• Journal of the Korean Society for Marine Environment & Energy
• /
• v.6 no.4
• /
• pp.67-82
• /
• 2003

A 2-dimensional hydrodynamic model has been applied to understand water circulation pattern in Lake Deacheong. The simulation results have been used in sediment transport modeling. A sediment transport model using a particle tracking method has been developed to simulate sediment transport in the ocean, river and reservoir. The model was applied to estimate transport track of particulate pollutants in the lake. The hydrodynamic model was verified for water level variations and showed good agreements. Through the results we found out that water velocity is less than 5 cnysec for mean yearly flow and more than 120 cnysec at some points for the simulated flood flow. The incoming sediment particles in flood season reached into the Daecheong Dam. But the incoming sediment particles in the mean flow were settled down at riverbed and didn't move into the dam. These results can be used in setting up water quality management plan in the lake.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.14 no.3
• /
• pp.197-203
• /
• 2008

This study analyzed the characteristics of sea water transport between Busan New-port and the Nakdong River estuary. Numerical modeling was used to evaluate the characteristics of the tidal current. Numerical simulations of three different topographies were conducted. The results are summarized as follows: 1) The volume of sea water transport was reduced by $0.7{\sim}18.4%$ when water depth was decreased at Busan New-port (10 m); 2) The volume of sea water transport was increased by $3.5{\sim}21.9%$ when a channel (depth 5 m) was constructed in the direction of the Nakdong River estuary.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.12 no.4
• /
• pp.349-358
• /
• 2007

In order to understand biogeochemical cycles of organic carbon in the permeable intertidal sandy sediments of the Nakdong estuary, we estimated the organic carbon production and consumption rates both in situ and in the laboratory. The Chl-a content of the sediment and the nutrient concentrations in below surface pore water in the sandy sediment were lower than in the muddy sediment. The sediment oxygen consumption rates were relatively high, especially when compared with rates reported from other coastal muddy sediments with higher organic carbon contents. This implied that both the organic carbon degradation and material transport in the sandy sediment were enhanced by advection-related process. The simple mass balance estimation of organic carbon fluxes showed that the major sources of carbon in the sediment would originate from benthic microalgae and detrital organic carbon derived from salt marsh. The daily natural biocatalzed filtration, extrapolated from filtration rates and the total area of the Nakdong estuary, was one order higher than the maximum capability of sewage plants in Busan metropolitan city. This implies that the sandy sediment contributes greatly to biogeochemical purification in the area, and is important for the re-distribution of materials in the coastal environment.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.418-421
• /
• 2007

Using gridded wind-stress products constructed by satellite scatterometers (ERS-1, 2 and QSCAT) data and those by numerical weather prediction(NWP) model(NCEP-reanalysis), we estimate wind-driven transports of the North Pacific subtropical gyre, and compare them in the central portion of the gyre (around 300 N) with geostrophic transports calculated from historical hydrographic data (World Ocean Database 2005). Even if there are some discrepancies between the wind-driven transports by the QSCAT and NCEP products, they are both in good agreement with the geostrophic transports within reasonable errors, except for the regional difference in the eastern part of the zone. The difference in the eastern part is characterized by an anticyclonic deviation of the geostrophic transport resulting from an anti-cyclonic anomalous flow in the surface layer, suggesting that it is related to the Eastern Gyral produced by the thermohaline process associated with the formation of the Eastern Subtropical Mode Water. We also examine the consistency of the Sverdrup transports estimated from these products by comparing them with the transports of the western boundary current, namely the Kuroshio regions, in previous studies. The net southward transport, based on the sum of the Sverdrup transports by QSCAT and NCEP products and the thermohaline transport, agrees well with the net northward transport of the western boundary current, namely the Kuroshio transport. From these results, it is concluded that the Sverdrup balance can hold in the North Pacific subtropical gyre.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.6
• /
• pp.867-873
• /
• 2011

The transportation of a truss-spar hull from a transport barge of 6000 ton topside module on the spar hull is investigated in the present study. Two possible routes from a fabrication yard in Teeside, England to the Gulf of Mexico are considered in the paper. The results of motion responses of the transport barge obtained from a spectral analysis and the limiting criteria of sea fastening, deck wetness and lateral acceleration are compared and the route selection is discussed. Long-crested waves and short-crested seas as well as the joint probabilities of significant wave heights and wave periods in different sea areas are considered. Generally speaking, the results for long-crested seas are higher than those for short-crested waves.

