• Membrane Journal
• /
• v.30 no.4
• /
• pp.205-212
• /
• 2020

This short review focuses on fouling by proteins and macromolecules in microfiltration/ultrafiltration. First, an experimental system that enables investigation of how the extent of the adsorption of proteins and macromolecules on membrane surfaces contributes to a decrease in filtrate flux in microfiltration/ultrafiltration is described. Using this system, a causal relationship - not a correlation - indicating that adsorption results in a decrease in filtrate flux could be clearly demonstrated in some cases. Second, a hydration structure at the membrane surface that can suppress adsorption is discussed, inspired by biomaterial research. In their hydrated states, polymers with low-fouling properties have water molecules with a particular structure. Finally, some successful examples of the development of low-fouling membranes via surface modification using low-fouling polymers are discussed.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.6
• /
• pp.779-785
• /
• 2013

This study investigated the applicability of a two step microfiltration(MF) and reverse osmosis(RO) membrane system for reuse of tunnel wastewater. In this two step process, the MF system first treated only micropollutants in tunnel wastewater such as suspended solids(SS) and heavy metals, achieving less than 0.2 NTU turbidity, less than 1.1 mg/L chemical oxygen demand($COD_{Mn}$) and less than 0.8 mg/L total manganese(Mn). The RO system then removed over 95 % of the remaining pollutnats and particles, resulting in less than 0.02 NTU turbidity, less than 0.5 mg/L chemical oxygen demand($COD_{Mn}$), less than 0.04 mg/L total nitrogen(T-N) and less than 0.01 mg/L total phosphorus(T-P). In particular, addition of an RO system could lead to markedly reduced high salt concentrations in tunnel wastewater, approaching almost zero. Thus, reclaimed water using the combined membrane system could satisfy current South Korean regulations concerning wastewater reuse(turbidity ${\leq}2.0$ NTU; T-N ${\leq}10mg/L$; T-P ${\leq}0.5mg/L$; Salinity ${\leq}250mg{\cdot}Cl/L$).

• Textile Coloration and Finishing
• /
• v.16 no.4
• /
• pp.10-18
• /
• 2004

In this work, Aqueous sericin solution was prepared by degumming process with electrolytic reduction water. Then, the microfiltration and ultrafiltration systems were applied to the concentration of aqueous sericin solution. The objective of this study was to select the optimum operating condition among the different pressure. The permeate flux and rejection ratio were observed with time, pressure, flow rate and concentration. and, the wastewater and permeated water quality values such as pH, BOD, COD, and NH levels were measured. In order to see the influence of electrolytic reduction water, the flux of pure water and electrolytic reduction water by PVDF22(MF) and PS100(UF) membrane was measured. In microfiltration system, the relative flux reduction decreased rapidly to 0.02 in the 30min, as the concentration polarization and gel layer formation were increased. and then the sericin concentration rejection ratio was 40%. In ultrafiltration system, the permeate flux decreased with time and concentration, and increased with the operating pressure and flow rate. Optimal condition in PS100 membrane system for sericin concentration was operating pressure 1.464kgf/$cm^24, operating flow rate $7\ell/min at\; 40^{\circ}C$. At that time, sericin concentration rejection ratio was 83% respectably. The sericin solution was concentrated from 0.1wt% solution to 0.2 wt % solution during about 2 hrs by the UF filteration membrane system.

• KSBB Journal
• /
• v.5 no.4
• /
• pp.335-339
• /
• 1990

In order to develop economic processes for ethanol production from starch, a simultaneous saccharification and fermentation(SSF) process using Zymomonas mobilis and amyloglucosidase (AMG) was studied in semibatch modes using cell recycle. The cell recycle was carried out by adopting two different methods; microfiltration and settling. The cell recycle using microfiltration revealed higher productivity(5.4 g/l/h) than that using a settler(4.3 g/l/h). Taking the large-scale ethanol fermentation into account, the semibatch process using microfiltration system appeared most promising among others with respect to ethanol productivity, feasibility of scale-up and simplification of operation.

• Korean Membrane Journal
• /
• v.9 no.1
• /
• pp.12-17
• /
• 2007

We performed periodic water-back-flushing using permeate water to minimize membrane fouling to enhance permeate flux in tubular ceramic microfiltration system for water treatment of high turbid source. The filtration time (FT) = 2 min with periodic 6 sec water-back-flushing showed the highest value of dimensionless permeate flux ($J/J_o$), and the lowest value of resistance of membrane fouling ($R_f$), and we acquired the highest total permeate volume $(V_T)\;=\;6.805L$. Also in the result of BT effect at fixed FT = 10 min and BT (back-flushing time) = 20 sec showed the lowest value of $R_f$ and the highest value of $J/J_o$, and we could obtain the highest $V_T\;=\;6.660\;L$. Consequently, FT = 2 min and BT = 6 sec could be the optimal condition in water treatment of high turbid source above 10 NTU. However, FT = 10 min and BT = 20 sec was superior to reduce operating costs because of lower back-flushing frequency. Then the average quality of water treated by our tubular ceramic MF system was turbidity of 0.07 NTU, $COD_{Mn}$ of 1.86 mg/L and $NH_3-N$ of 0.007 mg/L.

