• Journal of the Korean Geotechnical Society
• /
• v.30 no.2
• /
• pp.65-76
• /
• 2014

For soil improvement, sand mats or sand compaction piles are often constructed on soft marine clays. In such cases, some amounts of sand and clay are inevitably mixed. Sand or gravel often exists in the weathered soils near the slope surface. This research investigates the effect of mixing sand content on consistency limits and shear strength of clays. Firstly, sand was mixed with kaolinite or bentonite at 0, 9, 17, 23, 29, 33, 50% and then liquid and plastic limits were measured. Both plastic and liquid limits decreased as a sand content increased. The water content of clay-sand mixtures with different sand content increased by 10% or 20% step by step and then their undrained shear strength was measured using a portable vane shear device called Torvane. For all cases, undrained shear strength of clay-sand mixtures decreased rapidly until reaching a certain value. Their state changed from undrained to drained state gradually as the sand content increased, which caused their undrained shear strength to decrease. On the other hand, a series of direct shear tests were also conducted on such clay-sand mixtures to investigate the effect of sand content on cohesion and angle of internal friction. It was found from clay-sand mixtures that their cohesion decreased but angle of internal friction increased as the sand content increased.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.1
• /
• pp.8-13
• /
• 2016

This study investigated the removal of a radioactive cesium ($Cs^+$) in the water at the water treatment processes. Since cesium is mostly present as the $Cs^+$ ion state in water, it is not removed by sand filtration, and coagulation with polyaluminum chloride (PACl), powdered activated carbon (PAC) and mixture of PACl and PAC. However, it is known that the removal rate of cesium increases as the turbidity increases in raw water. As the turbidity was adjusted by 74 NTU and 103 NTU using the surrounding solids near G-water intake and yellow soils, removal rate of cesium was about 56% and 51%, respectively. In case of a GAC filtration with supernatants after jar-mixing/setting was conducted, 80% of cesium is approximately eliminated. The experimental results show that it is efficient to get rid of cesium when the turbidity of the raw water is more than 80 NTU. In case of a GAC filtration, about 60% of cesium is removed and it is considered by the effect of adsorption. Cesium is not eliminated by microfiltration membrane while about 75% of cesium is removed by reverse osmosis.

• Asian Journal of Turfgrass Science
• /
• v.16 no.1
• /
• pp.11-18
• /
• 2002

This research was designed to know optimize soil sampling time, soil sampling depth and fertilizers according to season and soil condition in the golf course. One of the results was revealed that sampling point and depth have to be consistent for much fluctuation by sampling. Especially, Soil pH is decreased by soil depth remarkably. Top soil (0-5 cm depth) pH is higher than the sub soils (5-10 cm, 10-15 cm depth). It was confirmed that soil pH would increase when the state of soil is appropriate to H$^{+}$ ion concentration. Therefore, Soil pH modification is always not determined by lime content rather than soil conditions, i.e., Organic matter content, moisture content, and soil air content. More effective fertilizing time according to soil pH correction is the middle of october, and it's quantity is 100 g/$m^2$ silicate and 200 g/$m^2$ lime (Pel-Lime Mini) in this experiment. Recommended soil sampling method for acidity measurement is dividing by soil depth into each 5 cm respectively, rather than mixing 15 cm total soil.

• Journal of the Korean GEO-environmental Society
• /
• v.18 no.5
• /
• pp.27-33
• /
• 2017

In this research, laboratory tests were carried out to investigate the engineering properties of Light-Weight Air Foamed Soil (LWAS) based on silty clays with the animal foaming agent and cement. LWAS has been used as an embankment material over soft ground for road and side extension of the existing road. In field, unit weight and flow value is measured right after producing in mixing plant in order to control the quality of LWAS, and laboratory tests are carried out to confirm the quality through compressive strength of LWAS as well. In this research, direct estimation of the specification requirement of strength using flow values in field is the main purpose of the study together with other characteristics. From the test results, it can be seen that flow values increase with the initial water content and unit weight increases with the depth due to material segregation. Compared to the upper specimen, lower end of 60 cm specimen shows about 2 times higher compressive strength. Relationship between flow values and normalized factor presented by Yoon & Kim (2004) was presented. With that relationship, compressive strength can be predicted from flow values in field. From the relationship, the normalized factor was calculated. Thereafter calculated compressive strengths according to the flow values were compared to measured strengths in the laboratory. The higher the initial water content of the dredged soil has, the better relationship between predicted and measured shows. Therefore it is necessary to predict the compressive strength in advance through the relationship between the flow value and the normalized factor to reflect it in the design stage.

