• 유기물자원화
• /
• 제3권2호
• /
• pp.47-57
• /
• 1995

본 연구의 목적은 유기성폐기물 퇴비화시 교반강도가 퇴비화공정에 미치는 영향을 알아보기 위한 것이다. 주된 연구지표는 교반강도와 초기수분함량이었다. 본 연구를 위하여 기계식 교반장치를 갖춘 실험실규모의 퇴비화반응조가 이용되었다. 실험대상폐기물은 생분뇨슬러지와 감압증발처리공정을 거친 분뇨슬러지, 그리고 돈분을 이용하였다. 초기수분함량이 60%와 63% 인 경우 연속교반시 간헐교반보다 유기물분해율이 더 높게 나타났다. 또한 시료의 물리적 성상도 연속교반이 간헐교반보다 더 균등질의 양호한 상태를 나타내었다. 한편 초기 수분함량 68%인 경우는 혼합되기 보다는 시료 일부가 반죽상태를 형성하는 문제가 발생하였으며 유기물분해율도 연속교반의 경우가 간헐교반보다 더 낮게 나타났다.

• 한국안전학회지
• /
• 제7권3호
• /
• pp.73-82
• /
• 1992

This paper was concerned with the risk evaluation of oxidizing substances by burning test method. The samples were prepared the heaped cone-shaped mixtures of solid oxidizing sub-stance with sawdust, and ignition of the sample was made on contact with heating wire inside the combution chamber that the temperature and humidity of atmosphere can be kept at $25^{\circ}C$ and 60% respectively. Accordingly, it were measured the combustivity effect of mixing ratio and amount of sample weight on the burning rate. As a result of burning test of these samples, it could be noticed that the case when the sawdust has so and 30 wt.% in the mixing ratio shows effective combustivity, and as the amount of sample weight was increasing, It showed more rapid burning time. So the average burning time could be obtained by considering the weighting factors to the parameters of the mixing ratio and the amount of sample weight. Finally, it was compared with the effects of cation and anion of oxidizing substances and also applied analytically to the classification and evaluation of oxidizing sub-stances as dangerous goods.

• Preventive Nutrition and Food Science
• /
• 제5권4호
• /
• pp.197-199
• /
• 2000

Clarified fruit and vegetable juices (apple, carrot and tangerine) were produced using ultrafiltration and their color change due to the mixing ratio were evaluated. clarification was carried out by passing he supernatant of extracted juice through a filter and also by using a membrane of molecular weight cut-off 10,000 Daltons to obtain the juice ultrafiltrates. The mixing ratio between apple and carrot juices was kept constant at 1:1 while increasing the amount of tangerine juice according to 10, 20, 30, 40 and 50% an stored at 4$^{\circ}C$ prior to the color measurement. Hue angle ({TEX}$h_{ab}${/TEX}) and {TEX}$L^{*}${/TEX}-value increased as the tangerine mixing ratio increased. The color difference indicated by ΔE-value also increased as the amount of tangerine increased indicating that the color of the mixed juice became pale and the changes were slight but distinctive. On the other hand, chroma ({TEX}$C^{*}${/TEX}), {TEX}$La{*}${/TEX}- and {TEX}$b^{*}${/TEX}-values decreased as the tangerine mixing ratio increased indicating that the color of the mixed juice became slightly more grayish and the samples were becoming les yellow. A simple mathematical model to predict each color characteristic is proposed.

• 펄프종이기술
• /
• 제34권3호
• /
• pp.25-31
• /
• 2002

The purpose of this study was to analyze how the fiber properties and mixing ratio of softwood and hardwood pulp affect on roundness of printed image. Softwood pulp and hardwood pulp were refined to 400 and 600ml CSF by Valley beater and handsheets of 70 g/$m^2$ basis weight were made at different mixing ratios of hardwood and softwood pulp. The roundness, dot area, and shape of the printed dot were measured by Image Analyzer. The depths and shapes of the acridine orange penetration into paper were measured by CLSM. With higher mixing ratio of hardwood pulp, the paper showed higher air-permeability and better formation, especially at lower freeness. The roundness of the printed image became better and the dot size became smaller when the amount of hardwood pulp increased. Penetration depth of acridine orange by CLSM became greater and roundness increased to real circle when the amount of hardwood pulp increased. It was thought that higher mixing ratio of hardwood fibers resulted in efficient penetration by better formation with uniform micro-pore distribution and it increased roundness. It was thought that fiber properties and mixing ratio affected the structure of paper and the shape of the printed dot. This study showed that the measurement of depth of the liquid penetration into paper without destruction and contact was feasible. Moreover, this method showed that the shape of the liquid penetration was measurable.

