• Journal of the Korean Institute of Gas
• /
• v.17 no.6
• /
• pp.67-72
• /
• 2013

The flash point is the lowest temperature at which there is enough concentration of flammable vapor to form an ignitable mixture with air. The flash point is a major physical property used to analyse the fire and explosion hazards of a flammable liquid solution. The flash point data for pure components are easily available in several literature. But the flash points of the flammable binary solutions appear to be scarce in the literature. The objective of this study is to measure and estimate the flash point of acetic acid-formic acid system. Cleveland open cup tester was used to measure the flash point. The experimental data were compared with the values estimated by the Raoult's law and the optimization methods based on van Laar and Wilson equations. As a result, the estmated values by optimization methods were found to be better than those based on the Raoult's law.

• Korean journal of applied entomology
• /
• v.49 no.1
• /
• pp.43-47
• /
• 2010

This study was conducted to investigate optimal conditions for formation of synnemata from Beauveria bassiana. The strain of B. bassiana was isolated from a host of Oncotympana fuscata in Halla mountain of Jeju island. The yield of synnemata was the highest at application of brown rice (90%) and silkworm pupae (10%) media. On the other hand, the other media did not result in formation of synnemata. The highest formation of synnemata was achieved at conditions of moderate air inflow and $20^{\circ}C$. The optimal moisture and light intensity for formation of synnemata were 60% and 300 lux, respectively. In addition, inoculation of the liquid spawn resulted in higher yield than that of asexual spore.

• Plant Journal
• /
• v.15 no.4
• /
• pp.36-42
• /
• 2019

In recent, according to the tightening of environment regulation policy, the height of the site of the power plant is increased and the length of the cooling water pipe is increased. This has a serious impact on the stability of the plant. This study analyzes the transient phenomenon using LIQT 7.2, an unsteady state one-dimensional analysis software, to secure the stability of 1,000 MW high-capacity coal-fired power plant cooling water system with high head. To prevent water hammer, The effects on performance characteristics were predicted by individual and combination application. The surge pressure of the cooling water which occurs when the pump was stopped without installing the anti-surge devices was the largest at the pump outlet side. The most effective and simple way to reduce surge pressure in these cooling water systems is to combine a vacuum breaker with a hydraulic non-return valve, which is an essential device for pump protection.

• Journal of ILASS-Korea
• /
• v.20 no.2
• /
• pp.121-129
• /
• 2015

This study was designed to investigate the emission characteristics of unregulated pollutants (Aldehyde, VOCs, PAHs) as well as regulated pollutants (CO, HC, NOx and PM) from diesel medium-duty trucks. The emission characteristics of unregulated and regulated pollutants were assessed based on regulation standards (EURO 4 and EURO 5) and intake weight (2.5 ton and 5 ton). The results show that unregulated and regulated pollutants remained almost unchanged at higher speeds but decreased at below 23.5 km/h. Reduction in unregulated and regulated pollutants was noticeable in vehicles of recent regulation standards and light intake weight. The analysis of aldehyde using UPLC showed that formaldehyde and acetaldehyde of aldehyde were most dominant. The GC/MS analysis showed that benzene, toluene, ethylbenzene and xylene of VOCs was over 80% followed by toluene, xylene, ethylbenzene and benzene. In addition, the analysis of PAHs using GC/TOF-MS indicated that bi- and tricyclic aromatic ring of aromatic compounds was 73% and 53% at 2.5 ton and 5 ton vehicles, respectively. The results of this study will be contributed to establish HAPs inventory.

• Korean Journal of Soil Science and Fertilizer
• /
• v.18 no.1
• /
• pp.32-37
• /
• 1985

Effects of straw mulching on growth of shoot and root of Panax ginseng, soil physical and chemical characteristics were investigated. Straw mulching increased root yield, stem length, leaf area and decreased defoliated plant rate and missing root rate. Percent solid phase and soil hardness decreased, and porosity, percent air phase and percent liquid phase increased under straw mulch. It increased soil water content and decreased soil temperature especially in the rear side of the bed. Available soil phosphorus (very harmfully in some case), exchangeable potassium, organic matter increased while exchangeable calcium decreased and the lowering of pH was retarded under mulch. Straw mulching greatly reduced need population, prevented soil covering on the lower side of leaves and eliminated solings to plants, bed sides and on bed top.

