• Aerospace Engineering and Technology
• /
• v.8 no.1
• /
• pp.179-186
• /
• 2009

This paper describes the design and implementation for spread spectrum FTS encoder and decoder. The FTS command format is defined by 64 bit encrypted packet that contains all required information relayed between the ground and the vehicle. Encryption is accomplished using the Tripple-DES encryption algorithm in block encryption form. The proposed FTS encoder and decoder is using the Convolution Encoding and Viterbi Decoding for forward error correction. The Spread Spectrum Modulation is done using a PN code, which is 256 bit gold code. The simulation result shows that the designed FTS decoder is compatible with the designed FTS encoder.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.2
• /
• pp.417-426
• /
• 2000

In this paper, CE-CPSK(Constant Envelope Continuous Phase Shift Keying) modulated DS/SS(Direct Sequence Spread Spectrum) transceiver with 908 MHz carrier frequency and 1.5 MHz PN clock rate is proposed. To overcome the effect of nun-linear power amplifier, CE-CPSK modulation method which has the constant envelope and continuous phase characteristics is proposed. To analyze the DS/SS receiver performance with respect to code tracking loop, multipath fading channel is characterized as a two-ray Rayleigh fading channel. To compensate the demerit of analog delay locked loop, digital delay locked loop is employed for code tracking loop. Simulation and experimental examination has been carried out in AWGN(Additive White Gaussian Noise) and Rayleigh fading channel environment in order to prove validity of the proposed method.

• Journal of IKEEE
• /
• v.22 no.3
• /
• pp.800-804
• /
• 2018

This paper presents a novel HF band differential quadrature phase-shift keying (DQPSK) orthogonal frequency-division multiplexing (OFDM) communication system. The system can deliver 3.6 kbps with a bandwidth of about 3 kHz. In a digital modem, OFDM with 32-point fast Fourier transform is used. In the system, each subcarrier uses DQPSK modulation. Hence, a demodulator does not require carrier phase recovery and symbol timing recovery. And, each subcarrier employs CRC error check code individually. By using CRC code for each subcarrier, bit error caused by multipath fading can be recovered simply.

• Journal of Biosystems Engineering
• /
• v.27 no.5
• /
• pp.459-466
• /
• 2002

In Korea, a need of automatic dairy farm management system has been increased to lower production cost and to strengthen international competition. However, the present management system was mostly relied on foreign technologies and caused some problems in post management and after-sales services. Therefore, though there is a problem of price and quality at present, domestic technologies of the management system should be developed for the long run. This study was conducted to develop an electronic identification unit for an automatic dairy farm management system. The developed system was consisted of a tag, a reader, a switching circuit, and a personal computer. The tag attachable to each individual cow was developed to transmit individual radio frequency(RF) code into the air with modulation of ASK(amplitude shift keying). And the switching circuit was added to avoid confusion on reception and transmittance. The reader attached to a feeding device was developed to transmit activating signal periodically and to identify code of the individual tag when the tag was approached to the device. The reader was consisted of an active filter, a detecter, a comparator and a microcontroller. The test result was feasible enough to apply it for the automatic farm management system and the identified maximum distance was about 37cm.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.2
• /
• pp.1-11
• /
• 1997

We developed a base station modulator ASIC for CDMA digital cellular system. In CDMA digital cellular system, the modulation is performed by convolutional encoding and QPSK with spread spectrum. The function blocks of base station modulator are CRC, convolutional encoder, interleaver pseudo-moise scrambler, power control bit puncturing, walsh cover, QPSK, gain controller, combiner and multiplexer. Each function block was designed by the logic synthesis of VHDL codes. The VHDL code was described at register transfer level and the size of code is about 8,000 lines. The circuit simulation and logic simulation were performed by COMPASS tools. The chip (ES-C2212B CMB) contains 25,205 gates and 3 Kbit SRAM, and its chip size is 5.25 mm * 5,45 mm in 0.8 mm CMOS cell-based design technology. It is packaged in 68 pin PLCC and the power dissipation at 10MHz is 300 mW at 5V. The ASIC has been fully tested and successfully working on the CDMA base station system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.2
• /
• pp.360-367
• /
• 2006

In this paper, we design the complementary code keying (CCK) modulation/demodulation structure that is proposed in the IEEE 820.11b and IEEE 802.11g. And, this paper proposes the CCK Rake receiver to be fitted for the large delay spread case like the inter-vehicle communications. The channel estimation of each path in the multipath Rayleigh fading channel is done using the packet preamble and, the combining of the multipath signals in the coherent CCK Rake receiver is achieved as the symbol level combining type. In this paper, in order to validate the utilization of CCK modem for the inter-vehicle communications of the telematics communications, we suggest the CCK modem performance that is made for the multipath Rayleigh fading channel with the mobile speed of 300km/h.

