• Journal of the Korean Chemical Society
• /
• v.58 no.3
• /
• pp.277-282
• /
• 2014

The optical purity of 11 commercial dexibuprofens and 7 ibuprofens sold in Korea in 2013 were examined by chiral HPLC. The Chiralcel OD-H column and LUX-Cellulose-1 column were used as chiral stationary phases and the mixed eluent of hexane:isopropanol:acetic acid as 100:1:0.1 was used as a mobile phase with a flow rate of 1.0 mL/min. Each data was obtained from an average value of at least three different experiments for each sample and the average value of relative standard deviation of them appeared very small, 0.19%. Average optical purity value (97.5%) of eleven commercial dexibuprofens used in this study were smaller than those of 9 years ago (99.2%), but larger than four years ago (95.6%). Enantiomeric ratios of (R)- and (S)-isomers of seven ibuprofen samples used in this experiment were achieved at about 50:50 which was different with the result (44:56) from four years ago.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.8
• /
• pp.117-124
• /
• 2009

This paper describes a 3 to 5 GHz frequency synthesizer for MB-OFDM (Multi-Band OFDM) UWB (Ultra- Wideband) application using 0.13 ${\mu}m$ CMOS process. The frequency synthesizer operates in the band group 1 whose center frequencies are 3432 MHz 3960 MHz, and 4488 MHz. To cover the overall frequencies of group 1, an efficient frequency planning minimizing a number of blocks and the power consumption are proposed. And, a high-frequency VCO and LO Mixer architecture are also presented in this paper. A new mixed coarse tuning scheme that utilizes the MIM capacitance, the varactor arrays, and the DAC is proposed to expand the VCO tuning range. The frequency synthesizer can also provide the clock for the ADC in baseband modem. So, the PLL for the ADC in the baseband modem can be removed with this frequency synthesizer. The single PLL and two SSB-mixers consume 60 mW from a 1.2 sV supply. The VCO tuning range is 1.2 GHz. The simulated phase noise of the VCO is -112 dBc/Hz at 1 MHz offset. The die area is 2 ${\times}$ 2mm$^2$.

• Progress in Superconductivity and Cryogenics
• /
• v.19 no.1
• /
• pp.36-41
• /
• 2017

The effects of $MgB_4$ addition on the superconducting properties and the microstructure of in situ processed $MgB_2$ bulk superconductors were studied. $MgB_4$ powder of 1-20 wt.% was mixed with (Mg + 2B) powder and then pressed into pellets. The pellets of (Mg + 2B + $xMgB_4$) were heat-treated at $650^{\circ}C$ for 1 h in flowing argon. The powder X-ray diffraction (XRD) analysis for the heat-treated samples showed that the major formed phase in all samples was $MgB_2$ and the minor phases were $MgB_4$ and MgO. The full width at half maximum (FWHM) values showed that the grain size of $MgB_2$ decreased as the amount of $MgB_4$ addition increased. $MgB_4$ particles included in a $MgB_2$ matrix is considered to suppress the grain growth of $MgB_2$. The onset temperatures ($T_{c,onset}$) of $MgB_2$ with $MgB_4$ addition (0-10 wt.%) was between 37-38 K. The 20 wt.% $MgB_4$ addition slightly reduced the $T_{c,onset}$ of $MgB_2$ to 36.5 K. This result indicates that $MgB_4$ addition did not influence the superconducting transition temperature ($T_c$) of $MgB_2$ significantly. On the other hand, the small additions of 1-5 wt.% $MgB_4$ increased the critical current density ($J_c$) of $MgB_2$. The $J_c$ enhancement by $MgB_4$ addition is attributed not only to the grain size refinement but also to the possible flux pinning of $MgB_4$ particles dispersed in a $MgB_2$ matrix.

