• ETRI Journal
• /
• v.35 no.1
• /
• pp.51-57
• /
• 2013

In this paper, a small internal antenna for a mobile handset is presented using multiband, wideband, and high-isolation multiple-input multiple-output techniques. The proposed antenna consists of three planar inverted-F antennas (PIFAs) that operate in the global system for mobile communication (GSM900), the digital communication system (DCS), the personal communication system (PCS), the universal mobile telecommunication system (UMTS), and wireless local area network (WLAN) bands with a physical size of $40mm{\times}10mm{\times}10mm$. A resonator attached to the folded PIFA creates dual resonances, achieving a wide bandwidth of approximately 460 MHz, covering the DCS, PCS, and UMTS bands; a meander shorting line is used to improve impedance matching. Additionally, a modified neutralization link is embedded between diversity antennas to enhance isolation, which results in a 6-dB improvement in the isolation and less than 0.1 in the envelope correlation coefficient evaluated from the far-field radiation patterns. Simulation and measurements demonstrate very similar results for S-parameters and radiation patterns. Peak gains show 3.73 dBi, 3.77 dBi, 3.28 dBi, 2.15 dBi, and 5.86 dBi, and antenna efficiencies show 56.15%, 72.15%, 68.59%, 52.92%, and 82.93% for GSM900, DCS, PCS, UMTS, and WLAN bands, respectively.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.7
• /
• pp.2972-2991
• /
• 2016

WLAN is the best choice in the place where complex network is hard to set up. Intelligent terminals are more and more assembled in some areas now. However, according to IEEE 802.11n/802.11ac, the access-point (AP) can only serve one user at a single frequency channel. The spectrum efficiency urgently needs to be improved. In theory, AP with multi-antenna can serve multiple users if these users do not interfere with each other. In this paper, we propose a user clustering scheme that could achieve multi-user selection through the mutual cooperation among users. We focus on two points, one is to achieve multi-user communication with multiple antennas technique at a single frequency channel, and the other one is to use a way of distributed users' collaboration to determine the multi-user selection for user clustering. Firstly, we use the CSMA/CA protocol to select the first user, and then we set this user as a source node using users' cooperation to search other proper users. With the help of the users' broadcast cooperation, we can search and select other appropriate user (while the number of access users is limited by the number of antennas in AP) to access AP with the first user simultaneously. In the network node searching, we propose a maximum degree energy routing searching algorithm, which uses the shortest time and traverses as many users as possible. We carried out the necessary analysis and simulation to prove the feasibility of the scheme. We hope this work may provide a new idea for the solution of the multiple access problem.

• Journal of Advanced Navigation Technology
• /
• v.14 no.3
• /
• pp.328-335
• /
• 2010

In this paper, an efficient algorithm and area-efficient hardware architecture have been proposed for $2{\times}2$ MIMO-OFDM based WLAN baseband modem with two transmit and two receive antennas. To enhance the performance of the receiver, the efficient timing synchronization algorithm and symbol detector based on MML algorithm are presented. Also, by sharing the hardware block with multi-stage pipeline structure and using the complex multiplier based on polar-coordinate, the complexity of the proposed architecture is dramatically decreased. The proposed area-efficient hardware design was designed in hardware description language (HDL) and synthesized to gate-level circuits using 0.13um CMOS standard cell library. As a result, the complexity of the proposed modem receiver is reduced by 56% over the conventional architecture.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.719-727
• /
• 2016

This paper proposes a unified medium access control (MAC) design methodology and presents the implementation of the IEEE 802.11ac down-link multi-user multi-input and multi-output wireless local area network MAC using the proposed design methodology. The proposed methodology employs unified code for both network simulation and system implementation. Because the unified code closely relates these two processes, the performance of the implemented MAC system can be estimated before implementation. The MAC architecture for an access point implemented using the proposed design methodology is verified on an ARM-based platform, and it is applied to a 65 nm CMOS library.

• Journal of Satellite, Information and Communications
• /
• v.9 no.4
• /
• pp.16-19
• /
• 2014

In this paper, the beacon signals of WiFi doppler frequency detection based WiFi-AP was designed with the subcarrier between a transmitter and a receiver of WLAN(wireless LAN). We can use such signals to identify human moving as an antenna array and tracking of RF beam. This wireless security services with the combination of WiFi doppler frequency and adaptive beacon time signal was proposed for wireless detection and motion based services.

• Journal of information and communication convergence engineering
• /
• v.2 no.2
• /
• pp.61-66
• /
• 2004

This paper presents a way to maximize transmission efficiency and reception ability through transmission diversity technology, which can be adapted to wireless multimedia Wireless LAN system. The presented method is a comparative analysis between a case where parameter a for time average is 0.3.1 with consideration of channel presumption with two types of rms delayed spread, which is 50nsec. 150nsec, for the performance analysis of STTC (Space-Time Trellis Code) adopting time-space ciphering method appropriate for MIMO channel, and performance in the case where presumed channel value from long training column section is applied to according frame in a single frame. The result showed that BER brought SNR improvement of l.0dB in $10^{-3}$ when a was 0.3 than adopting only the long training column, and showed increase of general performance improvement for the sake of time average rather than the case without.