• Journal of Korean Society for Atmospheric Environment
• /
• v.32 no.6
• /
• pp.633-641
• /
• 2016

Two identical Particle Into Liquid Samplers-Total Organic Carbon (PILS-TOC) were operated to measure fine particle Water Soluble Organic Carbon (WSOC) for one week on Feb. in 2016. The dual instrument operations provided validated WSOC concentrations to have a continuous WSOC measurement during the sample analysis period. Both PILS-TOC instruments were operated downstream of an carbon denuder to remove positive adsorption artifacts associated with semi-volatile organic compounds. Comparison of WSOC showed good agreement each other. The linear regression had a coefficient of determination ($r^2$) of 0.92 and a regression slope of 1.01 for the first period. The lower collection efficiency due to lower steam temperature is discussed. In addition, the potential primary source related to WSOC based on the comparison of black carbon (BC) concentrations is explained. The results of good agreement between two PILS-TOC measurements can provide the validation of WSOC cooperations and knowledge regarding the origins of WSOC and their behaviors.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.14 no.3
• /
• pp.151-156
• /
• 1994

Exertion has been made to develop high-temperature (about $250{\sim}650^{\circ}C$) immersion ultrasonic sensor for the visualization of objects, temperature measurement, dimensional check, or nondestructive testing of welds under liquid sodium. In this study, the feasibility of the ultrasonic sensor taking advantage of a strip waveguide was confirmed by water-experiment. The lowest order of antisymmetric Lamb wave was used in the frequency range with negligible dispersion. This plate wave was excited in the stainless steel strip waveguide of 1.0mm thickness and 13mm width by the comb-structure transducer of 2.3MHz frequency. Its attenuation coefficient was 1.2dB/m in air and 380dB/m in water. The signal to noise ratio of 25dB was obtained from a planar reflector 270mm away from the beam aperture of $13mm{\times}39mm$ size.

• Journal of the Korean Electrochemical Society
• /
• v.5 no.1
• /
• pp.27-29
• /
• 2002

We report a fuel cell power supply unit for mobile phone which operates at room temperature and ambient pressure using liquid methanol and air. The unit consists of a direct methanol fuel cell (DMFC) and a back-up battery connected parallely to the fuel cell. DMFC supplies half of the required power and the back-up battery supplies the other half during talk mode. In standby mode, DMFC covers $100\%$ of the required power and charges the back-up battery as well, Eight unit cells, each having $9 cm^2$ of active area, were connected in series in order to raise the output volotage to $2.5\~3.9V$, which is typical for most mobile phones.

• Journal of Environmental Health Sciences
• /
• v.34 no.1
• /
• pp.42-48
• /
• 2008

The objectives of this study were to measure ambient TGM concentrations in Seoul Korea, to determine the temporal variation of TGM, and to analyze the relationships among TGM, meteorological data and PM2.5 measured at the same time. Ambient TGM and PM2.5 concentrations were measured at the roof of the Graduate School of Public Health building in Seoul, Korea for the period of January to October 2004. Average TGM concentration was $3.43{\pm}1.17ng/m^3$. The average TGM was at a low concentration similar to those of background sites in other countries. The temporal variations and meteorological phenomena of TGM were not statistically significant. There was a positive link between TGM and PM2.5. It didn't indicate that reduction of $Hg^{2+}$ to Hg0 had occurred in liquid water contained in smog as in a previous study, but it shows that PM2.5 and TGM could be emitted from the same sources such as power plants and combustion engines. Also, the strong correlation between TGM and $SO_2$ concentrations indicated that the source of TGM was from fossil fuel combustions including coal combustion. Specifically, $SO_2\;and\;SO_4{^2-}$ concentrations correlated to TGM concentrations could be linked to TGM emitted from local and regional sources as well.

• Applied Chemistry for Engineering
• /
• v.9 no.1
• /
• pp.20-27
• /
• 1998

The characteristics of the bubble adsorptive separation of CTAB(cetyltrimethylammonium bromide) and CuS precipitates was investigated. The Langmuir adsorption equation was adequate at very low concentration of CTAB, and the adsorption heat was determined from the batch analysis considering the bulk liquid accompanied between bubbles. The adsorption mechanism was explained with the collision adsorption between bubbles and precipitate particles. The optimum concentration ratio of (CTAB) to (CuS) for adsorptive separation was 0.1 and coincided with the ratio for the coagulation of particles. The collection efficiency was depended on pH and CTAB concentration but independent of the air flow rate, and the maximum efficiency was 0.0002. The selective separation of ZnS from the mixture of Cu-Cd-Zn sulfides was obtained by the bubble adsorption with CTAB.