• 한국세라믹학회지
• /
• 제28권2호
• /
• pp.101-108
• /
• 1991

0.2 mo1% La doped BaTiO3 samples were prepared by a wet chemical process (Pechini process) and electrical conductivity were measured from annealing temperatures(800-110$0^{\circ}C$) to room temperature continuously. 2 probe I-V characteristics showed that Pt electrodes were non-ohmic below about 80$0^{\circ}C$ for Ladoped sample. I-V curves showed varistor behavior and breakdown voltages showed PTC-like behavior. AC complex impedance of 0.2 La and 0.05 Mn mo1% doped BaTiO3 samples with three different electrodes (electroless Ni, Pt, Ag electrodes) were measured with temperature variation. Complex impedance plots showed that the samples with electroless Ni electrodes have negligible electrode resistance. Samples with Ag or Pt paste electrodes showed large electrode resistance. PTC effect, which is defined as the ratio of maximum resistance to minimum resistance, was found to be less than 10 for 0.2 mo1% La doped dense sample however greater than 105 with codoping of 0.05 mo1% Mn and 0.2 mol% La.

• 한국재료학회지
• /
• 제12권3호
• /
• pp.220-224
• /
• 2002

The oxide scales formed on $Ni_3Al$-7.8%Cr-1.3%Zr-0.8%Mo-0.025%B after oxidation at 900, 1000 and 110$0^{\circ}C$ in air were studied using XRD, SEM, EPMA and TEM. The oxide scales consisted primarily of $NiO,\; NiAl_2O_4,\;{\alpha}-Al_2O_3,\; monoclinic-ZrO_2,\; and \;tetragonal-ZrO_2$. The outer layer of the oxide scale was rich in Ni-oxides, whereas the internal oxide stringers were rich in Al-oxides and $ZrO_2$. Within the above oxide scales, Cr and Mo tended to exist as dissolved ions.

• 대한전자공학회논문지
• /
• 제21권6호
• /
• pp.34-41
• /
• 1984

RMOS(refractors metal oxide semiconductor)의 게이트 금속으로 사용되는 Mo2N/Mo 이중층을 N2와 Ar을 혼합하여 저온의 반응성 스펏터링법으로 제조하였다. Ar : N2=95 : 5로 혼합된 가스 분위기에서 반응성 스펏터링을 할 때 Mo2N이 잘 형성되었다. 이렇게 제조한 Mo2N 박막은 면저항이 약 1.20∼1.28Ω/□로서 다결정 실리콘의 1/10정도가 되어 반도체 소자의 동작속도를 크게 향상시킬 것으로 기대된다. 1100℃의 N2분위기에서 PSC(phosphorus silicate glass)를 불순물 확산원으로 하여 소오스와 드레인의 불순물 확산을 할때 Mo2N 박막이 Mo으로 환원되어 확산전의 면저항보다 훨씬 작은 약 0.38Ω/□정도의 면저항을 나타내었다. 본 실험에서 제작한 자기정렬된 RMOSFET의 문턱전압은 약 -1.5V이고 결핍과 증가의 두 가지 동작특성을 나타내었다.

• Bulletin of the Korean Chemical Society
• /
• 제25권9호
• /
• pp.1314-1320
• /
• 2004

The adsorption and configuration of CO molecules adsorbed on W (110) and W (100) surfaces have been calculated by the atomic superposition and electron delocalization molecular orbital (ASED-MO) method. Referred to as the ASED-MO method, it has been used in the present study to calculate the geometries, binding energies, vibrational frequencies, orbital energies, reduced overlap population (ROP), and charges. From these results adsorption properties of ${\alpha}$-state and ${\beta}$-state were deduced. The calculated binding energies are in good agreement with the experimental result. On the W (110), the calculated average binding energies are 2.56 eV for the end-on configuration and 3.20 eV for the lying-down configuration. Calculated vibrational frequency is 1927 $cm^{-1}$ at a 1-fold site and 1161 $cm^{-1}$ at a long-bridge (2) site. These results are in reasonable agreement with experimental values. On the W(100) surface, calculated average binding energies of the end-on and the lying-down are 2.54 eV and 4.02 eV respectively. The differences for binding energy and configuration on the surfaces are explained on the basis of surface-atom coordination and atom-atom spacing. In the favored lyingdown CO configuration on the W(110) and W(100) surfaces, 4 ${\sigma}$ and 1 ${\pi}$ donation interactions, coupled with the familiar 5 ${\sigma}$ donation to the surfaces and back-donations to the CO 2 ${\pi}^{\ast}$ orbital, are responsible for adsorption to the surface.