• 한국건축시공학회지
• /
• 제8권5호
• /
• pp.59-65
• /
• 2008

In the evaluation method of KS on the activity factor of fly ash, same amount of cement should be replaced with fly ash. Therefore, contradictory effects on concrete strength exist, i. e. strength decease due to low content of cement and strength increase of strength due to filling-pore-function of fly ash. European Committee for Standardization (CEN) specifies the method 1 to 4. adding fly ash without reducing the content of cement, for the evaluation method on activity factor of fly ash. This study investigates the applicability of the method 2 of CEN to mix design of concrete. The followings are derived ; There is a key ratio of f)y ash mixing which enhances the incremental ratio of mixing water to improve fluidity of mortar. The incremental ratio of mixing water is maximized about 11% ratio of fly ash mixing. Compressive strength most slightly increases at that ratio of fly ash mixing. Activity factor of fly ash increases as water-cement ratio becomes low and contents of fly ash becomes high. Moreover, quality of fly ash and condition of mix design affect the applicable amount of fly ash and available range of water-cement ratio. However, this method has some problems for practical purpose because activity factors of fly ash for some cases are over 1.0. Further research should be conducted to develop more useful method of evaluating activity factor of fly ash.

• 한국지반환경공학회 논문집
• /
• 제25권6호
• /
• pp.5-12
• /
• 2024

현재 저수지 제체의 차수성 및 안전성 확보를 위해 약액을 저압으로 주입하여 제체 손상을 최소화하는 그라우팅 공법이 보편적으로 사용되고 있으나, 내구성 확보와 체계적인 고화재의 배합비 결정방법이 정립되어 있지 않은 문제들이 있다. 본 연구에서는 원지반과 고화재를 다양한 중량비율로 교반·혼합하였을 경우 혼합체의 투수계수와 강도를 실내시험을 통해 확인하였으며, 시험결과들의 분석을 통해 최적 배합비를 제안하였다. 실내실험을 위한 공시체는 고화재의 배합량을 고려하여 제작하였다. 투수시험용 공시체는 사질토와 점성토 별 고화재 배합량 1.5kN/m³에 대해 제작하였으며, 투수시험 결과 차수 성능이 확보되어 각종 설계기준을 만족하는 것을 확인하였다. 강도시험을 위한 공시체는 점성토의 경우 5가지, 사질토는 3가지 배합비로 각각 3개 총 24개의 시편을 제작하였으며, 시험 결과 사질토와 점성토 모두 배합량 2.0kN/m³ 이하에서는 일축압축강도가 재령일이 증가함에 따라 선형적으로 증가하는 경향을 나타냈다. 따라서 현장에 적용되는 최적의 배합비는 고화재 배합량을 1.5kN/m³ 및 2.0kN/m³으로 결정하였다. 또한 현재 운영 중인 노후 저수지 개보수사업 설계사례를 대상으로 실험성과를 반영한 수치해석을 실시한 결과 저수지 제체의 차수 및 안전성 증대 효과를 확인하였다.

• 한국환경보건학회지
• /
• 제26권4호
• /
• pp.129-133
• /
• 2000

The objective of this study was to invetigate the coagulation effects of landfill leachate by using Acid Mine Drainage(AND). The coagulation efficiency was investigated by mixing landfill leachate with F $e^{+3}$ solution earned by oxidation of pyrite(AMD). In the results of this experiment, it was found that the amount of removed COD and SS was approximately 30% respectively by mixing at the ratio of AMD three to leachate one. And it showed highest turbidity removal efficiency at all mixing ratio. Concentration of Fe was decreased with increasing mixing ratio, however it was increased inversely at mixing ratio 4. Optimal mixing ratio was 3 at the results obtained by leachate coagulation experiments. Also removal efficiency at mixing ratio 3 corresponded to 500mg/$\ell$ of FeC $l_3$ dosage. it was suggested that pretreatment by mixing of AMD and leachate remove both suspended organic material of leachate and metal of AMD.

