• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.3
• /
• pp.127-136
• /
• 1990

In this paper, the experimental study was carried out for the removal of olive oil in wastewater by the use of Biological Fluidized Bed(BFB) with the reticulated polypropylene sheets as media. The nonbiodegradable olive oil, one of the animal and vegitable oil, was used bacause of the relative simplicity of constitution. Biological degraciability and removal characteristics of emulsified olive oil were studied by batch and continuous experiments respectively. From the results of batch experiments, it was observed that the emulsified olive oli used in BFB reactor was absorbed by media and sludge in about 12 hours, and degradation of the absorbed olive oli was mostly completed for 24 hours. The functional relationship of Michaelis-Menten's Enzyme reaction equation exists between oil concentration and maximum specific rate of olive oil. From the continuous experiments for the removal of olive oil using BFB reactor, it was proved that the substrate removal rate coefficient $k=0.004d^{-1}$, which is the first order kinetics. It was apperared that oxygen utlization coefficients for synthesis(a') and endogeneous respiration(b') of microorganisms in the reactor are respectively 0.85mg $O_2/mg$ $COD_{cr}$ and 0.011mg $O_2/mg$ BVS. day.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.486-487
• /
• 2007

$Bi_2Sr_2Ca_{n-1}Cu_nO_x$(n=0, 1, 2) thin films have been fabricated by co-deposition at an ultra-low growth rate using ion beam sputtering(IBS) method. The growth rates of the films was set in the region from 0.17 to 0.27 nm/min. MgO(100) was used as a substrate. In order to appreciate stable existing region of Bi 2212 phase with temperature and ozone pressure, the substrate temperature was between 655 and $820^{\circ}C$ and the highly condensed ozone gas pressure in vacuum chamber was varied between $2{\times}10^{-6}{\sim}4{\times}10^{-5}$ Torr. Bi 2212 phase appeared in the temperature range of 750 and $795^{\circ}C$ and single phase of Bi 2201 existed in the lower region than $785^{\circ}C$. Whereas, $PO_3$ dependance on structural formation was scarcely observed regardless of the pressure variation.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.312-312
• /
• 2012

Magnesium oxide has become focus for research activities due to its use in magnetic tunnel junctions and for understanding of do ferromagnetism. Theoretical investigations on such type of system indicate that the presence of defects greater than a threshold value is responsible for the magnetic behaviour. It has also been shown experimentally that by decreasing the film thickness and size of nanoparticles, enhancement/increase in magnetization can be achieved. Apart from the change in dimension, swift heavy ions (SHI) are well known for creating defects and modifying the properties of the materials. In the present work, we have studied the irradiation induced effects in magnesium oxide thin film deposited on quartz substrate via X-ray absorption spectroscopy (XAS). Magnesium oxide thin films of thickness 50nm were deposited on quartz substrate by using e-beam evaporation method. These films were irradiated by 200 MeV Ag15+ ion beam at fluence of $1{\times}10^{11}$, $5{\times}10^{11}$, $1{\times}10^{12}$, $3{\times}10^{12}$ and $5{\times}10^{12}ions/cm^2$ at Nuclear Science Centre, IUAC, New Delhi (India). The grain size was observed (as studied by AFM) to be decreased from 37 nm (pristine film) to 23 nm ($1{\times}10^{12}ions/cm^2$) and thereafter it increases upto a fluence of $5{\times}10^{12}ions/cm^2$. The electronic structure of the system has been investigated by X-ray absorption spectroscopy (XAS) measurements performed at the high energy spherical grating monochromator 20A1 XAS (HSGM) beamline in the National Synchrotron Radiation Research Center (NSRRC), Taiwan. Oxides of light elements like MgO/ZnO possess many unique physical properties with potentials for novel application in various fields. These irradiated thin films are also studied with different polarization (left and right circularly polarized) of incident x-ray beam at 05B3 EPU- Soft x-ray scattering beamline of NSRRC. The detailed analysis of observed results in the wake of existing theories is discussed.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.17 no.4
• /
• pp.348-357
• /
• 1988

