• Journal of Animal Environmental Science
• /
• v.19 no.2
• /
• pp.177-182
• /
• 2013

We studied the possibility to produce solid fuel using cattle manure and to apply TAO (Thermophilic Aerobic Oxidation) process of solid-liquid separation fraction. The physiochemical compositions of cattle manure solid fuel chip were analyzed as water 0.12%, low calorific value 3,510 kcal/kg, ashes 11.9%, chlorine 0.82%, sulfur dust 0.5%, mercury non-detection, cadmium 1.0 mg/kg, lead 2 mg/kg, arsenic non-detection. In treating cattle manure with TAO reactor the internal temperature of the reactor was increasing higher and $50^{\circ}C$ and over was maintained after 20 hours on. The physiochemical compositions of liquids increased from pH 7.3 to pH 9.18 and EC decreased from 4.6 to 3.48 mS/cm in treating process of cattle manure with TAO reactor. COD and SCOD decreased from 16,800 to 10,400 mg/L, from 4,600 to 2,040 mg/L respectively, which showed about 38% and 56% of remove efficiency respectively.

• Journal of the Korean Chemical Society
• /
• v.38 no.2
• /
• pp.146-150
• /
• 1994

The simultaneous determination of Zn, Cd, Pb and Cu in 1.000%(w/v) tungsten matrix by differential pulse anodic stripping voltammetry at a hanging mercury drop electrode has been studied. Tartaric acid(pH=5.00) was used as a supporting electrolyte. Optimum analytical conditions were found that the deposition potential was -1.2 volt(vs. Ag/AgCl), the deposition time was 3 minutes. The linear concentration range of all trace metal ions in 1.000%(w/v) tungsten matrix were 10 to 50 ppb. And the detection limit(3${\sigma}$) of zinc, cadmium, lead and copper were 1.25, 1.02, 1.69, and 1.02 ppb respectively. This method was superior to the ICP-AES method which detection limits(3${\sigma}$) in 1.000%(w/v) tungsten matrix were 8.0, 5.0, 120 and 5 ppb respectively.

• Journal of Korean Society of Water and Wastewater
• /
• v.30 no.6
• /
• pp.673-682
• /
• 2016

In this study, we investigated influent and effluent water pollutants in 53 Public Sewage Treatment Works (PSTWs) where industrial wastewater or landfill leachate is combined four times for two years from 2014 to 2015. Also, we analyzed the characteristics of heavy metals and volatile organic carbons at influent and effluent of these PSTWs caused by sewage treatment combined with industrial wastewater or landfill leachate. As a result, six heavy metals such as barium, copper, iron, manganese, nickel and zinc, and four volatile organic carbons (VOCs) including phenols, di(2-)ethylhexyl phthalate (DEHP), formaldehyde and toluene were observed above detection limits in most of PSTWs. Also, it was revealed that six heavy metals such as hexavalent chromium, mercury, cadmium, chromium, nickel and selenium, and four VOCs including 1,1-dichloroethylene, vinyl chloride, naphthalene, and epichlorohydrin were observed more frequently according to precipitation. As a result of reviewing the monitoring data on "Water Quality Monitoring Networks" in lower watersheds of PSTWs, both heavy metals and VOCs were below detection limits, indicating that the effluent water had little influence on the watershed. Nevertheless for the better management of influent and effluent pollutants in PSTWs, it is necessary to establish the advanced management plans for water pollutants in PSTWs, which include a list of priority substances management, monitoring plans, and guidelines for industrial wastewater and landfill leachate combined in PSTWs.

• Journal of Space Technology and Applications
• /
• v.1 no.1
• /
• pp.49-63
• /
• 2021

The exploration of the solar system is carried out through various payloads, and accordingly, many research results are emerging. We tried to apply deep-learning as a method of studying the bodies of solar system. Unlike Earth observation satellite data, the data of solar system differ greatly from celestial bodies to probes and to payloads of each probe. Therefore, it may be difficult to apply it to various data with the deep-learning model, but we expect that it will be able to reduce human errors or compensate for missing parts. We have implemented a model that detects craters on the lunar surface. A model was created using the Lunar Reconnaissance Orbiter Camera (LROC) image and the provided shapefile as input values, and applied to the lunar surface image. Although the result was not satisfactory, it will be applied to the image of the permanently shadow regions of the Moon, which is finally acquired by ShadowCam through image pre-processing and model modification. In addition, by attempting to apply it to Ceres and Mercury, which have similar the lunar surface, it is intended to suggest that deep-learning is another method for the study of the solar system.

• Analytical Science and Technology
• /
• v.10 no.3
• /
• pp.216-224
• /
• 1997

In the study of cyclic voltammogram of rubeanic acid, rubeanic acid has two reduction peaks; first peak is similar with that of $S^{2-}$ and thiourea, which is conceded to by HgS, second peak is very weak and unidentified. The study also describes the differential pulse cathodic stripping voltammetric method for the determination of rubeanic acid. The followings were optimal conditions of rubeanic acid for the study : 0.05M borate buffer solution(pH 10.0) ; an accumulation potential of -0.30V(vs. Ag/AgCl); accumulation time of 120sec. : scan rate of 10mV/sec. The detection limit of trace analysis shows $2.7{\times}10^{-8}M$ of rubeanic and at optimal conditions.

