• Journal of Korean Port Research
• /
• v.13 no.1
• /
• pp.113-122
• /
• 1999

Congestion and traffic accidents occur on the merge and diverge sections in the interchange of the freeway. Studies have been conducted to reduce the traffic delay and accidents on the merge section in the freeway since 1960s. but a study was not conducted to estimate the speed variation on the merge section construct models estimated for the speed variation and suggest the appropriate measures. The purpose of this study was to identify the traffic flow characteristics on the merge section in the freeway construct the models estimated for the speed variation on the merge section in the freeway and finally establish the appropriate measure for reduction of traffic delay and accidents on the merge section in the freeway. The following results were obtained: I) Speed variations in the urban freeway appeared to be about 3.2mph, 6.5mph and 7.4mph based on the morning peak period, afternoon peak period and 24-hours period but those in the suburban freeway appeared to be about 8.0mph, 11.1mph and 10.1mph based on the same periods respectively. So different speed reduction signs need be installed to reduce delay and accidents on the merge section in the freeway based on the areas and periods as the freeway traffic management system(FTMS). ii) These models estimated for speed variation need to be studied with the changeable message sign(CMS) technique based on the real-time data so that the traffic flow could be maximized and the traffic delay and accidents be on the merge section in the freeway as more efficient freeway traffic management system(FTMS) in the near future.

• International Journal of Highway Engineering
• /
• v.11 no.2
• /
• pp.217-228
• /
• 2009

Sections under the influence of merging in an uninterrupted facility create irregular interaction between vehicles, such as lane change, speed acceleration and deceleration because of the merging of ramp traffic flows which have traffic characteristics different from those of the main line. This causes a confused traffic flow phenomenon(turbulence), which is considered an unstable traffic characteristic between various continuous points in consideration of v conditions. In this study, in merge influence sections, detectors by lane-point were installed to create time and space-series -traffic data. The least significant difference(LSD), as the criteria for discriminating a significant speed change between points, was calculated to examine the turbulence. As a result, turbulence in merge influence section was found to change the zones of such occurrence and the seriousness levels according to traffic condition. Thus, the maximum merge influence section due to the turbulence was created in the traffic condition before congestion when traffic increases. According to characteristics of changes in speed, merge influence section was divided into upstream 100m$\sim$downstream 100m(a section of speed reduction), and downstream 100m$\sim$downstream 400m(a section of reduced speed maintenance and acceleration).

• Journal of Broadcast Engineering
• /
• v.18 no.5
• /
• pp.691-701
• /
• 2013

In this paper, an early termination algorithm for merge process is proposed to reduce the computational complexity in High Efficiency Video Coding (HEVC) encoder. In the HEVC, the same candidate modes from merge candidate list (MCL) are shared to predict a merge or merge SKIP mode. This search process is performed by the number of the obtained candidates for the both of the merge and SKIP modes. This may cause some redundant search operations. To reduce this redundant search operation, we employ the neighboring blocks which have been encoded in prior, to check on the contextual information. In this study, the spatial, temporal and depth neighboring blocks have been considered to compute a correlation information. With this correlation information, an early termination algorithm for merge process is suggested. When all modes of neighboring blocks are SKIP modes, then the merge process performs only SKIP mode. Otherwise, usual merge process of HEVC is performed Through experimental results, the proposed method achieves a time-saving factor of about 21.25% on average with small loss of BD-rate, when comparing to the original HM 10.0 encoder.