The present work was undertaken to investigated the purification and characterization of polyphenol oxidase (PPO ; EC 1.10.3.1) in sweet potato, particularly the number of PPO isozymes, and PPO properties such as pH optimum, heat stability, substrate specificity, kinetics, and inhibitor studies. The purification achieved was 23.1 fold from crude extract with a yield of 41.5%. Eight PPO isozymes and twelve PPO isozymes were detected by disc polyacrylamide gel electrophoresis and isoelectric focusing, respectively. The specific activity of each isozyme separated by isoelectric focusing was in the range of $6,000{\sim}46,700U/mg$. This enzyme was sweet below $65^{\circ}C$ and the pH optimum of PPO occurred at 6.0-6.5. The substrate specificity of sweet potato PPO showed the high affinity toward the odiphenolic compounds. Km and Vmax for catechol were found to be 6.7 mM and $20{\triangle}A/min$, me protein, respectively. Inhibitor studies indicated that dithiothreitol was the most potent among the inhibitors used in the present work.

• Applied Biological Chemistry
• /
• v.30 no.3
• /
• pp.258-263
• /
• 1987

The waste gained from alcohol production with sweet potato was considered as a potential substrate for the production of single cell protein (SCP). The high content in organic materials, simplicity to filtrate and a suitable pH for the growth of yeasts were indicated as a good substrate. A yeast utilizing this substrate was isolated from the compost ground and identified as Candida boidinii. The strain was the highest in assimilation of this alcoholic waste and the yield was maximized at pH 5.0, $30^{\circ}C$ after 72 hrs incubation. The dry cell weight and crude protein content at optimal conditions were 1.02g/100ml and 54.5%, respectively. The growth of the yeast was stimulated with the addition of 0.2% urea, 0.1% $K_2HPO_4$, and 0.02% $MgSO_4{\cdot}7H_2O$.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.3
• /
• pp.587-595
• /
• 2000

The most problems of domestic sewage for BNR(Biological Nutrients Removal) process are deficiency of carbon source and low C/N ratio. Primary sludge fermentation is seemed to be one of the best solutions producing biodegradable organic substrates. Soluble organic materials from sludge fermentation are mainly SCFAs(Short-Chain Fatty Acids) with 2~5 carbon atoms. In this research, it was attempted to apply $A_2/O$ process with the side-stream acid fermenter to improve the nutrients removal efficiency. The result showed that proper SCFAs production is about 3.000mg/L with SRT of 4~5 days. SCFAs yield of approximately 0.10~0.16 mg SCFAs(as COD) per mg of primary sludge(as COD) were achieved. The ratio of acetic. propionic. butyric and valerie acid were 1, 0.7, 0.5 and 0.6. Significant improvements of nutrients removal over 70% in BNR process were observed. thus will reduce the demand for chemical dosing to increase nutrients removal efficiency. When the fermentate was entered $A_2/O$ process, the ratio of phosphate release to substrate uptake amounts to $0.34gPO_4-Pg^{-1}COD$.

• Journal of the Korean Ceramic Society
• /
• v.33 no.7
• /
• pp.802-808
• /
• 1996

PbTiO3 thin films were fabricated onto MgO(100) single crystal substrate by reactive D. C magnetron sput-tering of Pb and Ti metal in an oxygen and argon gas mixture. The annealing of the thin films resulted in the decrease of both the c-axis orientation ratio and the lattice parameter. It is well known that the c-axis lattice parameter of thin film is dependent on the Pb/(Pb+Ti)ratio and the residual stress in the film The PbTiO3 thin films with a Pb/(Pb+T) ratio ranging from 0.45 to 0.57 were fabricated and annealed. The structure of the film the c-axis orientation ratio and the lattice parameter were not dependent on the Pb/(Pb+Ti) ratio before and after annealing. These experimental results proved that the decrease of the c-axis lattice parameter under the annealing conditions was due to the relaxation of the intrinsic stress in the film. This relaxation of the intrinsic stress caused the decrease of the c-axis orientation ratio and this phenomenon can be explained by c-axis growth lattice model.

