• Journal of the Korean Society for Heat Treatment
• /
• v.4 no.3
• /
• pp.31-38
• /
• 1991

Effect of thermal cycling on shape memory effect and stabilization of austenite was investigated in Fe-21%Mn alloy. The thermal cyclic treatment was carried out with two types, room temperature${\leftrightarrow}215^{\circ}C$ and room temperature${\leftrightarrow}260^{\circ}C$. In case of the room temperature${\leftrightarrow}215^{\circ}C$, the SME was rapidly increased up to 3 cycles and maintained nearly constant value regardless of further cycles. In case of the room temperature${\leftrightarrow}260^{\circ}C$, however, the SME was increased with increasing the thermal cycle up to 5 cycles and decreased gradually with further cycle. The variation of the ${\varepsilon}$ martensite volume pet with the thermal cycle was in good agreement with the variation of the SME. Therefore, the change of the SME due to the cyclic treatment was explained with the change of the ${\varepsilon}$ martensite content. As the thermal cycle was increased, the $M_s$ temperature was decreased, and the $A_s$ and $A_f$ temperatures were increased, respectively.

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2002.11a
• /
• pp.12-12
• /
• 2002

Lanthanum manganites have been extensively studied for the application to magnetic devices since the colossal magnetoresistance of these compounds has been observed [1]. The critical temperatures, Tc, of manganites La/sub 0.7/Ca/sub 0.3-x/Ba/sub x/MnO₃ increased as the content of Ba increased except the abrupt jump near the critical concentration. The step like behavior of the critical temperature for a similar compound has been known to be related to the structural phase transition [2]. To understand the step like behavior of Tc, the EXAFS technique is applied to the La/sub 0.7/Ca/sub 0.3-x/Ba/sub x/MnO₃ compound system. The ordering between the manganese and oxygen was examined by this method. The EXAFS analysis shows that the coordination numbers were not changed before and after the phase transition, the bonding distance between manganese and oxygen is about 1.94 ± 0.02 Å, which is consistent with other work [3] and the Debye waller parameters were about σ²= 0.0037 ± 0.0005 Ų for x=0.0 and x=3.0, respectively. The value of Debye-Waller parameter for x=0.09 is about σ² = 0.0050 ± 0.0005 Ų in about phase transition concentration. Based on the Debye-Waller parameters, it is shown that the ordering between manganese and oxygen is significantly reduced near the phase transition concentration.

• Journal of Welding and Joining
• /
• v.12 no.2
• /
• pp.87-96
• /
• 1994

Correlation between microstructural features and segregation of elements (Si, Mn, P and S) near the mid of thickness in the base metal and the synthetic HAZ was investigated. Furthermore, the relationship between the degree of center segregation and weld cold cracking susceptibility in the thickness direction was also conducted by evaluating the effect of P concentration on the critical applied stress. The results obtained are as follows: 1) Pearlite band, containing the MnS type inclusion and a locally transformed structure with a higher hardness, was observed in the center segregation region. 2) By the weld thermal cycle, center segregation region was transformed to the white band which had a higher hardness than that of base metal due to a greater hardenability of concentrated Mn, P etc.. 3) Weld cold cracking susceptibility in the thickness direction was mainly dependent on the concentration of impurity elements rather than on the number of the segregated particles near the mid of thickness. 4) During welding, the higher concentrated region was easily changed into white band. Therefore, it could be predicted that the initiation and propagation of a cold crack would be promoted by increasing the restraint stress and hydrogen content.