• Toxicological Research
• /
• v.29 no.3
• /
• pp.211-215
• /
• 2013

The trace toxic metal copper was assayed using mercury immobilized on a carbon nanotube electrode (MCW), with a graphite counter and a reference electrode. In this study, a macro-scale convection motor was interfaced with a MCW three-electrode system, in which a handmade MCW was optimized using cyclic- and square-wave stripping voltammetry. An analytical electrolyte for tap water was used instead of an expensive acid or base ionic solution. Under these conditions, optimum parameters were 0.09 V amplitude, 40 Hz frequency, 0.01 V incremental potential, and a 60-s accumulation time. A diagnostic working curve was obtained from 50.0 to 350 ${\mu}g/L$. At a constant Cu(II) concentration of 10.0 ${\mu}g/L$, the statistical relative standard deviation was 1.78% (RSD, n = 15), the analytical accumulation time was only 60 s, and the analytical detection limit approached 4.6 ${\mu}g/L$ (signal/noise = 3). The results were applied to non-treated drinking water. The content of the analyzed copper using 9.0 and 4.0 ${\mu}g/L$ standards were 8.68 ${\mu}g/L$ and 3.96 ${\mu}g/L$; statistical values $R^2$ = 0.9987 and $R^2$ = 0.9534, respectively. This method is applicable to biological diagnostics or food surveys.

• Journal of Environmental Science International
• /
• v.22 no.10
• /
• pp.1273-1278
• /
• 2013

Novel rhodamine 6G fluorescent chemosensors 1 and 2 for the detection of transition metal cations were synthesized through the condensation of rhodamine 6G ethylenediamine with each of 2-hydroxy-1-naphthaldehyde and 2,6-pyridinedicarbaldehyde, respectively. 1 and 2 were characterized using $^{13}C$ NMR, $^1H$ NMR and mass spectroscopy. Fluorometric and colorimetric measurements involving various metal ions revealed the ring opening of the rhodamine 6G spirocycle framework. In the absence of metal cations, 2 was colorless and non-fluorescent, whereas the addition of metal cations ($Hg^{2+}$ and others) changed the color to pink, accompanied by the appearance of an orange fluorescence. The chemosensors exhibited high selectivity for $Hg^{2+}$ over other divalent first-row transition metals. The complexes of $Hg^{2+}$ with 1 and 2 were successfully isolated. A huge enhancement in the fluorescence for both one- and two-photon excitations makes these compounds suitable candidates to be used for fluorescent labeling of biological systems.

• Journal of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.506-511
• /
• 1991

A sensitive adsorptive stripping voltammetric study was investigated on the complex of indium with morin at a hanging mercury drop electrode in 0.1 M acetate buffer (pH 3.20) solution. The adsorption phenomena were observed by differential-pulse voltammetry. The effects of various analytical conditions were discussed on the reduction peak current of the adsorbed complex on the surface of HMDE. Interferences by other trace metals and surfactant were also discussed. Detection limit was 2.6 nM of indium after 90 second deposition time, and the relative standard deviation (n = 7) at 4TEX>${\mu}g$/l indium was 2.0%.

• Journal of the Korean Chemical Society
• /
• v.32 no.2
• /
• pp.130-134
• /
• 1988

Direct differential-pulse cathodic stripping voltammetry on mercury electrode (HMDE) provides a sensitive technique for low level cyanide measurement in distilled and sulfide free solution. Cyclic voltammetry revealed the forming and redissolution reactions were reversible at pH 7 in 0.1M KCl-0.01M phosphate supporting electrolyte. The analytical conditions have been optimized. With deposition time of 3 min at deposition potential 0.00V(vs. Ag/AgCl) in this medium of pH7, quite reproducible and linear calibration curve was obtained down to $3{\times}10^{-7}M$ (8ppb) $CN^-$ which was the detection limit.

• Archives of Pharmacal Research
• /
• v.24 no.2
• /
• pp.100-104
• /
• 2001

Differential pulse polarographic(DPP) analytical procedure for the rifampicin antibiotic, which can be applied to monitor its synthetic process from the starting antibiotic of rifamycin B or rifamycin SV has been developed based on the electrochemical reduction of an azomethine group. Rifampicin exhibited a cathodic peak due to the azomethine group in the side chain of 3-[(4-methyl-1-piperazinyl)imino]methyl moiety and another cathodic peak due to the carbonyl group in rifamycin SV by DPP. The experimental peak potential shift of an azomethine reduction was -73 mV/pH in the pH range between 3.0 and 7.5, agreeing with involvement of 4 e-and 5 $H^5$ in its reduction. By the cyclic voltammetric(CV) studies, the azomethine and the carbonyl reductions in rifampicin were processed irreversibly on the mercury electrode. The plot of peak currents vs. concentrations of rifampicin ranging $1.0{\times}10^{-7} M~$1.0{\times}10^{-5} M yielded a straight line with a correlation coefficient of 0.9996. The detection limit was $1.0{\times}10^{-8} M with a modulation amplitude of 50 mV DPP has been successfully applied for the determination of rifampicin in the pharmaceutical preparations.