• Journal of Powder Materials
• /
• v.28 no.1
• /
• pp.31-37
• /
• 2021

This study explores reducing the oxygen content of a commercial Ti-48Al-2Cr-2Nb powder to less than 400 ppm by deoxidation in the solid state (DOSS) using Ca vapor, and investigates the effect of Ca vapor on the surface chemical state. As the deoxidation temperature increases, the oxygen concentration of the Ti-48Al-2Cr-2Nb powder decreases, achieving a low value of 745 ppm at 1100℃. When the deoxidation time is increased to 2 h, the oxygen concentration decreases to 320ppm at 1100℃, and the oxygen reduction rate is approximately 78% compared to that of the raw material. The deoxidized Ti-48Al-2Cr-2nb powder maintains a spherical shape, but the surface shape changes slightly owing to the reaction of Ca and Al. The oxidation state of Ti and Al on the surface of the Ti-48Al-2Cr-2Nb powder corresponds to a mixture of TiO2 and Al2O3. As a result, the peaks of metallic Ti and Ti suboxide intensify as TiO2 and Al2O3 in the surface oxide layer are reduced by Ca vapor deposition.

• Journal of Korean Society of Environmental Engineers
• /
• v.33 no.7
• /
• pp.523-529
• /
• 2011

This study has been performed to examine the influence of the size of particles on the stabilization in the aerobic stabilization equipment connected with MBT system. The biodegradable waste inside the reactor (60% of food waste, 25% of paper waste, 2% of wood waste and 5% of compost) has been charged in same composition. The degree of stabilization was compared and analyzed after charging with adjustment of particle size in 5 mm, 10 mm, 20 mm, 50 mm, 100 mm and state of no separation. The experiment revealed that highest temperature beyond $65^{\circ}C$ was shown in the particle size of less than 50 mm in change of temperature and the highest temperature was about $50^{\circ}C$ in reactor of 100 mm and no separation. The proportionality between generated quantity of $CO_2$ and particle size was not observed, even the highest in generated quantity was shown in over 100 mm. The weight changes based on wet and dry conditions in the reaction process showed the 30% and 46% of reduction in the smallest particle size of 5 mm and it showed the trend of the lower reduction rate at the bigger particle size. The water soluble $COD_{Cr}$ and TOC showed the reduction rate of 60% in reactor of particle size in 100 mm and no separation while the reduction rate comparing to the initial stage of reaction in the reactor of less than 50 mm was 80%. Such result derived the conclusion of acceleration in the decomposing stabilization of biodegradable material due to the decomposing rate of organic substance as the particle size of biodegradable waste gets smaller. It is concluded as necessary to react in adjustment under 50 mm of particle size as much as possible.

• Resources Recycling
• /
• v.7 no.3
• /
• pp.52-57
• /
• 1998

The objective of this study was to investigate the effect of cow manure as additive material on the ripening of sewage s sludge for vermistabiJization. The changes of the waste properties by ripening for 50days were observed as a function of the v various mixture ratios of sewage sludge ‘and cow manure. The pH values of the mixture wastes decreased from 7.5-7.67 to 6_ 9~7.2 by the ripening for 50days, and the mixture ratio made dIfferent pH values. The initial value of oxidation-reduction p potential (Eh) of the mixture waste was a negative (-) value indicating an unfavorable condition for earthworm after, but the v values of Eh increased with the opening time. The Increase rate at Eh value was prop$\alpha$rtional to the mixture ratio of cow m manure. The value of alkalinity was also changed into the favorable range for earthworm after 50days except for non-use of 1 the cow manure When the mixture ratio of the cow manure increased from 10% to 30%, the growth of earthworms increased h from 63.7% to 88.3 % tor the survival rate, 265% to 321% for the liveweight increasing rate and 66.7_7% to 91% for hatching f rate of the cocoons. It can be concluded that the proper content of tbe cow manure in the sewage sludge to ensure effective v vermistabilization was over 20%, when the mixture was ripened during 50 days. The quantity of ingestion and 며ectian at 20%-30% was found to be O.15--i.L18g sludge and 0 1l--O.14g solid per capacity earthworm per day, respectively.

• Journal of the Korean Society of Radiology
• /
• v.4 no.2
• /
• pp.21-25
• /
• 2010

Recently, various semiconductor compounds as radiation detection material have been researched for a diagnostic x-ray detector application. In this paper, we have fabricated the CdS detecton sensor that has good photosensitivity and high x-ray absorption efficiency among other semiconductor compounds, and evaluated the application feasibility by investigating the detection properties about energy range of diagnostic x-ray generator. We have fabricated the line voltage selector(LCV) for a signal acquisition and quantities of CdS sensor, and designed the voltage detection circuit and rectifying circuit. Also, we have used a relative relation algorithm according to x-ray exposure condition, and fabricated the interface board with DAC controller. Performance evaluation was investigated by data processing using ANOVA program from voltage profile characteristics according to resistive change obtained by a tube voltage, tube current, and exposure time that is a exposure condition of x-ray generator. From experimental results, an error rates were reduced according to increasing of a tube voltage and tube current, and a good properties of 6%(at 90 kVp) and 0.4%(at 320 mA) ere showed. and coefficient of determination was 0.98 with relative relation of 1:1. The error rate according to x-ray exposure time showed exponential reduction because of delayed response velocity of CdS material, and the error rate has 2.3% at 320 msec. Finally, the error rate according to x-ray dose is below 10%, and a high relative relation was showed with coefficient of determination of 0.9898.

