• Journal of the Korean institute of surface engineering
• /
• v.25 no.1
• /
• pp.24-33
• /
• 1992

Cr-N films were deposited on low-carbon steel sheets by the reactive arc-induced ion plating (AIIP). The influence of the deposition conditions (nitrogen pressure and substrate bias voltage) on the crystal orientation, morphology and microhardness of the Cr-N films has been investigated using x-ray diffractometer and scanning electron microscope. The impurities and contaminations on the surface and at the interface, and the layer-by-layer compositions of the film have been analyzed using scanning Auger multiprobe (SAM) and glow discharge spectroscope (GDS). The mixed state of Cr and Cr₂N turned out to have a fine fibrous structure. The Cr₂N films were deposited at a wide range of nitrogen flow rates. The orientations of Cr₂N films were mainly (110) and (111), and the intensity of the (111) peak increased as the substrate bias voltage increased. The microstructure of the Cr₂N film was dense and no columnar structure was observed. The films in the mixed state of Cr₂N and CrN were also dense without columnar structure. The maximum microhardness of the Cr-N films was 2400 kg/㎟ at 10 gf load.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.503-504
• /
• 2006

This paper presents the design and fabrication of a LC voltage-controlled oscillator (VCO) using 1-poly 6-metal mixed signal CMOS process. To obtain the high-quality factor inductor in LC resonator, patterned-ground shields (PGS) is placed under the symmetric inductor to reduce the effect from image current of resistive Si substrate. Moreover, due to the incapability of using thick top metal layer of which the thickness is over $2{\mu}m$, as used in many RF CMOS process, the structure of dual-metal layer in which we make electrically short circuit between the top metal and the next metal below it by a great number of via materials along the metal traces is adopted. The circuit operated from 2.63 GHz to 3.09 GHz tuned by accumulation-mode MOS varactor. The corresponding tuning range was 460 MHz. The measured phase noise was -115 dBc/Hz @ 1MHz offset at 2.63 GHz carrier frequency and the current consumption and the corresponding power consumption were about 2.6 mA and 4.68 mW respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.427-428
• /
• 2008

New high efficiency green light emitting phosphorescent devices with emission layers of [TCTA/TCTA:TAZ/TAZ]:Ir$(ppy)_3$ have been fabricated and evaluated in this paper. Among the devices having different thicknesses of TCTA:TAZ mixed layer in the total 300$\AA$-thick host of TCTA(80$\AA$)/TCTA:TAZ (50~100$\AA$)/TAZ, the device with host of TCTA(80$\AA$)/TCTA:TAZ(90$\AA$)/TAZ(130$\AA$) showed the best electroluminescent characteristics with the current density of 95 mA/$cm^2$ and luminance of 25,000 cd/$m^2$ at an applied voltage of 10V. The maximum current efficiency was 52 cd/A under the luminance of 400 cd/$m^2$.

• Journal of Information Display
• /
• v.12 no.1
• /
• pp.51-55
• /
• 2011

Efficient two-color-mixed white organic light-emitting diodes are presented herein by employing a sky-blue phosphorescent dopant of iridium(III)bis[4,6-(difluorophenyl)-pyridinato-N,$C^{2'}$]picolinate (FIrpic) and an orange phosphorescent dopant of bis(2-phenylquinoline)(acetylacetonate)iridium(III) ($Ir(phq)_2$acac) on the emissive layer. Very stable color variation under ${\Delta}$0.02 until a 5000 cd/$m^2$ brightness value was realized by efficient carrier control in a multi-stacked emitting layer of blue/red/blue colors. Maximum current and power efficiencies of 23.8 cd/A and 22.9 lm/W in the forward direction were obtained. With balanced emission from the two emitters, the white-light emission of high correlated color temperature of 7308K and the Commission Internationale de I'Eclairage coordinates of (0.30, 0.33) were achieved.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.5 no.5
• /
• pp.458-461
• /
• 2004

In order to improve the adhesion properties of copper, MPS(3-mercaptopropyltrimethoxysilane) organic film were employed. The plasma pretreatment in pure He or $He/O_{2}$ mixed gas environment greatly increased adhesion force. Adhesion force was measured by scratch test with nano indenter. Microstructures and surface roughness were observed with scanning electron microscope(SEM). The characteristics of MPS layer for pretreatment were studied with flourier transform infrared spectroscope(FT-IR) and contact angle tester. The heighest adhesion was achieved in the specimen pretreated with mixed plasma and NPS coating, which was 56mN. Other specimen showed lower value by $20{\%}$ to $30{\%}$. The roughness of substrate was not affected by the bonding strength of copper plating.