• Language and Information
• /
• v.9 no.2
• /
• pp.69-83
• /
• 2005

This paper discusses the distribution of a null complementizer C, as opposed to an overt counterpart 'that', presenting empirical support both for and against the PF-merge analysis of C proposed by Boscovic and Lasnik (2003, henceafter B&L) who in turn attribute to the proposal in Pesetsky (1992) and Halle & Marantz (1993). In Section I, as a background, I discuss B&L's proposal that a null complementizer C is a PF-affix which undergoes a PF-merger operation at the PF component. In Section 2, after a brief sketch of the distribution of a null C mostly in bare-relatives, I explore the possibility of extending B&L's analysis to accomodate the null C's in the bare-relative constructions. In Section 3, I argue that despite some empirical difficulties, B&L's analysis of a null C as a PF-affix can still be maintained, if Adverb Fronting is an operation to Spec-C position. Furthermore, I propose a rule - PF Spell-Out Constraint - to account for the C-trace (i.e. that-trace) effect in relative constructions. With the PF Spell-Out Constraint and B&L's PF-merge account, the distribution of a null C can better be analyzed.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.4D
• /
• pp.443-450
• /
• 2009

Uninterrupted facility - since there is a close relationship between traffic volume, speed and density -, when a ramp traffic flow merges into the main line, will change the traffic speed or density, and the corresponding correlational model equation will be changed. Thus, this study, using time and space-series traffic data on areas under the influence of such a merging, identified sections which changed the correlation between speed and density variables, and examined such changes. As a result, the upstream and merging sections showed the "Underwood"-shaped exponent, and the downstream after passing the merging section showed a straight line "Greenshields" model. The downstream section which changed the correlation between speed and density showed a gradual downstream movement phenomenon within 100 m-500 m from the end of the third lane linking with the ramp, as the traffic approached the inner lanes. Also, the upstream section, merging section, and downstream section involving a change showed heterogeneous traffic flows which, in the speed-density model, have a statistically different free flow speed (constant) and a different ratio of free flow speed to jam density (gradient).

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.5
• /
• pp.59-74
• /
• 2021

The domestic road space is reaching the limit of planar space distribution, and Increasingly, the importance of three-dimensional space distribution through the development of underground space. therefore, In this study, a study was conducted on a traffic control method that can safely induce two different traffic flows in the connection between the ground road and the underground road. Through VISSIM, we calculated the appropriate amount of outflow and inflow traffic compared to the capacity of the main line when there is a Merge/Diverge section in the underground road. and Through the analysis of the number of conflicts, the appropriate traffic control level for safety in the underground, A basic study was conducted on the level of risk in the underpass according to the level of delay in the ground part through the analysis of the delay scenario of the ground road.

• Journal of Korean Society of Transportation
• /
• v.17 no.1
• /
• pp.19-28
• /
• 1999

This study deals with developing Critical GaP Model and Merge Probability Model which describe traffic patterns in the microscopic view, for the Purpose of suggesting a proper design criteria within the climbing lane section. Minimum tolerance speeds at the end of the climbing lane are calculated 60km/hr for 2-lane freeway, and 75km/hr for 4-lane freeway. In case of 2-lane freeway, the result is same as existing design criteria. and a new value is 15km/hr higher than existing design criteria for 4-lane freeway. In addition, auxiliary length at the end of the climbing lane is needed about 200m for 4-lane freeway to adjust high minimum tolerance speed. Therefore we propose to increase minimum tolerance speed for 4-lane freeway.