• Journal of the Korea Society of Computer and Information
• /
• v.11 no.3
• /
• pp.271-279
• /
• 2006

This study proposes a new diversity algorithm to improve the signal-to-noise ratio. In the wireless channel, if fading occurs due to the multipaths, the performance of the system is apparently reduced. One of the methods to reduce fadings like this is the diversity method, and this study aims to improve the performance of the system by proposing a new diversity algorithm. This study applied rake receiver It applied QPSK and OQPSK modulation methods and applied the convolutional codes, where the code rate is 1/3 and the constraint length is 9, and the turbo code where the constraint length is 4. Under these conditions, this study compared and analyzed the average error probability of Multicarrier CDMA system.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.5
• /
• pp.338-343
• /
• 2020

In this paper, it was shown that the decoding method of Hamming codes using soft values can be applied to molecular communication channels. A soft value criterion that can be used for decoding of Hamming codes for a molecular communication channel was proposed, and it has been shown through simulation that the decoding method using these values can improve reliability even in the molecular communication channel. A diffusion-based molecular communication channel was assumed, and information symbols were transmitted using BCSK modulation. After demodulating the number of molecules absorbed by the receiver at each symbol interval with an appropriate threshold, the number of molecules is no longer used. In this paper, the BER performance of the decoder was improved by utilizing information on the number of molecules that are no longer used as soft values in the decoding process. Simulation was performed to confirm the improvement in BER performance. When the number of molecules per bit is 600, the error rate of the Hamming code (15,11) was improved about 5.0×10^-3 to the error rate of the BCSK system without the Hamming code. It can be seen that the error rate of (15,11) Hamming code with the soft values was improved to the same extent. In the case of (7,4) Hamming code, the result is similar to that of (15,11) Hamming code. Therefore, it can be seen that the BER performance of the Hamming code can be greatly improved even in the molecular communication channel by using the difference between the number of molecules absorbed by the receiver and the threshold value as a soft value.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.2
• /
• pp.118-124
• /
• 2008

For forward error correction, DVB-S2, which is the digital video broadcasting forward error coding and modulation standard for satellite television, uses a system based the concatenation of BCH with LDPC inner coding. In DVB-S2 the LDPC codes are defined for 11 different code rates, which means that a DVB-S2 LDPC decoder should support multiple code rates. Seven of the 11 code rates, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, and 9/10, are regular and the rest four code rates, 1/4, 1/3, 2/5, and 1/2, are irregular. In this paper we propose a flexible decoder for the regular LDPC codes. We combined the partially parallel decoding architecture that has the advantages in the chip size, the memory efficiency, and the processing rate with Benes network to implement a DVB-S2 LDPC decoder that can support multiple code rates with a block size of 64,800 and can configure the interconnection between the variable nodes and the check nodes according to the parity-check matrix. The proposed decoder runs correctly at the frequency of 200MHz enabling 193.2Mbps decoding throughput. The area of the proposed decoder is $16.261m^2$ and the power dissipation is 198mW at a power supply voltage of 1.5V.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.5
• /
• pp.139-146
• /
• 2009

Parametric array for audio applications is analyzed by numerical modeling and analytical approximation. The nonlinear wave equations are used to provide design guidelines for the audio parametric array. A time domain finite difference code that accurately solves the KZK (Khokhlov-Zabolotskaya-Kuznetsov) nonlinear parabolic wave equation is used to predict the response of the parametric array. The time domain code relates the source size and the carrier frequency to the audible signal response including the output level and beamwidth to considering the implementation issues for audio applications of the parametric array, the emphasis is given to the frequency response and distortion. We use the time domain code to find out the optimal parameters that will help produce the parametric array with highest achievable output in terms of the average power within the demodulated signal. Parameters such as primary input frequency, audio source radius and the modulation method are given utmost importance. The output effect of those parameters are demonstrated through the numerical simulation.