combined with surfactant micelle (micellar-enhanced ultrafiltration) or polyelectrolyte (polyelectrolyte-enhanced ultrafiltration) can remove heavy metals effectively. However, the environmental hazard of surfactant or polyelectrolyte remained in effluent is a serious disadvantage of these methods. In this study, humic substances (HS) were used as complexing agents for metal removal instead of synthetic chemicals. The HS are a sort of natural organic matters which are biodegradable and abundant in natural environment. And the functional groups such as carboxyl groups and phenols in HS can bind with the cationic radionuclides and form complexes. Therefore separation process using them will be more environmental-friendly. The effects of concentration of HS and pH on the removal of cobalt were investigated. The ultrafiltration process was applied to the separation of the cobalt - HS complexes from the aqueous stream. At the concentration of > 3 g/L of HS and pH of 6, over 95 % of cobalt was removed by regenerated cellulose membrane of molecular weight cut-off (MWCO) 3,000. As the concentration of HS increased, the removal of cobalt also was improved because of increase in biding sites (functional groups). The cobalt removal increased from 72.5 % to 97.5 % when pH increased from 4 to 8 at the concentration of 3 g/L HS because of increase in HS solubility and cobalt hydroxide precipitation. In the presence of NaCl, the removal efficiency of cobalt decreased.