• Korean Journal of Environment and Ecology
• /
• v.24 no.1
• /
• pp.26-36
• /
• 2010

The purpose of this study is to investigate the change and structure of the altitudinal vegetation on the east side of Hallasan National Park, and to accomplish this research, seventeen plots($400m_2$ per zone) were set up along the Seongpanak trail starting from 750m to 1,450m(which was 700m long). These zones, according to the two-way indicator species analysis(TWINSPAN) and ordination analysis(DCA), were divided into six communities: Carpinus tschonoskii-Stryrax japonica community(I), Stryrax japonica-Quercus serrata community(II), Carpinustschonoskii-Q. serrata community(III), Q. mongolica-C tschonoskii community(IV), Acer pseudosieboldianum community(V), and Q. mongolica-Abies koreana community(VI). The findings of my investigation are as follows: the altitudinal vegetation structure of all the investigated zones from 750m to 1,000m above sea level is similar to one another, whereas the same zones from 1,000m to 1,450m above sea level showed dissimilarities among them. That indicates that altitudinal vegetation structure on the east side of Hallasan National Park has changed drastically at the 1,000m areas above sea level, and the forest age of this area is over 50 years.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.736-744
• /
• 2016

Network on chip (NoC) is an emerging technology in the field of multi core interconnection architecture. The routers plays an essential components of Network on chip and responsible for packet delivery by selecting shortest path between source and destination. State-of-the-art NoC designs used routing table to find the shortest path and supports four ports for packet transfer, which consume high power consumption and degrades the system performance. In this paper, the multi port multi core router architecture is proposed to reduce the power consumption and increasing the throughput of the system. The shared buffer is employed between the multi ports of the router architecture. The performance of the proposed router is analyzed in terms of power and current consumption with conventional methods. The proposed system uses Modelsim software for simulation purposes and Xilinx Project Navigator for synthesis purposes. The proposed architecture consumes 31 mW on CPLD XC2C64A processor.

• Journal of the Korean Institute of Rural Architecture
• /
• v.17 no.3
• /
• pp.27-36
• /
• 2015

This research studies the adequate size standard of Seogwipo cruise terminal CIQ facility that is scheduled to be built around Gangjeong harbor area in Seogwipo-city. In order to respond to the highly increasing number of passenger cruise ships compared to Seogwipo cruise terminal design in 2010, the adequate size standard of Seogwipo cruise terminal CIQ facility was examined for passenger service level grade. Based on size computation elements such as the number of passengers of cruise ships with the largest size of port entry, ship landing rate, passenger processing ratio, and surge factor, the CIQ facility size for each service level grade was reviewed. As a result, the area of 2,971m2 (A grade), 2,409 m2 (B grade), and 2,088 m2 (C grade) were computed. This showed that the area of B grade was about 82% and C grade 70% compared to the area of A grade. The CIQ facility size computed for each service level grade in this research was analyzed that its area needed to be increased by 322% at least and 458% at most, compared to the CIQ facility area of 649m2 of the existing design (2010). In order to respond to the increasing number of cruise passengers, provide high-level passenger service, and improve the international image of Jeju, Seogwipo cruise terminal should secure the size that is equal to or higher than the B grade of service level.

• Journal of the Korean Solar Energy Society
• /
• v.37 no.4
• /
• pp.13-22
• /
• 2017

In this study, long and short-wave radiations were observed in urban and suburban areas during the summer season, and frequency analysis was performed for each radiation intensity by a new analysis method. The following results were obtained. (1) Long-wave radiation values were found to be larger in the afternoon than in the morning, in both urban and suburban areas, unlike short-wave radiation values. (2) Short-wave radiation showed a right-skewed frequency distribution. In the high energy area greater than $900W/m^2$, the frequency was significantly higher in the suburbs than in the urban areas. (3) Long-wave radiation was in the range of $290{\sim}479W/m^2$, its frequency distribution resembled a normal distribution, and the frequency of 410, $420W/m^2$ was the highest.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.16 no.1
• /
• pp.193-206
• /
• 2013

This study was to provide the base data on the status of vegetations and soils in green roofs by analyzing the soil and vegetation characteristics of 4 green roofs in Dongguk University in September 2012. Sanglokwon(SW), Dongguk Hall(DH), University Library(UL), and Information and Culture Hall P(IC) were established in 2005, 2008, 2009, and 2010, respectively. The areas of green roofs were $700m^2$, $2,300m^2$, $1,240m^2$, and $640m^2$ in SW, DH, UL, and IC respectively. The investigated floras of vascular plants were 26 families, 55 genera, 65 species in Sanglokwon(SW), 53 families, 99 genera, 112 species in Dongguk Hall(DH), 43 families, 77 genera, 84 species in University Library(UL), and 41 families, 71 genera, 75 species in Information and Culture Hall P(IC), respectively. A positive correlation is shown between the number of plant species and planting area. Total nitrogen, organic matter, and potassium in soil have positive correlation with the number of plant species. The number of plant species was proportional to area and increased more than twice after planting. About a quarter of the invaded plants (including native and naturalized species) were naturalized plants. The total soil depths including vegetation soil and drainage soil at SW, DH, UL, and IC were 20cm, 10cm, 10cm, and 8cm, respectively. The depths of vegetation soil at SW, DH, UL, and IC were <7cm, <3cm, <2cm, and <2cm respectively. The soil pH in vegetation soil ranged from 5.22 to 5.36, and from 6.13 to 6.39 in drainage soil. Available-P concentration ranged from 10.17 to 189.77mg/kg in vegetation soil and from 6.70 to 81.17mg/kg in drainage soil. Carbon concentration in vegetation soil ranged from 2.93 to 9.70%, and 2.93 to 9.70% in drainage soil. Carbon contents in 20cm, 10cm, 10cm, and 8cm soil depths were $2.62kg/m^2$, $1.89kg/m^2$, $0.50kg/m^2$, and $0.53kg/m^2$ at SW, DH, UL, and IC, respectively.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.3
• /
• pp.17-25
• /
• 1999

