• Journal of information and communication convergence engineering
• /
• v.14 no.4
• /
• pp.268-271
• /
• 2016

An efficient inductive switching noise suppression technique for mixed-signal integrated circuits (ICs) using standard CMOS digital technology is proposed. The proposed design technique uses a parallel RC circuit, which provides a damping path for the switching noise. The proposed design technique is used for designing a mixed-signal circuit composed of a ring oscillator, a digital output buffer, and an analog noise sensor node for $0.13-{\mu}m$ CMOS digital IC technology. Simulation results show a 47% reduction in the on-chip inductive switching noise coupling from the noisy digital to the analog blocks in the same substrate without an additional propagation delay. The increased power consumption due to the damping resistor is only 67% of that of the conventional source damping technique. This design can be widely used for any kind of analog and high frequency digital mixed-signal circuits in CMOS technology

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.20 no.1
• /
• pp.1-6
• /
• 2010

CuInGaSe(CIGS) mixed-source was prepared by hydride vapor phase epitaxy (HVPE). Each metal was mixed in regular ratio and soaked at $1090^{\circ}C$ for 90 minutes in nitrogen atmosphere. After making the mixed-source to powder state, the pellet was made by the powder. The diameter of pellet is 10 mm. The CIGS thin film was deposited on soda lime glass evaporated Mo layer bye-beam evaporator. To confirm the crystallization, we measured X-ray diffraction (XRD). High intensity X-ray peaks diffracted from (112), (204)/(220), (116)/(312) and (400) of CIGS thin film and from (110) of Mo were confirmed by XRD measurement.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.2
• /
• pp.61-65
• /
• 2009

In this paper, we report on the growth and optical characteristics of white-LED without fluorescent material. The growth of DH(double heterostructure) with AlGaN active layer was performed on a n-GaN/(0001) $Al_{2}O_{3}$ by the mixed-source HVPE and multi-sliding boat. The CRI(color rendering index) of packaging device charged in the range 72-93 with CIE chromaticity coordinates(x=$0.26{\sim}0.34$, y=$0.31{\sim}0.40$). And CCT(correlated color temperature) values was measured $5126{\sim}10406K$ with increasing injection current. The CIE point of conventional phosphor white LED shifts blue region, but cm point of non-phosphor white LED shifts opposite direction. These results show the mixed-source HVPE can be possible to newly fabricate method of phosphor free white LED with high CRI value.

• Journal of the Korean Solar Energy Society
• /
• v.26 no.4
• /
• pp.9-16
• /
• 2006

Geothermal-energy has been getting popular as a natural energy source for green buildings these days. Public building with gross area more than $3000m^2$, planned after March, 2005, should spend about 5% of total building cost for equipment run by natural energy source (e.g. geothermal, solar heat, solar power, etc) according to renewable energy promotion law in Korea. As a result geothermal-energy using heat pump system is emerging as a effective alternative for realistic and economic plan although design guidelines and construction code for the system is in progress and technical data is far from sufficient. The quantitative analysis on the performance of geothermal-energy using heat pump system is insufficient for appropriate design of it. In this paper, cooling performance of geothermal-energy using heat pump system of residential and retail etc. mixed-use building has been analyzed on the basis of temperature comparison between inlet and outlet of heat exchangers of the operating system. Additionally, dry-bulb temperature and relative humidity have been measured and analyzed together as an index of indoor thermal environment.

• Journal of Korean Society on Water Environment
• /
• v.24 no.3
• /
• pp.345-353
• /
• 2008

In order to design storage-based non-point source management facilities, the aspect of statistical features of the entire precipitation time series should be considered since non-point source pollutions are delivered by continuous rainfall runoffs. The 3-parameter mixed exponential probability density function instead of traditional single-parameter exponential probability density function is applied to represent the probabilistic features of long-term precipitation time series and model urban stormwater runoff. Finally, probability density functions of water quality control basin overflow are derived under two extreme intial conditions. The 31-year continuous precipitation time series recorded in Busan are analyzed to show that the 3-parameter mixed exponential probability density function gives better resolution.