• Journal of Food Hygiene and Safety
• /
• v.15 no.3
• /
• pp.209-218
• /
• 2000

This study was conducted to determine the content of trace metals in crops cultivated in Han-riverside, Anyang stream, Tan stream, and Jungryang stream. Trace metals (Pb, Cr, Cd, Fe, Zn, Cu, Hg) were detected in 36 crops, 285 samples by Atomic Absorption Spectrophotometer and Mercury Analyzer. The average concentration of trace metals in crop samples was in the order of Fe (34.592 ppm)>Mn (11.071 ppm)$\geq$Zn(8.853 ppm)>Cu(1.795 ppm)>Cr(0.237 ppm)>Pb(0.100 ppm)>Cd(0.011 ppm)>Hg(0.003 ppm). In crop samples, the contents of Fe, Cu, Mn, and Zn, which ranges were 0.004-203.083 ppm, 0.017~22.727 ppm, 0.000~74.373 ppm, 0.080~37.166 ppm, respectively, were relatively higher than those of Pb, Cd, Cr, and Hg, which ranges were 0.000~0.654 ppm, 0.000~0.270 ppm, 0.000~l.229 ppm, 0.000~0.037 ppm, respectively. The concentration of trace metals in crop samples was in the order of leafy vegetables > stem vegetables > root vegetables > fruity vegetables. In the root vegetables, such as radish, the content of Pb was leaf(0.055 ppm)>root(0.035 ppm), that of Cr, leaf (0.118 ppm)>root(0.031 ppm), that of Cd, leaf(0.004 ppm)>root(0.001 ppm), that of Hg, leaf(0.004 ppm)>root(0.001 ppm). As the results, it could be thought that root is the organ which doesn't accumulate the heavy metal ions, but absorb them.

• Journal of the Mineralogical Society of Korea
• /
• v.6 no.1
• /
• pp.1-16
• /
• 1993

The chemical and optical absorption spectroscopic characters of pink and colorless tourmalines from San Diego mine in California, U.S.A., blue/green tourmalines from anonymous mine, Brazil, and brownis black tourmalines from Uncheon and Haksan mines in Korea have been studied using X-ray diffractometer, electron microprobe, optical absorption spectroscopy, and heat treatment. Least-squares refinements give unit cell diminsions : a = 15.96-16.01 ${\AA}$, c = 7.15-7.16 ${\AA}$ for the brownish black tourmalines, a = 15.82 - 15.87 ${\AA}$, c = 7.09 - 7.10 ${\AA}$ for pink tourmalines, and a = 15.88 - 15.94 ${\AA}$, c = 7.12 - 7.15 ${\AA}$ for blue green tourmalines. The colors of tourmalines are responsible for the transition elements. The pink color is attributed to the $Mn^{3+}$ ions, the blue-green to $Fe^{2+}$ and $Mn^{2+}$, bluish green to $Cu^{2+}$, and the brownish black to $Fe^{2+}$, $Fe^{2+}$ - $Fe^{3+}$, and $Fe^{2+}$ - $Ti^{4+}$. The $Mn^{3+}$ ions of pink color tourmalines are stabilized in the Y sites compressed along the O(1)H-O(3)H axis by Jahn-Teller distortion. Heating removes the pink or red component from tourmalines, producing the colorless stones from the pink and red ones. The bluish green samples change into the greenish blue ones and a certain yellowish green samples change into the light green ones by heat treatment. In the elbaite-schorl series, the concentration of Fe and Mn are variable depending on the color zones. The green zone is characterrized by the high content of Fe and Mn are variable depending on the color zones. The green zone is characterized by the high content of Fe, whereas the pink zone by the high content of Mn. Mn increases in deep yellow zone compared with yellow or colorless zones.

• Korean Journal of Soil Science and Fertilizer
• /
• v.5 no.1
• /
• pp.41-47
• /
• 1972

An experiment was conducted to study the zinc deficiency of rice plant grown on Boeun soil of Korea and on Batangas soil of the philippines. The results obtained are summarized as follows: 1. Batangas soil was deficient in zinc because of the high pH, high organic matter and high calcium. Zinc content of the rice plant grown on Batangas soil was l6ppm. On the other hand, Boeun soil had low organic matter. Zinc content of the rice plant grown on Boeun soil was 33ppm. 2. The top leaf had higher zinc content than any other leaves. Zinc deficiency apparently occured when the zinc content of the rice plant was below 18ppm. 3. The physiologically acid fertilizer such as ammonium sulfate was more advantageous in improving zinc up take than the urea. 4. The zine deficiency was promoted when the Mn/Zn ratio is high, and zinc and manganess interact antagonistically in the growth of rice plant. 5. The zinc deficiency could be overcome by applying zinc chloride and fritted Trace elements to the Batangas soil, and the yield was significantly increased than conrtol.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.19 no.2
• /
• pp.187-193
• /
• 1990