• 한국해양환경ㆍ에너지학회지
• /
• 제11권2호
• /
• pp.92-97
• /
• 2008

일반적으로 해수가 강으로 침입하거나 담수가 해양으로 유입을 하면 두 유체간의 밀도차에 의한 밀도류의 성질을 가진다. 하지만, 염분과 온도가 동시에 밀도의 차를 결정하는 경우, 특히 이 중 하나가 중력과 불안정한 수직 분포를 갖게되면 이중확산이 혼합을 결정하는 중요한 요인이 된다. 본 연구에서는 고온, 고염의 수괴가 저온, 저염의 수괴로 진입할 때 기계적 혼합과 이중확산에 의한 대류가 혼합에 미치는 상대적 영향을 비교 연구하였다. 실험실에서 차갑고 염도가 없는 주 흐름에 온도가 높고 염분이 높은 밀도류를 조심스럽게 방류시켜 정상상태의 염수침입 형태를 유지하였다. 수평방향으로 따라 밀도율(Turner 1979)이 15정도 되면 온도와 염분의 유출입량비율이 가파르게 변화하였고, 전체적으로 방출구 부분에서 이중확산의 영향이 강하게 나타나게 되며 이 경우에는 총 방출량도 함께 증가하였다. 아울러 밀도율이 낮은 경우 밀도율이 높은 경우에 비해서 약 $6{\times}10$배의 높은 혼합율을 보였다.

• 센서학회지
• /
• 제14권5호
• /
• pp.291-296
• /
• 2005

In this paper, the PDMS based micromixer having 3-dimension triangular structure has been developed for the reaction of samples in the micro volume. The mixing efficiency was measured according to the change of Reynolds number (Re: 0.08, 0.8, 8, 16) and channel height (100, 200, $300{\mu}m$). Total length of mixing region is 7.4 mm and the measured mixing efficiencies at the outlet were over 85 %. Within the mixing length 2.4 mm, the mixing efficiencies were more than 70 % at any Reynolds numbers, and this indicates the strong mixing has occurred inside the mixing channel due the triangular structures. By employing these 2 mixers, we have fabricated the microreactor to detect the glucose-catalysts reaction. The microreactor showed good reactivity of glucose and enzymes with the small amount of sample solution.

• Journal of Pharmaceutical Investigation
• /
• 제41권2호
• /
• pp.83-90
• /
• 2011

Main objectives of this study were to investigate the effects of a lubricant, magnesium stearate, as blended in a hydrophilic matrix tablet and to identify significant factors using a tablet ejection force and a swelling property. The characteristics of tablet ejection were evaluated with three different compression forces (30, 40, and 60 MPa) and two controlled factors, amount of magnesium stearate and its mixing time. A hydrophilic model drug (terazosin HCl dihydrate) was regarded as a default factor. Tablet swelling was also evaluated. The optimal amount of PEG compared to PEO was set to be 88.50% w/w. As the amount of magnesium stearate was varied from 0.79% to 2.20% w/w, the amount of PEO and PEG was adjusted to meet the tablet's total weight while maintaining the ratio between the two excipients constant. As the mixing time of magnesium stearate was increased, the tablet ejection force and the swelling property were decreased. As the amount of magnesium stearate was increased, the tablet ejection force and the swelling property were decreased since the increased mixing time and the amount of magnesium stearate induced hydrophobic properties of the matrix tablet more effectively. The ejection force of the tablet increased as a result of increase in the compression force, which means that the breaking of tablet/die-wall adhesion energy was also increased when the compression energy was increased. The results gavea valuable guide how to choose suitable amount of the lubricant with processing conditions for the development of hydrophilic matrix formulations.