• Journal of Korean Port Research
• /
• v.13 no.2
• /
• pp.333-350
• /
• 1999

Today freeway is thought to be a very important transportation facility carrying tremendous traffic flow as the main corridor within the area of between the areas. However freeway is experiencing severe congestion and accidents by increased entrance ramp flow especially at peak time period. Ramp meters on the freeway entrance ramps that supply traffic to the freeway in a measured or appropriately regulated amount are needed for alleviating freeway congestion. Because ramp meters can be operated to discharge traffic at a measured or regulated rate thus maintaining more uniform speed on the mainline section maximizing the throughput to the freeway within the capacity of a downstream bottleneck and reducing the congestion related accidents. Thus the objectives in this study were to analyze the traffic characteristics on the freeway I-94 with ramp metering system before/after ITS technology in Detroit (Michigan) area compare shifts of the traffic characteristics on the freeway I-94 before/after ITS technology and finally suggest a better ramp metering strategy for the freeway system The following results were obtained: i)Flow occupancies and speeds on the mainline merge section of freeway were shown to be a big difference depending on the peak periods areas and directions based on the distribution of traffic flow characteristics on the freeway. ii)Reduced speed was shown to be more than 5 mph and ramp flow was also shown to be more than 240 vph at peak periods if there was the ramp metering system constructed on the freeway. iii)Ramp metering system was shown to be optimally operated on the freeway if ramp flow could be maximized within the range of over 900 vph and reduced occupancy could be also maximized by no more than 2 percent at peak periods. iv)The average flows on the freeway after the ITS technology were shown to be a decrease of over 20% depending on the peak periods areas and directions when compared with those flow on the freeway before the ITS technology. over 20% depending on the peak periods areas and directions when compared with those speeds on the freeway before the ITS technology. vi)The average metering rates on the freeway after the ITS technology were shown to be an increase of over 10% depending on the peak periods areas and directions when compared with those metering rates on the freeway before the ITS technology.

• Journal of Korean Port Research
• /
• v.14 no.1
• /
• pp.66-75
• /
• 2000

From the traffic analysis, and model constructions and verifications for speed prediction on the freeway ramp junctions with 70mph speed limit, the following results were obtained : ⅰ) The traffic flow distribution showed a big difference depending on the time periods. Especially, more traffic flows were concentrated on the freeway junctions in the morning peak period when compared with the afternoon peak period. ⅱ) The occupancy distribution was also shown to be varied by a big difference depending on the time periods. Especially, the occupancy in the morning peak period showed over 100% increase when compared with the 24hours average occupancy, and the occupancy in the afternoon peak period over 25% increase when compared with the same occupancy. ⅲ) The speed distribution was not shown to have a big difference depending on the time periods. Especially, the speed in the morning peak period showed 10mph decrease when compared with the 24hours'average speed, but the speed did not show a big difference in the afternoon peak period. ⅳ) The analyses of variance showed a high explanatory power between the speed predictive models(SPM) constructed and the variables used, especially the upstream speed. ⅴ) The analysis of correlation for verifying the speed predictive models(SPM) constructed on the ramp junctions were shown to have a high correlation between observed data and predicted data. Especially, the correlation coefficients showed over 0.95 excluding the unstable condition on the diverge section. ⅵ) Speed predictive models constructed were shown to have the better results than the HCM models, even if the speed limits on the freeway were different between the HCM models and speed predictive models constructed.

• Journal of Korean Port Research
• /
• v.14 no.2
• /
• pp.175-185
• /
• 2000

Today freeway is experiencing a severe congestion with incoming or outgoing traffic through freeway ramps during the peak periods. Thus, the purpose of this study is to identify the traffic characteristics, analyze the relationships between the traffic characteristics and finally construct the delay predictive models on the rap junctions of freeway with 70mph speed limit. From the traffic analyses, and model construction and verification for delay prediction on the ramp junctions of freeway, the following results were obtained : ⅰ) Traffic flow showed a big difference depending on the time periods. Especially, more traffic flows were concentrated on the freeway junctions in the morning peak period. ⅱ) The occupancy also showed a big difference depending on the time periods, and the downstream occupancy(Od) was especially shown to have a higher explanatory power for the delay predictive model construction on the ramp junctions of freeway. ⅲ) The delay-occupancy curve showed a remarkable shift based on the occupancies observed : O$\_$d/〈9% and O$\_$d/$\geq$9%. Especially, volume and occupancy were shown to be highly explanatory for delay prediction on the ramp junctions of freeway under O$\_$d/$\geq$9%, but lowly for delay prediction on the ramp junctions of freeway under O$\_$d/〈9%. Rather, the driver characteristics or transportation conditions around the freeway were thought to be a little higher explanatory for the delay prediction under O$\_$d/〈9%. ⅳ) Integrated delay predictive models showed a higher explanatory power in the morning peak period, but a lower explanatory power in the non-peak periods.