• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.39 no.4
• /
• pp.68-75
• /
• 2007

In order to supplement insufficient nutrients of paper sludges, additional materials such as saw dust and rice husk were added during preparation of bed soils. Rice husk was more finely ground, compared to saw dust. The fine particles of the rice husk prevented their flow in a barrel of the expander. The mixed additives with paper sludges could be used to control the quantity of required nutrients for raising plants. That is, except for potassium and manganese, most of nutrients were decreased with adding the additives to paper sludge. The acidity of the paper sludges mixed with the saw dust or the rice husk was a little decreased with the increased amount of the additives. Differently from the bulk density of the paper sludges, the moisture content and the water absorption rate of the paper sludges were incremented with increasing the additives.

• Nuclear Engineering and Technology
• /
• v.55 no.9
• /
• pp.3450-3463
• /
• 2023

In the two-step analysis of Pebble-Bed type High-Temperature Gas-Cooled Reactor (PB-HTGR), the lattice physics calculation for the generation of homogenized cross-sections is based on the fuel pebble. However, the randomly-dispersed fuel particles in the fuel pebble introduce double heterogeneity and randomness. Compared to the deterministic method, the Monte Carlo method which is flexible in geometry modeling provides a high-fidelity treatment. Therefore, the Monte Carlo code NECP-MCX is extended in this study to perform the lattice physics calculation of the PB-HTGR. Firstly, the capability for the simulation of randomly-dispersed media, using the explicit modeling approach, is developed in NECP-MCX. Secondly, the capability for the generation of the homogenized cross-section is also developed in NECP-MCX. Finally, simplified PB-HTGR problems are calculated by a two-step neutronics analysis tool based on Monte Carlo homogenization. For the pebble beds mixed by fuel pebble and graphite pebble, the bias is less than 100 pcm when compared to the high-fidelity model, and the bias is increased to 269 pcm for pebble bed mixed by depleted fuel pebble. Numerical results show that the Monte Carlo lattice physics calculation for the two-step analysis of PB-HTGR is feasible.

• Journal of the Korean Society of Safety
• /
• v.14 no.3
• /
• pp.84-92
• /
• 1999

The effects of air velocity and excess air on combustion characteristics were studied in a fluidized bed combustor. The domestic low-grade anthracite coal with heating value of 2010 kcal/kg and the imported bituminous coal from Australia with heating value of 6520 kcal/kg were used as coal samples. The combustion characteristics of mixed fuels in a fluidized bed combustor could be interpreted by pressure fluctuation properties, ash distribution and gas emission. The properties of the pressure fluctuations, such as the standard deviation, cross-correlation function, dominant frequency and the power spectral density function, were obtained from the statistical analysis. From this study, the combustion region increased with increasing air velocity but decreased with excess air due to combustion characteristics of anthracite and bituminous coal.

• Journal of Microbiology and Biotechnology
• /
• v.9 no.3
• /
• pp.265-270
• /
• 1999

A three phase fluidized bed bioreactor immobilized with Thiobacillus sp. IW was tested to remove hydrogen sulfide and methylmercaptan with high loading rate. In a single gas treatment, the bioreactor removed 92- 98％ of hydrogen sulfide with loading rate of 15- 66 g/l/h and removed 87-98％ of methylmercaptan with loading rate of 14-60 gl/sup -1/h/sup -1/. In the mixed gas treatment, the removal efficiencies of hydrogen sulfide and methylmercaptan maintained at 89-99％ for various inlet loading rates and were not affected by the inlet loading ratio of both gases in low loading rates. When the inlet concentration of methylmercaptan increased 3.8 times and was maintained for 30 h to observe the response of the bioreactor to sudden environmental change, the removal efficiency of methylmercaptan was maintained at an average of 91％.

• Journal of Korea Water Resources Association
• /
• v.37 no.5
• /
• pp.387-395
• /
• 2004

A computer model was proposed to simulate channel changes and bed material sorting of the meandering channels with different grain size in time and space simultaneously. The bed at the outside of the meandering channel with mixed sediments was scoured deeply and composed of coarser materials, and at the inside was aggradated and composed of finer materials. The sorting process started at the upstream inflection point and was finished at the downstream inflection point. At the natural with complicated boundaries and non-uniform grain sizes, the bed near the outside at the bend and narrow width was scoured deeper with coarse materials than in the channel with uniform grain sizes. The point bars showed lip at the inside near the bend and the bed materials were finer The bed at the outside near the bend and in the narrow width was scoured deeply with the coarser materials.