• 한국자기학회지
• /
• 제9권4호
• /
• pp.203-209
• /
• 1999

CoCrTa/Cr 자성박막의 Cr 하지층에 Mo와 Si을 첨가하여 제조한 박막의 자기적 성질에 미치는 Mo와 Si의 영향에 대하여 조사하였다. 증착시 사용된 장비는 DC magnetron sputtering system이었고, CoCrTa 자성층의 두께는 30.0$\AA$으로 Cr 하지층의 두께는 700$\AA$으로 고정하였으며 기판의 가열온도는 26$0^{\circ}C$이었다. CrMo 하지층의 박막이 순수한 Cr 하지층에 비하여 약 200 Oe의 보자력 증가를 나타내었다. 하지만 Si을 첨가하였을 경우엔 첨가량의 증가에 따라 보자력이 점차 감소하는 것으로 나타났다. CrMo 하지층에서는Mo를 첨가함에 따라 Cr 하지츠의 (200)면의 결정배향성이 증가하였고, Mo를 첨가한 Cr(200)과 CoCrTa(110)의lattice misfit가 Si을 첨가한 경우보다 작았고, 이것이 보자력 증가의 원인이었다.

• Applied Science and Convergence Technology
• /
• 제26권1호
• /
• pp.11-15
• /
• 2017

To improve the adhesion of Mo thin film as a back contact material, a DC magnetron sputtering system was used to deposit in the form of a bi-layer on soda-lime glass. Films with low resistivity and good adhesion were obtained from this deposition, even though the two qualities were found be hard to obtain at the same time. The best Mo bi-layer showed a resistivity of $8.13{\times}10^{-4}{\Omega}{\cdot}cm$ at $500^{\circ}C$ and $3.0{\times}10^{-3}\;Torr$. The XRD measurements showed that the crystallites of the films were mainly oriented in the (110) direction, the FE-SEM images revealed that the resistivity of the Mo films decreased with increasing substrate temperature, which temperature reduction is accompanied by an increase of the grain size. These experimental results were analyzed using the Fuchs-Sondheimer theory. Our Mo bi-layer film with better crystallinity and lower resistivity can be suitably used as a back-contact layer for CIGS solar cells.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2010년도 제39회 하계학술대회 초록집
• /
• pp.88-88
• /
• 2010

We synthesized molybdenum thin films deposited by RF magnetron sputtering and physicochemical analysis was performed. The physical and chemical properties of these films were examined with X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). The obtained film at the oxygen ratio of 0% showed crystallinity of cubic Mo(110) phase. After the oxygen ratio increased more than 5% in the sputter gas, the molybdenum films were formed as an amorphous phase. The thickness of the Mo thin film was drastically decreased from 1000 nm to ca 70 nm after introduction of oxygen in the sputter gas confirmed by spectroscopic ellipsometer (SE) and scanning electron spectroscopy (SEM). The calculated band gap of the film deduced from SE data increased from 3.17 to 3.63 eV by addition of oxygen in the sputter gas. The roughness of the Mo film was examined with atomic force microscopy (AFM) and it was dramatically decreased by introducing of oxygen during sputtering. XPS results revealed that the ratio of metallic Mo species in the film decreased by the contents of Mo(VI) species increased at the ratio of oxygen increased in the sputter gas and fully oxidized at low content of oxygen in the sputter gas.

• BMB Reports
• /
• 제29권2호
• /
• pp.156-162
• /
• 1996

Transcription of hepatitis B viral pregenomic promoter is known to be regulated mainly by the combined interaction of enhancers I, II and the intervening regulatory sequences between the two enhancers. A positive regulatory element was identified by serial deletion and measuring the linked chloramphenicol acetyltransferase (CAT) activities, which overlapped with the 5' region of the X open reading frame. When the positive regulatory element was inserted upstream of the SV40 early promoter, it elevated SV40 promoter activity in HepG2 cells. Two cellular proteins of 110 (p110) and 33 (p33) kDa interacted with the positive element and both of them were present in the nucleus, but p110 also existed in the cytoplasm in phosphorylated form. Dephosphorylation of p110 by acid phosphatase enhanced the DNA-binding activity of p110. The p33 could bind to single-strand DNA specifically as well as to double-strand DNA.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2004년도 International Symposium on Powder Materials and Processing
• /
• pp.109-110
• /
• 2004

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2008년도 추계학술대회 초록집
• /
• pp.108-110
• /
• 2008

다이아몬드마이크로블레이드의 윤활제첨가에 따른 절삭 성능과 수명향상을 위해 절삭에 따른 블레이드의 마모량을 측정시험을 행하였고 블레이드의 절삭성능을 평가할 수 있는 지표인 일정속도로 절삭 중 블레이드의 전력소모량을 측정하였다.