• Resources Recycling
• /
• v.16 no.1 s.75
• /
• pp.68-72
• /
• 2007

The influences of reduction time, potential difference and ionic concentration flow rate have been investigated on the electrolytic recovery of silver from artificial photographic wastewater in continuous flow reactor system. As the initial concentration of silver ion and applied potential were increased, the amount of silver recovered was observed to be raised. Also, the electrolytically recovered material from artificial wastewater was proved to be pure silver based on the qualitative analyses by EPMA and XRD.

• Journal of Powder Materials
• /
• v.21 no.2
• /
• pp.131-136
• /
• 2014

Cathode materials and their precursors are prepared with transition metal solutions recycled from the the waste lithium-ion batteries containing NCM (nickel-cobalt-manganese) cathodes by a $H_2$ and C-reduction process. The recycled transition metal sulfate solutions are used in a co-precipitation process in a CSTR reactor to obtain the transition metal hydroxide. The NCM cathode materials (Ni:Mn:Co=5:3:2) are prepared from the transition metal hydroxide by calcining with lithium carbonate. X-ray diffraction and scanning electron microscopy analyses show that the cathode material has a layered structure and particle size of about 10 ${\mu}m$. The cathode materials also exhibited a capacity of about 160 mAh/g with a retention rate of 93~96% after 100 cycles.

• Electrical & Electronic Materials
• /
• v.4 no.2
• /
• pp.123-131
• /
• 1991

SiH$_{4}$환원에 의한 selective CVD-W 공정에서 SiH$_{4}$ 유속의 W막 특성에 대한 효과를 조사하였다. 0.7$_{4}$/SW$_{2}$(=R)<0.9에서 .betha.-W이 나타나기 시작하여 SiH$_{4}$ 유속의 증가에 따라 .betha.-W의 함량은 게속 증가한다. W막의 표면 형태도 SiH$_{4}$유속의 증가에 따라 나뭇잎 모양(R<0.5), 흐릿하고 불안정한 모양(0.70.9에서는 주상의 결정립을 나타낸다. R.leq.0.7에서는 .alpha.-W만 존재하다가 0.7$_{4}$유속의 증가에 따라 증착속도와 W막의 정기저항이 증가한다. 특히, R.geq.0.9에서 전기저항이 급증한다. SiH$_{4}$유속의 증가에 따라 선택성이 악화되며 특히 1.1

• Journal of Electrochemical Science and Technology
• /
• v.11 no.4
• /
• pp.346-351
• /
• 2020

The removal characteristics of copper (Cu) from electrochemical surface by voltage-activated reaction were reviewed to assess the applicability of electrochemical-mechanical polishing (ECMP) process in three types of electrolytes, such as HNO₃, KNO₃ and NaNO₃. Electrochemical surface conditions such as active, passive, transient and trans-passive states were monitored from its current-voltage (I-V) characteristic curves obtained by linear sweep voltammetry (LSV) method. In addition, the oxidation and reduction process of the Cu surface by repetitive input of positive and negative voltages were evaluated from the I-V curve obtained using the cyclic voltammetry (CV) method. Finally, the X-ray diffraction (XRD) patterns and energy dispersive spectroscopy (EDS) analyses were used to observe the structural surface states of a Cu electrode. The electrochemical analyses proposed in this study will help to accurately control the material removal rate (MRR) from the actual ECMP process because they are a good methodology for predicting optimal electrochemical process parameters such as current density, operating voltage, and operating time before performing the ECMP process.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05b
• /
• pp.95-101
• /
• 1996

In this paper, the steady 2-dimensional model for a long horizontal line with different end temperatures undergoing natural convection at very high Rayleigh number is proposed to numerically investigate the heat transfer and flow characteristics. The dimensionless governing equations are solved by using SIMPLE (Semi-Implicit Method for Pressure Linked Equations) algorithm which is developed using control volumes and staggered grids. The numerical results are verified by comparison with the operating PWR test data. The analysis focuses on the effects of variation of the heat transfer rates at the pipe surface, the thermal conductivities of the pipe material and the thickness of the pipe wall on the thermal stratification. The results show that the heat transfer rate at the pipe surface is the controlling parameter. A significant reduction and disappearance of thermal stratification phenomenon is observed at the Biot number of 5.0$\times$10$^{-2}$. The results also show that the increment of the thermal conductivity and thickness of the wall weakens the thermal stratification and somewhat reduces azimuthal temperature gradient in the pipe wall. Those effects are however minor, when compared with those due to the variation of the heat transfer rates at the surface of the pipe wall.

• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.7
• /
• pp.1048-1060
• /
• 2005

Dietary acidifiers appear to be a possible alternative to feed antibiotics in order to improve performance of weaning pigs. It is generally known that dietary acidifiers lower gastric pH, resulting in increased activity of proteolytic enzymes, improved protein digestibility and inhibiting the proliferation of pathogenic bacteria in GI tract. It is also hypothesized that acidifiers could be related to reduction of gastric emptying rate, energy source in intestine, chelation of minerals, stimulation of digestive enzymes and intermediate metabolism. However, the exact mode of action still remains questionable. Organic acidifiers have been widely used for weaning pigs' diets for decades and most common organic acidifiers contain fumaric, citric, formic and/or lactic acid. Many researchers have observed that dietary acidifier supplementation improved growth performance and health status in weaning pigs. Recently inorganic acidifiers as well as organic acidifiers have drawn much attention due to improving performance of weaning pigs with a low cost. Several researchers introduced the use of salt form of acidifiers because of convenient application and better effects than pure state acids. However, considerable variations in results of acidifier supplementation have been reported in response of weaning pigs. The inconsistent responses to dietary acidifiers could be explained by feed palatability, sources and composition of diet, supplementation level of acidifier and age of animals.