• Economic and Environmental Geology
• /
• v.51 no.1
• /
• pp.49-65
• /
• 2018

The lime-soil mixture on tomb barrier (LSMB) is a type of tomb in Joseon Dynasty, which made with so-called 'Sammul' (three material compound) that mixture of lime, fine sand and yellow ocher. This study divided the tombs of the Gungri Site from Joseon Dynasty with layered wall and integrated wall according to the manufacturing types, and investigated on the basis of analysis to material characteristics and making techniques. Analytical samples were classified with lime-soil mixtures and soils, and interpreted the mixing characteristics of Sammul based on types of tomb barrier. The tomb barrier which is directly effect to control the inner environment was made with high content of lime. But the finishing or bottom layer were made with low content of lime. Overall the LSMB with integrated wall has higher content of lime and physical property than the LSMB with layered wall. The soil which was compounded as a Sammul and collected near the Gungri Site had similar with mineralogical and geochemical characteristics. Therefore, it is presumed that the fine sand and yellow ocher that made as a Sammul, were used with soil that was distributed around the site. Meanwhile, large scale limestone quarry is distributed near the site. Especially, Gungri Site has a possibility of material supply through water transport, due to the sea route from Asan bay is connected near the site. Thus, there is the possibility of transportation of lime materials from nearby quarry.

• Economic and Environmental Geology
• /
• v.29 no.6
• /
• pp.713-724
• /
• 1996

The time-series resident solute concentrations, monitored at two field plots using the automated 144-channel TDR system by Kim (this issue), are used to investigate the dominant transport mechanism at field scale. Two models, based on contradictory assumptions for describing the solute transport in the vadose zone, are fitted to the measured mean breakthrough curves (BTCs): the deterministic one-dimensional convection-dispersion model (CDE) and the stochastic-convective lognormal transfer function model (CLT). In addition, moment analysis has been performed using the probability density functions (pdfs) of the travel time of resident concentration. Results of moment analysis have shown that the first and second time moments of resident pdf are larger than those of flux pdf. Based on the time moments, expressed in function of model parameters, variance and dispersion of resident solute travel times are derived. The relationship between variance or dispersion of solute travel time and depth has been found to be identical for both the time-series flux and resident concentrations. Based on these relationships, the two models have been tested. However, due to the significant variations of transport properties across depth, the test has led to unreliable results. Consequently, the model performance has been evaluated based on predictability of the time-series resident BTCs at other depths after calibration at the first depth. The evaluation of model predictability has resulted in a clear conclusion that for both experimental sites the CLT model gives more accurate prediction than the CDE model. This suggests that solute transport at natural field soils is more likely governed by a stream tube model concept with correlated flow than a complete mixing model. Poor prediction of CDE model is attributed to the underestimation of solute spreading and thus resulting in an overprediction of peak concentration.

• Journal of the Korean GEO-environmental Society
• /
• v.23 no.9
• /
• pp.5-16
• /
• 2022

In recent years due to the development of urban and underground space, the number of ground disasters is increasing, and it is also leading to social problems. To solve the problem, a grouting method is generally used. However, the grouting method has material (grout) limitations in permeability, gelation properties and tensile resistance. Therefore, research on grout materials mixed with fibers is actively carried out to improve the problems. However, in the actual ground injection process, many difficulties have been faced causing the blockage of the inlet port and the injection tube. In this study, 'CNT-mixed grout material' was developed using CNT powder that can reinforce the tensile strength of soils. The uniaxial compressive and tensile strength tests were performed to obtain the optimal content and mechanical properties of the CNT Powder-mixed grout. It was found that the optimal CNT powder content is 0.5% that gives the average maximum strength. A one-dimensional injection test and the bulb formation test were carried out, and it was identified that the injection rate and bulb form could be controlled by pressure and mixing ratio. Field application of the CNT-Mixed grout is simulated using numerical analysis of slopes, foundations, and tunnels reinforced in several types. The positive effect of reducing plastic ranges and settlements was confirmed.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.27 no.3
• /
• pp.276-282
• /
• 1982

