• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.5
• /
• pp.473-478
• /
• 2016

In this paper, the MIS(: Metal-Insulator-Semiconductor) Capacitor with the nitrided-oxide by RTP are fabricated to investigate the carrier trap parameters due to avalanche electron injection. Two times turn-around phenomenon of the flatband voltage shift generated by the avalanche injection are observed. This shows that electron trapping occurs in the oxide film at the first stage. As the electron injection increases, the first turn-around occures due to a positive charge in the oxide layer. After further injection, the curves turns around once again by electron captured. Based on the experimental results, the carrier trapping model for system having multi-traps is proposed and is fitting with experimental data in order to determine trap parameter of nitrided-oxide.

• Journal of Sensor Science and Technology
• /
• v.27 no.1
• /
• pp.21-24
• /
• 2018

A temperature sensor with a binary output was implemented using switched-capacitor circuits in a $0.35-{\mu}m$ CMOS(com-plementary metal-oxide semiconductor) process. The measured temperature exhibited good agreement with the oven temperature after calibration. The measured power consumption was 5.61 mW, slightly lower than the simulated power consumption of 6.63 mW.

• ETRI Journal
• /
• v.35 no.4
• /
• pp.594-602
• /
• 2013

This paper proposes printed organic one-time programmable read-only memory (PROM). The organic PROM cell consists of a capacitor and an organic p-type metal-oxide semiconductor (PMOS) transistor. Initially, all organic PROM cells with unbroken capacitors store "0." Some organic PROM cells are programmed to "1" by electrically breaking each capacitor with a high voltage. After the capacitor breaking, the current flowing through the PROM cell significantly increases. The memory data is read out by sensing the current in the PROM cell. 16-bit organic PROM cell arrays are fabricated with the printed organic PMOS transistor and capacitor process. The organic PROM cells are programmed with -50 V, and they are read out with -20 V. The area of the 16-bit organic PROM array is 70.6 $mm^2$.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.4
• /
• pp.159-163
• /
• 2003

ln this work, we studied electrical characteristics and leakage current mechanism of $Ta_2O_{5}$ MOS(Metal-Oxide-Semiconductor) devices. $Ta_2O_{5}$ thin film (63 nm) was deposited by ALD(Atomic Layer Deposition) method at temperature of 235 $^{\circ}C$. The structures of the $Ta_2O_{5}$ thin films were examined by XRD(X-Ray Diffraction). From XRD, it is found that the structure of $Ta_2O_{5}$ is single phase and orthorhombic. From capacitance-voltage (C-V) anaysis, the dielectric constant was 19.4. The temperature dependence of current density-electric field (J-E) characteristics of $Ta_2O_{5}$ thin film was studied at temperature range of 300 - 423 K. In ohmic region (<0.5 MV/cm), the resistivity was 2.456${\times}10^{14}$ ($\omega{\cdot}cm$ at 348 K. The Schottky emission is dominant at lower temperature range from 300 to 323 K and Poole-Frenkel emission is dominant at higher temperature range from 348 to 423 K.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.128-129
• /
• 2008

The annealing effects of $SiO_2/Si_3N_4$ stacked tunneling dielectrics were investigated. I-V characteristics of band gap engineered tunneling gate stacks consisted of $Si_3N_4/SiO_2/Si_3N_4$(NON), $SiO_2/Si_3N_4/SiO_2$(ONO) dielectrics were evaluated and compared with $SiO_2$ single layer using the MOS(Metal-Oxide-Semiconductor) capacitor structure. The leakage currents of engineered tunneling barriers (ONO, NON stacks) are lower than that of the conventional $SiO_2$ single layer at low electrical field. Meanwhile, the engineered tunneling barriers have larger tunneling current at high electrical field and improved electrical characteristics by annealing processes than $SiO_2$ layer.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05c
• /
• pp.41-46
• /
• 2002

In this work, we studied electrical characteristics and leakage current mechanism of Au/$Ta_2O_5$/Si metal-oxide-semiconductor (MOS) devices. $Ta_2O_5$ thin film (63nm) was deposited by atomic layer deposition (ALD) method at temperature of $235^{\circ}C$. The structures of the $Ta_2O_5$ thin films were examined by X-Ray Diffraction (XRD). From XRD, the structure of $Ta_2O_5$ was single phase and orthorhombic. From capacitance-voltage (C-V) analysis, the dielectric constant was 19.4. The temperature dependence of current-voltage (I-V) characteristics of $Ta_2O_5$ thin film was studied from 300 to 423 K. In ohmic region (<0.5 MVcm${-1}$), the resistivity was $2.4056{\times}10^{14}({\Omega}cm)$ at 348 K. The Schottky emission is dominant in lower temperature range from 300 to 323 K and Poole-Frenkel emission dominant in higher temperature range from 348 to 423 K.

