• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2008년도 춘계학술대회 논문집
• /
• pp.205-208
• /
• 2008

본 논문에서는 LED(light emitting diode)조명과 CNT(carbon nano-tube)조명에 대한 전기적인 특성과 광학적 특성을 측정하여 비교하고 고찰하였다. 특히 IES format 파일을 사용하여 각각의 조명등기구에 대한 LID(luminous intensity distribution) 분석과 조도 시뮬레이션을 수행하여 최대 및 최소, 그리고 평균조도 등을 분석하였다. 향후 LED 및 CNT 신광원은 면조명으로의 관련 기술기준 및 규격의 작성시 참고자료로 활용될 것으로 판단된다.

• 오토저널
• /
• 제11권6호
• /
• pp.48-56
• /
• 1989

A shock tube technique was developed in which a freely falling droplets column produced by an ultrasonic atomizer was ignited behind reflected shock. In the present study, the effects of turbulent mixing on the ignition delay of a cetane was decided, also, ignition process was investigated. For the purpose of disturbance of droplets column and mixing, authors installed turbulent lattice in shock tube. Usually, the ignition delay is so called Arrhenius plot which found break point in the Arrhenius plot on the high temperature side. The rate of misfiring increased rapidly below 1080K, but ignition took place from 838k and luminous flame was seen to spread over the whole section by turbulent lattice. Length, from end plate to turbulent lattice, was varied with 60,40,20mm. Also, ignition process was detected by Photo transistor. As a result, it was found that physical factors changed ignition delay greatly and turbulent mixing had a considerable effects in the ignition process.

• 대한전기학회논문지
• /
• 제34권7호
• /
• pp.289-296
• /
• 1985

The Townsend primary ionization coefficient a was measured by the luminous-flux method using the fact that the intensity of radiant light is proportional to electron density in the townsend discharge domain. The ranges of measurements were 15for He gas and 10

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 추계학술대회 논문집 학회본부
• /
• pp.285-288
• /
• 1996

The electronic operation of the gas discharge tube is controlled by the electrical energy as sinusoidal waveform in arbitrary frequency range, or as a sequence of pulses at a wide range of duty cycle, the gas composition, the kind of electrode and the vessel geometry. In this paper, the pulsed mode operated gas discharge tube is composed with mixed gas of IIg-Ne ( 10 Torr ), in the tube of 15.0 mm outer diameter and has variable color from red to blue with changing frequency and pulse width in high voltage. As increasing pulse width and frequency in the gas discharge tube, the phenomenons that the electron temperature in the positive column increases and the radiation from atoms of higher upper state energy levels increases, exist. The color have the locus from red (0.4972, 0.3128) to blue (0.2736, 0.2619) in CIE chromacity diagram with increasing pulse width and frequency. The changing method of pulse width and frequency has been shown to be suitable for the luminous color control.

• 전기학회논문지
• /
• 제59권12호
• /
• pp.2262-2267
• /
• 2010

In order to analyze the reason of wall blackening, which affect the decline of lifetime in a ceramic metal halide lamp, we carried out the deterioration of ceramic tubes by a change in operating conditions with arc tubes of two types of spherical and cylindrical, and we have confirmed the cause of wall blackening through the analysis of element composition and spectrum from SEM/EDS and spectrum analyzer. Wall blackening of tungsten was shown by sputtering from ignition in 20 minute on/off condition and wall blackening from chemical reaction between PCA wall and rare earth halides was shown significantly in a condition without on/off test. Especially, the wall blackening and the decline of luminous flux were reduced by inner convection in spherical type arc tube. Moreover, the color temperature and color coordinate were changed by reduction of emission spectrum of Dy which causes the chemical reaction with PCA wall.

• 한국에너지공학회:학술대회논문집
• /
• 한국에너지공학회 2003년도 춘계 학술발표회 논문집
• /
• pp.377-382
• /
• 2003

본 연구의 대상인 자체발광 유리관은 밀봉된 유리관 내의 삼중수소에서 방출되는 베타입자와 유리관 내벽의 형광체와의 발광반응 메카니즘을 이용한 것이다. 자발광체는 삼중수소의 자연 붕괴와 형광체의 열화에 의해서 형광 효율이 감소되어 자발광체를 제조한 날로부터 지속적으로 휘도가 줄어들게 된다. 본 연구에서는 자발광체 제조 시 형광체의 열화를 최소화하기 위하여 형광체 열화에 영향을 미치는 요소인 온도, 온도 유지 시간, 공정 시 필요한 분위기를 다꾸지 방법에 의한 실험계획법으로 3인자 3수준의 교호작용을 고려하여 형광체의 음극선 발광 특성을 검토하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 A
• /
• pp.143-145
• /
• 1997

특수변압기의 일종인 네온 변압기의 기본원리와 특성을 조사하고 원가절감, 효율향상등 특성개선을 위하여 누설자속의 해석기술과 규소강판의 압연방향에 따른 자속의 영향, 압연방향성 코아의 형상설계방향 등을 제시한다.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 2005년도 추계학술발표회
• /
• pp.755-756
• /
• 2005

• 한국콘텐츠학회논문지
• /
• 제6권12호
• /
• pp.163-168
• /
• 2006

LCD의 배면광원으로 활용될 무수은 형광램프를 제작한 다음, 전기 광학적 특성을 평가하였다. PDP 형광체, nitro-cellulose 및 n-butyl acetate를 혼합하여 유리관 내부에 얼룩 없이 균일하게 코팅하였다. 또 $550^{\circ}C$에서 20 분 동안 소성하였고, 가스혼합장치를 이용하여 $10^{-6}$ torr까지 배기시킨 다음 방전가스를 주입하여 형광램프를 완성시켰다. 형광체 두께 및 유리관 직경 등을 변화시켜 제작, 평가한 결과 이들 변수들에 대하여 최적의 값을 찾아 낼 수 있었다. 또한 Ne+Xe 방전가스를 주입하여 제작된 형광램프에 75 kHz의 정현파 전압을 공급시킨 결과 휘도 $6,270cd/m^2$, 발광효율 13 lm/W를 얻었다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1253-1256
• /
• 2007

A display device combining plasma display panel (PDP) and field emission display (FED) is proposed to achieve high luminous efficiency. The device can avoid the main energy loss channels of both PDP (ion loss) and FED (low CL efficiency). $2{\sim}6$”-diagonal test panels with carbon nano-tube (CNT) electron emitter and Xenon ambient gas showed the luminous efficiency of 4.14lm/W and brightness of $263cd/m^2$ at 35V (1kHz, 1% duty), indicating that it is a good candidate for the low voltage driven, highly efficient next generation display.