• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1998.11a
• /
• pp.174-177
• /
• 1998

The effects of surfactants affecting polycyclic Aromatic Hydrocarbon(PAHs) solubility and biodegradation in soil slurry were investigated. The critical micelle concentration(CMC) values of surfactants used in this study were 12.7mg/L(Brij 30), 13.4mg/L(Tween 80), 13.6mg/t(Triton X-100). The solubility of PAH increased as the Hydrophile-Lipophile Balance(HLB) value of surfactant decrease. At surfactant biodegradation and toxicity experiement using respirometer, Brij 30 did not show any toxic effect and substrate inhibition upon the level of 1.5g/L. Also, biodegradation of Brij 30 gave no reduction on the phenanthrene biodegradation rate. When the desorption rate of phenanthrene between sand and clay is compared, lower percentage of phenanthrene was desorbed at clay because of the larger surface aera and higher organic content of clay. At the biodegradation experiments of phenanthrene in soil slurry phase, more than 90% of initial phenanthrene adsorbed onto both sand and clay were biodegraded by phenanthrene- acclimated cultures.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2006.05a
• /
• pp.53-56
• /
• 2006

Magnesium alloy AZ31, which processed by conventional rolling or extrusion, has high anisotropy of mechanical properties in its strength and elongation at room temperature. We compared the influence of differential speed rolling with conventional rolling process on microstructure and mechanical properties of commercial AZ31 sheet. Commercial AZ31 alloy sheets were processed with conventional and differential speed rolling with thickness reduction ratio of 30% at a various temperature. The elongation of AZ31 alloy, warm-rolled by differential speed rolling is larger than those rolled by conventional rolling. Besides, grain size and distribution on microstructure of the conventional rolled materials were coarse and inhomogeneous, on the contrary, those of the differential speed rolled were fine and homogeneous.

• Journal of Food Hygiene and Safety
• /
• v.11 no.2
• /
• pp.159-164
• /
• 1996

The antilipidperoxidative and hepatopreventive effects of Aloe water extract (30 mg, 50 mg, 100 mg) were investigated at the levels of liver-total homogenates and the sera of SDrats intoxicated with CCl4 (0.5 cc/100g) and 50% ethanol. We measured MDA (Malondialdehyde) in the liver homogenate, AST (L-Aspartate-2-oxoglutarate aminotransferase) and ALT(L-Alanine-2-oxo-glutraate aminotransferase) in the serum. The analysis of the measurement indicated that Aloe water extract reduced MDA, ALT and AST significantly and their reduction was in relation to dose dependence. In rat liver homogenate intoxicated with ethanol and CCl4, Aloe treatment group markedly inhibited lipidperoxidation by 30%∼70%. In rat serum intoxicated with ethanol and CCl4, Aloe treatment group inhibited AST, ALT by 40%∼90%. In these data Aloe may be used to inhibit or prevent the hapatic toxicity with results from the environmental and alcohlic factors through the further study of its exact antihepatotoxic mechanism.

• Natural Product Sciences
• /
• v.5 no.4
• /
• pp.155-158
• /
• 1999

Several biological activities of extracts from roots of Cichorium intybus Linne (Compositae) were studied in this paper. The antiinflammatory activity of the methanol extract of this root was investigated against carrageenin induced edema in rat‘s hind paw. Significant inhibitory effects were observed at the dose of 1,000 mg/kg and were compared with aspirin as a control. The hepatoprotective activities of the methanol extract, ethylacetate and butanol fraction were studied on mice whose livers are damaged by $CCl_4$. The serum transaminase activities (ALT, AST) were reduced at the dose of 1,000 mg/kg of the methanol extract, 500 mg/kg of ethylacetate and butanol fraction, respectively. The bile juice secretion was also increased significantly from each fraction. The antidiabetic activity was examined on strepto-zotocin-induced diabetic rats with methanol extract. Methanol extract gave a significant reduction of blood glucose levels in 1 week and 3 weeks.

• Environmental Engineering Research
• /
• v.22 no.2
• /
• pp.157-161
• /
• 2017

Simultaneous treatment of food waste leachate and power generation was investigated in an air-cathode microbial fuel cell. A TCOD removal efficiency of $95.4{\pm}0.3%$ was achieved for an initial COD concentration of 2,860 mg/L. Maximum power density ranged was maximized at $1.86W/m^3$, when COD concentration varied between 60 mg/L and 2,860 mg/L. Meanwhile, columbic efficiency was determined between 1.76% and 11.07% for different COD concentrations. Cyclic voltammetric data revealed that the oxidation peak voltage occurred at -0.20 V, shifted to about -0.25 V. Moreover, a reduction peak voltage at -0.45 V appeared when organic matters were exhausted, indicating that reducible matters were produced during the decomposition of organic matters. The results showed that it was feasible to use food waste leachate as a fuel for power generation in a microbial fuel cell, and the treatment efficiency of the wastewater was satisfied.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.7
• /
• pp.621-625
• /
• 1996