• Journal of Korea Water Resources Association
• /
• v.32 no.3
• /
• pp.311-319
• /
• 1999

Membrane separation process is considered as an alternative of conventional water purification system using coagulationㆍsedimentation＋sand filtration. In this study, it was examined that the application possibility of Hollowfiber Microfiltration membrane for water purification process. A $20m^3/day$ scale pilot plant was used for studying the possibility of long-term operation and the stability of water quality under the optimum conditions, 0.03m/h permeate flux, filtration for 10 minutes, pause for 2 minutes(including air-scrubbing for 30 seconds), obtained by lab-scale experiment. As a result, it was proved stability of pilot plant over one year and filtrate quality(Turbidity. SS etc). Therefore, it was proved that membrane separation process using Hollowfiber Microfiltration membrane can be applied for water purification system

• Journal of environmental and Sanitary engineering
• /
• v.12 no.1
• /
• pp.77-83
• /
• 1997

An experimental research was conducted in order to study the treatment of waste reuse system using the membrane. Cell tester which supplied by Amicon was used to compare the fluxes of various membranes. Specially investigated items in the experiment were carried out by using 5 species of microfiltration membranes as to various MLSS concentrations. From the results, it is recognized from the cell test that 0.2 $\mu $m pore-sized membrane have the most effective performance at 2000mg/L of MLSS, and physical properties of membranes such as strength, deflection, elongation, structure of pore are more important than chemical properties in microfiltration membrane.

• Proceedings of the Membrane Society of Korea Conference
• /
• 2004.05a
• /
• pp.15-18
• /
• 2004

Computational fluid dynamics (CFD) was applied to modeling particle dynamics in microfiltration (MF). The rejection properties of poly methylmethacrylate (PMMA) and polystyrene (PS) were calculated. Calculated rejection (R) of PMMA was independent with the porosity of the membrane, and the R was constant in the range of volume flux between $1\times 1-^{-4}-1\times 10^{-2}$ m/s. These observations were in quantity agreement with our experimental observations. The dependence of PMMA and PS rejection on the ratio of particle diameter and pore diameter were good agreement with the experimental values, which suggesting that the validity of CFD simulation to evaluate rejection of particle in MF membranes. Change of rejection of PMMA as a function of time was molded based on the CFD result which explained well the experimental observation.

• Journal of Korean Society of Water and Wastewater
• /
• v.24 no.6
• /
• pp.735-741
• /
• 2010

A pilot test was carried out to investigate the long term operation characteristics of Microfiltration (MF) system as a pretreatment for seawater reverse osmosis (SWRO) processes for two years. A commercialized MF module with pressurized operation type was used to filter seawater to remove particles which can foul reverse osmosis (RO) membrane. Silt Density Index (SDI) values of filtered seawater by the MF system were ranged from 0.14 to 1.79, which meet the SDI standard for RO feed water as depicted in previous literatures. Although the tested seawater is quite clean (i.e., dissolved organic cabon (DOC) concentration and turbidity were about 1 mg/l and less than 1 NTU, respectively) enough not to foul the MF membrane, steep increase in trans-membrane pressure (TMP) with a constant flux were observed over a whole operation period. A set of operation and water analysis data implies that the steep increase in TMP was resulted from iron and maganese fouling by the combination of metal corrosion by seawater and oxidation state by aeration and residual chlorine.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1999.04b
• /
• pp.1-12
• /
• 1999

In Kimchi (a salt-pickled and fermented food) manufacturing industry, the process of brining and rinsing the raw vegetable produces a vast amount of wastewater of high salinity. Instead of expensive and low-efficient conventional treatment system, brining wastewater reuse system was developed using hybrid chemical precipitation / microfiltration. In the microfiltration of chemically treated brining wastewater, comparison of flux, backwashing frequency and energy consumption was made between dead-end and crossflow filtration mode. The optimum location of neutralization step in this system was also discussed in connection with the micro filtration performance. The quality test of Kimchi prepared by the reuse system conformed the new approach was successful in terms of water/raw material (salt) savings and wastewater reduction.