To estimate the responses of sesame plant in growth and yielding traits to different soil drainage conditions, a pot trial was conducted by using of sesame variety "Suweon-9" were introduced with 5 different mixing combinations of clay and sea-sand soils as 0:100, 25:75, 50:50, 75:25, and 100:0 percents in volumetric ratio. Also two irrigation methods as 20mm/6 days interval and 10mm/3 days interval were detected. As a result, water drainage was linearly decreased with increament of clay contents. And the excess drainage condition(such as pure sand soil) required more irrigation, however in crop growths, no significant differences among various soil drainage conditions except the pure sand were recognized. On the other hand, number of capsules per plant, among other yielding components, was most contributed factor to the yield, which was effectively given from the soil mixed with clay and sea-sand as 75% and 25%, respectively. Therefore, much similar responses were also detected from the seed yields per a sesame plant. However, the number of seeds per capsule and maturity function were more effectively composed under the soil mixed with clay and sea-sand as 25% and 75% respectively better than under the soil of 75% and 25%. As a conclusion, the yielding responses of sesame plant was advanced more effectively at the soil conditions of water conserved type (e.g. 25%/75% in clay/sand ratio) than of water-draining type (e.g. 75%/25% in clay/sand ratio).nd ratio).

• Journal of the Korean GEO-environmental Society
• /
• v.25 no.5
• /
• pp.39-47
• /
• 2024

In this study, the environmental implications of electric arc furnace steel slag, commonly used in road construction and soil reinforcement, were examined. Experiments were conducted to assess the leaching of heavy metals based on particle size and to investigate ion leaching from specimens with varying mixtures of steel slag and clay. The official waste test revealed no detectable heavy metals in the sample items. However, when subjected to leaching experiments and analyzed using ICP-OES, certain heavy metals were found. The reaction of steel slag with water, facilitated by free CaO within the slag, was identified as the cause of leaching. Results showed that aluminum, exhibiting the highest leaching rate, displayed an inverse relationship with particle size. In mixed soil containing steel slag and clay, higher steel slag content resulted in increased aluminum leaching. Nonetheless, the quantity of leached aluminum was notably lower in mixed soil compared to pure steel slag. Furthermore, leaching of other heavy metals remained within acceptable limits. These findings suggest that recycling mixed soil of steel slag and clay for road construction or soil stabilization presents reduced environmental risks compared to using steel slag alone. Utilizing such mixtures could offer an environmentally sustainable and safe alternative.

• Economic and Environmental Geology
• /
• v.42 no.6
• /
• pp.527-539
• /
• 2009

The Kumho River flows through volcanic and sedimentary rocks at upstream and downstream regions and also through industrial district including dyeing complex before it meets the Nakdong River, and as a result, many factors can influence the geochemistry of river water. The concentrations of dissolved ions generally increased as it flows downstream. The concentrations of cations are in the order of Ca>Na>Mg>K, and those of anions are $HCO_3$>$SO_4$>Cl>$NO_3$. These results show that the weathering of sandstone and shale containing carbonate including calcite caused the enrichment of Ca and $HCO_3$. At first 4 sampling sites, Si contents are relatively high mainly due to the weathering of silicate minerals of volcanic rocks. However, Na and $SO_4$ contents are higher at downstream sites due to the industrial and municipal sewage. Piper diagram also shows that the geochemical patterns changed from Ca-$HCO_3$ to Ca-Cl/Ca-$SO_4$ and Na-Cl/Na-$SO_4$ type. When comparing the samples collected in May and July, the concentrations of dissolved ions in July are generally lower than those in May, which indicates that dilution by precipitation played an important role. In July the relative concentration of Ca increased, indicating that Ca in soils probably from fertilizer were mixed into the river water by precipitation. The river waters are mainly from precipitation. The dissolved ions are mainly from weathering of carbonate minerals and pollutants from municipal sewage and discharged water from industrial complex. The composition of oxygen and deutrium isotope in July showed higher values, which is contrary to the amount effect, maybe due to Youngchon Dam. The nitrogen isotope showed lower values in July than those in May, which can be interpreted to indicate mixing of nitrate from soils and fertilizer in the cultivated land by the heavy rain. The isotope composition of nitrate increased downstream, indicating that the influence of sewage and animal manure also increased downstream.