• Solar Energy
• /
• v.17 no.4
• /
• pp.3-11
• /
• 1997

Because grain boundaries in polycrystalline silicon act as potential barriers and recombination centers for the photo-generated charge carriers, these defects degrade conversion effiency of solar cell. To reduce these effects of grain boundaries, we investigated various influencing factors such as thermal treatment, various grid pattern, selective wet etching for grain boundaries, buried contact metallization along grain boundaries, grid on metallic thin film. Pretreatment above $900^{\circ}C$ in $N_2$ atmosphere, gettering by $POCl_3$ and Al treatment for back surface field contributed to obtain a high quality poly-Si. To prevent carrier losses at the grain boundaries, we carried out surface treatment using Schimmel etchant. This etchant delineated grain boundaries of $10{\mu}m$ depth as well as surface texturing effect. A metal AI diffusion into grain boundaries on rear side reduced back surface recombination effects at grain boundaries. A combination of fine grid with finger spacing of 0.4mm and buried electrode along grain boundaries improved short circuit current density of solar cell. A ultra-thin Chromium layer of 20nm with transmittance of 80% reduced series resistance. This paper focused on the grain boundary effect for terrestrial applications of solar cells with low cost, large area, and high efficiency.

• Fire Science and Engineering
• /
• v.28 no.5
• /
• pp.8-13
• /
• 2014

The purpose of this study is to analyze the damage pattern when overcurrent is applied to a thermal magnetic type molded case circuit breaker (MCCB) using a Primary Current Injection Test System (PCITS). When an overcurrent of 150 A was applied to the PCITS for 5 seconds with the trip bar of an MCCB being damaged, it was found that the surface of the temperature control device (bimetallic strip) positioned at the right was significantly carbonized. When an overcurrent of 300 A was applied to the PCITS for 5 s under the same conditions, the entire temperature control device was deteriorated, becoming flattened and in close contact with the MCCB. When an overcurrent of 450 A was applied to the PCITS for 5 s, the coil of the temperature control device was melted and disconnected. In addition, it was observed that the contacts, the enclosure and upper cover were deformed and there was a trace of carbonization on them. When approximately 3 s had elapsed after an overcurrent of 600 A was applied, white smoke occurred inside the MCCB and a flame was radiated out, after which the overcurrent supply stopped with "phutt" (whomp) sound. It was observed that when the same type of MCCB is damaged by a general flame, the surfaces of its handle, terminal, arc divider (extinguisher) and temperature control device were carbonized uniformly. In addition, it was found that the trip bar of the operating mechanism was melted down and the metal operation pin was moved while being tripped.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.21 no.2
• /
• pp.201-206
• /
• 1992

Pinus pollen is used as the chief ingredient for Song-wha-dashik (Korea's traditional pattern-pressed candy). It has been the food stuff indispensable especially on the occasion of performing ancestral rites and holding a banquet since Shilla and Koryo Dynasty. In this paper, therefore, a new examination is made of the nutritive ingredients of the very Pinus pollen. Analysis has been made of the proximate composition, minerals, heavy metals, vitamins and free sugars of the Pollen of both Pinus densinora Siebol et Zuccarini and Pinus rigida Miller. In the proximate composition, Pinus rigida Miller is high except in free sugar ; crude ash (4.0%), crude protein (15.0%), crude fat (2.5%), crude fiber (17.5%). A lot of minerals have been found in both the samples. They contain Mg, Cl, Ca, Fe, Mn, Na, Zn, etc. In heavy metals, both the samples contain the same quantity of Cd(0.3 ppm) and the contents of Pb, Cu, and As are lower than the maximal limit permitted for food stuff. The contents of vitamin B$_1$, B$_2$, vitamin C are a little higher in Pinus rigida Miller : in vitamin E, on the contrary, Pinus densiflora Siebol et Zucarini (1.6 mg) doubles Pinus rigida Miller (0.8 mg). In free sugars, the results is as follows : 6.6%/6.9% in sucrose : 0.2% in fructose : 2.1% /2.9% in glucose respectively.

