• Journal of Power Electronics
• /
• 제15권5호
• /
• pp.1402-1408
• /
• 2015

A MOSFET's gate driver based on magnetic coupling is investigated. The gate driver can meet the demands in applications for wide range of duty cycles and high frequency. Fully galvanic isolation can be realized, and no auxiliary supply is needed. The driver is insensitive to the leakage inductor of the isolated transformer. No gate resistor is needed to damp the oscillation, and thus the peak output current of the gate driver can be improved. Design of the driving transformer can also be made more flexible, which helps to improve the isolation voltage between the power stage and the control electronics, and aids to enhance the electromagnetic compatibility. The driver's operation principle is analyzed, and the design method for its key parameters is presented. The performance analysis is validated via experiment. The disadvantages of the traditional magnetic coupling and optical coupling have been conquered through the investigated circuit.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.687-690
• /
• 2004

Fabrication and characterization of dye-sensitized TiO2 solar cells(DSSC) consisting of spray-coated TiO2 electrode, an electrolyte containing I-/I3- redox couple, and a Pt-coated counter electrode carried out, using mainly FE-SEM and solar simulator. Also, effect of rapid thermal annealing(RTA) temperatue on I-V curves of DSSCS consisting of approximately 10m thickness and $5{\times}5mm2$ active area. No significant difference in the apparent size of TiO2 clusters was observed with increasing RTA temperature. Also, an open circuit voltage(Voc) of approximately 0.70V and a short-circuit photocurrent(Jsc) of 8 to 12mA/cm2 were observed in the TiO2 solar cell. With increasing RTA temperature upto 550oC, photocurrent density of dye-sensitized solar cells was enhanced, leading to enhancing the efficiency of dye-sensitized solar cells having Pt-electroplated counter electrode.

• Current Applied Physics
• /
• 제18권11호
• /
• pp.1275-1279
• /
• 2018

We investigate the change of the Fano effect by considering one Majorana zero mode to couple laterally to the single-dot Fano interferometer. It is found that the Majorana zero mode quenches the Fano effect thoroughly and causes the conductance to be independent of the dot level, the dot-lead coupling, and the increase of the Majorana-dot coupling. As a result, the linear conductance becomes only related to the interlead coupling and the magnetic-flux phase factor. These results can be helpful for the detection of Majorana zero mode.

• 한국초전도ㆍ저온공학회논문지
• /
• 제8권4호
• /
• pp.1-7
• /
• 2006

This paper reviews AC loss characteristics of high $T_c$ superconductors. The mechanisms of AC loss generation are explained briefly, and AC losses are classified by the magnetic field components which generate them. A couple of analytical formulae of AC losses, which are useful for simple and rough AC loss estimations, are presented. AC loss characteristics of single BSCCO multifilamentary conductors and single YBCO coated conductors are reviewed based on previous experimental and numerical studies. AC loss characteristics of those two types of practical high $T_c$ superconductors are compared with each other.

• 제어로봇시스템학회논문지
• /
• 제12권8호
• /
• pp.798-804
• /
• 2006

To overcome the limited relative uncertainty and work range of the existing planar stage and the bulk structure of the contact-less motor for rotation, the novel operating principle to realize the precise rotation is suggested. It uses the two-axial vector forces, normal force and thrust force, of three-induction type of axial motors located $120^{\circ}$ apart, resulting in the contact-free rotation of the mover. Firstly in this paper, the magnetic forces across the air gap are modeled and simulated under the various conditions. It clarifies the feasible range of the derived solution. And the algorithm compensating the strong cross couple between the forces and the control inputs; generally AC magnitude and slip frequency, is given to realize the independent control of six axes. Finally, for the successfully implemented system, the round test and the micro step test results are given.

• 한국항해항만학회지
• /
• 제29권4호
• /
• pp.335-339
• /
• 2005

The superconducting electromagnetic propulsion system has been proposed as one of new alternative propulsion systems. Especially, the helical-type propulsion system has the greatest merit that is able to use the solenoid-type superconducting magnets with high magnetic fields. In this study, calculations of characteristics of the large scale helical-type thruster are carried out on the basis of our experimental results. As a couple of results of calculations, it is found that the thruster efficiency quickly increases with the length of electrode up to about 5 m and then goes up to about 0.9. The thruster efficiency peaks at a certain point ($^{\sim}0.6\;m$) and then falls as length of pitch increases.