A variety of metal oxides were coated by sol-gel process from their metal alkoxides on the ribbons of Co-based and Fe-based amorphous alloys, and the effects of surface oxide coating on the magnetic properties of the alloy are investigated. The core loss is found to be reduced significantly by the oxide coating, the loss reduction becoming more prominent at higher frequencies. The shape of the hystersis loop is also dependent upon the kind of the coated metal oxide. The coatings of MgO, SiO2, MgO·SiO2 and MgO·Al2O3 induce tensile stress into the Fe-based ribbon whereas those of BaO, Al2O3, CaO·Al2O3, SrO·Al2O3 and BaO·Al2O3 induce compressive stress. These results may be explained by the modification of domain structures via magnetoelastic interactions with the shrinkage stress induced by the sol-gel coating.

• Progress in Superconductivity and Cryogenics
• /
• v.21 no.3
• /
• pp.18-21
• /
• 2019

We studied the effect of Fe ion irradiation on the upper critical field ($H_{c2}$) of 410 nm single-crystalline $MgB_2$ thin films. The irradiation energy was fixed at 140 keV when we increased the irradiation doses from $1{\times}10^{14}ion/cm^2$ to $4{\times}10^{14}ion/cm^2$. We found that $H_{c2}$ significantly increase with increasing irradiation dose, despite the low irradiation energy. The enhancement of $H_{c2}$ could be explained by the reduction of electron mean free path caused by defects induced from irradiation, leading to a decrease of coherence length (${\xi}$). We also discussed the effect of irradiation on temperature-dependent resistivity in details.

• Korean Journal of Materials Research
• /
• v.24 no.9
• /
• pp.465-468
• /
• 2014

The crystallization effects of boron (B) powder on the phase, full width at half maximum (FWHM) values, and critical properties were investigated for in-situ reacted $MgB_2$ bulk superconductors. The semi-crystalline B powder was heat-treated at different temperatures of 1000, 1300 and $1500^{\circ}C$ for 5 hours in an Ar atmosphere. Then, using as-received and heat-treated B powders, the $MgB_2$ samples were prepared at $600^{\circ}C$ for 40 hours in an Ar atmosphere. As the heat-treatment temperature of the B powder increased, both the particle size of the B powder and crystalline phase increased. In the case of $MgB_2$ samples using B powders heat-treated at above $1300^{\circ}C$, unreacted magnesium (Mg) and B remained due to the improved crystallinity of the B powder. As the heat-treatment temperature of B powder increased, the critical current density of $MgB_2$ decreased continuously due to the reduction of grain boundary density and superconducting volume caused by unreacted Mg and B.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.2
• /
• pp.198-203
• /
• 2016

We investigate the effects of magnesium (Mg) suppressor layer on the electrical performances and stabilities of amorphous indium-zinc-tin-oxide (a-ITZO) thin-film transistors (TFTs). Compared to the ITZO TFT without a Mg suppressor layer, the ITZO:Mg TFT exhibits slightly smaller field-effect mobility and much reduced subthreshold slope. The ITZO:Mg TFT shows improved electrical stabilities compared to the ITZO TFT under both positive-bias and negative-bias-illumination stresses. From the X-ray photoelectron spectroscopy O1s spectra with fitted curves for ITZO and ITZO:Mg films, we observe that Mg doping contributes to an enhancement of the oxygen bond without oxygen vacancy and a reduction of the oxygen bonds with oxygen vacancies. This result shows that the Mg can be an effective suppressor in a-ITZO TFTs.

• Korean Chemical Engineering Research
• /
• v.54 no.5
• /
• pp.712-718
• /
• 2016

Platinum catalysts supported on the mesoporous material synthesized from Y zeolite were applied to synthesis of jet-fuel through n-octadecane hydroupgrading. The mesoporous aluminosolicate, $MMZ_{HY}$ was synthesized using Y zeolite as its framework source. The effect of the addition of Mg to $Pt/MMZ_{HY}$ catalyst for n-octadecane hydroupgrading was investigated. Catalyst characterization was performed with X-ray diffraction, $N_2$ adsorption, temperature-programmed reduction in hydrogen flow, temperature-programmed desorption of ammonia, and infrared spectroscopy of adsorbed pyridine. The high yield of jet-fuel over the $PtMg(2.0)/MMZ_{HY}$ can be attributed not only to the higher dispersion of Pt metal and higher reducibility, but also the higher amount of acid sites and higher strength of acid sites. The selectivity to iso-paraffin in the jet-fuel fraction could be reached above 80% over the optimized $PtMg/MMZ_{HY}$ catalyst.