• Journal of Microbiology and Biotechnology
• /
• v.23 no.4
• /
• pp.511-517
• /
• 2013

In this work, a fibrous bed bioreactor with high specific surface area and good adsorption efficacy for S. cerevisiae cells was used as the immobilization matrix in the production of ethanol. In batch fermentation, an optimal ethanol concentration of 91.36 g/l and productivity of 4.57 g $l^{-1}\;h^{-1}$ were obtained at an initial sugar concentration of 200 g/l. The ethanol productivity achieved by the immobilized cells was 41.93% higher than that obtained from free cells. Ethanol production in a 22-cycle repeated batch fermentation demonstrated the enhanced stability of the immobilized yeast cells. Under continuous fermentation in packed-bed reactors, a maximum ethanol concentration of 108.14 g/l and a productivity of 14.71 g $l^{-1}\;h^{-1}$ were attained at $35^{\circ}C$, and a dilution rate of 0.136 $h^{-1}$ with 250 g/l glucose.

• The Journal of the Korea Contents Association
• /
• v.15 no.5
• /
• pp.436-443
• /
• 2015

The purpose of this study was to develop a self-diagnostic linearity quality control techniques of computed tomography (CT) by using measured CT number values from the various concentrations of iodine contrast media (CM) is diluted with distilled water under each condition of the tube voltage. The equipment was used for four-channel MDCT, the iodine concentration were using 300 mgI/ml, 350 mgI/ml, 370 mgI/ml and 400mgI/ml. Dilution of CM in distilled water was increased by each 5% until the maximum CT number values were measured. We applied the tube voltages for 90 kVp, 120 kVp, 140 kVp. As a result, we was obtained to the nearest linearity as 0.993 of correlation coefficient between the iodinated CM from 5% to 25% in 400 mgI/ml and the CT number values by 90 kVp. In conclusion, the proposed self-diagnostic linearity quality assurance technique by using iodine CM can be utilized to replace the AAPM CT performance phantom.

• Journal of the Korean Chemical Society
• /
• v.14 no.1
• /
• pp.51-59
• /
• 1970

The apparent molal volumes(${\phi}_v$) of the homologous salts $RNH_3Cl$, where R varies from methyl-($CH_{3^-}$) to n-butyl-(n-$C_4H_{9^-}$) in a series of methanol-water mixtures have been determined at 30$^{\circ}C$ by means of a float method to fifth decimal places down to 0.01 m. The values of ${\phi}_r$ extrapolated to infinite dilution give partial molal volumes $\bar{V}^{\circ}$which varies considerably in accordance with the solvent composition. that is, mole fraction of methanol. The experimental results are discussed in terms of the varying size and charge effect, hydrophobic nature of the solute species, and also the additivity relationship between successive homologous and the structure of the binary solvent. The results indicate that at 0.1 mole fraction methanol the enhanced structuredness of water cause a minimum in the partial molal volumes of cations $\bar{V}^{\circ}_+$, while at 0.4 mole fraction the solvent structure is such that the free volume is a minimum but the effect of electrostriction is a maximum.

• Journal of ILASS-Korea
• /
• v.16 no.3
• /
• pp.119-125
• /
• 2011

Due to the oxygen contents in biodiesel, application of the fuel to compression ignition engines has significant advantages in terms of lowering PM formation in the combustion chamber. In recent days, considerable studies have been performed to extend the low temperature combustion regime in diesel engines by applying biodiesel fuel. In this work, low temperature combustion characteristics of biodiesel blends in dilution controlled regime were investigated at a fixed engine operating condition in a single cylinder diesel engine, and the comparisons of engine performances and emission characteristics between biodiesel and conventional diesel fuel were carried out. Results show that low temperature combustion can be achieved at $O_2$ concentration of around 7~8% for both biodiesel and diesel fuels. Especially, by use of biodiesel, noticeable reduction (maximum 50% of smoke was observed at low and middle loads compared to conventional diesel fuel. In addition, THC(total hydrocarbon) and CO(Carbon monoxide) emissions decreased by substantial amounts for biodiesel fuel. Results also indicate that even though about 10% loss of engine power as well as 14% increase of fuel consumption rate was observed due to lower LHV(lower heating value) of biodiesel, thermal efficiencies for biodiesel fuel were slightly elevated because of power recovery phenomenon.