• Journal of Satellite, Information and Communications
• /
• v.8 no.4
• /
• pp.47-52
• /
• 2013

In this paper, The existing interference alignment algorithms were analyzed in Rayleigh fading channel environment. The interference alignment techniques are divided to two parts. First thing is Iterative-method, another is Linear-method. Iterative method needs local channel info, but it has the constraint of iteration. On the other hand Linear-method must have global channel info, but has free of iteration and better performance. This paper evaluates the performance of interference alignment algorithms in Rayleigh fading channel of outdoor environment and WLAN channel based on IEEE 802.11n of indoor environment.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.3
• /
• pp.1373-1392
• /
• 2017

WiFi Direct (WD) is a state of the art technology for a Device-to-Device (D2D) communication in 802.11 networks. The performance of the WD system can be significantly affected by some key factors such as the type of application, specifications of MAC and PHY layer parameters, and surrounding environment etc. It is, therefore, important to develop a system model that takes these factors into account. In this paper, we focus on investigating the design parameters of the PHY layer that could maximize the efficiency of the WD 802.11 system. For this purpose, a basic theoretical model is formulated for a WD network under a 2x2 Multiple In Multiple Out (MIMO) TGn channel B model. The design level parameters such as input symbol rate and antenna spacing, as well as the effects of the environment, are thoroughly examined in terms of path gain, spectral density, outage probability and Packet Error Rate (PER). Thereafter, a novel adaptive algorithm is proposed to choose optimal parameters in accordance with the Quality of Experience (QoE) for a targeted application. The simulation results show that the proposed method outperforms the standard method thereby achieving an optimal performance in an adaptive manner.

• Journal of Digital Convergence
• /
• v.12 no.10
• /
• pp.317-327
• /
• 2014

To improve the efficiency of wireless channel, IEEE 802.11ac uses the DL MU-MIMO MAC scheme through which an AP transmits multiple frames to different mobile nodes simultaneously. IEEE 802.11ac DL MU-MIMO MAC needs a new step, called as TXOP sharing, between legacy IEEE 802.11n DL SU-MIMO's two operations, the obtaining an EDCA TXOP and the transmitting multiple frames for EDCA TXOP. In the TXOP sharing operation, both wireless channel destinations and frames transmitted for its TXOP period should are determined. So this paper deals with the TXOP sharing for improving IEEE 802.11ac MAC performance. However, the EDCA priority based method mentioned by IEEE 802.11ac standard document not fair among the buffers and the frames of buffers, and occurs in high_loss rate and high_delay about specific buffers. In this paper, we propose a new scheme of the TXOP sharing with sequencing p-AC, s-AC in similar properties, and all S-AC. This method provides a differentiated service without damage of EDCA characteristics.

• Journal of IKEEE
• /
• v.19 no.1
• /
• pp.18-26
• /
• 2015

In this paper, we proposed and evaluated the performance of an internal MIMO (Multiple Input Multiple Output) antenna for multiband operations including LTE (Long Term Evolution) 700/2300/2500. And to enhance the isolation characteristic, a parasitic element is designed and applied. The proposed single antenna has a volume of $60mm(W){\times}38mm(L)$, and the ground plane is $60mm(W){\times}100mm(L)$. The parasitic element used for enhancing the isolation of the antenna was designed with a copper on FR4 sized $60mm(W){\times}20mm(L){\times}1.6mm(H)$, and the pattern size is $60mm(W){\times}15mm(L)$. Simulated and measured results showed that LTE 700/2300/2500, DCS (Digital Cellular Service: 1710-1880MHz), K-PCS (Korea-Personal Communication Service: 1750-1870MHz), US-PCS (US-Personal Communication Service: 1850-1990MHz), WCDMA (Wideband Code Division Multiple Access: 1920-2170MHz), Wibro (2300-2390MHz), Bluetooth (2400-2483MHz), WLAN (Wireless Local Area Network: 2400-2483.5MHz), US-WiMAX (US-World interoperability for Microwave Access: 2400-2590MHz) frequency bands were covered with $S_{11}$ values less than -6dB (VSWR < 3). Simulated and measured results on $S_{21}$ at 730MHz for the firstly designed MIMO antenna showed -5.50dB and -5.65dB, respectively. When with the parasitic element at the separated ground plane to enhance the isolation performance, -10.33dB and -12.90dB are obtained for the simulation and measurement, so the enhanced isolation performance at lower frequency band (617-867MHz) is confirmed.