• Journal of Pharmaceutical Investigation
• /
• v.34 no.3
• /
• pp.185-192
• /
• 2004

The objective of this study was to evaluate the effects of surfactant type and concentration upon dissolution rates of carbamazepine from an immediate-release tablet. The dissolution media used in this study were aqueous solutions containing 0.1-2% sodium lauryl sulfate, cetyltrimethylammonium bromide, or polysorbate 80. The solubility of carbamazepine in the dissolution media was determined at first. A dissolution study was then conducted by using the USP dissolution apparatus II (paddle method) with an agitation rate of 75 rpm. Aliquots of the dissolution media were taken at predetermined time intervals, and the amount of carbamazepine dissolved was measured spectrophotometrically at 285 nm. The dissolution data obtained were fitted into a biphasic exponential equation with four parameters. Excellent correlations were observed between the experimental data and the theoretical ones predicted by the equation. This equation permitted the calculation of $T_{50%}$ (the time required for dissolving 50% of carbamazepine) under various experimental conditions. Differentiation of the equation also led to the attainment of dissolution rates at dissolution time points. The addition of a surfactant to an aqueous solution led to increasing the solubility of carbamazepine by 3- to 12-folds, depending upon its type and concentration. This event also resulted in enhancing the magnitude of a sink condition during the dissolution study. As a result, the dissolution rate of carbamazepine was affected by the aqueous surfactant concentration in a proportional manner. Subsequently, $T_{50%}$ values declined rapidly, as the surfactant concentration increased. Such effects were observed in decreasing order of sodium lauryl sulfate, cetyltirmethylammonium bromide, and polysorbate 80. These results clearly demonstrated that it was possible to tailor a dissolution rate and $T_{50%}$ of carbamazepine by manipulating the type and concentration of a surfactant. Relevant information would be beneficial to setting up dissolution specifications for poorly water-soluble drug products.

• Journal of Environmental Science International
• /
• v.15 no.10
• /
• pp.945-949
• /
• 2006

For a membrane bio-reactor, it is possible to fillet and separate activated sludge and effluent by head loss of centimeters, if non-woven fabric material is used as titration media. However, if non-woven fabric material is used to thicken high-concentration sludge, excessive sludge attachment causes the rapid decrease of flux. Mesh with fore sizes of $100{\mu}m,\;150{\mu}m,\;and\;200{\mu}m$ allows for easy separation of attached sludge. This study examined the possibility of mesh as filtration media. Existing close-flow filtration process, which requires maintaining sludge movement, makes It difficult to obtain high thickening rate. With a view of complementing this weakness, this study has made an experimental examination on how high-concentration sludge (about 3,000mg/L to 10,000mg/L) will be filtered and thickened when mesh module is submersed in the bio-reactor. Effluent flowed from the bottom of the bio-reactor by head loss of 65cm. In case of pore size of $100{\mu}m$, SS showed high recovery of 80% to 96%; therefore, it has been decided that mesh can be used as filtration media. Filtration lasted for more than 9 hours, until sludge with 9,000mg/L in MLSS concentration was thickened 9 times as dense. In the range from 3,610mg/L to 9,060mg/L in MLSS concentration, it was possible to obtain effluent with less than 2mg/L in MLSS concentration within 10 minutes.

• Journal of Embryo Transfer
• /
• v.24 no.4
• /
• pp.281-287
• /
• 2009

As a simple and economical method for in vitro produced embryos, we have used BSA instead of serum for the production and embryo transfer of Hanwoo in vitro fertilized (IVF) embryos and obtained the following results: 1) When using serum (FBS; fetal bovine serum) or BSA-containing culture media as the initial culture media for immature oocytes, it is regarded as inappropriate to add only BSA to the culture solutions from maturation of the immature oocytes to development stage culture, but serum still needs be added though there is no significant difference in the concentration, with a change from 5% to 10%. 2) The results of culturing IVF embryos after development (4 cell stage) in the Medium199 solutions containing BSA instead of serum (FBS) showed that 0.3% BSA concentration is not optimal and 0.5% or higher BSA concentration has no significant difference among 0.5%, 0.7%, 1% and 2% (p > 0.05). 3) The post-freezing survival ratio after development in 5% FBS-Medium199 showed that 1% BSA concentration of the culture solution is the most suitable in the BSA concentrations of 0.3% (51%), 0.5% (67%), 0.7% (69%), 1% (77%) and 2% (75%). 4) The pregnancy rates of the transplanted fresh(not frozen) blastocyst had no significant concentration dependency (p > 0.5), and the average pregnancy rate was 63.8%. 14% of overweight calves were found among the calves given birth to by the transfer of IVF blastocysts cultured in the serum-added culture solution, but none was found in the experimental groups in which BSA was added instead of serum.