• Microbiology and Biotechnology Letters
• /
• v.32 no.2
• /
• pp.154-157
• /
• 2004

Immobilized cells of Aspergillus niger was employed to produce citric acid by fermentation of milk factory waste water. A. niger ATCC 9142 as a citric acid production strain was cultured for 3 days and was entrapped with Ca-alginate bead about 2.5∼3.5 mm. The optimal pH and temperature were estimated to be 3.0 and $30^{\circ}C$, respectively. Dilution rate for fermentation was calculated to be $0.025 h^{－1}$ . Maximum amount of citric acid was obtained at 4.5 g/$\ell$ with the optimized fermentation condition. The yield of citric acid produced by immobilized A. niger ATCC 9143 was 70.3%. The yield was increased by 20% with immobilized cell, compared to that of the shake flask culture. Hence, the milk factory waste water is worthy to be used for the substrate of citric acid fermentation.

• Journal of Microbiology and Biotechnology
• /
• v.21 no.7
• /
• pp.739-745
• /
• 2011

During the production of grape wine, the formation of thick leathery pellicle/bacterial cellulose (BC) at the airliquid interface was due to the bacterium, which was isolated and identified as Gluconacetobacter hansenii UAC09. Cultural conditions for bacterial cellulose production from G. hansenii UAC09 were optimized by central composite rotatable experimental design. To economize the BC production, coffee cherry husk (CCH) extract and corn steep liquor (CSL) were used as less expensive sources of carbon and nitrogen, respectively. CCH and CSL are byproducts from the coffee processing and starch processing industry, respectively. The interactions between pH (4.5-8.5), CSL (2-10%), alcohol (0.5-2%), acetic acid (0.5-2%), and water dilution rate to CCH ratio (1:1 to 1:5) were studied using response surface methodology. The optimum conditions for maximum BC production were pH (6.64), CSL (10%), alcohol (0.5%), acetic acid (1.13%), and water to CCH ratio (1:1). After 2 weeks of fermentation, the amount of BC produced was 6.24 g/l. This yield was comparable to the predicted value of 6.09 g/l. This is the first report on the optimization of the fermentation medium by RSM using CCH extract as the carbon source for BC production by G. hansenii UAC09.

• The Plant Pathology Journal
• /
• v.26 no.4
• /
• pp.328-339
• /
• 2010

A tobamovirus, Ribgrass mosaic virus (RMV), was identified newly from chinese cabbage (Brassica campestris L. pekinensis) in Korea. Virus disease incidence of RMV on chinese cabbage was 37.9% in alpine area on August in 1993. RMV induced the symptoms of necrotic ring spots, necrotic streak on midrib and malformation. RMV, Ca1 and Ca3 isolate, could infect 35 species out of 45 plants including Chenopodium amaranticolor. Physical properties of RMV Ca1 isolate were very stable as 10.8 over for dilution end point, $95^{\circ}C$ for temperature inactivation point and 18 weeks for longevity in vitro. RMV had the soil transmission rate of 75.0% for the chinese cabbages, 'Chunhawang' and 'Seoul' cultivars. The purified virions of RMV had the typical ultraviolet absorption spectrum of maximum at 260 nm and minimum at 247 nm. RMV of Ca1 isolate was related serologically with antisera of Tobacco mosaic virus (TMV)-Cym, TMV-O and Pepper mottle virus, but not related with antiserum of Odontoglossum ring spot virus. coat protein gene of RMV-Ca1, sized 473 nucleotides, encoded 158 amino acid residues. Nucleotide identity of RMV-Ca1 CP gene was 96.4% with RMV-Shanghai (GenBank accession No. of AF185272) from China and 96.0% with RMV-Impatiens (GenBank accession No. of AM040974) from Germany. Identity of amino acids between RMV-Ca1 and the two RMV isolates was 96.8%. Specific three primers were selected for rapid and easy genetic detection of RMV using Virion Captured (VC)/RT-PCR method.

