• Korean Journal of Food Science and Technology
• /
• v.36 no.6
• /
• pp.1001-1007
• /
• 2004

Chloroform layer from methanol extract of Corni fructus (Cornaceae) showed strong antiproliferation effect on human cancer cell lines by SRB assay. Anticarcinogenic-active compound was isolated and purified by silica gel column and thin layer chromatograpies, and identified as ursolic acid ($3{\beta}$-hydroxyrus-12-ene-28-oic acid, MW:456) by mass and IR spectrophotometries, and $^1H-and\;^{13}C-NMRs$. The compound inhibited proliferation of A549 (human lung cancer cell line) and MCF-7 (human breast cancer cell line) cells in dose-dependant manner when treated for 48 hr. Inhibition rates of both cells were over 40% and 90% compared with control cells at the $30\;{\mu}g/mL\;and\;100\;{\mu}g/mL$, respectively. Morphology of cells treated with the compound for 15 hr at $10\;{\mu}g/mL$ was distorted with shrinked cell mass, and cell number was lower than that of control cells. Cell cycle analysis showed sub-G1 phase arrest in both cell lines following 15 hr exposure to the compound; % of cell phase increased to 11.7 and 11.2% compared to the control of 4.0% and 2.1% in A549 and MCP-7 cells, respectively.

• Fire Science and Engineering
• /
• v.26 no.3
• /
• pp.21-28
• /
• 2012

The objective of this study is to evaluate the prediction accuracy of FDS(Fire Dynamic Simulator) for the thermal and chemical characteristics of under-ventilated fire with unsteady fire growth in a semi-closed compartment. To this end, a standard doorway width of the full-scale ISO 9705 room was modified to 0.1 m and the flow rate of heptane fuel was increased linearly with time (until maximum 2.0 MW based on ideal heat release rate) using a spray nozzle located at the center of enclosure. To verify the capability of FDS, the predicted results were compared with a previous experimental data under the identical fire conditions. It was observed that with an appropriate grid system, the numerically predicted temperature and heat flux inside the compartment showed reasonable agreement with the experimental data. On the other hand, there were considerable limitations to predict accurately the unsteady behaviors of CO and $CO_2$ concentration under the condition of continuous fire growth. These results leaded to a discrepancy between the present evaluation of FDS and the previous evaluation conducted for steady-state under-ventilated fires. It was important to note that the prediction of transient CO production characteristics using FDS was approached carefully for the under-ventilated fire in a semi-closed compartment.

• Journal of the Korean Wood Science and Technology
• /
• v.37 no.1
• /
• pp.78-86
• /
• 2009

In this study 2 cadalene homologues - 3,7-dimethoxycadalene and 7-hydroxycadalene-5,8-quinone (keyakinone A)-were further identified from ethanol extracts of Zelkova serrata wood, except 7-hydroxy-3-methoxycadalene. Two biological activities-scavenging activity of hydroxy radical and cell toxicity by MTT assay-were measured with 7-hydroxy-3-methoxycadalene. The scavenging activity of hydroxyl radical of the compound was excellent and increased with its concentration. At 100 ppm hydroxyl radicals were removed completely. However, MTT assay revealed that 7-hydroxy-3-methoxycadalene showed critical toxicity to the cells. When 1 ppm of the compound was treated to the cells, cell viability was reached up to 90%, while it was reduced to 22% after treatment of 9 ppm. In 4 different Ulmaceae species, such as Ulmus davidiana, Ulmus parvifolia, Ulmus macrocarpa, Ulmus macrophylla, 7-hydroxy-3-methoxycadalene was not found at all. Instead, 7-hydroxycadalene (Mw 214), in which methoxyl group is omitted from 7-hydroxy-3-methoxycadalene, was distributed in the heartwood of 4 Ulmaceae species as major cadalene compound.