• Microbiology and Biotechnology Letters
• /
• v.44 no.2
• /
• pp.124-129
• /
• 2016

The extraction and purification of the anti-hyperglycemic α-glucosidase inhibitor from an edible mushroom, Pleurotus cornucopiae, were investigated. The inhibitor was maximally extracted when the P. cornucopiae fruiting body was treated with distilled water at 30℃ for 12 h. Purification was achieved using Sephadex G-100 and G-50 filtration chromatography, pepsin hydrolysis, and reverse-phase HPLC. The compound’s solid yield and inhibitory activity were 12.2% and 9.10 mg/ml of IC₅₀, respectively. The purified inhibitor contained two hexapeptides with Thr-Ile-Ala-Phe-Ile-Asp (A) and Tyr-Tyr-Ala-Ile-Gly-Asp (B) sequences and molecular weights of 678.79 Da (A) and 643.7 Da (B). The purified inhibitor showed a mixed inhibition pattern to α-glucosidase and a dose-dependent anti-hyperglycemic effect in a streptozotocininduced diabetic Sprague-Dawley rat model, exhibited by decreased blood glucose levels at doses of 50 and 300 mg/kg.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.5
• /
• pp.949-957
• /
• 2000

This study investigates the remediation of the phenol or PNP(p-Nitrophenol) contaminated soils in a slurry reactor by a pure culture, P-99. The application of a pure culture for the phenol decontamination make the degradation rate three times faster than that of the mixed activated sludge. The destruction of 300 mg/L phenol was completed in 26 hours. As 1 mg of phenol was added, 0.1457 mg of microorganism was grown in the medium. The pure culture could not utilizes PNP, one of the xenobiotics, as a growth substrate. When the bacteria was induced by phenol enrichment medium. PNP could be effectively transformed with cometabolic process. The induction of the bacteria requires 1 mg of phenol for the destruction of 0.027 mg PNP. When PNP concentration in the medium contained phenol and PNP increased. the degradation rate of phenol was decreased. The degradation rate of phenol and PNP in the slurry reactor was about two times faster than in the reactor without slurry because of higher dissolved oxygen supply in the aqueous phase and adsorption on the surface of the soil.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.4
• /
• pp.645-650
• /
• 1998

Alumina- and yttria-coated SiC powder was prepared by the surface-induced precipitation method, and sintered properties of silicon carbide prepared from this powder were investigated. After a well dispersion of SiC powders in the aqueous solution of $Al_2(SO_4)_3$ and $Y_2(SO_4)_3$, the mixed precursors of aluminum hydroxide, aluminum carbonate, yttrium hydroxide, and yttrium carbonate were precipitated on the surfaces of SiC particles through the hydrolysis reaction of urea. SiC specimens with alumina and yttria exhibit, 97.8% of theoretical density after the sintering at $1900^{\circ}C$ for 2 hrs. During annealing at $2000^{\circ}C$, $\beta$longrightarrow$\alpha$ phase transformation of SiC had taken place and resulted with a rodlike microstructure. Toughness of sintered SiC was enhanced by crack deflection around the rodlike grains. In case of annealing less than that of 3 hr, the fracture toughness of SiC was slightly improved with increasing the amount of sintering aid. However, annealed specimens for a long time showed constant fracture toughness even though the amount of sintering aid increased. It is resulted that the main factor for toughening in annealed SiC for a long time is the pullout effect of rodlike grains during the propagation of cracks, and the amount of sintering aids is less effective on the fracture toughness of SiC.

• Journal of the Korea Concrete Institute
• /
• v.26 no.2
• /
• pp.201-210
• /
• 2014