• Journal of Environmental Science International
• /
• v.4 no.3
• /
• pp.197-206
• /
• 1995

Surface heat balance of the northern sea of Cheju Island for summer in 1993 and 1994 is analyzed using the observation data obtained by Marine Research Institute, Cheju National University. Each flux elements at the sea surface is derived from the marine meteorological reports with application of an aerodynamical bulk method for the turbulent heat fluxes, and empirical formulae for the long-wave radiation heat fluxes. The flux divergence of oceanic heat transport and the rate of heat storage in the ocean are estimated as residual. The features of the surface heat balance are mainly decided by the solar radiation flux and the latent heat flux for 199B. But the Bowen Ratios were large for 1993. This means that the sensible heat fluxes were nearly equal to the latent heat fluxes for 1993. In this period, mean flux divergence of oceanic heat transport is about 130 W/$m^2$.

• Journal of Mechanical Science and Technology
• /
• v.16 no.10
• /
• pp.1327-1335
• /
• 2002

The shock wave process represents an abrupt change in fluid properties, in which finite variations in pressure, temperature, and density occur over the shock thickness which is comparable to the mean free path of the gas molecules involved. This shock wave fluid phenomenon is simulated by using the finite difference lattice Boltzmann method (FDLBM). In this paper, a new model is proposed using the lattice BGK compressible fluid model in FDLBM for the purpose of speeding up the calculation as well as stabilizing the numerical scheme. The numerical results of the proposed model show good agreement with the theoretical predictions.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1998.11a
• /
• pp.48-51
• /
• 1998

This paper presents the transport and removal of organic substances from the contaminated soft soils and sludges such as marine dredging waste, marine sediments, mine tailing waste, and sewage sludge by electroosmosis. A series of laboratory experiments including variable conditions such as contamination levels, solid contents, and applied voltage rates were peformed with the contaminated soft clay specimen mixed with organic substance. Investigated are specimen density, dewatering rate, outflow rate, and outflow concentration. The test results showed that organic substances in the soils were removed by applied voltages. The results indicated that this process can be used efficiently to clean up the contaminated soil.

• Journal of Advanced Marine Engineering and Technology
• /
• v.28 no.7
• /
• pp.1159-1164
• /
• 2004

There is an Overhead Hoist Transport(OHT) for delivering the wafer in semiconductor processing. The transfer system is consists of carrier vehicle. rail, and support. OHTCMS(OHT Control and Management System) has to take the feature, such as the optimal control and integration with several OHT. In this paper, ESRA(Efficiency of Shortest - Route Algorithms) is proposed which can be transported optimal route and be prevented collision using the Floyd-Warshall algorithms. The proposed algorithm is verified through consecutive simulation for a long time.

• International Journal of CAD/CAM
• /
• v.6 no.1
• /
• pp.19-27
• /
• 2006

To survive in the current shipbuilding industry it is of vital importance for shipyards to achieve an optimal utilization of resources, make an achievable planning and ensure that this planning is kept. Possible problems should be eliminated before production starts and if unexpected disturbances occur in the actual production the right measures should be taken. Due to the dynamic nature of the production process, the continuous variation in products and the complexity of both, all this can hardly be achieved with conventional static planning and analysis systems. Simulation provides a solution here, since this enables the modelling and evaluation of the dynamic relations between product and production process. After a global introduction to production simulation in general and the application of simulation at the Flensburger shipyard, this paper presents a tool that has been developed to simulate the various complex assembly processes taking place at shipyards. Subsequently the simulation model for the subassembly production at Flensburger, in which this tool is applied, will be discussed.