• KSBB Journal
• /
• v.19 no.1
• /
• pp.50-56
• /
• 2004

The aim of this work was to investigate the purification and characterization dixoygenases isolated from Delftia sp. JK-2, which could utilize aniline, benzoate, and p-hydroxybenoate as sole carbon and energy source. Catechol 1,2-dioxygenase (C1, 2O), catechol 2,3-dioxygenase(C2, 3O), and protocatechuate 4,5-dioxygenase(4,5-PCD) were isolated by benzoate, aniline, and p-hydroxybenzoate. In initial experiments, several characteristics of C1 ,2O, C2, 3O, and 4,5-PCD separated with ammonium sulfate precipitation, DEAE-sepharose, and Q-sepharose were investigated. Specific activity of C1 ,2O, C2, 3O, and 4,5-PCD were approximately 3.3 unit/mg, 4.7 unit/mg, and 2.0 unit/mg. C1 ,2O and C2, 3O demonstrated their enzyme activities to other substrates, catechol and 4-methylcatechol. 4,5-PCD showed the specific activity to the only substrate, protocatechuate, but the substrates(e.g., catechol, 3-methylcatechol, 4-methylcatechol, 4-chlorocatechol, 4-nitrocatechol) did not show any specific activities in this work. The optimum temperature of C1, 2O, C2, 3O, and 4,5-PCD were 30$^{\circ}C$, and the optimal pHs were approximately 8, 8, and 7, respectively. Ag$\^$+/, Hg$\^$+/, Cu$\^$2+/ showed inhibitory effect on the activity of C1, 2O and C2, 3O, but Ag$\^$+/, Hg$\^$+/, Cu$\^$2+/, Fe$\^$3+/ showed inhibitory effect on the activity of 4,5-PCD. Molecular weight of the C1, 2O, C2, 3O, and 4,5-PCD were determined to approximately 60 kDa,35 kDa, and 62 kDa by SDS-PAGE.

• Journal of Advanced Marine Engineering and Technology
• /
• v.29 no.1
• /
• pp.98-106
• /
• 2005

The chemical conversion film formed on magnesium alloy was investigated by using the colloidal silica with some parameters such as solution pH. temperature, solution conditions, and treatment time. Moreover. the solutions consisted of colloidal silica titanium sulfate, and cobalt ions were used for the colloidal silica film to having a good corrosion resistance and adhesion properties. It was thought that the film at 298K was made with combination of Si-O. The quantity of film formed at high temperature such as 333K and 353K is smaller than dissolved quantity during chemical conversion treatment. Adding $CoSO_4$ to the colloidal silica solution enhanced the adhesion force between the silica film and magnesium substrate, The optimum conditions for the chemical conversion treatment solution were PH 2.90 s treatment, and 298K.

• Journal of the Korean Ceramic Society
• /
• v.43 no.12 s.295
• /
• pp.852-858
• /
• 2006

It is well known that $BaMgAl_{10}O_{17}:Eu^{2+}$ (BAM) and $CaMgSi_2O_6:Eu^{2+}$ (CMS) are a highly efficient blue phosphor. However, these phosphors in the form of thin films have not yet been realized clue to technical difficulties. We prepared thin film type BAM and CMS phosphors on quartz glass substrate using a pulsed laser deposition technique. The luminescent and structural properties of thin film phosphors were monitored as a function of key processing parameters such as oxygen partial pressure inside the deposition chamber, deposition time, laser energy density and the type of post-deposition treatments used. Even though we could not obtain single homogenous phases, thin films with large homogenous areas and a high photoluminescence could be produced by optimizing these processing parameters.