The present study proposes a phased model to assess the lifecycle $CO_2$ amount of concrete structures. The considered system boundary is from cradle to recycling, which includes constituent material, transportation, batching and mixing in ready-mixed concrete plant, use and demolition of structure, and crushing and recycling of demolished concrete. The $CO_2$ uptake of concrete by carbonation during lifetime (40 years) of a structure and the recycling life (20 years) after demolition is estimated using a simple approach generalized to predict the carbonation depth from the surfaces of concrete element and recycled aggregates. Based on the proposed phased model, a performance evaluation table is realized to straightforwardly examine the lifecycle $CO_2$ amount of concrete structures. The proposed model demonstrates that the contribution of ordinary portland cement (OPC) to lifecycle $CO_2$ emission of the concrete structure occupies approximately 85%. Furthermore, the $CO_2$ uptake is estimated to be approximately 15~18% of the lifecycle $CO_2$ emissions of concrete structures, which corresponds to be 19~22% of the emissions from OPC production. Overall, the proposed $CO_2$ performance table is expected to be practically useful as a guideline to determine the $CO_2$ emission or uptake at each phase of concrete structures.

• Journal of the Korean Ceramic Society
• /
• v.40 no.5
• /
• pp.447-454
• /
• 2003

Samples were prepared by the solid-state reaction method. The nominal composition of the samples was B $i_{1.84}$P $b_{0.34}$S $r_{1.91}$C $a_{2.03}$C $u_{3.06}$ $O_{10+{delta}$ prepared from powder of B $i_2$ $O_3$, PbO, SrC $O_3$, CaC $O_3$, and CuO. They were pulverized, mixed with AgO, A $u_2$ $O_3$and MgO of 50 wt%. Finally, they were sintered at 820 to 85$0^{\circ}C$ in air. The structural characteristics, the microstructure of surface and the critical temperature with respect to the each samples were analyzed by XRD, $T_{c}$, SEM and EDS respectively. It was found that the the critical temperature of the silver oxide additive samples (99.58 K) is higher than those of gold or magnesium oxides additive samples, but all those values are lower than that of pure Bi-2223 phase. The microstructure of surface showed the tendency which the AgO additive samples become more minuteness than A $u_2$ $O_3$ and MgO additive samples.s.samples.s.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.73-79
• /
• 1999

The superstructured $Li_{4/3}Ti_{5/3}O_4$ was prepared by sol-gel process using a mixed solution of lithium acetate (LA) and titanium n-butoxide (TNB). The gel phase was obtained by adding ammonia water ($NH_4OH/TNB$ mole ratio of 0.35) and water ($H_2O/TNH$ mole ratio of 3.5) into the clear sol that was prepared after mixing TNB/LA mole ratio of 5/4 with AA/TNB mole raio of 0.125. It was found that the most suitable $Li_{4/3}Ti_{5/3}O_4$ was obtained by heat treatment of xerogel at $600^{\circ}C$ for 30 hrs. The synthesized $Li_{4/3}Ti_{5/3}O_4$ showed an initial discharge capacity of 174 mAh/g and the capacity loss of about 27.3% during 25 cycles in Li/1M $LiClO_4(in\;PC)/Li_{4/3}Ti_{5/3}O_4$ at current density of $0.15mA/cm^2$ and the voltage range of 0.5~3.0 V.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.124-128
• /
• 1999

The photochemistry of the derivatives of o-nitrobenzylcarboxyl esters or benzylsulfonyl derivatives has been well studied separately. But little attempt has been made to combine the fruits these two studies. Being photochemically active, benzylsulphonyl and intro groups should influence the reactivity of each other's, especially when the excited states are fully mixed due to the proximity of their location. The questions which should be clearly answered are; what kind of effect will be excerted to the other group, and whether these two functional groups are coupled in the course of the reaction. To answer the questions raised above, wer have synthesized two sulfonyl esters and four amides from the newly available starting material, 2-nitro-${\alpha}$-toluenesulfonyl chloride. The products identified from the exploratory solution photochemistry were cyclohexanol, phenol, cyclohexylamine, and sulfur dioxide. The results are not much different from the products originally anticipated. It has been temporarily concluded that there is little interaction between the benzyl sulfonyl group and ortho-nitro chromophore. The fact that a base (an amine) has been photochemically generated in solution photochemistry was further confirmed by and utilized in the solid phase quantitative photochemistry done on the film, so as to carry out the photochemical epoxide cure.