• Analytical Science and Technology
• /
• v.16 no.5
• /
• pp.391-398
• /
• 2003

Basic research for the determination of boron content in biological sample has been carried out using the PGAA facility of the 24MW research reactor(HANARO). For investigation of characteristics for the measurement condition, neutron flux and its homogeneity were measured at irradiating geometry. The size of thermal neutron beam collimated from beam guide is $2{\times}2cm^2$ at the sample position. The neutron flux measured was the range of $1.0{\sim}6.5{\times}10^7n{\cdot}cm^{-2}{\cdot}s^{-1}$, and flux distribution from center within the radius of 4.5 mm and 9.0 mm was $5.77{\pm}0.71{\times}10^7n{\cdot}cm^{-2}{\cdot}s^{-1}$ and $4.68{\pm}1.64{\times}10^7n{\cdot}cm^{-2}{\cdot}s^{-1}$, respectively. Accordingly, sample size is adjusted within 10 mm for a homogeneous irradiation of high quality. Measurement system is designed to reduce the background source by Compton scattering and to improve the analytical sensitivity. To investigate the energy calibration and Compton suppression effect of gamma-ray counting system, the background conditions on both of Compton and single-mode were measured using NaCl standard. On the other hand, degree of spectral interference for sodium 472 keV peak as a matrix effect in the sample is established for an accurate boron analysis, and then boron content in three certified reference materials (NIST SRM 1570a, 1547, 1573a) was measured by using two modes and the results were compared with each other.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.06a
• /
• pp.21-29
• /
• 2005

The HANARO, a multi-purpose research reactor of 30 MWth open-tank-in-pool type, has been under normal operation since its initial criticality in February, 1995. Recently, ten years after the initial operation of the HANARO, one of the two primary cooling pumps was decontaminated for overhaul maintenance in 2004. Before decontamination exposure doserate and surface contamination level of primary cooling pump measured at 4 points. After final decontamination exposure doserate and surface contamination level of primary cooling pump remeasured by same method done before. It is easy to decontaminate the out side exposed surfaces of the pump, but it is difficult to approach the inside surface due to double volute installed in the casing. Therefore, a new decontamination facility has been developed to solve this problem. A concentrated de-contaminant (DX-300) is rotated in the closed pump casing by the impeller actuated by a temporary motor. Nuclide particles are removed by the emulsification effect of the de-contaminant and the surface contaminants are chemically removed from the pump by the corrosion and dissolution effect. The inside surfaces of the primary cooling pump have been decontaminated by using the facility. As results, the contamination level of the inside surfaces was maintained below the surface contamination limit.

• Journal of Life Science
• /
• v.8 no.4
• /
• pp.410-415
• /
• 1998

Procine pepsin hydrolysis of hexapeptide L-S-pNF-Nle-A-OMe in the presence of dipeptide L-L generates a new peak on HPLC analysis of reaction mixtures that is not seen when enzyme is incubated with either peptide alone. The peaks can be detected spectroscopically at either 214 or 254 nm, the latter consistent with a new peptide containing the p-nitro-F residue. The data suggest acyl transpeptidation between E(L-S-pNF) and L-L to form L-S-pNF-L-L. Consistent with this inference are (1) the ability of L-L-NH$_{2}$ and inability of Boc-L-L to undergo a similar transpeptidation reaction, and (2) the data from electrospray mass spectrum. This synthesis requires that Nle-A-L-OMe be released before L-S-pNF, an order opposite to that proposed on the basis of product inhibition kinetics. Consistent with this inference are reciprocal solvent isotope effects ; normal isotope effects of 1.736$\pm$0.121 on the formation of Nle-A-L-OMe and 2.281$\pm$0.184 in the formation of L-S-pNF, coupled to an inverse isotope effects of 0.576$\pm$0.045 on the formation of L-S-pNF-L-L. Because transpeptidation precedes faster in D$_{2}$O, the isotopically-sensitive step must occur after release of Nle-A-L-OMe. Isotopically-enhanced transpeptidation is consistent with the Uni-Bi iso memchanism postulated on the basis of an isotope effects on Vmax but not on Vmax/Km$^{1)}$ and confirmed by isotope effects on the onset of inhibition by pepstatin$^{2)}$.