Ganoderma lucidum has been widely used not only as ingredients in herbal medicine but also in pharmacological soft drinks. The author collected for analysis of content of 8 kinds of heavy metal(Cd, pb, Hg, Cu, Mn, Fe, As) in soil and cluture soil in an around the Taegu area including Sang Ju, Non Gong, Keum Ho, and Weol Bae. THe toxic content in Gaoderma lucidum showed relatively low level as in cadmium lead mercury arsenic : 0.8-0.13ppm 0.17-1.43ppm 0.02-0.32ppm 0.01-0.19ppm respectively : in copper mangenese zinc and iron : 0.93-4.29ppm, 0.37-2.18ppm 1.02-1.65ppm, 4.57-11.04ppm those grown in soil showed higher percentages of content than those grown on logs in lead copper zinc and iron by 43.2% 68.6%, 20.3% and 43.2% respectively. The content of heavy metals in those grown in soil and culture soil tended to be higher in the areas near factories of industrial complexes especially in manganese and iron. The content of heavy metals in soil and culture soil appeared lower than the mean values of Korean Soil. No interrelationship was found in the content of heavy metals between those of Ganoderma lucidum grown on logs and those grown in soil. In case of pot cultivation however the mushroom spawns are grown originally in soil which seems to influence the degree of content of heavy metals of media.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.12
• /
• pp.1326-1331
• /
• 2004

In this paper, we have investigated thermal properties and Impurities content of specimens showing by changing the content of carbon black that is semiconductive materials for underground power transmission. Specimens were made of sheet form with the three of existing resins and the nine of specimens for measurement. Impurities content of specimens was measured by ICPAES(Inductively Coupled Plasma Atomic Emission Spectrometer). Heat capacity(ΔH) and melting temperature(Tm) were measured by DSC(Differential Scanning Calorimetry). The ranges of measurement temperature were from $0^{\circ}C$ to 20$0^{\circ}C$, and heating temperature was 4$^{\circ}C$/min. And then thermal diffusivity was measured by LFA 447. The measurement temperature was $25^{\circ}C$. Impurities content was highly measured according to increasing the content of carbon black from ICPAES results. And heat capacity and melting temperature from the DSC results were simultaneously decreased according to increasing the content of carbon black, while thermal diffusivity was increased according to increasing the content of carbon black. Because ionic impurities of carbon black containg Fe, Co, Mn, Al, and Zn were rapidly increasing kinetic energy by vibration of ionic impurities through the applied heat energy.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.9
• /
• pp.455-458
• /
• 2004

In this paper, we investigated impurities content and physical properties showing by changing the content of carbon black that is semiconductive materials for underground power transmission. Specimens were made of sheet form with the three of existing resins and the nine of specimens for measurement. Impurities content of specimens was measured by ICP-AES (Inductively Coupled Plasma Atomic Emission Spectrometer), and density of specimens were measured by density meter And then specific heat (Cp) was measured by DSC (Differential Scanning Calorimetry). A ranges of measurement temperature were from $0^{\circ}[C]$ to $200^{\circ}[C]$, and heating temperature was $4^{\circ}[C/min]$. Impurities content was highly measured according to increasing the content of carbon black from this experimental result, also density was increased according to these properties. Especially impurities content values of the Al and A2 of existing resins were measured more than 4000［ppm］. Specific heat from the DSC results was decreased according to increasing the content of carbon black. Because ionic impurities of carbon black having Fe, Co, Mn, Al and Zn are rapidly passed kinetic energy increasing the number of times breaking during the unit time with the near particles according to increasing vibration of particles by the applied heat energy.

• Korean Journal of Soil Science and Fertilizer
• /
• v.28 no.2
• /
• pp.130-134
• /
• 1995

To investigate the influence of coal fly ash treatment on the heavy metal content in the infilteration water, 12t/10a/year of fly ash(Anthracite and Bituminous) were applicated at two paddy fields of different textured soils, clay loam and sandy loam, for 3 and 2 years, respectively. The infilteration waters were collected 30, 60 and 100cm of soil depth and the heavy metal contents were measured. In the paddy field of clay loam, the content of Zn in the infilteration water were increased with fly ash treatment and increasing soil depth, but it didn't show any significance. In the clay loam soil, successive application of fly ash for 3 years brought to increase Pb, Zn content in the infilteration water, Pb content was the highest at 100cm of soil depth, but the content of others were lower than non-treatment. In the paddy field of sandy loam, successive application of fly ash for 2 years increased Cd, Ni and Mn content in the infilteration water at anthracite ash application, but the contents of other elements were similar or lower than non-treatment.