• Journal of Microbiology and Biotechnology
• /
• v.16 no.9
• /
• pp.1331-1337
• /
• 2006

A mathematical model has been proposed for the batch culture of Agaricus blazei with mixed carbon sources of glucose and dextrin. In the proposed model, the metabolism of A. blazei was divided into three parts: cell growth, exopolysaccharides (EPS) production, and another EPS production pathway activated by dextrin hydrolysis. Each pathway was described mathematically and incorporated into the mechanistic model structure. Batch cultures were carried out with six different carbon source compositions. Although parameters were estimated by using the experimental data from the two extreme cases such as glucose only and dextrin only, the model represented well the profiles of glucose, cell mass, and EPS concentrations for all the six different carbon source mixtures, showing a good interpolation capability. Of note, the lag in EPS production could be quite precisely predicted by assuming that the glucose-to-cell mass ratio was the governing factor for EPS production.

• Horticultural Science & Technology
• /
• v.31 no.4
• /
• pp.415-422
• /
• 2013

This study was conducted to establish the optimum LED light source and quality for growth of Wasabia japonica seedlings in the LED chamber plant factory system. The light treatments were combined with four colors LED (red, blue, white, far-red), irradiation time ratio of the red and blue LED per minute(1:1, 2:1, 5:1, 10:1), and duty ratio of mixed light (100%, 99%, 97%). The growth response of W. japonica was the greatest in the R + B mixed light treatment, and seedlings grown in the red LED alone was higher than blue LED alone in the monochromic radiation treatments. In the R + B mixed LED, 1:1 ratio of R and B was the best for total biomass and tiller production. In mixed light treatments, the growth response of W. japonica was highest in the 100% duty ratio with R + B mixed light, while that was highest in the 97% duty ratio with R + B + W mixed light. Leaf area and dry weight were increased in the red light treatment alone, while specific leaf area was increased in the blue light alone. With the increasing red LED light ratio, leaf area and dry weight of W. japonica was significantly increased under the R + B mixed light treatment. In mixed light treatments, the leaf growth responses of W. japonica was highest in the 97% duty ratio with R+B mixed light, while that was highest in the 100% duty ratio with R + B + W mixed light. For cultivating W. japonica in a plant factory, treating red LED supplemented with a blue light or higher ratio of the red to blue LED was benefit to promote the growth of W. japonica.

• Asian-Australasian Journal of Animal Sciences
• /
• v.9 no.1
• /
• pp.45-49
• /
• 1996

A series of in vitro experiments was conducted to investigate response of rumen bacterial deamination to the ionophore salinomycin. Addition of salinomycin to the inoculum, strained rumen fluid, depressed ammonia production from casein, while increased accumulation of ${\alpha}$-amino acids. This suggests an inhibitory effect of salinomycin on ruminal deamination. When the effect in washed bacterial suspension was monitored with individual amino acid, aspartic acid degradation was markedly inhibited by salinomycin. This inhibition was not observed when the mixed rumen bacteria were ultrasonically disrupted and used as the enzyme source. Extent of the inhibition tended to be higher in the bacteria source from sheep on a high roughage diet. From these results it was speculated that the inhibition of deamination with salinomycin is caused by a decreased transport of amino acid into the bacterial cells as well as a decreased proportion of deaminating bacteria in the rumen.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05b
• /
• pp.663-668
• /
• 1996

A two-dimensional continuum model for the prediction of the hydrogen mixing phenomena in the containment compartment under the severe accident conditions is developed. The model could predict well the distribution of time-dependent hydrogen concentration for selected HEDL Experiment. For a simulation of these experiments, the hydrogen is mixed uniform over the test compartment. To predict the extent of non-uniform distribution, the dominant factors such as the geometrical shape of obstacle and velocity of source injection in mixing phenomena are investigated. If the obstacle disturbing the flow of gas mixture exists in the compartment, the uniform distribution of hydrogen may be not guaranteed. The convective circulation of gas flow is separately formed up and down of the obstacle position, which makes a difference of hydrogen concentration between the upper and lower region of the compartment. The recirculation flow must have a considerable mass flow rate relative to velocity of the source injection to sustain the well-mixed conditions of hydrogen.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2531-2533
• /
• 2001

This paper describes a low noise and high efficiency analog-digital switching mixed mode battery charger for production facilities of Li-Ion batteries. The requirements for battery chargers for production facilities are very strict. The accuracy of output voltage and output current should be below 0.1% with very low ripple current. Therefore analog type linear regulators are widely used for battery charger in spite of their inefficiency and bulkiness. We combined linear regulator as a voltage source with digital switching converter as a dependent current source. Low current ripple and high accuracy are obtained by linear regulator while high efficiency is achieved by digital switching converter. Experimental results show that proposed method has 0.1% ripple and 90% efficiency at an output current of 1A for a battery voltage of 4V.