• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.4
• /
• pp.145-151
• /
• 2005

Color enhancement of African rubies with dark red was carried out by the heat treatment and the hydrothermal treatment method respectively. The heat treatment method brought about an adverse effect causing the color to be deteriorated. However, the hydrothermal treatment method enhanced its color and clarity. The hydrothermal treatment conditions for color enhancement of them were as follows: solvent: 0.9M $Na_2CO_3-1M\;K_2CO_3$, temperature: $450^{\circ}C$, duration: 48 hrs, filling: $30\%$, pressure: 375 atm. As the results of characteristics for African rubies obtained under these conditions, it was known that the amount of $Cr^{3+},\;Fe^{3+},\;Ti^{4+}$ was reduced after the hydrothermal treatment from the ICP/MS and XRF analyses. Also, it was found that the red color from the colorimeter analyses was getting lighter. These results were consistent with the PL analysis showing that the intensity of the luminescence peak generated by the electron transition of $Cr^{3+}$ ion became lower after the hydrothermal treatment compared with the non-treated rubies.

• Journal of the Korean Ceramic Society
• /
• v.40 no.7
• /
• pp.637-643
• /
• 2003

In order to improve the photoluminescent properties and crystallinity, Zn$_2$SiO$_4$:Mn, M(M=Cr, Ti) phosphors were synthesized by the sol-gel method. The willemite single phase was obtained at 110$0^{\circ}C$, which is lower temperature than that of the conventional solid-state reaction (130$0^{\circ}C$). The characteristics of fired samples were obtained by a 147 nm excitation source under VUV (Vacuum Ultraviolet). To investigation the effect of co-dopant, the content of Mn and the ratio of $H_2O$ to TEOS was fixed as 2 ㏖% and 36. 1, respectively. The highest emission intensity was obtained when the concentration of Cr and Ti was 0.1 ㏖% relative to Zn$_2$SiO$_4$:Mn. While the emission intensity decrease continuously the decay time improved as increased the Cr concentration. In the case of Ti added samples, however, the emission intensity increase up to 2 ㏖％ concentration.

• Journal of the Korean Chemical Society
• /
• v.22 no.4
• /
• pp.239-244
• /
• 1978

Spectroscopic studies of trans-1,2-bispyrazylethylene (BPE), one of the stilbene analogues, were carried out. In normal UV spectra, a distinct $n{\rightarrow}{\pi}^*$ absorption band is missing because of a strong, nearly isoenergetic ${\pi}{\rightarrow}{\pi}^*$ absorption band. The second derivative and low temperature $(77^{\circ}K)$ UV absorption spectra were taken and $n{\rightarrow}{\pi}^*$ absorption band was identified by these methods. The transition energies of ${\pi}{\rightarrow}{\pi}^*$ transitions were calculated by Pariser-Parr-Pople (PPP)-SCF-CI MO method. The calculated values showed good agreement with the observed spectral data. Luminescence studies were also carried out at low temperature. From the fluorescence spectra, fluorescence polarization studies, and PPP-SCF-CI MO calculation, the fluorescent state was determined to be a singlet $({\pi},\;{\pi}^*)$ state. This conclusion is in good agreement with the results obtained from alkaline salt effects on the fluorescence of this compound.

• Journal of the Korean Ceramic Society
• /
• v.55 no.1
• /
• pp.55-60
• /
• 2018

In this study, quantum dots composed of $Mn^{2+}$ doped ZnS core and ZnS shell were synthesized using MPA precursor at room temperature. The ZnS: Mn/ZnS quantum dots were prepared by varying the content of MPA in the synthesis of ZnS shells. XRD, Photo-Luminescence (PL), XPS and TEM were used to characterize the properties of the ZnS: Mn/ZnS quantum dots. As a result of PL measurement using UV excitation light at 365 nm, the PL intensity was found to greatly increase when MPA was added at 15 ml, compared to the case with no MPA; the PL peaks shifted from 603 nm to 598 nm. A UV sensor was fabricated by using a sputtering process to form a Pt pattern and placing a QD on the Pt pattern. To verify the characteristics of the sensor, we measured the electrical properties via irradiation with UV, Red, Green, and Blue light. As a result, there were no reactions for the R, G, and B light, but an energy of 3.39 eV was produced with UV light irradiation. For the sensor using ZnS: Mn/ZnS quantum dots, the maximum current (A) value decreased from $4.00{\times}10^{-11}$ A to $2.62{\times}10^{-12}$ A with increasing of the MPA content. As the MPA content increases, the PL intensity improves but the electrical current value dropped because of the electron confinement effect of the core-shell.