• Ocean and Polar Research
• /
• v.30 no.3
• /
• pp.261-275
• /
• 2008

The profile of a fixed site at station M ($34.77^{\circ}N,\;129.13^{\circ}E$) in the Korea Strait was studied from March 2006 to February 2007. The aim was to understand the relationship between the annual thermal stratification pattern and seasonal variation in phytoplankton community structure. Physicochemical factors including temperature, salinity and nutrient concentrations, which strongly influence the proliferation and diversity of phytoplankton, were measured. The study period was divided into three due to the characteristic of thermohaline structures; mixed I (March-May 2006), stratified (June-November 2006) and mixed II(December 2006-Feburuary 2007). Diatoms dominated during the mixed I (89%) and II (48%) periods, while nanoplankton group occupied over 83% of total population during the stratified period. The dominant species during the mixed I and II was Chaetoceros socialis (47% and 29%, respectively), while during the stratified period Gyrodinium sp.(4%) was the most dominant. Averaged total chl a concentrations during the mixed I and II periods were 0.61 mg $m^{-3}$ and 0.72 mg $m^{-3}$, respectively, which were at least two-fold higher than that during the stratified period (0.30 mg $m^{-3}$). The vertical mixing and convection process of the water column induced nutrient supply from the bottom layer to the euphotic zone. It also led to the dominance of diatoms during the mixed periods, whereas small phytoplankton prevailed over large phytoplankton as stratification blocked the upward movement of nutrients to subsurface during the stratified period. During the mixed I and II periods, microplanktonic chl a dominated concentrations (50% and 48%, respectively), while picoplanktonic chl a occupied over 37% of total chl a during the stratified period.

• Journal of agriculture & life science
• /
• v.44 no.3
• /
• pp.31-40
• /
• 2010

This study was carried out to offer a basis data for conservation and application of effective management of Camellia japonica stand in Hakdong, Geoje Island. Field survey was conducted at C. japonica stand, mixed stand, Chamaecyparis obtusa plantation, and Pinus thunbergii stand. Importance value of C. japonica at tree layer was highest in C. japonica stand and mixed stand, and that of C. obtusa and P. thunbergii were highest in C. obtusa plantation and P. thunbergii stand, respectively. At subtree layer, C. japonica, Callicarpa dichotoma, Neolitses serices, and Styrax japonica had the highest importance value in C. japonica stand, mixed stand, C. obtusa plantation, and P. thunbergii stand, respectively. The species diversity ranged from 0.121 to 1.589 in C. japonica stand, 0.543 to 1.540 in mixed stand, 0.276 to 1.321 in C. obtusa plantation, and 0.764 to 1.523 in P. thunbergii stand, respectively. Soil pH was 5.72 in C. japonica stand, 5.26 in mixed stand, 5.21 in C. obtusa plantation, and 5.32 in P. thunbergii stand. The content of organic matter and total N were 5.77, 0.48% in C. japonica stand, 4.41, 0.30% in mixed stand, 3.28, 0.33% in C. obtusa plantation, and 5.32, 0.28% in P. thunbergii stand.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.1
• /
• pp.38-46
• /
• 2005

In this research, we tried to combine the coagulation/sedimentation process as pre-treatment with UF membrane filtration to reduce the membrane fouling and to improve the permeate water quality. We used the Jet Mixed Separator (JMS) as coagulation/sedimentation process. We observed that the HPC and E.Coli can't be removed through the direct UF memebrane filtation of surface water. The removal efficiency of dissolved organic substances, indicated by E260 and DOC, was 40% and 15%, respectively. However, the removal efficiency of it increased two time as a result of combination of JMS process as coagulation/sedimentation pre-treatment. This was resulted from the formation of high molecular humic micro-floc through JMS process. The accumulation amount of irreversible cake layer which was not removed by backwashing was less than direct UF membrane filtration of surface water. Moreover, the loading rate of fouling induced substances, such as humic substances and suspended substances, on membrane surface decreased drastically through JMS process. As a result, the accumulation amount of irreversible cake on membrane surface was decreased.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.10 no.6
• /
• pp.102-108
• /
• 2001

To prevent green house effect and destruction of an ozone layer, an ozone destruction potential(OBP) must be zero and a refrigerant for low global warming potential(GWP) is needed. HFC-l34a, in which hydrogen is mixed instead of chlorine is a refrigerant used for automobile conditioners and its destruction potential is ecologically zero. However, it is not consid- ered as a perfect substitutive refrigerant as its GWP is high. It is studied refrigerant mixtures in which HFC-l52a and $CF_3 I$ in HFC-l52a with low GWP and zero ODP are mixed by experimentally and concluded as follows: 1) With the variation of speed of compressor outside temperature and flow rate, 7he heat of evaporator and compressor and coefficient of perfor- mance was varied, and influenced the air conditioner. 2) The pressure of evaporator was decreased with increasing the speed of compressor and the pressure of evaporator with the refrigerant HFC-l52a was higher 24% than that of azotrope refrigerant mixed with $CF_3 I$

• Journal of the korean society of oceanography
• /
• v.31 no.4
• /
• pp.196-206
• /
• 1996

Vertical profiles of the chlorophyll ${\alpha}$, phytoplankton abundance, nutrients and sigma-t were compared with the vertical distribution of phytoplankton species in conjunction with $^{14}$C primary production in the Southern Waters of the East Sea, Korea. In the upper mixed layer the water column was only weakly stratified and ambient nitrogenic nutrient concentrations were markedly depleted. Dissolved silicate seemed to be another limiting nutrient in the surface layer. The occupation of different water depths by several dominant diatom species was well explained by the degree of silicification of each cell and the silicate concentration of ambient seawater. Subsurface chlorophyll maxima were continuously observed in the lower parts of the euphotic layer and the depth coincided with nutricline, supporting our view that chlorophyll maximum was sustained partially by enhancement of in situ growth of phytoplankton and partially by increase of cellular chlorophyll content. The persistence of chlorophyll maximum layer was attributed to the physiological adaptation of the phytoplankters to low light intensities and to the utilization of regenerated nutrients. Integrated water column production of organic matter by photosynthesis appeared to be better related to phytoplankton cell division than to the cell growth in terms of biosynthesis of pigments and other intracellular components.