• Clinics in Shoulder and Elbow
• /
• v.10 no.2
• /
• pp.199-203
• /
• 2007

Purpose: It is very important to evaluate and fix coronoid process fractures because they are a critical element for a stable, effective elbow function. The lateral view of the elbow joint is used for a radiographic evaluation of the coronoid but an understanding of the fracture pattern is often difficult because of overlap of the radial head and obliquity of the fracture line. We developed the coronoid view, which is a new radiograph for an evaluation of the coronoid process fracture, and discuss its advantages for a postoperative follow-up. Materials and Methods: The coronoid view was designed for an evaluation of the anteromedial fragment of the coronoid process. After the patient sat on his side, the shoulder was abducted $45^{\circ}$ and the elbow was flexed $90^{\circ}$. The X-ray beam was shot perpendicular to the table. Since shoulder was abducted $45^{\circ}$ the fracture line of the coronoid process can be parallel to the X-ray beam, and the radial head can be cleared. Conclusion: The coronoid view can be a good alternative radiograph for an evaluation of a coronoid process fracture because the beam is parallel to the fracture line. The coronoid view can be particularly useful in postoperative patient follow-up where computed tomography is impractical due to metal implants and cost.

• Applied Biological Chemistry
• /
• v.43 no.3
• /
• pp.163-168
• /
• 2000

To remove phosphate accumulated in the soil and water, Acinetobacter lwoffi PO8 possessing a high ability to accumulate phosphate was isolated from a active sludge. Bacterium was cultured in the liquid medium containing $150\;{\mu}g/mL$ of phosphate at $30^{\circ}C$ in different culture conditions to examine intracellular phosphate uptake. The initial pH in the range of $7.5{\sim}8.5$ was effective on the growth and phosphate uptake of the strain. Glycerol and arabinose used as a carbon sources showed 93 and 91% the phsphate uptake, respectively. Among the nitrogen sources, ammonium salt such as $NH_4NO_3$ and $(NH_4)_2SO_4$ was effectively utilized on the phosphate uptake compared with amino compounds. The rate of phosphate uptake of $NH_4NO_3$, and $(NH_4)_2SO_4$, was 95 and 96%, respectively The growth and Phosphate uptake ability in the strain were significantly promoted when metal ions were added in the medium; $Co^{2+}$, however, was not utilized by the strain. The capacity of phosphate uptake was enhanced to $10{\sim}20%$ when arginine, methionine, or lysine was added. Using $^{32}P$ to examine the uptake Pattern of intracellular phosphate, experiment result showed that polyphosphate was largely found in the fraction of intracellular inorganic phosphate of Acinetobacter lwoffi PO8.

• Journal of the Mineralogical Society of Korea
• /
• v.4 no.1
• /
• pp.43-50
• /
• 1991

Two solid solution-type phases has been experimentally found in the quaternary system Cu-Fe-Sn-S:$(Fe, Cu, Sn)_{1+x}$ and $Cu_{2-x}Fe_(1+x}SnS_4$. These solid solutions are stable around the CuS-FeS-SnS referecne plane in the composition tetrahedron. One is the sphalerite-type monosulfide solid solution which has a extensive stability range with varying degrees of sulfur/metal ratio 9.7-1.0/1.0. The other is tetrahedrite-type phase $Cu_{2-y)Fe_{1+y}SnS_4(y_{max}=0.4)$ which is stable along the $Cu_2FeSnS_4-FeS$ tie line, but shows no phase transformation in the subsolidus range and decomposes incongruently at the range of 835-862${\circ}C$, depending on the compositional variation. Particularly, the latter phase shows the characteristic superstructure reflections, indicating that it is a derivative of sphalerite structure. The stability field of these two sphalerite-type phases are defined on the basis of diffraction pattern and optical homogeneity of the synthetic materials at the temperature range of 700-400${\circ}C$.

• Resources Recycling
• /
• v.26 no.4
• /
• pp.71-78
• /
• 2017

This study investigated the recovery of metallic aluminium in the black dross generated from used beverage can recycling process with crushing mechanism such as compression and impact. The as-received Al black dross had a spherical shape, and its size was about 10~40 mm. Also, The X-ray diffraction pattern showed that the main contents of black dross are composed of halite (NaCl), sylvite (KCl), spinel ($MgAl_2O_4$) and corundum ($Al_2O_3$). A metallic aluminium recovery test was performed using jaw crusher and hammer mill having different crushing mechanism. It was analysed that Jaw crushing process can separate into metallic aluminium and non metallic constituents. However, hammer milling process shows significant difference on the separation results. It was found that jaw crushing process was effective for recovery of metallic aluminium in the black dross than that of hammer milling process.