• Journal of the Korean institute of surface engineering
• /
• v.49 no.1
• /
• pp.81-86
• /
• 2016

$Eu^{3+}$-doped $MgMoO_4$ phosphor thin films were deposited on quartz substrates by radio frequency magnetron sputtering with changing various growth temperatures. The effects of growth temperature on the structure, transmittance, optical band gap, and luminescence of the phosphor thin films were characterized. All the phosphor thin films, irrespective of growth temperature, showed a monoclinic structure with a main (220) diffraction peak. The thin film deposited at a growth temperature of $400^{\circ}C$ indicated an average transmittance of 90% in the wavelength range of 500 ~ 1100 nm and band gap energy of 4.81 eV. The excitation spectra of the phosphor thin films consisted of a broad charge transfer band peaked at 284 nm in the range of 230 ~ 330 nm and two weak peaks located at 368 and 461 nm, respectively. The emission spectra under ultraviolet excitation at 284 nm exhibited a sharp emission peak at 614 nm and several weak bands. All the phosphor thin films showed high asymmetry ratio values, indicating that $Eu^{3+}$ ions incorporated into the host lattice occupied at the non-inversion symmetry sites. The results suggest that the growth temperature plays an important role in growing high-quality phosphor thin films.

• Korean Journal of Materials Research
• /
• v.18 no.2
• /
• pp.84-91
• /
• 2008

The effects of the deposition and annealing temperature on the structural, electrical and optical properties of Ag doped ZnO (ZnO : Ag) thin films were investigated. All of the films were deposited with a 2wt% $Ag_2O-doped$ ZnO target using an e-beam evaporator. The substrate temperature varied from room temperature (RT) to $250^{\circ}C$. An undoped ZnO thin film was also fabricated at $150^{\circ}C$ as a reference. The as-grown films were annealed in temperatures ranging from 350 to $650^{\circ}C$ for 5 h in air. The Ag content in the film decreased as the deposition and the post-annealing temperature increased due to the evaporation of the Ag in the film. During the annealing process, grain growth occurred, as confirmed from XRD and SEM results. The as-grown film deposited at RT showed n-type conduction; however, the films deposited at higher temperatures showed p-type conduction. The films fabricated at $150^{\circ}C$ revealed the highest hole concentration of $3.98{\times}1019\;cm^{-3}$ and a resistivity of $0.347\;{\Omega}{\cdot}cm$. The RT PL spectra of the as-grown ZnO : Ag films exhibited very weak emission intensity compared to undoped ZnO; moreover, the emission intensities became stronger as the annealing temperature increased with two main emission bands of near band-edge UV and defect-related green luminescence exhibited. The film deposited at $150^{\circ}C$ and annealed at $350^{\circ}C$ exhibited the lowest value of $I_{vis}/I_{uv}$ of 0.05.

• Journal of the Korean Ceramic Society
• /
• v.56 no.1
• /
• pp.98-103
• /
• 2019

Optical filters to control light wavelength of displays or cameras are fabricated by multi-layer stacking process of low and high index thin films. The process of multi-layer stacking of thin films has received much attention as an optimal process for effective manufacturing in the optical filter industry. However, multi-layer processing has disadvantages of complicated thin film process, and difficulty of precise control of film morphology and material selection, all of which are critical for transmittance and coloring effect on filters. In this study, the composite $TiO_2$, which can be used to control of UV absorption, coated on nano hollow silica sol, was synthesized as a coating material for optical filters. Furthermore, systematic analysis of the process parameters during the chemical reaction, and of the structural properties of the coating solutions was performed using SEM, TEM, XRD and photo spectrometry. From the structural analysis, we found that the 85 nm nano hollow silica with 2.5 nm $TiO_2$ shell formation was successfully synthesized at proper pH control and titanium butoxide content. Photo luminescence characteristics, excited by UV irradiation, show that stable absorption of 350 nm-light, correlated with a 3.54 eV band gap, existed for the $TiO_2$ shell-nano hollow silica reacted with 8.8 mole titanium butoxide solution. Transmittance observed on substrate of the $TiO_2$ shell-nano hollow silica showed effective absorption of 200-300 nm UV light without deterioration of visible light transparency.