• Transactions of the Korean hydrogen and new energy society
• /
• v.23 no.4
• /
• pp.337-345
• /
• 2012

To check effects of operating variables on reaction characteristics of WGS catalyst for SEWGS process, water gas shift reaction tests were carried out in a pressurized fluidized bed reactor using commercial WGS catalyst and sand(as a substitute for $CO_2$ absorbent) as bed materials. Simulated syngas(mixed with $N_2$) was used as a reactant gas. Operating temperature was $210^{\circ}C$ and operating pressure was 20 bar. WGS catalyst content, steam/CO ratio, gas velocity, and syngas concentration were considered as experimental variables. CO conversion increased as the catalyst content and steam/CO ratio increased. CO conversion at fluidized bed condition was higher than that of fixed bed condition. However, CO conversion were maintained almost same value within the fluidized bed condition. CO conversion decreased as the syngas concentration increased. The optimum operation condition was confirmed and long time water gas shift reaction test up to 24 hours at the optimum operating conditions was carried out.

• Journal of Mechanical Science and Technology
• /
• v.16 no.10
• /
• pp.1336-1345
• /
• 2002

A triboelectrostatic separation system using a fluidized bed tribocharger for the removal of PVC material in the mixture of PVC/PS plastics is designed and evaluated as a function of electric field strength, air flow rate, and the mixing ratio of two-component mixed plastics. It consists of a fluidized-bed tribocharger, a separation chamber, a collection chamber and a controller. PVC and PS particles can be imparted negative and positive surface charges, respectively, due to the difference in the work function values of plastics suspended in the fluidized-bed tribocharger, and can be separated by passing them through an external electric field. Experimental results show that separation efficiency is strongly dependent on the electric Deld strength and particle mixing ratio. In the optimum conditions of 150 Ipm air flow rate and 2.6 kV/cm electric field strength a highly concentrated PVC (99.1%) can be recovered with a yield of more than 99.2% from the mixture of PVC and PS materials for a single stage of processing.

• Journal of Electrochemical Science and Technology
• /
• v.8 no.3
• /
• pp.236-243
• /
• 2017

A fixed-bed zinc/nickel redox flow battery (RFB) is designed and developed. The proposed cell has been established in the form of a fixed bed RFB. The zinc electrode is immersed in an aqueous NaOH solution (anolyte solution) and the nickel electrode is immersed in the catholyte solution which is a mixture of potassium ferrocyanide, potassium ferricyanide and sodium hydroxide as the supporting electrolyte. In the present work, the electrode area has been maximized to $1500cm^2$ to enforce an increase in the energy efficiency up to 77.02% at a current density $0.06mA/cm^2$ using a flow rate $35cm^3/s$, a concentration of the anolyte solution is $1.5mol\;L^{-1}$ NaOH and the catholyte solution is $1.5mol\;L^{-1}$ NaOH as a supporting electrolyte mixed with $0.2mol\;L^{-1}$ equimolar of potassium ferrocyanide and potassium ferricyanide. The outlined results from this study are described on the basis of battery performance with respect to the current density, velocity in different electrolytes conditions, energy efficiency, voltage efficiency and power of the battery.

• Journal of Mushroom
• /
• v.13 no.3
• /
• pp.250-255
• /
• 2015

In this study spent mushroom substrate has ingredient raising rice bed soil. spent mushroom substrates are organic content is 60.72% were nitrogen - phosphoric acid - potassium is 1.39 - 0.89 - 0.81% of the chemical characteristics determine. Post-harvested mushroom substrates of the stabilization process, the temperature of the 20 days time progress in the pH of the rise and fall of temperature down were germination index also 77, as identified, Spent mushroom substrate bed soil for raising rice Ingredient to take advantage of the 20 days or more stabilization process needed to be investigated. Rice seed germination characteristic is in the common bed soil for raising rice ingredients manufactured control group and the comparison in spent mushroom substrate is 10% or less of a mixed experimental population of the germination rate is 82% was more than average days to germination and germination energy, even a statistical significant difference is or control group than good level was ok. Growth initial also spent mushroom substrate is 10% or less of a mixed experimental population of shoot dry matter (top) and grave less than control group higher as confirmed spent mushroom substrates are bed soil for raising rice ingredients are likely to take advantage of the high, as was the judge.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.391-394
• /
• 2004