• ETRI Journal
• /
• v.46 no.4
• /
• pp.708-715
• /
• 2024

We propose a 10-GHz 2 × 2 phased-array radio frequency (RF) receiver with an 8-bit linear phase and 15-dB gain control range using 65-nm complementary metal-oxide-semiconductor technology. An 8 × 8 phased-array receiver module is implemented using 16 2 × 2 RF phased-array integrated circuits. The receiver chip has four single-to-differential low-noise amplifier and gain-controlled phase-shifter (GCPS) channels, four channel combiners, and a 50-Ω driver. Using a novel complementary bias technique in a phase-shifting core circuit and an equivalent resistance-controlled resistor-inductor-capacitor load, the GCPS based on vector-sum structure increases the phase resolution with weighting-factor controllability, enabling the vector-sum phase-shifting circuit to require a low current and small area due to its small 1.2-V supply. The 2 × 2 phased-array RF receiver chip has a power gain of 21 dB per channel and a 5.7-dB maximum single-channel noise-figure gain. The chip shows 8-bit phase states with a 2.39° root mean-square (RMS) phase error and a 0.4-dB RMS gain error with a 15-dB gain control range for a 2.5° RMS phase error over the 10 to10.5-GHz band.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.8-9
• /
• 2006

Hafnium oxide ($HfO_2$) thin films were deposited on p-type (100) silicon wafers by atomic layer deposition (ALD) using TEMAHf and $O_3$. Prior to the deposition of $HfO_2$ films, a thin Hf ($10\;{\AA}$) metal layer was deposited. Deposition temperature of $HfO_2$ thin film was $350^{\circ}C$ and its thickness was $150\;{\AA}$. Samples were then annealed using furnace heating to temperature ranges from 500 to $900^{\circ}C$. The MOS capacitor of round-type was fabricated on Si substrates. Thermally evaporated $3000\;{\AA}$-thick AI was used as top electrode. In this work, We study the interface characterization of $HfO_2$/Hf/Si MOS capacitor depending on annealing temperature. Through AES(Auger Electron Spectroscopy), capacitance-voltage (C-V) and current-voltage (I-V) analysis, the role of Hf layer for the better $HfO_2$/Si interface property was investigated. We found that Hf meta1 layer in our structure effective1y suppressed the generation of interfacial $SiO_2$ layer between $HfO_2$ film and silicon substrate.

• Proceedings of the IEEK Conference
• /
• 2000.06b
• /
• pp.318-321
• /
• 2000

We showed that the change of Ar to $N_2$flow during the TiN deposition by the reactive sputtering decides the crystallinity of LPCVD W, as well as the electrical properties of the W-TiN/SiO$_2$Si capacitor. In particular, the threshold voltage can be controlled by the Ar to $N_2$ratio. As compared to the results obtained from the LPCVD W/SiO$_2$/Si MOS capacitor, the insertion of approximately 50 nm TiN film effectively prohibits the fluorine diffusion during the deposition and annealing of W films, resulting in negligible leakage currents at the low electric fields.

• Transactions on Electrical and Electronic Materials
• /
• v.12 no.3
• /
• pp.127-130
• /
• 2011

We investigated the effects of $O_2$ annealing (i.e., temperature and time) on the characteristics of hafnium silicate ($HfSi_xO_y$) films deposited on a Si substrate by atomic layer deposition process (ALD). We found that the post deposition annealing under oxidizing ambient causes the oxidation of residual Hf metal components, resulting in the improvement of electrical characteristics (e.g., hysteresis window and leakage current are decreased). In addition, we observed the annealing temperature is more important than the annealing time for post deposition annealing. Based on these observations, we suggest that post deposition annealing under oxidizing ambient is necessary to improve the electrical characteristics of $HfSi_xO_y$ films deposited by ALD. However, the annealing temperature has to be carefully controlled to minimize the regrowth of interfacial oxide, which degrades the value of equivalent oxide thickness.