• Journal of Environmental Health Sciences
• /
• v.15 no.2
• /
• pp.59-68
• /
• 1989

This study was performed employing the two stage aerated submerged biofilter of media pore size 1.5cm and 2cm, and infiuent substrate concentrations were 30.25mg COD/l, 50.1mg COD/l respectively. The purpose was to determine the treatment efficiency at the low concentration infiuent, reaction order and substrate flux with application of variable-order model that was presented by Rittmann and McCarty. . The results are as follows. 1. Treatment efficiency of 1st reactor was about BOD 82% and COD 76%, when effluent concentration was BOD 3.9 ~ 6.8, COD 7.1 ~ 12.5 mg/l, and this effluent concentration didn't satisfy the water quality grade I, II of river and lake. But as treated effluent of 1st reactor with 2nd reactor, we could achieve appropriate water quality, since instillation of 2nd reactor was needed. 2. Difference of media pore size between 1.5cm and 2cm didn't effect significantly to treatment efficiency and since this of 2nd reactor was about BOD 60%, COD 50%, an consideration of economic point of view should be carried out in field application. 3. Reaction order and substrate flux was varied 0.9851~0.9956 and 0.0028~0.0405 mg/$cm^{2} \cdot day$, and the substrate flux was increased as infiuent substrate concentration increased.

• Proceedings of the Korean Society for Applied Microbiology Conference
• /
• 1978.10a
• /
• pp.207.2-207
• /
• 1978

Arthrobacter simplex (ATCC 6946) was cultured, induced and immobilized in acrylamide polymer. The characteristics of the immobilized whole-cell enayme were studied using hydrocortisone as the substrate. The enzyme activity was increased during the incubation of the gel particle in 0.5％ peptone media. The ennzyme reaction kinetics of the Δ'-dehydrogenase (3-oxosteroid Δ'-oxydo reductase, E. C. 1.3.99.4) foliowed the Michaelis-Menten type. Km and Vm values were different significantly after immobilization of the cell. The optimum pH and temperature were changed, too. Nitrogen sources such as casitone, peptone or tryptone were good media for the enzyme reaction. And there was no need to add cofactors of the enzyme in the pre-sence of energy sources used in the test. The effect of metal ions on the enzyme activity was insignificant. Organic solvents were used increase the substrate concentration and there was no optimum solvent concentration depending on the substrate concentration.

• Environmental Engineering Research
• /
• v.20 no.3
• /
• pp.230-236
• /
• 2015

26 multi-regional water treatment plants (WTPs) were investigated, to determine the characteristics of manganese (Mn) concentration and removal in Korea. Mn concentrations of raw water in most WTPs were higher than the drinking water standard (i.e., 0.05 mg/L); thus, proper removal of Mn at the WTPs is needed. Mn concentration was generally higher in lakes than rivers due to seasonal lake turnovers. The Mn concentrations of treated water at 26 WTPs in 2012 were less than 0.05 mg/L, due to strict law enforcement and water treatment processes optimization. However, before 2010, those concentrations were more than 0.05 mg/L, which could have led to an accumulation of Mn oxides in the distribution system. This could be one of the main reasons for black water occurrence. Therefore, regular monitoring of Mn concentration in the distribution system, flushing, and proper Mn removal at WTPs are needed, to supply clean and palatable tap water.