• Economic and Environmental Geology
• /
• v.50 no.6
• /
• pp.497-508
• /
• 2017

This study was carried out to document and diagnose the conditions of the seated stone statue of Buddhist Master Seungga in Seunggasa temple immediately after its conservation treatment, which was found to be long covered in surface of white materials. The stone Halo was researched along with the Statue, and basic data was secured through precisely examination and nondestructive diagnosis. The result from the surface deterioration evaluation shows that both the Statue and Halo had a little bit of physical deterioration, although their level of chemical deterioration was proportionally higher due to discoloration. The physical property diagnosis using ultrasonic measurements on the Statue and Halo showed that the average ultrasonic velocity was found to be 3,570 m/s and 3,373 m/s, respectively, which corresponds to grade III, an indication of a favorable physical property. The surface covered materials were detected to be Ca, Ti, Pb, Fe, Al and Si, emanating from Hobun (Oster shell powder; $CaCO_3$) or lime ($CaO{\cdot}Ca(OH)_2$) and silicate minerals. Furthermore, Ti and Pb seems to be the component of the white coloring pigments, titanium white ($TiO_2$) and white lead ($2PbCO_2{\cdot}Pb(OH)_2$). Therefore, the seated stone statue of Buddhist Master Seungga is presumed to be painted with Hobun or lime and thereafter painted over with titanium white and white lead.

• Korean Journal of Food Science and Technology
• /
• v.47 no.3
• /
• pp.293-298
• /
• 2015

This study aimed at characterizing the rheological properties and molecular weight of tara gum fractionated with ammonium sulfate. Tara gum was separated into six fractions (F1-F6) at different concentrations of ammonium sulfate, ranging from 12.21 to 28.67% (w/w). The yield of the tara gum fractions ranged between 4.98 and 17.47%, and their intrinsic viscosity ranged from 9.38 to 12.44 dL/g. The highest values of Huggins coefficient (k') and viscosity-molecular mass were observed in fraction F3. The shear viscosity of the tara gum fractions was measured by a cone-plate viscometer, clearly showing shear thinning behavior. Size-exclusion chromatography results showed that the molecular weight ranged between 635.42 and 776.71 kg/mol, and the F3 fraction exhibited higher values of molecular weight.

• Applied Chemistry for Engineering
• /
• v.7 no.3
• /
• pp.496-503
• /
• 1996

Aromatic and aliphatic copolyesters for the dispersing agent were synthesized by two stage reaction, esterification and polycondensation. Copolyesters were blended with PET in the melt state and their thermal and rheological properties were investigated. From GPC analysis Mn's and Mw's of copolyesters were about 30000 and 65000g/mol, respectively. From DSC experiment copolyesters had melting range of $90{\sim}150^{\circ}C$. Copolymer composition was in good agreement with comonomer feed ratio from $^1H$-NMR analysis. Copolyesters and SPA (standard sample) were blended with PET in the melt state. From DSC experiment, copolyesters and SPA were miscible with PET. From the dynamic melt viscosity experiment, melt viscosity of blended sample was increased as the content of aromatic copolyester was increased, while it was decreased as the content of aliphatic and SPA were increased. As for volume resistivity of dry color containing carbon black and copolyesters with dispersing time, aromatic copolyester showed highest value. It was conferred from this result that aromatic copolyester was the best dispersing agent for carbon black in PET resin.

• Korean Journal of Food Science and Technology
• /
• v.35 no.1
• /
• pp.67-71
• /
• 2003

Alginates were irradiated in an aqueous solution with $Co^{60}$ gamma rays in the dose ranges from 0 to 100 kGy, and investigated the relationship between the intrinsic viscosity $([{\eta}])$ and the molecular weight $(M_w)$ of alginates. The molecular weight of alginate was measured by gel permeation chromatography and the ranges from 1,894 to 135,174 Da were obtained. The molecular weight of alginate decreased markedly with increasing the degree of ${\gamma}-ray$ dose rate. The intrinsic viscosity of alginate solution after ${\gamma}-irradiation$ showed the ranges from 9.83 (g/g) to 602.69 (g/g), depending upon the ${\gamma}-irradiation$ dose. The molecular weight of alginate dependence of the intrinsic viscosity of the alginate solution would be expressed by Mark-Houwink equation. With a linearization of molecular weight and the intrinsic viscosity of the alginate solution, Mark-Houwink equation could be expressed with constant variables and the real data fitted to the equation of $[{\eta}]=2.2{\times}10^{-6}\;{M_w}^{1.656}\;(R^2=0.998)$.