• 대한화학회지
• /
• 제39권5호
• /
• pp.356-363
• /
• 1995

유기 리간드(디크로로 비스[η-싸이크로 펜타디엔닐])을 가지고 전이금속 4가$(Nb^{4+}와\;Mo^{4+}$와의 착물들에 대한 거동을 UV-vis 분광학적, 자기적, 그리고 전기화학적 방법에 의해 조사하였다. 2 또는 3개의 에너지 흡수띠가 이들 착물들의 스펙트라에 의해 관찰되었다. 결정장 갈라짐 에너지 크기와 스핀 짝지움 에너지 그리고 결합 세기는 착물들의 스펙트라로부터 얻어졌다. 이들은 비편재화이고, 낮은 스핀 상태이며 그리고 강한 결합 세기임을 알았다. 자기쌍극자 모멘트는 상자기성과 반자기성 착물이었다. 착물들의 산화환원 과정은 비수용매속에서 순환 전압전류법에 의해서 조사되었다. Nb-C 착물의 산화환원 반응과정은 일전자의 확산과 반응 전류에 의한 짝-단일 반응이었고 또한 Mo-C 착물에서는 일전자의 반응전류에 의한 짝-단일 반응이었다.

• Current Applied Physics
• /
• 제18권11호
• /
• pp.1381-1387
• /
• 2018

One dimensional (1D) grating has been fabricated (using focused ion beam) on 50 nm gold (Au) film deposited on higher refractive index Gallium phosphate (GaP) substrate. The sub-wavelength periodic metal nano structuring enable to couple photon to couple with the surface plasmons (SPs) excited by them. These grating devices provide the efficient control on the SPs which propagate on the interface of noble metal and dielectric whose frequency is dependent on the bulk electron plasma frequency of the metal. For a fixed periodicity (${\Lambda}=700 nm$) and slit width (w = 100 nm) in the grating device, the efficiency of SPP excitation is about 40% compared to the transmission in the near-field. Efficient coupling of SPs with photon in dielectric provide field localisation on sub-wavelength scale which is needed in Heat Assisted Magnetic recording (HAMR) systems. The GaP is also used to emulate Vertical Cavity Surface emitting laser (VCSEL) in order to provide cheaper alternative of light source being used in HAMR technology. In order to understand the underlying physics, far-and near-field results has been compared with the modelling results which are obtained using COMSOL RF module. Apart from this, grating devices of smaller periodicity (${\Lambda}=280nm$) and slit width (w = 22 nm) has been fabricated on GaP substrate which is photoluminescence material to observe amplified spontaneous emission of the SPs at wavelength of 805 nm when the grating device was excited with 532 nm laser light. This observation is unique and can have direct application in light emitting diodes (LEDs).

• 한국군사과학기술학회지
• /
• 제7권4호
• /
• pp.13-19
• /
• 2004

A system for detecting underwater target demands a high operational reliability because of the difficulty of maintenance and repair when the system has a few troubles during long operating period. Therefore, in this paper, we have proposed a signal transport system with a high reliability in an underwater sensor array system composed of magnetic and acoustic sensors. In this system, the nodes for signal transport are connected dually each other with single-hop construction and a magnetic sensor is connected to a couple of neighboring nodes. This enables the output signal to transport from a node to the next node and the next but one node. Also, the signal from a magnetic sensor can be transported to two nodes at the same time. Thus, the system with this construction makes possible to transport sensor data to another node which works normally when a transport node or cable have some faults and will operate normally although it happens some problems in a few signal transport nodes and connection cables.

• 한국초전도ㆍ저온공학회논문지
• /
• 제3권2호
• /
• pp.15-20
• /
• 2001

This paper describes a model flux pump experiment recently performed at the MIT Francis Bitter Magnet Laboratory. The results of the model flux pump will be used in the development of a prototype flux pump that will be couple to a high-temperature superconductor (HTS) insert coil of a high-field NMR (Nuclear Magnetic Resonance) magnet, Such an HTS insert is unlikely to operate in persistent model because of the conductors low index(n) The flux pump can compensate fro field decay in the HTS insert coil and make the insert operate effectively in persistent mode . The flux pump, comprised essentially of a transformer an two switches. all made of superconductor, transfers into the insert coil a fraction of a magnetic energy that is first introduced in the secondary circuit of the transformer by a current supplied to the primary circuit. A model flux pump has been designed. fabricated, and operated to demonstrate that a flux pump can indeed supply a small metered current into a load superconducting magnet. A current increment in the range of microamperes has been measured in the magnet after each pumping action. The superconducting model flux pump is made of Nb$_3$ Sn tape, The pump is placed in a gaseous environment above the liquid helium level to keep its heat dissipation from directly discharged in the liquid: the effluent helium vapor maintains the thermal stability of the flux pump.