• Journal of Plant Biology
• /
• v.34 no.4
• /
• pp.253-260
• /
• 1991

Spirodela polyrhiza and Lemna aequinoctialis often occurred at the sites of high ammonium concentration and at the sites of high nitrate concentration, respectively. We investigated the different distribution between two species in relation to the type of nitrogen sources and their concentrations. Our experiments showed that L. aequinoctialis grew faster than S. polyrhiza in nitrate media with lower than 15 mM concentration. The nitrate uptake was also faster in L. aequinoctialis than in S. polyrhiza. However, neither differences in growth nor in uptake patterns between these two species were observed in ammonium media. Glutamine synthetase (GS), glutamate dehydrogenase (GDH) and glutamate synthetase (GOGAT) activities were higher in L. aequinoctialis. In particular, nitrate reductase activity (NRA) in L. aequinoctialis was 12.1 times as high as that in S. polyrhiza. These results showed that the two species responded varyingly to the types of nitrogen sources and their concentrations. Therefore, the difference in geographic distribution between the two species appeared to reflect the interspecific differences in enzyme activities and, subsequently, nitrogen absorption abilities.

• Korean Journal of Microbiology
• /
• v.26 no.2
• /
• pp.129-136
• /
• 1988

To investigate the influence of cosubstrate supplement and ammonium sulfate on lignin degradation by Pseudomonas diminuta KM-4-2, isolated in the laboratory, the strain was cultured on the lignin media which contained lignin as a source of carbon and the culture filtrate was analyzed by Sephadex G-75 column chromatography. It was found that polymerization was not appeared unlike wood-rot fungi. When the carbohydrates were added, the peak of lignin at 280nm by UV scanning spectra of the filtrate, was significantly increased. In order to determine the effect of ammonium sulfate on the ligninolytic activity, the isolated strain was incubated in the media containing 0.1%, 0.25% and 0.5% of nitrogen concentration in the Warburg flask and the rate of oxygen uptake was esitmated by Warbuge Respirometer. As a result, the activity was maximum at 0.1% of nitrogen concentration and thereafter decreased in parallel with nitrogen concentration.

• Korean Journal of Food Science and Technology
• /
• v.27 no.2
• /
• pp.210-215
• /
• 1995

Korean medicinal herbs -sasam, gilkyung, jakyak, danggwi, hwangki and chunkung were soaked to the distillate of Korean rice wine for 75 days. The alcohol concentration of distillate, soaking media was adjusted to 45, 35, and 25% respectively with distilled water. Changes in alcohol concentration, pH, optical density, concentration of peoniflorin and decursin were analyzed. Quality of the final product was determined by sensory evaluation. Alcohol concentration was rapidly decreased but pH increased in 15 days and thereafter they showed slow decrease. Decrease of alcohol concentration was affected by the kind of herb and alcohol concentration of soaking media. The strongest effect was observed from danggwi and low alcohol concentration. Concentration of paeoniflorin and decursin, an index component of jakyak and danggwi respectively, showed the similar trend of decrease after increase to maximum concentration. From the sensory evaluation, the best overall quality was obtained from liquors made from 45% alcohol concentration. The quality was decreased in the order of sasam, jakyak, chunkung and hwanggi.

• Journal of Environmental Science International
• /
• v.23 no.4
• /
• pp.737-742
• /
• 2014

This study aimed for evaluating the applicability of the two stage dual media filtration system in field water treatment plant. The field plant of two stage and dual media filtration system was operated for 2 months. Average iron concentrations of the settled water, existing filtered water and second stage filtered water was 0.041 mg/L, 0.007 mg/L and 0.005 mg/L, respectively. Removal efficiency of iron concentration in the second stage is appropriately 35% more than in existing filtered water. Also removal efficiency of residual chlorine in the dual media filtration system is relatively 42.3% more than in existing filtered water due to adsorption of activated carbon, but the removal of ammonia nitrogen by adsorption is insufficient. Average concentrations of THM and chloroform in the settled water are 0.033 mg/L, 0.026 mg/L, respectively and in existing filtered water are 0.023 mg/L and 0.023 mg/L. Average concentrations of THM and chloroform in the dual media filtration system are 0.008 mg/L and 0.013 mg/L. Therefore removal efficiency of THM concentration in second stage is more than 66.4% in existing filtrated water. Also removal efficiency of chloroform in the dual media filtration system is more than 50.0% in existing filtered water because of the adsorption of activated carbon. In this case backwashing period in dual stage system is 4~5 days, but in existing filtration system is 1~2 days.