• Korean Journal of Microbiology
• /
• v.53 no.4
• /
• pp.257-264
• /
• 2017

Pseudomonas veronii MS1 and P. migulae MS2 have several mechanisms of copper resistance and plant growth promoting capability, and also can alleviate abiotic stress in plant by hydrolysis of a precursor of stress ethylene, 1-aminocyclopropane-1-carboxylic acid (ACC) by ACC deaminase. In 4-week pot test for tomato growth in soil contained 700 mg/kg Cu, inoculation of MS1 and MS2 significantly increased root and shoot lengths, wet weight and dry weight of tomato plants compared to those of uninoculated control. The inoculated tomato plants contained less amounts of proline that can protect plants from abiotic stress, and malondialdehyde, an oxidative stress marker than those of control. ACC synthase genes, ACS4 and ACS6, and ACC oxidase genes, ACO1 and ACO4, both involved in ethylene synthesis, were strongly expressed in Cu stressed tomato, whereas significantly reduced in tomato inoculated with MS1 and MS2. Also, a gene encoding a metal binding protein metallothionein, MT2 showed similar expression pattern with above genes. All these results indicated that these rhizobacteria could confer Cu resistance to tomato plant under Cu stress and allowed a lower level of Cu stress and growth promotion.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.31 no.1
• /
• pp.73-82
• /
• 2021

Objectives: This study aimed to investigate the public cognition and information acquisition route for heavy metals and organic solvents in the general population in order to provide information for the development of public relations materials. Methods: The study was carried out by questionnaire from January to March 2011 by an interview with trained surveyors. There were 700 participants, divided by gender and age. A questionnaire was issued consisting of subjective and objective cognition evaluation items and questions about information acquisition route and preferred information acquisition route for six heavy metals and five organic solvents. Data were expressed as a percentage using the SPSS 23.0 software package. Result: For heavy metals, subjective and objective cognition degrees were higher in the order of lead, mercury, cadmium, and arsenic. They were higher among males than females, and in adults compared to school-age subjects. For organic solvents, both cognition degrees were high in the order of acetone, benzene, and formaldehyde. However, cognition degree by gender and age showed a complex pattern. As a response to information acquisition route, broadcast media had the highest in all ages and genders, followed by word of mouth from neighbors in elementary school children, school education or expert lectures in middle and high school students up to people in their 30s, and print media among those in their 40s to over 60s. There was no difference in the order by gender. As a response to preference for information acquisition route, broadcast media also proved the highest in all ages and genders, followed by school education or professional lectures among those in elementary school and over their 60s, and the internet in other age groups. Females preferred school education or expert lectures and word of mouth from neighbors, while males preferred the internet. In the case of the internet, the ranking was higher for preferred information acquisition route compared with the ranking for information acquisition route. Conclusions: This data on cognition degree, information acquisition route, and preferred information acquisition route according to gender and age can provide basic data for the development of educational and promotional materials for heavy metals and organic solvents exposure management.

• Applied Chemistry for Engineering
• /
• v.22 no.5
• /
• pp.479-485
• /
• 2011

Pt-Bi/C catalysts supported on carbon black with various Pt/Bi ratios were synthesized by a reduction method. Chloroplatinic acid hydrate ($H_2PtCl_6{\cdot}xH_2O$) and bismuth (III) nitrate pentahydrate ($Bi(NO_3)_3{\cdot}5H_2O$) were used as precursors for Pt and Bi, respectively. Before loading metal on carbon, heat treatment and pretreatment of carbon black in an acidic solution was conducted to enhance the degree of dispersion. The physical property of the synthesized catalysts was investigated by X-ray diffraction and X-ray photoelectron spectroscopy. The XRD pattern of untreated Pt-Bi/C catalyst showed BiPt and $Bi_2Pt$ peaks in addition to Pt peaks. These results imply that Bi atoms were incorporated into the Pt crystal lattice by Pt-Bi alloy formation. The catalytic activity for methanol oxidation was measured using cyclic voltammetry in a mixture of 0.5 M $H_2SO_4$ and 0.5 M $CH_3OH$ aqueous solution. The addition of proper amount of Bi was found to significantly improve catalytic activity for methanol oxidation. The catalytic activity for methanol oxidation was closely related to the stability between electrode and electrolyte. In order to investigate the stability of catalysts, chronoamperometry analysis was carried out in the same solution at 0.6 V.