This paper proposes a new bit-serial multiplier/divider architecture to reduce the hardware complexity significantly and to maintain the same number of cycles compared with existing architectures. Since the proposed bit-serial multiplier/divider architecture does not extend the number of bits in registers and an adde $r_tractor to calculate a partial product or a partial remainder, the hardware overhead can be greatly reduced. In addition, the proposed architecture can perform an additio $n_traction and a shift operation in parallel and the number of cycles for $\textit{N}$-bit multiplication and division for the proposed circuits is $\textit{N}$ and $\textit{N}$ + 2, repectively. Thus, the number of cycles for multiplication and division is the same compared with existing architectures. The SliM Image Processor employs the proposed multiplier/divider architecture and proves the performance of the proposed architecture.cture.

• Journal of Bio-Environment Control
• /
• v.14 no.2
• /
• pp.128-136
• /
• 2005

The objective of this study was to determine the effect of calcium concentrations in fertilizer solution on growth and cut flower quality of chrysanthemum 'Biarritz' To achieve this, deficiency symptom and growth characteristics as influenced by controlled Ca concentrations in fertilizer solution were investigated. The analysis of plant tissue and soil solution of root media were also conducted to secure optimum concentration for plant growth. Calcium deficiency developed on the very youngest leaves and the young leaves developed 'cupped' shape as they expand. The cut flower length of 0, 3.0 and 6.0 mM treatments were 105.8, 106.5, and 107.3cm, respectively. Elevated Ca concentration within the range from 0 to 6.0mM in fertilizer solution increased cut flower weight. The cut flower weight of control and 6.0mM treatment were 51.6 and 59.4 g, respectively. The tissue Ca content of 6.0mM treatment in which crops showed the highest growth among treatments was $3.09\%$ based on the dry weight of the youngest fully expanded leaves. From the results, it seems necessary to maintaining tissue Ca content higher than $2.8\%$. Soil Ca concentrations increased as K concentrations in fertilizer solution were elevated. Ca concentration in 0.0, 1.5, 3.0, 4.5 and 6.0mM treatments were 5.0, 7.4, 12.1, 16.5 and $28.2mg{\cdot}L^{-1}$, respectively, at harvesting stage. It is suggested that Ca concentration higher than $25.4mg{\cdot}L^{-1}$ in soil solution of root media is required to maintain normal growth.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2017.11a
• /
• pp.236-237
• /
• 2017

In this research, experimental seakeeping results of Warped hull form 2 on the regular waves were compared with numerical results of strip method and CFD. In case of ship's speed, there are 3 cases (3.4m/s, 4.6m/s, 5.75m/s) for numerical simulation, and they are belong to semi-planing and planing condition. Consequently, in case of strip method, it is shown that the resonance phenomena occurred from around ${\lambda}/L_{OA}=2$ to 4 and RAO value were significantly higher than that of other. this is different from experimental results. In case of CFD, overall trends were similar with experimental values except there are somewhat excessive RAO values around ${\lambda}/L_{OA}=0.5$ to 2.5. these phenomena is confirmed that it became larger as the ship's speed increased, and it was considered that the error occurred because the number of mesh in vertical direction of wave height at ${\lambda}/L_{OA}=0.5$ to 2.5 were relatively less than those of wave height at ${\lambda}/L_{OA}=2.5$ to 5.2.

• Proceedings of the IEEK Conference
• /
• 2000.11b
• /
• pp.208-211
• /
• 2000

This paper describes the design of a CMOS frequency synthesizer using programmable frequency divider with novel architecture. A novel architecture of programmable divider can be producted all of integer-N and fabricated by 0.65$\mu\textrm{m}$ 2-poly, 2-metal CMOS technology. Frequency synthesizer is simulated by 0.25$\mu\textrm{m}$ 2-poly, 5-metal CMOS technology. This circuit has settling time of 1.5${\mu}\textrm{s}$ and power consumption of 70㎽. Operating frequency of the frequency synthesizer is 820MHz∼l㎓ with a 2.5V supply voltage.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.4
• /
• pp.826-832
• /
• 2004

A CMOS 8 bit folding and interpolating ADC for an embedded system inside VLSI is presented in this paper. This folding ADC uses the 2 stage architecture for improving of nonlinearity. repeating the folding and interpolating twice. At a proposed structure, a transistor differential pair operates on the second folder. A ADC with 2 stage architecture reduces the number of comparators and resisters. So it is possible to provide small chip size, low power consumption and high operating speed. The design technology is based on fully standard 0.25m double-Poly 2 metal n-well CMOS Process. The simulated Power consumption is 45mW with an applied voltage of 2.5V and sampling frequency of 250MHz. The INL and DNL are within <ㅆㄸㅌ>$\pm$0.2LSB, respectively. The SNDR is approximately 45dB for input frequency of 10MHz.