• Journal of the Microelectronics and Packaging Society
• /
• v.26 no.1
• /
• pp.23-28
• /
• 2019

The Titanium oxide ($TiO_2$) is an attractive ceramic material which shows non-toxic, high refractive index, catalytic activity and biocompatibility, and can be fabricated at a low cost due to its high chemical stability and large anisotropy. $TiO_2$ nanoparticles have been prepared by sol-gel method. The pH of solution can affect the $TiO_2$ crystallinity during the formation of nanoparticles. The prepared nanoparticles were characterized using Fourier transform infrared spectroscopy, scanning electron microscopy, X-ray diffraction, photoluminescence spectroscopy in order to investigate their structural and photoluminescence properties. Through these analysis, the size of $TiO_2$ nanoparticles were found to be smaller than 5 nm. As the crystallinity of the nanoparticles increased, the emission of PL in the 550 nm region increased. Therefore, luminescence characteristics can be improved by controlling the crystallinity of the $TiO_2$ nanoparticles.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.30 no.6
• /
• pp.232-236
• /
• 2020

In this study, the optical properties of CaF2-Al2O3-B2O3-TiO2 (CABT) system glass doped with rare earth ion, that is used in various light devices due to its excellent luminous properties, were analyzed as a function of kind of crystal phases formed and size of crystals generated in the glass matrix. TiO2 was added to control nucleation and crystallization, and Eu2O3 was added to enhance the luminescence characteristics. DTA analysis was performed to confirm the heat treatment condition of crystal generation, and XRD and SEM anal ysis were carried out for the crystal phase change of nanometer size. As a result of the analysis, the luminous properties of oxy-fluoride-based glass were improved duo to crystallization of nanometer size, but was rather degraded when excessively large crystals were generated.

• The Journal of Korean Medicine
• /
• v.38 no.2
• /
• pp.15-30
• /
• 2017

Objectives: Hwangryunhaedok-tang (HHT; Huanglianjiedu-tang, Orengedoku-to), a traditional herbal formula, is used for treating inflammation, hypertension, gastritis, liver dysfunction, cerebrovascular diseases, dermatitis and dementia. The objective of this study was to assess the sub-acute toxicity of HHT in Sprague-Dawley (SD) rats, and its effect on the activities of human microsomal cytochrome P450s (CYP450s) and UDP-glucuronosyltransferases (UGTs). Methods: Male and female SD rats were orally administered HHT once daily at doses of 0, 500, 1000 and 2000 mg/kg for 4 weeks. We analyzed mortality, clinical observations, body weight, food consumption, organ weights, urinalysis, hematology, serum biochemistry, and histopathology. The activities of major human CYP450s (CYP1A2, CYP3A4, CYP2B6, CYP2C9, CYP2C19, CYP2D6, and CYP2E1) and UGTs (UGT1A1, UGT1A4, and UGT2B7) were assessed using in vitro fluorescence- and luminescence-based enzyme assays, respectively. Results: No toxicologically significant changes related to the repeated administration of HHT were observed in both male and female SD rats. The no observed adverse effect level (NOAEL) value was more than 2000 mg/kg/day for both sexes. HHT inhibited the activities of human microsomal CYP1A2, CYP2C19, CYP2D6, and CYP2E1, whereas it weakly inhibited the activities of CYP2B6, CYP2C9, CYP3A4, and UGT1A1. In addition, HHT negligibly inhibited the activities of human microsomal UGT1A4 and UGT2B7 with $IC_{50}$ values in excess of $1000{\mu}g/mL$. Conclusions: Our findings indicate that HHT may be safe for repeated administration up to 4 weeks. In addition, these findings provide information on the safety and effectiveness of HHT when co-administered with conventional drugs.