• Plant Journal
• /
• v.18 no.3
• /
• pp.52-61
• /
• 2022

This study tested the effect of de-NOx Facility operating condition on Nox emisiion in a 125 MW wood pellet power plant in Yeongdong Eco Power Plant Unit 1, which is in operation. As SNCR urea flow rate increased, NOx emission gradually decreased, but ammonia slip after SCR increased. The boiler under test has a structure that is unfavorable to SNCR operation due to the high internal temperature, and the optimum location of the nozzle will be required. SCR dilution air temperature change did not affect the amount of NOx generated. Increasing SCR ammonia flow reduced the NOx emission at SCR outlet and also increased the NOx removal efficiency. However, the ammonia flow rate of 111 kg/h, which does not exceed the ammonia slip its own reference limit, is estimated to be the maximum operating standard. The increase in SCR mixer pressure reduced NOx emission and the removal efficiency was also measured to be the most effective variable to inhibit NOx production.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.4 no.2
• /
• pp.127-131
• /
• 2002

The qualitative and quantitative changes of bacterial flora associated with the Pure Mysore (Multivoltine) and NB$_4$D$_2$ (Bivoltine) silkworm (Bombyx modi L.) midgut during third, fourth and fifth instars were studied. Larvae reared on mulberry leaves were dissected and their midgut bacterial populations were enumerated through serial dilution technique and after 72 hrs of incubation period at 28 $\pm$ 1$^{\circ}C$, the bacterial population was estimated. The results showed a highest mean value of 15$\times$10/ sup 6/ sup 6/ CFU/g and 28$\times$10/ sup 6/ CFU/g in Pure Mysore and NB$_4$D$_2$races, respectively, in midgut tissue of fifth instar larvae. The natural epiphytic microflora of mulberry leaves fed during the respective instars was also studied and found maximum 14$\times$10$^3$ CFU/g in leaves fed in third instars, followed by 5.3$\times$10$^3$ CFU/g and 2.1$\times$10$^3$ CFU/g in leaves fed during fourth and fifth instars, respectively. The bacterial flora colonized in midgut was found to be elaborating amylase, caseinase, gelatinase, lipase and urease enzymes. The highest percentages of isolates were amylase producers followed by protein and lipid splitters in Pure Mysore, whereas in NB$_4$D$_2$ protein splitter were dominated followed by lipase and amylase producers in NB$_4$D$_2$. The results indicate that the natural microflora may play a vital role in the digestion of ingested food materials in silkworms.

• Journal of ILASS-Korea
• /
• v.28 no.1
• /
• pp.43-48
• /
• 2023

The waste-heat-recovery boiler with water spray (HR-B/WS) applies the heat exchange between the inlet air and exhaust gas with the water spray into the inlet air. The evaporation of water in the inlet air promotes heat recovery from the exhaust gas so that thermal efficiency can be improved by the enhanced condensing effect. The NOx emission can also be reduced by lowering the flame temperature due to the dilution effect of the water. In this study, the validity of this concept is examined by the practical boiler test performed with a 24 kW condensing boiler under the full load condition according to the water injection amount. The theoretical amount of water injection is calculated under the assumption of full evaporation of the sprayed water, which is calculated as 50 g/min. Since the injected water cannot evaporate fully in the actual system, the maximum water spray amount is set as 100 g/min. The results showed that the water injection can increase the thermal efficiency up to 95.59% and reduce NOx and CO emissions simultaneously to 8.9 ppm and 35 ppm at 0% of O₂. Although the heat energy loss increased due to the unevaporated water, the increase in water injection amount caused higher thermal efficiency due to the increased amount of the evaporated water.